7,656 research outputs found
The interfascicular matrix enables fascicle sliding and recovery in tendon, and behaves more elastically in energy storing tendons
While the predominant function of all tendons is to transfer force from muscle to bone and position the limbs, some tendons additionally function as energy stores, reducing the cost of locomotion. Energy storing tendons experience extremely high strains and need to be able to recoil efficiently for maximum energy storage and return. In the equine forelimb, the energy storing superficial digital flexor tendon (SDFT) has much higher failure strains than the positional common digital extensor tendon (CDET). However, we have previously shown that this is not due to differences in the properties of the SDFT and CDET fascicles (the largest tendon subunits). Instead, there is a greater capacity for interfascicular sliding in the SDFT which facilitates the greater extensions in this particular tendon (Thorpe et al., 2012). In the current study, we exposed fascicles and interfascicular matrix (IFM) from the SDFT and CDET to cyclic loading followed by a test to failure. The results show that IFM mechanical behaviour is not a result of irreversible deformation, but the IFM is able to withstand cyclic loading, and is more elastic in the SDFT than in the CDET. We also assessed the effect of ageing on IFM properties, demonstrating that the IFM is less able to resist repetitive loading as it ages, becoming stiffer with increasing age in the SDFT. These results provide further indications that the IFM is important for efficient function in energy storing tendons, and age-related alterations to the IFM may compromise function and predispose older tendons to injury
NO sub x deposited in the stratosphere by the space shuttle, phase 1
The results of calculations to determine the amount of NOx deposited in the stratosphere by space shuttle solid rocket motors (SRM) are presented. Flow properties and chemical composition in the exhaust nozzle and plume were analyzed. The nozzle calculations show that about 4.5 lbm/sec of NOx leaves the two SRMs. The total amount of NOx deposited in the stratosphere is related to the amount leaving the nozzle via an overall plume enhancement factor (OPEF), which depends upon the influence of afterburning and shocks in enhancing the exit plane NOx mole fraction. Calculations show that the OPEF is approximately 2, indicating the mass flow of NOx in the plume to be approximately l0 lbm/sec at 30 km altitude with a possible error factor of 4. For a vehicle velocity of 3750 ft/sec, therefore, the NOx deposition rate in the stratosphere is about 2.7 x 10(-3) lbm/ft
Algorithms for 3D rigidity analysis and a first order percolation transition
A fast computer algorithm, the pebble game, has been used successfully to
study rigidity percolation on 2D elastic networks, as well as on a special
class of 3D networks, the bond-bending networks. Application of the pebble game
approach to general 3D networks has been hindered by the fact that the
underlying mathematical theory is, strictly speaking, invalid in this case. We
construct an approximate pebble game algorithm for general 3D networks, as well
as a slower but exact algorithm, the relaxation algorithm, that we use for
testing the new pebble game. Based on the results of these tests and additional
considerations, we argue that in the particular case of randomly diluted
central-force networks on BCC and FCC lattices, the pebble game is essentially
exact. Using the pebble game, we observe an extremely sharp jump in the largest
rigid cluster size in bond-diluted central-force networks in 3D, with the
percolating cluster appearing and taking up most of the network after a single
bond addition. This strongly suggests a first order rigidity percolation
transition, which is in contrast to the second order transitions found
previously for the 2D central-force and 3D bond-bending networks. While a first
order rigidity transition has been observed for Bethe lattices and networks
with ``chemical order'', this is the first time it has been seen for a regular
randomly diluted network. In the case of site dilution, the transition is also
first order for BCC, but results for FCC suggest a second order transition.
