Remarks concerning the East African coastal form of the Tropical Boubou Laniarius aethiopicus sublacteus (Cassin 1851), and its supposed black morph

No Abstract

The Detection of Damage and the Measurement of Strain within Composites by Means of Embedded Optical Fiber Sensors

Structurally integrated fiber optic sensors hold the promise of improved quality control of composites and “real-time, in-service” monitoring of the loads to which they are subjected and any damage they may sustain. This could reduce overdesign and increase confidence in their use by improving both safety and their economics especially in terms of inspection and maintenance, Figure 1. This would be particularly relevant to the Aerospace Industry where any weight saving has a multiplier effect. The technology of imbedding arrays of optical fiber sensors within advanced composite material structures during their fabrication essentially provides materials with “optical nerves”. Improved quality control would be achieved by monitoring the internal of composites during their manufacture. Also since “in-service” monitoring of structural loads and structural integrity would permit weaknesses to be indicated before they became critical, longer periods could be allowed between costly inspections. When the system is taken out of service for such an inspection, a shorter downtime might be expected since the built-in sensors would have already indicated sites of weakness and their rate of deterioration. A recent overview of fiber optic based “Smart Structures” has been prepared by the author[1]

Settlement Of Oyster (Crassostrea-Virginica) Larvae - Effects Of Water-Flow And A Water-Soluble Chemical Cue

Although previous evidence indicates that larvae of benthic marine invertebrates can respond to waterborne cues in still water, the importance of waterborne cues in mediating natural settlement out of flowing water has been questioned. Here, we summarize the results of flume experiments demonstrating enhanced settlement of oyster larvae in small target wells (circles of 7-cm diam) with the release of a waterborne settlement cue compared to identical substrates without the cue. In concurrent still-water experiments, more oyster larvae settled in solutions of waterborne cue than in seawater controls. Velocity and electrochemical measurements of a conservative tracer verified that at low flow velocities (2 and 6 cm s(-1)) with U* value

Impact of Novel Sorghum Bran Diets on DSS-Induced Colitis.

We have demonstrated that polyphenol-rich sorghum bran diets alter fecal microbiota; however, little is known regarding their effect on colon inflammation. Our aim was to characterize the effect of sorghum bran diets on intestinal homeostasis during dextran sodium sulfate (DSS)-induced colitis. Male Sprague-Dawley rats (N = 20/diet) were provided diets containing 6% fiber from cellulose, or Black (3-deoxyanthocyanins), Sumac (condensed tannins) or Hi Tannin Black (both) sorghum bran. Colitis was induced (N = 10/diet) with three separate 48-h exposures to 3% DSS, and feces were collected. On Day 82, animals were euthanized and the colon resected. Only discrete mucosal lesions, with no diarrhea or bloody stools, were observed in DSS rats. Only bran diets upregulated proliferation and Tff3, Tgfβ and short chain fatty acids (SCFA) transporter expression after a DSS challenge. DSS did not significantly affect fecal SCFA concentrations. Bran diets alone upregulated repair mechanisms and SCFA transporter expression, which suggests these polyphenol-rich sorghum brans may suppress some consequences of colitis

The role of tool geometry in process damped milling

The complex interaction between machining structural systems and the cutting process results in machining instability, so called chatter. In some milling scenarios, process damping is a useful phenomenon that can be exploited to mitigate chatter and hence improve productivity. In the present study, experiments are performed to evaluate the performance of process damped milling considering different tool geometries (edge radius, rake and relief angles and variable helix/pitch). The results clearly indicate that variable helix/pitch angles most significantly increase process damping performance. Additionally, increased cutting edge radius moderately improves process damping performance, while rake and relief angles have a smaller and closely coupled effect

Towards a fair and transparent research participant compensation and reimbursement framework in Viet Nam

Background: Providing compensation for participants in clinical research is well established and whilst international guidelines exist, defining a context specific and fair compensation for participants in low resource settings is challenging due to ethical concerns and the lack of practical, national compensation and reimbursement frameworks. Methods: We reviewed OUCRU (Oxford University Clinical Research Unit) internal reimbursement documentation over a ten-year period and conducted a scoping literature review to expand our knowledge of compensation and reimbursement practices including ethical concerns. We developed a preliminary reimbursement framework that was presented to Community Advisory Boards (CAB) and clinical investigators to assess its applicability, fairness, and transparency. Results: The main topics discussed at the workshops centered on fairness and whether the reimbursements could be perceived as financial incentives. Other decisive factors in the decision making process were altruism and the loss of caregivers’ earnings. Investigators raised the issue of additional burdens, whereas the CAB members were focused on non-monetary elements such as the healthcare quality the patients would receive. All elements discussed were reviewed and where possible, incorporated into the final framework. Conclusion: Our new reimbursement framework provides a consistent, fair and transparent decision-making process and will be implemented across all future OUCRU clinical research in Viet Nam

The pharmaceutical use of permethrin: Sources and behavior during municipal sewage treatment

This is the author's accepted manuscript. The final published article is available from the link below. Copyright @ 2010 Springer Science+Business Media, LLC.Permethrin entered use in the 1970s as an insecticide in a wide range of applications, including agriculture, horticultural, and forestry, and has since been restricted. In the 21st century, the presence of permethrin in the aquatic environment has been attributed to its use as a human and veterinary pharmaceutical, in particular as a pedeculicide, in addition to other uses, such as a moth-proofing agent. However, as a consequence of its toxicity to fish, sources of permethrin and its fate and behavior during wastewater treatment are topics of concern. This study has established that high overall removal of permethrin (approximately 90%) was achieved during wastewater treatment and that this was strongly dependent on the extent of biological degradation in secondary treatment, with more limited subsequent removal in tertiary treatment processes. Sources of permethrin in the catchment matched well with measured values in crude sewage and indicated that domestic use accounted for more than half of the load to the treatment works. However, removal may not be consistent enough to achieve the environmental quality standards now being derived in many countries even where tertiary treatment processes are applied.United Utilities PL

