7 research outputs found
Impact of woven fabric: Experiments and mesostructure-based continuum-level simulations
Woven fabric is an increasingly important component of many defense and commercial systems, including deployable structures, restraint systems, numerous forms of protective armor, and a variety of structural applications where it serves as the reinforcement phase of composite materials. With the prevalence of these systems and the desire to explore new applications, acomprehensive, computationally efficient model for the deformation of woven fabrics is needed. However, modeling woven fabrics is difficult due, inparticular, to the need to simulate the response both at the scale of the entire fabric and at the meso-level, the scale of the yarns that compose the weave. Here, we present finite elements for the simulation of the three- dimensional, high-rated eformation of woven fabric. We employ a continuum- level modeling technique that, through the use of an appropriate unit cell, captures the evolution of the mesostructure of the fabric without explicitly modeling every yarn. Displacement degrees of freedom and degrees of freedom representing the change in crimp amplitude of each yarn family fully determine the deformed geometry of the mesostructure of the fabric, which in turn provides, through the constitutive relations, the internal nodal forces. In order to verify the accuracy of the elements, instrumented ballistic impact experiments with projectile velocities of 22–550 m/s were conducted on single layers of Kevlar ® fabric. Simulations of the experiments demonstrate that the finite elements are capable of efficiently simulating large, complex structures
Impact of woven fabric: Experiments and mesostructure-based continuum-level simulations
Direct Material Property Determination: One‐Dimensional Formulation Utilising Full‐Field Deformation Measurements
A direct approach is described to determine the elastic modulus distribution in a nominally heterogeneous material subject to tensile/compression loading and primarily experiencing deformations in the axial direction. The formulation is developed for uniaxial applications using basic theoretical constructs, resulting in a computational framework that has a matrix form [A] {E} = {R}, where the [A] matrix components are known functions of measured axial strains and axial positions, {R} components are known functions of axial body forces, applied loads and reactions and {E} components are the unknown elastic moduli at discrete locations along the length of the specimen. For a series of one-dimensional (1D) material property identification procedure with known axial strains at discrete locations and various levels of random noise, results are presented to demonstrate the accuracy and noise sensitivity of the methodology. Finally, experimental measurements for a heterogeneous bone specimen are compared to our 1D model predictions, demonstrating that the predictions are in very good agreement with independent estimates at each load level of interest along the length of the bone specimen
Mechanical response of pig skin under dynamic tensile loading
Uniaxial tensile experiments were performed on pig skin to investigate the tensile stressestrain response at both quasi-static and dynamic rates of deformation. A Kolsky tension bar, also called a split Hopkinson tension bar (SHTB), was modified to conduct the dynamic experiments. Semiconductor strain gages were used to measure the low levels of the transmitted signal from pig skin. A pulse shaper technique was used for generating a suitable incident pulse to ensure stress equilibrium and approximate constant strain rate in the specimen of a thin skin sheet wrapped around the ends of the bars for minimizing radial inertia. In order to investigate the strain-rate effect over a wide range of strain rates, quasi-static tests were also performed. The experimental results show that pig skin exhibits rate-sensitive, orthotropic, and non-linear behavior. The response along the spine direction is stiffer at lower rate but is less rate sensitive than the perpendicular direction. An Ogden model with two material constants is adopted to describe the rate-sensitive tensile behavior of the pig skin