2,554 research outputs found
Wind mapping in Venus' upper mesosphere with the IRAM-Plateau de Bure interferometer
The dynamics of the upper mesosphere of Venus (~85-115 km) have been
characterized as a combination of a retrograde superrotating zonal wind (RSZ)
with a subsolar-to-antisolar flow (SSAS). Numerous mm-wave single-dish
observations have been obtained and could directly measure mesospheric
line-of-sight winds by mapping Doppler-shifts on CO rotational lines, but their
limited spatial resolution makes their interpretation difficult. By using
interferometric facilities, one can obtain better resolution on Doppler-shifts
maps, allowing in particular to put firmer constraints on the respective
contributions of the SSAS and RSZ circulations to the global mesospheric wind
field. We report on interferometric observations of the CO(1-0) line obtained
with the IRAM-Plateau de Bure interferometer in November 2007 and June 2009,
that could map the upper mesosphere dynamics on the morning hemisphere with a
very good spatial resolution (3.5-5.5"). All the obtained measurements show,
with a remarkably good temporal stability, that the wind globally flows in the
(sky) East-West direction, corresponding in the observed geometry either to an
unexpected prograde zonal wind or a SSAS flow. A very localized inversion of
the wind direction, that could correspond to a RSZ wind, is also repeatedly
detected in the night hemisphere. The presence of significant meridional winds
is not evidenced. Using models with different combinations of zonal and SSAS
winds, we find that the data is best reproduced by a dominant SSAS flow with a
maximal velocity at the terminator of ~200 m/s, displaying large diurnal and
latitudinal asymmetries, combined with an equatorial RSZ wind of 70-100 m/s,
overall indicating a wind-field structure consistent with but much more complex
than the usual representation of the mesospheric dynamics.Comment: Accepted for publication in A&
Did EU Commission deliberately just quietly inflate the Brexit bill with dodgy pension figures? Real questions now for the UK Treasury and negotiators.
The EU commission has just quietly published its 2017 accounts. About just over a week ago, they slipped out. Did you spot that? No? Well….very few did.
John has spent the last week or so here at the Centre for Brexit Studies at BCU pouring over them. And we think that if you look closely at the boring bits, something of a bomblet is contained. The Brexit bill has just soared upwards. And the UK needs now to ask some tough questions of the EU Commission about their figures – questions which, to be frank, the Treasury and our negotiators should have been asking a long time ago
Human Factors Issues and the Risk of High Voltage Equipment: Are Standards Sufficient to Ensure Safety by Design?
High voltage equipment is mostly designed according to technically prescriptive standards requirements based on electrical engineering safety principles. However a more risk-based approach to standards and regulation may be advisable to enable designer and user to take an active role in establishing that their installation is inherently safe. The use of Gas Insulated Switchgear (GIS) for instance is enabling the new substation to be housed indoors and condensed into around one quarter of the space. The manufacturers argue that design improvements in GIS make it virtually “maintenance free”, comply with all the relevant standards. However some of these improvements have implications for the operators that need to be taken into account. Commissioning, operational checks and inspections and the occasional maintenance interventions are activities during which the technicians need to interface with the equipment, the issues regarding the interfaces provided have been analysed to identify their relevance in the overall risk assessment of the equipment. The paper reports about a study aimed at verifying through a risk analysis the impacts that the issues related to deficit in ergonomic design may present for the overall availability and safety of the plant. Those issues are not tackled in the technical standards and/or designers current practice
Helicobacter pylori: comparative genomics and structure-function analysis of the flagellum biogenesis protein HP0958
Helicobacter pylori is a gastric pathogen which infects ~50% of the global population and can lead to the development of gastritis, gastric and duodenal ulcers and carcinoma. Genome sequencing of H. pylori revealed high levels of genetic variability; this pathogen is known for its adaptability due to mechanisms including phase variation, recombination and horizontal gene transfer. Motility is essential for efficient colonisation by H. pylori. The flagellum is a complex nanomachine which has been studied in detail in E. coli and Salmonella. In H. pylori, key differences have been identified in the regulation of flagellum biogenesis, warranting further investigation. In this study, the genomes of two H. pylori strains (CCUG 17874 and P79) were sequenced and published as draft genome sequences. Comparative studies identified the potential role of restriction modification systems and the comB locus in transformation efficiency differences between these strains. Core genome analysis of 43 H. pylori strains including 17874 and P79 defined a more refined core genome for the species than previously published. Comparative analysis of the genome sequences of strains isolated from individuals suffering from H. pylori related diseases resulted in the identification of “disease-specific” genes. Structure-function analysis of the essential motility protein HP0958 was performed to elucidate its role during flagellum assembly in H. pylori. The previously reported HP0958-FliH interaction could not be substantiated in this study and appears to be a false positive. Site-directed mutagenesis confirmed that the coiled-coil domain of HP0958 is involved in the interaction with RpoN (74-284), while the Zn-finger domain is required for direct interaction with the full length flaA mRNA transcript. Complementation of a non-motile hp0958-null derivative strain of P79 with site-directed mutant alleles of hp0958 resulted in cells producing flagellar-type extrusions from non-polar positions. Thus, HP0958 may have a novel function in spatial localisation of flagella in H. pylor
