New implementation of a GMSK demodulator in linear software radio receiver

This paper proposes a practical linear software-radio architecture (dealing with linear modulations) that is suitable for multi-mode operation. In particular, it is shown how to integrate GMSK into the proposed architecture. Coherent and noncoherent detections of GMSK signals are detailed for the implementation of the proposed software radio.published_or_final_versio

A comparison between coherent and noncoherent mobile systems in large Doppler shift, delay spread, and C/I environment

The performance and implementation complexity of coherent and of noncoherent QPSK and GMSK modulation/demodulation techniques in a complex mobile satellite systems environment, including large Doppler shift, delay spread, and low C/I, are compared. We demonstrate that for large f(sub d)T(sub b) products, where f(sub d) is the Doppler shift and T(sub b) is the bit duration, noncoherent (discriminator detector or differential demodulation) systems have a lower BER floor than their coherent counterparts. For significant delay spreads, e.g., tau(sub rms) greater than 0.4 T(sub b), and low C/I, coherent systems outperform noncoherent systems. However, the synchronization time of coherent systems is longer than that of noncoherent systems. Spectral efficiency, overall capacity, and related hardware complexity issues of these systems are also analyzed. We demonstrate that coherent systems have a simpler overall architecture (IF filter implementation-cost versus carrier recovery) and are more robust in an RF frequency drift environment. Additionally, the prediction tools, computer simulations, and analysis of coherent systems is simpler. The threshold or capture effect in low C/I interference environment is critical for noncoherent discriminator based systems. We conclude with a comparison of hardware architectures of coherent and of noncoherent systems, including recent trends in commercial VLSI technology and direct baseband to RF transmit, RF to baseband (0-IF) receiver implementation strategies

Cyclic redundancy check-based detection algorithms for automatic identification system signals received by satellite.

This paper addresses the problem of demodulating signals transmitted in the automatic identification system. The main characteristics of such signals consist of two points: (i) they are modulated using a trellis-coded modulation, more precisely a Gaussian minimum shift keying modulation; and (ii) they are submitted to a bit stuffing procedure, which makes more difficult the detection of the transmitted information bits. This paper presents several demodulation algorithms developed in different contexts: mono-user and multi-user transmissions, and known/unknown phase shift. The proposed receiver uses the cyclic redundancy check (CRC) present in the automatic identification system signals for error correction and not for error detection only. By using this CRC, a particular Viterbi algorithm, on the basis of a so-called extended trellis, is developed. This trellis is defined by extended states composed of a trellis code state and a CRC state. Moreover, specific conditional transitions are defined to take into account the possible presence of stuffing bits. The algorithms proposed in the multi-user scenario present a small increase of computation complexity with respect to the mono-user algorithms. Some performance results are presented for several scenarios in the context of the automatic identification system and compared with those of existing techniques developed in similar scenarios

Symbol timing recovery for generalized minimum shift keying modulations in software radio receiver

A new symbol timing estimator for generalized MSK signals is proposed. It is based on the squaring algorithm and has a feedforward structure. The proposed timing estimator is fully-digital and is suitable for implementation in software radios. The performance in AWGN channel is compared with the Modified Cramer-Rao bound and that of the ML algorithm. The proposed timing estimator is found to have a performance close to that of the ML algorithm, but with a lower implementation complexity.published_or_final_versio

Trellis coding with Continuous Phase Modulation (CPM) for satellite-based land-mobile communications

This volume of the final report summarizes the results of our studies on the satellite-based mobile communications project. It includes: a detailed analysis, design, and simulations of trellis coded, full/partial response CPM signals with/without interleaving over various Rician fading channels; analysis and simulation of computational cutoff rates for coherent, noncoherent, and differential detection of CPM signals; optimization of the complete transmission system; analysis and simulation of power spectrum of the CPM signals; design and development of a class of Doppler frequency shift estimators; design and development of a symbol timing recovery circuit; and breadboard implementation of the transmission system. Studies prove the suitability of the CPM system for mobile communications

Capacity -based parameter optimization of bandwidth constrained CPM

Continuous phase modulation (CPM) is an attractive modulation choice for bandwidth limited systems due to its small side lobes, fast spectral decay and the ability to be noncoherently detected. Furthermore, the constant envelope property of CPM permits highly power efficient amplification. The design of bit-interleaved coded continuous phase modulation is characterized by the code rate, modulation order, modulation index, and pulse shape. This dissertation outlines a methodology for determining the optimal values of these parameters under bandwidth and receiver complexity constraints. The cost function used to drive the optimization is the information-theoretic minimum ratio of energy-per-bit to noise-spectral density found by evaluating the constrained channel capacity. The capacity can be reliably estimated using Monte Carlo integration. A search for optimal parameters is conducted over a range of coded CPM parameters, bandwidth efficiencies, and channels. Results are presented for a system employing a trellis-based coherent detector. To constrain complexity and allow any modulation index to be considered, a soft output differential phase detector has also been developed.;Building upon the capacity results, extrinsic information transfer (EXIT) charts are used to analyze a system that iterates between demodulation and decoding. Convergence thresholds are determined for the iterative system for different outer convolutional codes, alphabet sizes, modulation indices and constellation mappings. These are used to identify the code and modulation parameters with the best energy efficiency at different spectral efficiencies for the AWGN channel. Finally, bit error rate curves are presented to corroborate the capacity and EXIT chart designs