Scalable and network aware video coding for advanced communications over heterogeneous networks

This thesis was submitted for the degree of Doctor of Philosophy and was awarded by Brunel UniversityThis work addresses the issues concerned with the provision of scalable video services over heterogeneous networks particularly with regards to dynamic adaptation and user’s acceptable quality of service. In order to provide and sustain an adaptive and network friendly multimedia communication service, a suite of techniques that achieved automatic scalability and adaptation are developed. These techniques are evaluated objectively and subjectively to assess the Quality of Service (QoS) provided to diverse users with variable constraints and dynamic resources. The research ensured the consideration of various levels of user acceptable QoS The techniques are further evaluated with view to establish their performance against state of the art scalable and non-scalable techniques. To further improve the adaptability of the designed techniques, several experiments and real time simulations are conducted with the aim of determining the optimum performance with various coding parameters and scenarios. The coding parameters and scenarios are evaluated and analyzed to determine their performance using various types of video content and formats. Several algorithms are developed to provide a dynamic adaptation of coding tools and parameters to specific video content type, format and bandwidth of transmission. Due to the nature of heterogeneous networks where channel conditions, terminals, users capabilities and preferences etc are unpredictably changing, hence limiting the adaptability of a specific technique adopted, a Dynamic Scalability Decision Making Algorithm (SADMA) is developed. The algorithm autonomously selects one of the designed scalability techniques basing its decision on the monitored and reported channel conditions. Experiments were conducted using a purpose-built heterogeneous network simulator and the network-aware selection of the scalability techniques is based on real time simulation results. A technique with a minimum delay, low bit-rate, low frame rate and low quality is adopted as a reactive measure to a predicted bad channel condition. If the use of the techniques is not favoured due to deteriorating channel conditions reported, a reduced layered stream or base layer is used. If the network status does not allow the use of the base layer, then the stream uses parameter identifiers with high efficiency to improve the scalability and adaptation of the video service. To further improve the flexibility and efficiency of the algorithm, a dynamic de-blocking filter and lambda value selection are analyzed and introduced in the algorithm. Various methods, interfaces and algorithms are defined for transcoding from one technique to another and extracting sub-streams when the network conditions do not allow for the transmission of the entire bit-stream

Simulation and experimental testbed for adaptive video streaming in ad hoc networks

[EN] This paper presents a performance evaluation of the scalable video streaming over mobile ad hoc networks. In particular, we focus on the rate-adaptive method for streaming scalable video (H.264/SVC). For effective adaptation a new cross-layer routing protocol is introduced. This protocol provides an efficient algorithm for available bandwidth estimation. With this information, the video source adjusts its bit rate during the video transmission according to the network state. We also propose a free simulation framework that supports evaluation studies for scalable video streaming. The simulation experiments performed in this study involve the transmission of SVC streams with Medium Grain Scalability (MGS) as well as temporal scalability over different network scenarios. The results reveal that the rate-adaptive strategy helps avoid or reduce the congestion in MANETs obtaining a better quality in the received videos. Additionally, an actual ad hoc network was implemented using embedded devices (Raspberry Pi) in order to assess the performance of the proposed adaptive transmission mechanism in a real environment. Additional experiments were carried out prior to the implementation with the aim of characterizing the wireless medium and packet loss profile. Finally, the proposed approach shows an important reduction in energy consumption, as the study revealed.This paper was performed with the support of the National Secretary of Higher Education, Science, Technology and Innovation (SENESCYT)–Ecuador Government (scholarship 195-2012) and the Multimedia Communications Group (COMM) belong to the Institute of Telecommunications and Multimedia Applications (iTEAM)-Universitat Politècnica de València.Gonzalez-Martinez, SR.; Castellanos Hernández, WE.; Guzmán Castillo, PF.; Arce Vila, P.; Guerri Cebollada, JC. (2016). Simulation and experimental testbed for adaptive video streaming in ad hoc networks. Ad Hoc Networks. 52:89-105. https://doi.org/10.1016/j.adhoc.2016.07.007S891055

Robust multi-view video streaming through adaptive intra refresh video transcoding

A multi-view video (MVV) transcoder has been designed. The objective is to deliver maximum quality 3D video data from the source to the 2D video destination, through a wireless communication channel using all of its available bandwidth. This design makes use of the spatial and view downscaling algorithm. The method involves the reuse of motion information obtained from both the reference frames and views. Consequently, highly compressed MVV is converted into low bit rate single view video that is compliant with H.264/AVC format. Adaptive intra refresh (AIR) error resilience tool is configured to mitigate the error propagation resulting from channel conditions. Experimental results indicate that error resilience plus transcoding performed better than the cascaded technique. Simulation results demonstrated an efficient 3D video streaming service applied to low power mobile devices

{WAVA}: a New Web Service for Automatic Video Data Flow Adaptation in Heterogeneous Collaborative Environments

International audienceThe progressive needs for using video streaming for different applications in varied domains have created a new set of heterogeneous environments. In order to get the best performance of such environments, video streaming has to be adapted to the different parameters that characterize these environments, namely: bandwidth, CPU, GPU, screen resolution, etc. In this paper, we define a new web service, named Wava (Web service for Automatic Video Data Flows Adaptation). Wava allows multimedia platform to adjust the adaptation at two levels: the static level during initialization and the dynamic level according to the fluctuation of the environment

