An improved time-delay implementation of derivative-dependent feedback

We consider an LTI system of relative degree that can be stabilized using output derivatives. The derivatives are approximated by finite differences leading to a time-delayed feedback. We present a new method of designing and analyzing such feedback under continuous-time and sampled measurements. This method admits essentially larger time-delay/sampling period compared to the existing results and, for the first time, allows to use consecutively sampled measurements in the sampled-data case. The main idea is to present the difference between the derivative and its approximation in a convenient integral form. The kernel of this integral is hard to express explicitly but we show that it satisfies certain properties. These properties are employed to construct the Lyapunov–Krasovskii functional that leads to LMI-based stability conditions. If the derivative-dependent control exponentially stabilizes the system, then its time-delayed approximation stabilizes the system with the same decay rate provided the time-delay (for continuous-time measurements) or the sampling period (for sampled measurements) are small enough

PID Control of Biochemical Reaction Networks

Principles of feedback control have been shown to naturally arise in biological systems and successfully applied to build synthetic circuits. In this work we consider Biochemical Reaction Networks (CRNs) as a paradigm for modelling biochemical systems and provide the first implementation of a derivative component in CRNs. That is, given an input signal represented by the concentration level of some species, we build a CRN that produces as output the concentration of two species whose difference is the derivative of the input signal. By relying on this component, we present a CRN implementation of a feedback control loop with Proportional-Integral-Derivative (PID) controller and apply the resulting control architecture to regulate the protein expression in a microRNA regulated gene expression model.Comment: 8 Pages, 4 figures, Submitted to CDC 201

Proportional-integral-plus control applications of state-dependent parameter models

This paper considers proportional-integral-plus (PIP) control of non-linear systems defined by state-dependent parameter models, with particular emphasis on three practical demonstrators: a microclimate test chamber, a 1/5th-scale laboratory representation of an intelligent excavator, and a full-scale (commercial) vibrolance system used for ground improvement on a construction site. In each case, the system is represented using a quasi-linear state-dependent parameter (SDP) model structure, in which the parameters are functionally dependent on other variables in the system. The approach yields novel SDP-PIP control algorithms with improved performance and robustness in comparison with conventional linear PIP control. In particular, the new approach better handles the large disturbances and other non-linearities typical in the application areas considered

An Improved Link Model for Window Flow Control and Its Application to FAST TCP

This paper presents a link model which captures the queue dynamics in response to a change in a transmission control protocol (TCP) source's congestion window. By considering both self-clocking and the link integrator effect, the model generalizes existing models and is shown to be more accurate by both open loop and closed loop packet level simulations. It reduces to the known static link model when flows' round trip delays are identical, and approximates the standard integrator link model when there is significant cross traffic. We apply this model to the stability analysis of fast active queue management scalable TCP (FAST TCP) including its filter dynamics. Under this model, the FAST control law is linearly stable for a single bottleneck link with an arbitrary distribution of round trip delays. This result resolves the notable discrepancy between empirical observations and previous theoretical predictions. The analysis highlights the critical role of self-clocking in TCP stability, and the proof technique is new and less conservative than existing ones

Analysis and equalization of data-dependent jitter

Data-dependent jitter limits the bit-error rate (BER) performance of broadband communication systems and aggravates synchronization in phase- and delay-locked loops used for data recovery. A method for calculating the data-dependent jitter in broadband systems from the pulse response is discussed. The impact of jitter on conventional clock and data recovery circuits is studied in the time and frequency domain. The deterministic nature of data-dependent jitter suggests equalization techniques suitable for high-speed circuits. Two equalizer circuit implementations are presented. The first is a SiGe clock and data recovery circuit modified to incorporate a deterministic jitter equalizer. This circuit demonstrates the reduction of jitter in the recovered clock. The second circuit is a MOS implementation of a jitter equalizer with independent control of the rising and falling edge timing. This equalizer demonstrates improvement of the timing margins that achieve 10/sup -12/ BER from 30 to 52 ps at 10 Gb/s

Optomechanical detection of weak forces

Optomechanical systems are often used for the measurement of weak forces. Feedback loops can be used in these systems for achieving noise reduction. Here we show that even though feedback is not able to improve the signal to noise ratio of the device in stationary conditions, it is possible to design a nonstationary strategy able to improve the sensitivity.Comment: 12 pages, 6 figures, contribution to the proceedings of the SPIE Conference on Fluctuations and Nois

SuperSpike: Supervised learning in multi-layer spiking neural networks

A vast majority of computation in the brain is performed by spiking neural networks. Despite the ubiquity of such spiking, we currently lack an understanding of how biological spiking neural circuits learn and compute in-vivo, as well as how we can instantiate such capabilities in artificial spiking circuits in-silico. Here we revisit the problem of supervised learning in temporally coding multi-layer spiking neural networks. First, by using a surrogate gradient approach, we derive SuperSpike, a nonlinear voltage-based three factor learning rule capable of training multi-layer networks of deterministic integrate-and-fire neurons to perform nonlinear computations on spatiotemporal spike patterns. Second, inspired by recent results on feedback alignment, we compare the performance of our learning rule under different credit assignment strategies for propagating output errors to hidden units. Specifically, we test uniform, symmetric and random feedback, finding that simpler tasks can be solved with any type of feedback, while more complex tasks require symmetric feedback. In summary, our results open the door to obtaining a better scientific understanding of learning and computation in spiking neural networks by advancing our ability to train them to solve nonlinear problems involving transformations between different spatiotemporal spike-time patterns

Physics and Applications of Laser Diode Chaos

An overview of chaos in laser diodes is provided which surveys experimental achievements in the area and explains the theory behind the phenomenon. The fundamental physics underpinning this behaviour and also the opportunities for harnessing laser diode chaos for potential applications are discussed. The availability and ease of operation of laser diodes, in a wide range of configurations, make them a convenient test-bed for exploring basic aspects of nonlinear and chaotic dynamics. It also makes them attractive for practical tasks, such as chaos-based secure communications and random number generation. Avenues for future research and development of chaotic laser diodes are also identified.Comment: Published in Nature Photonic

Regulation Theory

This paper reviews the design of regulation loops for power converters. Power converter control being a vast domain, it does not aim to be exhaustive. The objective is to give a rapid overview of the main synthesis methods in both continuous- and discrete-time domains.Comment: 23 pages, contribution to the 2014 CAS - CERN Accelerator School: Power Converters, Baden, Switzerland, 7-14 May 201