The H-band Emitting Region of the Luminous Blue Variable P Cygni: Spectrophotometry and Interferometry of the Wind

This is the final version of the article. Available from American Astronomical Society / IOP Publishing via the DOI in this record.We present the first high angular resolution observations in the near-infrared H band (1.6 μm) of the luminous blue variable star P Cygni. We obtained six-telescope interferometric observations with the CHARA Array and the MIRC beam combiner. These show that the spatial flux distribution is larger than expected for the stellar photosphere. A two-component model for the star (uniform disk) plus a halo (two-dimensional Gaussian) yields an excellent fit of the observations, and we suggest that the halo corresponds to flux emitted from the base of the stellar wind. This wind component contributes about 45% of the H-band flux and has an angular FWHM = 0.96 mas, compared to the predicted stellar diameter of 0.41 mas. We show several images reconstructed from the interferometric visibilities and closure phases, and they indicate a generally spherical geometry for the wind. We also obtained near-infrared spectrophotometry of P Cygni from which we derive the flux excess compared to a purely photospheric spectral energy distribution. The H-band flux excess matches that from the wind flux fraction derived from the two-component fits to the interferometry. We find evidence of significant near-infrared flux variability over the period from 2006 to 2010 that appears similar to the variations in the Hα emission flux from the wind.We acknowledge with thanks the variable star observations from the AAVSO International Database contributed by observers worldwide and used in this research. Support for Ritter Astrophysical Research Center during the time of the observations was provided by the National Science Foundation Program for Research and Education with Small Telescopes (NSF-PREST) under grant AST-0440784 (N.D.M.). This work was also supported by the National Science Foundation under grants AST-0606861 and AST-1009080 (D.R.G.). N.D.R. gratefully acknowledges his current CRAQ postdoctoral fellowship. We are grateful for the insightful comments of A. F. J. Moffat that improved portions of the paper, discussions with Paco Najarro and Luc Dessart about spectroscopic modeling of P Cygni, and support of the MIRC 6 telescope beam combiner by Ettore Pedretti. Institutional support has been provided by the GSU College of Arts and Sciences and by the Research Program Enhancement fund of the Board of Regents of the University System of Georgia, administered through the GSU Office of the Vice President for Research. Operational funding for the CHARA Array is provided by the GSU College of Arts and Sciences, by the National Science Foundation through grants AST-0606958 and AST-0908253, by the W. M. Keck Foundation, and by the NASA Exoplanet Science Institute. We thank the Mount Wilson Institute for providing infrastructure support at Mount Wilson Observatory. The CHARA Array, operated by Georgia State University, was built with funding provided by the National Science Foundation, Georgia State University, the W. M. Keck Foundation, and the David and Lucile Packard Foundation. This research was conducted in part using the Mimir instrument, jointly developed at Boston University and Lowell Observatory and supported by NASA, NSF, and the W. M. Keck Foundation. J.D.M. acknowledges University of Michigan and NSF AST-0707927 for support of MIRC construction and observations. D.P.C. acknowledges support under NSF AST-0907790 to Boston University. We gratefully acknowledge all of this support. This research has made use of the SIMBAD database operated at CDS, Strasbourg, France

Clinical Value of Prognostic Instruments to Identify Patients with an Increased Risk for Osteoporotic Fractures: Systematic Review

There is a plethora of evidence available studying the association of risk profiles and the development of osteoporotic fractures. The small number of out-of-sample validations, the large variety of study characteristics, outcomes and follow-up periods impedes from deriving robust summaries and from conclusions regarding the clinical performance of many tools. First and foremost, future activity in this field should aim at reaching a consensus among clinical experts in respect to the existing instruments. Then we call for careful validations and expedient adaptations for local circumstances of the most promising candidates

Social disorganization and history of child sexual abuse against girls in sub-Saharan Africa : a multilevel analysis

Background: Child sexual abuse (CSA) is a considerable public health problem. Less focus has been paid to the role of community level factors associated with CSA. The aim of this study was to examine the association between neighbourhood-level measures of social disorganization and CSA. Methods: We applied multiple multilevel logistic regression analysis on Demographic and Health Survey data for 6,351 adolescents from six countries in sub-Saharan Africa between 2006 and 2008. Results: The percentage of adolescents that had experienced CSA ranged from 1.04% to 5.84%. There was a significant variation in the odds of reporting CSA across the communities, suggesting 18% of the variation in CSA could be attributed to community level factors. Respondents currently employed were more likely to have reported CSA than those who were unemployed (odds ratio [OR] = 2.05, 95% confidence interval [CI] 1.48 to 2.83). Respondents from communities with a high family disruption rate were 57% more likely to have reported CSA (OR=1.57, 95% CI 1.14 to 2.16). Conclusion: We found that exposure to CSA was associated with high community level of family disruption, thus suggesting that neighbourhoods may indeed have significant important effects on exposure to CSA. Further studies are needed to explore pathways that connect the individual and neighbourhood levels, that is, means through which deleterious neighbourhood effects are transmitted to individuals