A Decoding-Complexity and Rate-Controlled Video-Coding Algorithm for HEVC

Video playback on mobile consumer electronic (CE) devices is plagued by fluctuations in the network bandwidth and by limitations in processing and energy availability at the individual devices. Seen as a potential solution, the state-of-the-art adaptive streaming mechanisms address the first aspect, yet the efficient control of the decoding-complexity and the energy use when decoding the video remain unaddressed. The quality of experience (QoE) of the end-users’ experiences, however, depends on the capability to adapt the bit streams to both these constraints (i.e., network bandwidth and device’s energy availability). As a solution, this paper proposes an encoding framework that is capable of generating video bit streams with arbitrary bit rates and decoding-complexity levels using a decoding-complexity–rate–distortion model. The proposed algorithm allocates rate and decoding-complexity levels across frames and coding tree units (CTUs) and adaptively derives the CTU-level coding parameters to achieve their imposed targets with minimal distortion. The experimental results reveal that the proposed algorithm can achieve the target bit rate and the decoding-complexity with 0.4% and 1.78% average errors, respectively, for multiple bit rate and decoding-complexity levels. The proposed algorithm also demonstrates a stable frame-wise rate and decoding-complexity control capability when achieving a decoding-complexity reduction of 10.11 (%/dB). The resultant decoding-complexity reduction translates into an overall energy-consumption reduction of up to 10.52 (%/dB) for a 1 dB peak signal-to-noise ratio (PSNR) quality loss compared to the HM 16.0 encoded bit streams

Workload model for video decoding and its applications

Ph.DDOCTOR OF PHILOSOPH

Toward a General Parametric Model for Assessing the Impact of Video Transcoding on Objective Video Quality

Video transcoding can cause degradation to an original video. Currently, there is no general model that assesses the impact of video transcoding on video quality. Such a model could play a critical role in evaluating the quality of the transcoded video, and thereby optimizing delivery of video to end-users while meeting their expectations. The main contribution of this research is the development and substantiation of a general parametric model, called the Video Transcoding Objective-quality Model (VTOM), that provides an extensible video transcoding service selection mechanism, which takes into account both the format and characteristics of the original video and the desired output, i.e., viewing format with preferred quality of service. VTOM represents a mathematical function that uses a set of media-related parameters for the original video and desired output, including codec, bit rate, frame rate, and frame size to predict the quality of the transcoded video generated from a specific transcoding. VTOM includes four quality sub-models, each describing the impact of each of these parameters on objective video quality, as well as a weighted-product aggregation function that combines these quality sub-models with four additional error sub-models in a single function for assessing the overall video quality. I compared the predicted quality results generated from the VTOM with quality values generated from an existing objective-quality metric. These comparisons yielded results that showed good correlations, with low error values. VTOM helps the researchers and developers of video delivery systems and applications to calculate the degradation that video transcoding can cause on the fly, rather than evaluate it statistically using statistical methods that only consider the desired output. Because VTOM takes into account the quality of the input video, i.e., video format and characteristics, and the desired quality of the output video, it can be used for dynamic video transcoding service selection and composition. A number of quality metrics were examined and used in development of VTOM and its assessment. However, this research discovered that, to date, there are no suitable metrics in the literature for comparing two videos with different frame rates. Therefore, this dissertation defines a new metric, called Frame Rate Metric (FRM) as part of its contributions. FRM can use any frame-based quality metric for comparing frames from both videos. Finally, this research presents and adapts four Quality of Service (QoS)-aware video transcoding service selection algorithms. The experimental results showed that these four algorithms achieved good results in terms of time complexity, success ratio, and user satisfaction rate

Video QoS/QoE over IEEE802.11n/ac: A Contemporary Survey

The demand for video applications over wireless networks has tremendously increased, and IEEE 802.11 standards have provided higher support for video transmission. However, providing Quality of Service (QoS) and Quality of Experience (QoE) for video over WLAN is still a challenge due to the error sensitivity of compressed video and dynamic channels. This thesis presents a contemporary survey study on video QoS/QoE over WLAN issues and solutions. The objective of the study is to provide an overview of the issues by conducting a background study on the video codecs and their features and characteristics, followed by studying QoS and QoE support in IEEE 802.11 standards. Since IEEE 802.11n is the current standard that is mostly deployed worldwide and IEEE 802.11ac is the upcoming standard, this survey study aims to investigate the most recent video QoS/QoE solutions based on these two standards. The solutions are divided into two broad categories, academic solutions, and vendor solutions. Academic solutions are mostly based on three main layers, namely Application, Media Access Control (MAC) and Physical (PHY) which are further divided into two major categories, single-layer solutions, and cross-layer solutions. Single-layer solutions are those which focus on a single layer to enhance the video transmission performance over WLAN. Cross-layer solutions involve two or more layers to provide a single QoS solution for video over WLAN. This thesis has also presented and technically analyzed QoS solutions by three popular vendors. This thesis concludes that single-layer solutions are not directly related to video QoS/QoE, and cross-layer solutions are performing better than single-layer solutions, but they are much more complicated and not easy to be implemented. Most vendors rely on their network infrastructure to provide QoS for multimedia applications. They have their techniques and mechanisms, but the concept of providing QoS/QoE for video is almost the same because they are using the same standards and rely on Wi-Fi Multimedia (WMM) to provide QoS