Towards energy-autonomous wake-up receiver using visible light communication

The use of Visible Light Communication (VLC) in wake-up communication systems is a potential energy-efficient and low-cost solution for wireless communication of consumer electronics. In this paper, we go one step further and propose the use of visible light both for wake-up communication and energy harvesting purposes, with the final objective of an energy-autonomous wake-up receiver module. We first present the details and the design criteria of this novel system. We then present the results of evaluation of design criteria such as solar panel and capacitor type choices. To evaluate the performance of the developed wake-up system with energy-autonomous receiver system, we perform realistic indoor scenario tests, analyzing the effect of varying distances, angles, and light intensities as well as the effect of presence of interfering lights.Peer ReviewedPostprint (author's final draft

On-demand sensor node wake-up using solar panels and visible light communication

To significantly reduce, or eliminate completely, the energy waste caused by the standby (idle) mode of wireless sensor nodes, we propose a novel on-demand wake-up system, which allows the nodes to be put into sleep mode unless their activation is truly necessary. Although there have been many studies proposing RF-based wake-up radio systems, in this work, we develop the first visible light communication (VLC)-based wake-up system. The developed system can extend the existing VLC systems and can be exploited to derive new application areas such as VLC tags. The system uses an off-the-shell indoor solar panel as receptor device of the wake-up signal as well as for energy harvesting purposes, through which it is able to harvest enough energy for its autonomous work. The design, implementation details and the experimental evaluation results are presented, which include flickering characterization and wake-up range evaluations. The results show that the developed system achieve reasonable wake-up distances for indoor environments, mainly where the use of VLC systems are considered.Peer ReviewedPostprint (published version

The effect of initial conditions on the electromagnetic radiation generation in type III solar radio bursts

Copyright 2013 American Institute of Physics. This article may be downloaded for personal use only. Any other use requires prior permission of the author and the American Institute of Physics. This article appeared in Physics of Plasmas 20, 062903 (2013) and may be found at .Extensive particle-in-cell simulations of fast electron beams injected in a background magnetised plasma with a decreasing density profile were carried out. These simulations were intended to further shed light on a newly proposed mechanism for the generation of electromagnetic waves in type III solar radio bursts [D. Tsiklauri, Phys. Plasmas, 18, 052903 (2011)]. The numerical simulations were carried out using different density profiles and fast electron distribution functions. It is shown that electromagnetic L and R modes are excited by the transverse current, initially imposed on the system. In the course of the simulations no further interaction of the electron beam with the background plasma could be observed

Lasers for Communication and Coordination Control of Spacecraft Swarms

Swarms of small spacecraft offer whole new capabilities in Earth observation, global positioning and communications compared to a large monolithic spacecraft. These small spacecraft can provide bigger apertures that increase gain in communication antennas, increase area coverage or effective resolution of distributed cameras and enable persistent observation of ground or space targets. However, there remain important challenges in operating large number of spacecrafts at once. Current methods would require a large number of ground operators monitor and actively control these spacecraft which poses challenges in terms of coordination and control which prevents the technology from scaled up in cost-effective manner. Technologies are required to enable one ground operator to manage tens if not hundreds of spacecraft. We propose to utilize laser beams directed from the ground or from a command and control spacecraft to organize and manage a large swarm. Each satellite in the swarm will have a customized “smart skin” containing solar panels, power and control circuitry and an embedded secondary propulsion unit. A secondary propulsion unit may include electrospray propulsion, solar radiation pressure-based system, photonic laser thrusters and Lorentz force thrusters. Solar panels typically occupy the largest surface area on an earth orbiting satellite. A laser beam from another spacecraft or from the ground would interact with solar panels of the spacecraft swarm. The laser beam would be used to select a ‘leader’ amongst a group of spacecraft, set parameters for formation-flight, including separation distance, local if-then rules and coordinated changes in attitude and position

Methods and Tools for Battery-free Wireless Networks

Embedding small wireless sensors into the environment allows for monitoring physical processes with high spatio-temporal resolutions. Today, these devices are equipped with a battery to supply them with power. Despite technological advances, the high maintenance cost and environmental impact of batteries prevent the widespread adoption of wireless sensors. Battery-free devices that store energy harvested from light, vibrations, and other ambient sources in a capacitor promise to overcome the drawbacks of (rechargeable) batteries, such as bulkiness, wear-out and toxicity. Because of low energy input and low storage capacity, battery-free devices operate intermittently; they are forced to remain inactive for most of the time charging their capacitor before being able to operate for a short time. While it is known how to deal with intermittency on a single device, the coordination and communication among groups of multiple battery-free devices remain largely unexplored. For the first time, the present thesis addresses this problem by proposing new methods and tools to investigate and overcome several fundamental challenges

Laser Communication and Coordination Control of Spacecraft Swarms

Swarms of small spacecraft offer whole new capabilities in Earth observation, global positioning and communications compared to a large monolithic spacecraft. These small spacecrafts can provide bigger apertures that increase gain in communication antennas, increase area coverage or effective resolution of distributed cameras and enable persistent observation of ground or space targets. However, there remain important challenges in operating large number of spacecrafts at once. Current methods would require a large number of ground operators monitor and actively control these spacecrafts which poses challenges in terms of coordination and control which prevents the technology from scaled up in cost-effective manner. Technologies are required to enable one ground operator to manage tens if not hundreds of spacecrafts. We propose to utilize laser beams directed from the ground or from a command and control spacecraft to organize and manage a large swarm. Each satellite in the swarm will have a customized "smart skin" con-taining solar panels, power and control circuitry and an embedded secondary propulsion unit. A secondary propulsion unit may include electrospray pro-pulsion, solar radiation pressure-based system, photonic laser thrusters and Lorentz force thrusters. Solar panels typically occupy the largest surface area on an earth orbiting satellite. A laser beam from another spacecraft or from the ground would interact with solar panels of the spacecraft swarm. The laser beam would be used to select a 'leader' amongst a group of spacecrafts, set parameters for formation-flight, including separation distance, local if-then rules and coordinated changes in attitude and position.Comment: 11 pages, 10 figures, Space Traffic Management Conference 201

Waldo: Batteryless Occupancy Monitoring with Reflected Ambient Light

Reliable and accurate room-level occupancy-tracking systems can enable many new advances in sensors and applications of modern smart buildings. This allows buildings to be more capable of adapting to the needs of their occupants in their day-to-day activities and better optimize certain resources, such as power and air conditioning, to do so. Unfortunately, existing occupancy-tracking systems are plagued by large size, high energy consumption, and, unsurprisingly, short battery lifetimes. In this paper, we present Waldo, a batteryless, room-level occupancy monitoring sensor that harvests energy from indoor ambient light reflections, and uses changes in these reflections to detect when people enter and exit a room. Waldo is mountable at the top of a doorframe, allowing for detection of a person and the direction they are traveling at the entry and exit point of a room. We evaluated the Waldo sensor in an office-style setting under mixed lighting conditions (natural and artificial) on both sides of the doorway with subjects exhibiting varying physical characteristics such as height, hair color, gait, and clothing. 651 number of controlled experiments were ran on 6 doorways with 12 individuals and achieved a total detection accuracy of 97.38%. Further, it judged the direction of movement correctly with an accuracy of 95.42%. This paper also evaluates and discusses various practical factors that can impact the performance of the current system in actual deployments. This work demonstrates that ambient light reflections provide both a promising low-cost, long-term sustainable option for monitoring how people use buildings and an exciting new research direction for batteryless computing