3,847 research outputs found
Avoiding core's DUE & SDC via acoustic wave detectors and tailored error containment and recovery
The trend of downsizing transistors and operating voltage scaling has made the processor chip more sensitive against radiation phenomena making soft errors an important challenge. New reliability techniques for handling soft errors in the logic and memories that allow meeting the desired failures-in-time (FIT) target are key to keep harnessing the benefits of Moore's law. The failure to scale the soft error rate caused by particle strikes, may soon limit the total number of cores that one may have running at the same time. This paper proposes a light-weight and scalable architecture to eliminate silent data corruption errors (SDC) and detected unrecoverable errors (DUE) of a core. The architecture uses acoustic wave detectors for error detection. We propose to recover by confining the errors in the cache hierarchy, allowing us to deal with the relatively long detection latencies. Our results show that the proposed mechanism protects the whole core (logic, latches and memory arrays) incurring performance overhead as low as 0.60%. © 2014 IEEE.Peer ReviewedPostprint (author's final draft
Turbo NOC: a framework for the design of Network On Chip based turbo decoder architectures
This work proposes a general framework for the design and simulation of
network on chip based turbo decoder architectures. Several parameters in the
design space are investigated, namely the network topology, the parallelism
degree, the rate at which messages are sent by processing nodes over the
network and the routing strategy. The main results of this analysis are: i) the
most suited topologies to achieve high throughput with a limited complexity
overhead are generalized de-Bruijn and generalized Kautz topologies; ii)
depending on the throughput requirements different parallelism degrees, message
injection rates and routing algorithms can be used to minimize the network area
overhead.Comment: submitted to IEEE Trans. on Circuits and Systems I (submission date
27 may 2009
Fault-tolerant building-block computer study
Ultra-reliable core computers are required for improving the reliability of complex military systems. Such computers can provide reliable fault diagnosis, failure circumvention, and, in some cases serve as an automated repairman for their host systems. A small set of building-block circuits which can be implemented as single very large integration devices, and which can be used with off-the-shelf microprocessors and memories to build self checking computer modules (SCCM) is described. Each SCCM is a microcomputer which is capable of detecting its own faults during normal operation and is described to communicate with other identical modules over one or more Mil Standard 1553A buses. Several SCCMs can be connected into a network with backup spares to provide fault-tolerant operation, i.e. automated recovery from faults. Alternative fault-tolerant SCCM configurations are discussed along with the cost and reliability associated with their implementation
VLSI implementation of a multi-mode turbo/LDPC decoder architecture
Flexible and reconfigurable architectures have gained wide popularity in the communications field. In particular, reconfigurable architectures for the physical layer are an attractive solution not only to switch among different coding modes but also to achieve interoperability. This work concentrates on the design of a reconfigurable architecture for both turbo and LDPC codes decoding. The novel contributions of this paper are: i) tackling the reconfiguration issue introducing a formal and systematic treatment that, to the best of our knowledge, was not previously addressed; ii) proposing a reconfigurable NoCbased turbo/LDPC decoder architecture and showing that wide flexibility can be achieved with a small complexity overhead. Obtained results show that dynamic switching between most of considered communication standards is possible without pausing the decoding activity. Moreover, post-layout results show that tailoring the proposed architecture to the WiMAX standard leads to an area occupation of 2.75 mm2 and a power consumption of 101.5 mW in the worst case
On chip interconnects for multiprocessor turbo decoding architectures
International audienc
Reconfigurable Turbo/Viterbi Channel Decoder in the Coarse-Grained Montium Architecture
Mobile wireless communication systems become multi-mode systems. These future mobile systems employ multiple wireless communication standards, which are different by means of algorithms that are used to implement the baseband processing and the channel decoding. Efficient implementation of multiple wireless standards in mobile terminals requires energy-efficient and flexible hardware. We propose to implement both the baseband processing and channel decoding in a heterogeneous reconfigurable system-on-chip. The system-on-chip contains many processing elements of different granularities, which includes our coarse-grained reconfigurable MONTIUM architecture. We already showed the feasibility to implement the baseband processing of OFDM and WCDMA based communication systems in the MONTIUM. In this paper we implemented two kinds of channel decoders in the same MONTIUM architecture: Viterbi and Turbo decoding
- …