A low power UART design based on asynchronous techniques

pre-printAbstract-Universal Asynchronous Receiver Transmitter (UART) implements serial communication between peripherals and remote embedded systems. The UART protocol is defined based on fixed frequencies with a sampling method to achieve robustness under reasonable frequency variations between systems. Such design specifications are natural for clocked domains. This work investigates whether this simple clocked hardware protocol can be advantageously implemented using asynchronous design techniques. A full duplex clocked and asynchronous UART are implemented and compared. The asynchronous design results in average power of about one fourth that of the clocked design under standard operating modes

From FPGA to ASIC: A RISC-V processor experience

This work document a correct design flow using these tools in the Lagarto RISC- V Processor and the RTL design considerations that must be taken into account, to move from a design for FPGA to design for ASIC

EXTEND-L : an input language for extensible register transfer compilation

This report discusses the model and input language for EXTEND, a synthesis system that permits extensible register transfer synthesis. EXTEND-L fills the need for a language that bridges the gap between existing behavioral input descriptions, which are too abstract, and structural schematics, which cannot capture the high-level behavior. The report first discusses previous work in behavioral synthesis and summarizes the deficiencies of these behavioral specifications. The report then describes the proposed langauge in detail, and concludes with a few examples that show its utility

Development of an interface for an ultrareliable fault-tolerant control system and an electronic servo-control unit

The NASA Ames Research Center sponsors a research program for the investigation of Intelligent Flight Control Actuation systems. The use of artificial intelligence techniques in conjunction with algorithmic techniques for autonomous, decentralized fault management of flight-control actuation systems is explored under this program. The design, development, and operation of the interface for laboratory investigation of this program is documented. The interface, architecturally based on the Intel 8751 microcontroller, is an interrupt-driven system designed to receive a digital message from an ultrareliable fault-tolerant control system (UFTCS). The interface links the UFTCS to an electronic servo-control unit, which controls a set of hydraulic actuators. It was necessary to build a UFTCS emulator (also based on the Intel 8751) to provide signal sources for testing the equipment

Implementation of the advanced encryption standard algorithm on an FPGA for image processing through the universal asynchronous receiver-transmitter protocol

Communication among end users can be based either on wired or wireless technology. Cryptography plays a vital role in ensuring data exchange is secure among end users. Data can be encrypted and decrypted using symmetric or asymmetric key cryptographic techniques to provide confidentiality. In wireless technology, images are exchanged through low-cost wireless peripheral devices, such as radio frequency identification device (RFID), nRF, and ZigBee, that can interface with field programmable gate array (FPGA) among the end users. One of the issues is that data exchange through wireless devices does not offer confidentiality, and subsequently, data can be lost. In this paper, we propose a design and implementation of AES-128 cipher algorithm on an FPGA board for image processing through the universal asynchronous receiver transmitter (UART) protocol. In this process, the advanced encryption standard (AES) algorithm is used to encrypt and decrypt the image, while the transmitter and receiver designs are implemented on two Xilinx BASYS-3 circuits connected with a ZigBee RF module. The encrypted image uses less memory, such as LUTs (141), and also consumes less chip power (0.0291 w), I/O (0.003), block RAM (0.001 w), data, and logic to provide much higher efficiency than wired communication technology. We also observe that images can be exchanged through the UART protocol with different baud rates in run time

A micropower centroiding vision processor

Published versio

Signal Capturing on VLSI Systems in Real Time

Now-a- days, every communication system is prototyped on FPGAs before fabricating them on ASIC. Counter side, the FPGAs with very high gate logic densities and embedded block RAMs allowed the high speed signal capturing and storage for real time analysis. By performing various functions on the captured data allows high speed spectrum analysis. These two allow the prototyping of complex communication system on FPGA and real time analysis of implemented blocks. There are several types of interface methods possible to communicate the FPGA with a computer. In this paper novel techniques are implemented for capturing and analyzing the signals of any design on FPGA with configurable UART interface. VHDL will be used for implementation of necessary modules such as block memory, capture FSM, triggering logic and UART interface. Necessary scripts will be developed to generate the synthesizable VHDL code as per the requirements of user. The captured data will be sent to PC using UART. Xilinx ISE will be used for synthesis and performance analysis