A Demonstration of LISA Laser Communication

Over the past few years questions have been raised concerning the use of laser communications links between sciencecraft to transmit phase information crucial to the reduction of laser frequency noise in the LISA science measurement. The concern is that applying medium frequency phase modulations to the laser carrier could compromise the phase stability of the LISA fringe signal. We have modified the table-top interferometer presented in a previous article by applying phase modulations to the laser beams in order to evaluate the effects of such modulations on the LISA science fringe signal. We have demonstrated that the phase resolution of the science signal is not degraded by the presence of medium frequency phase modulations.Comment: minor corrections found in the CQG versio

Suppressed carrier full-spectrum combining

A technique to accomplish full spectrum arraying where all the telemetry power is put into the subcarrier sidebands (suppressed carrier) is described. The matched filter needed in each antenna prior to cross correlation for deriving the coherence delay and phase offsets is an open loop version of the telemetry phase lock loop provided in the Advanced Digital Receiver. In analogy with a Costas loop telemetry receiver, a squaring loss is derived, and a signal to noise ratio for the cross correlation loop phase is presented

Cyclic redundancy check-based detection algorithms for automatic identification system signals received by satellite.

This paper addresses the problem of demodulating signals transmitted in the automatic identification system. The main characteristics of such signals consist of two points: (i) they are modulated using a trellis-coded modulation, more precisely a Gaussian minimum shift keying modulation; and (ii) they are submitted to a bit stuffing procedure, which makes more difficult the detection of the transmitted information bits. This paper presents several demodulation algorithms developed in different contexts: mono-user and multi-user transmissions, and known/unknown phase shift. The proposed receiver uses the cyclic redundancy check (CRC) present in the automatic identification system signals for error correction and not for error detection only. By using this CRC, a particular Viterbi algorithm, on the basis of a so-called extended trellis, is developed. This trellis is defined by extended states composed of a trellis code state and a CRC state. Moreover, specific conditional transitions are defined to take into account the possible presence of stuffing bits. The algorithms proposed in the multi-user scenario present a small increase of computation complexity with respect to the mono-user algorithms. Some performance results are presented for several scenarios in the context of the automatic identification system and compared with those of existing techniques developed in similar scenarios

AMiBA Wideband Analog Correlator

A wideband analog correlator has been constructed for the Yuan-Tseh Lee Array for Microwave Background Anisotropy. Lag correlators using analog multipliers provide large bandwidth and moderate frequency resolution. Broadband IF distribution, backend signal processing and control are described. Operating conditions for optimum sensitivity and linearity are discussed. From observations, a large effective bandwidth of around 10 GHz has been shown to provide sufficient sensitivity for detecting cosmic microwave background variations.Comment: 28 pages, 23 figures, ApJ in press

Unbalanced quadriphase demodulator

A new and improved apparatus and method are described for demodulation of quaternary phase shift keyed (QPSK) data, particularly unbalanced QPSK. Phase adjustment of the output of a phase locked loop local oscillator is performed to reduce sensitivity to amplitude variations internal to the demodulator

Digital demodulator-correlator

An apparatus for demodulation and correlation of a code modulated 10 MHz signal is presented. The apparatus is comprised of a sample and hold analog-to-digital converter synchronized by a frequency coherent 40 MHz pulse to obtain four evenly spaced samples of each of the signal. Each sample is added or subtracted to or from one of four accumulators to or from the separate sums. The correlation functions are then computed. As a further feature of the invention, multipliers are each multiplied by a squarewave chopper signal having a period that is long relative to the period of the received signal to foreclose contamination of the received signal by leakage from either of the other two terms of the multipliers

Implementation Aspects of a Transmitted-Reference UWB Receiver

In this paper, we discuss the design issues of an ultra wide band (UWB) receiver targeting a single-chip CMOS implementation for low data-rate applications like ad hoc wireless sensor networks. A non-coherent transmitted reference (TR) receiver is chosen because of its small complexity compared to other architectures. After a brief recapitulation of the UWB fundamentals and a short discussion on the major differences between coherent and non-coherent receivers, we discuss issues, challenges and possible design solutions. Several simulation results obtained by means of a behavioral model are presented, together with an analysis of the trade-off between performance and complexity in an integrated circuit implementation

Ultramicrowave communications system, phase 2

Communications system design was completed and reviewed. Minor changes were made in order to make it more cost effective and to increase design flexibility. System design activities identified the techniques and procedures to generate and monitor high data rate test signals. Differential bi-phase demodulation is the proposed method for this system. The mockup and packaging designs were performed, and component layout and interconnection constraints were determined, as well as design drawings for dummy parts of the system. The possibility of adding a low cost option to the transceiver system was studied. The communications program has the advantage that new technology signal processing devices can be readily interfaced with the existing radio frequency subsystem to produce a short range radar

Programmable rate modem utilizing digital signal processing techniques

The engineering development study to follow was written to address the need for a Programmable Rate Digital Satellite Modem capable of supporting both burst and continuous transmission modes with either binary phase shift keying (BPSK) or quadrature phase shift keying (QPSK) modulation. The preferred implementation technique is an all digital one which utilizes as much digital signal processing (DSP) as possible. Here design tradeoffs in each portion of the modulator and demodulator subsystem are outlined, and viable circuit approaches which are easily repeatable, have low implementation losses and have low production costs are identified. The research involved for this study was divided into nine technical papers, each addressing a significant region of concern in a variable rate modem design. Trivial portions and basic support logic designs surrounding the nine major modem blocks were omitted. In brief, the nine topic areas were: (1) Transmit Data Filtering; (2) Transmit Clock Generation; (3) Carrier Synthesizer; (4) Receive AGC; (5) Receive Data Filtering; (6) RF Oscillator Phase Noise; (7) Receive Carrier Selectivity; (8) Carrier Recovery; and (9) Timing Recovery

A turn-key Concept for active cancellation of Global Positioning System L3 Signal

We present a concept, developed at the National Astronomy and Ionosphere Center (NAIC) at Arecibo, Puerto Rico, for active suppression of Global Positioning System (GPS) signals in the 305 m dish radio receiver path prior to backend processing. The subsystem does not require an auxiliary antenna and is intended for easy integration with radio telescope systems with a goal of being a turnkey addition to virtually any facility. Working with actual sampled signal data, we have focused on the detection and cancellation of the GPS L3 signal at 1381.05 MHz which, during periodic test modes and particularly during system-wide tests, interfere with observations of objects in a range of redshifts that includes the Coma supercluster, for example. This signal can dynamically change modulation modes and our scheme is capable of detecting these changes and applying cancellation or sending a blanking signal, as appropriate. The subsystem can also be adapted to GPS L1 (1575.42 MHz), L2C (1227.6 MHz), and others. A follow-up is underway to develop a prototype to deploy and evaluate at NAIC.Comment: Presented at the RFI mitigation workshop, 29-31 March 2010, Groningen, the Netherlands. Accepted for publication by the Proceedings of Scienc