Even in bond-diluted lattices, while the transition appears massively first
order in the order parameter (the percolating cluster size), it is continuous
in the elastic moduli. This, and the apparent non-universality, make this phase
transition highly unusual.Comment: 28 pages, 19 figure
NO sub X Deposited in the Stratosphere by the Space Shuttle Solid Rocket Motors
The possible effects of the interaction of the plumes from the two solid rocket motors (SRM) from the space shuttles and mixing of the rocket exhaust products and ambient air in the base recirculation region on the total nitrous oxide deposition rate in the stratosphere were investigated. It was shown that these phenomena will not influence the total NOx deposition rate. It was also shown that uncertainties in the particle size of Al2O3, size distributions and particle/gas drag and heat transfer coefficients will not have a significant effect on the predicted NOx deposition rate. The final results show that the total mass flow of NOx leaving the plume at 30 km altitude is 4000 g./sec with a possible error factor of 3. For a vehicle velocity of 1140 meter/sec this yields an NOx deposition rate of about 3.5 g./meter. The corresponding HCl deposition rate at this altitude is about a factor of 500 greater than this value
Self-organization with equilibration: a model for the intermediate phase in rigidity percolation
Recent experimental results for covalent glasses suggest the existence of an
intermediate phase attributed to the self-organization of the glass network
resulting from the tendency to minimize its internal stress. However, the exact
nature of this experimentally measured phase remains unclear. We modify a
previously proposed model of self-organization by generating a uniform sampling
of stress-free networks. In our model, studied on a diluted triangular lattice,
an unusual intermediate phase appears, in which both rigid and floppy networks
have a chance to occur, a result also observed in a related model on a Bethe
lattice by Barre et al. [Phys. Rev. Lett. 94, 208701 (2005)]. Our results for
the bond-configurational entropy of self-organized networks, which turns out to
be only about 2% lower than that of random networks, suggest that a
self-organized intermediate phase could be common in systems near the rigidity
percolation threshold.Comment: 9 pages, 6 figure
Influences on outdoor education teachers\u27 content selection
This study sought to identify what teachers perceive to be the major factors influencing their selection of content in outdoor education formal curricula in two Western Australian government senior high schools. The study uses comparative and descriptive measures, including a documentary analysis comparing Ministry of Education and school formal curricula. This analysis initially identified discrepancies with content selection, prompting the investigation, through interviewing, of teachers\u27 perceptions of their causes. From the perceptions investigated, five categories of factors were identified: Time, cost; expertise; needs; and resources. These categories were integrated to form a substantive theory for influences on content selection by outdoor education teachers
Fascicles and the interfascicular matrix show decreased fatigue life with ageing in energy storing tendons
Tendon is composed of rope-like fascicles bound together by interfascicular matrix (IFM). The IFM is critical for the function of energy storing tendons, facilitating sliding between fascicles to allow these tendons to cyclically stretch and recoil. This capacity is required to a lesser degree in positional tendons. We have previously demonstrated that both fascicles and IFM in energy storing tendons have superior fatigue resistance compared with positional tendons, but the effect of ageing on the fatigue properties of these different tendon subunits has not been determined. Energy storing tendons become more injury-prone with ageing, indicating reduced fatigue resistance, hence we tested the hypothesis that the decline in fatigue life with ageing in energy storing tendons would be more pronounced in the IFM than in fascicles. We further hypothesised that tendon subunit fatigue resistance would not alter with ageing in positional tendons. Fascicles and IFM from young and old energy storing and positional tendons were subjected to cyclic fatigue testing until failure, and mechanical properties were calculated. The results show that both IFM and fascicles from the SDFT exhibit a similar magnitude of reduced fatigue life with ageing. By contrast, the fatigue life of positional tendon subunits was unaffected by ageing. The age-related decline in fatigue life of tendon subunits in energy storing tendons is likely to contribute to the increased risk of injury in aged tendons. Full understanding of the mechanisms resulting in this reduced fatigue life will aid in the development of treatments and interventions to prevent age-related tendinopathy
Computational models for the viscous/inviscid analysis of jet aircraft exhaust plumes
Computational models which analyze viscous/inviscid flow processes in jet aircraft exhaust plumes are discussed. These models are component parts of an NASA-LaRC method for the prediction of nozzle afterbody drag. Inviscid/shock processes are analyzed by the SCIPAC code which is a compact version of a generalized shock capturing, inviscid plume code (SCIPPY). The SCIPAC code analyzes underexpanded jet exhaust gas mixtures with a self-contained thermodynamic package for hydrocarbon exhaust products and air. A detailed and automated treatment of the embedded subsonic zones behind Mach discs is provided in this analysis. Mixing processes along the plume interface are analyzed by two upgraded versions of an overlaid, turbulent mixing code (BOAT) developed previously for calculating nearfield jet entrainment. The BOATAC program is a frozen chemistry version of BOAT containing the aircraft thermodynamic package as SCIPAC; BOATAB is an afterburning version with a self-contained aircraft (hydrocarbon/air) finite-rate chemistry package. The coupling of viscous and inviscid flow processes is achieved by an overlaid procedure with interactive effects accounted for by a displacement thickness type correction to the inviscid plume interface
- …