‘I wanted to offer my sympathy … woman to woman’:Reading The Crown during a conjuncture of crisis
Increasing carbon fiber composite strength with a nanostructured “brick-and-mortar” interphase
Conventional fiber-reinforced composites suffer from the formation of critical clusters of correlated fiber breaks, leading to sudden composite failure in tension. To mitigate this problem, an optimized “brick-and-mortar” nanostructured interphase was developed, in order to absorb energy at fiber breaks and alleviate local stress concentrations whilst maintaining effective load transfer. The coating was designed to exploit crack bifurcation and platelet interlocking mechanisms known in natural nacre. However, the architecture was scaled down by an order of magnitude to allow a highly ordered conformal coating to be deposited around conventional structural carbon fibers, whilst retaining the characteristic phase proportions and aspect ratios of the natural system. Drawing on this bioinspiration, a Layer-by-Layer assembly method was used to coat multiple fibers simultaneously, providing an efficient and potentially scalable route for production. Single fiber pull out and fragmentation tests showed improved interfacial characteristics for energy absorption and plasticity. Impregnated fiber tow model composites demonstrated increases in absolute tensile strength (+15%) and strain-to-failure (+30%), as compared to composites containing conventionally sized fibers
Simulation study of the two-dimensional Burridge-Knopoff model of earthquakes
Spatiotemporal correlations of the two-dimensional spring-block
(Burridge-Knopoff) model of earthquakes are extensively studied by means of
numerical computer simulations. The model is found to exhibit either
``subcritical'' or ``supercritical'' behavior, depending on the values of the
model parameters. Transition between these regimes is either continuous or
discontinuous. Seismic events in the ``subcritical'' regime and those in the
``supercritical'' regime at larger magnitudes exhibit universal scaling
properties. In the ``supercritical'' regime, eminent spatiotemporal
correlations, {\it e.g.}, remarkable growth of seismic activity preceding the
mainshock, arise in earthquake occurrence, whereas such spatiotemporal
correlations are significantly suppressed in the ``subcritical'' regime.
Seismic activity is generically suppressed just before the mainshock in a close
vicinity of the epicenter of the upcoming event while it remains to be active
in the surroundings (the Mogi doughnut). It is also observed that, before and
after the mainshock, the apparent -value of the magnitude distribution
decreases or increases in the ``supercritical'' or ``subcritical'' regimes,
respectively. Such distinct precursory phenomena may open a way to the
prediction of the upcoming large event
Metal mimics: lightweight, strong, and tough (nano)composites and nanomaterial assemblies
The ideal structural material would be high strength and stiffness, with a tough ductile failure, all with a low density. Historically, no such material exists, and materials engineers have had to sacrifice a desired property during materials selection, with metals (high density), fibre composites (brittle failure), and polymers (low stiffness) having fundamental limitations on at least one front. The ongoing revolution of nanomaterials provides a potential route to build on the potential of fibre-reinforced composites, matching their strength while integrating toughening behaviours akin to metal deformations all while using low weight constituents. Here, the challenges, approaches, and recent developments of nanomaterials for structural applications are discussed, with an emphasis on improving toughening mechanisms – often the neglected factor in a field which chases strength and stiffness
The p14 fusion-associated small transmembrane (FAST) protein effects membrane fusion from a subset of membrane microdomains
The reovirus fusion-associated small transmembrane (FAST) proteins are a unique family of viral membrane fusion proteins. These nonstructural viral proteins induce efficient cell-cell rather than virus-cell membrane fusion. We analyzed the lipid environment in which the reptilian reovirus p14 FAST protein resides to determine the influence of the cell membrane on the fusion activity of the FAST proteins. Topographical mapping of the surface of fusogenic p14-containing liposomes by atomic force microscopy under aqueous conditions revealed that p14 resides almost exclusively in thickened membrane microdomains. In transfected cells, p14 was found in both Lubrol WX-and Triton X-100-resistant membrane complexes. Cholesterol depletion of donor cell membranes led to preferential disruption of p14 association with Lubrol WX (but not Triton X-100)-resistant membranes and decreased cell-cell fusion activity, both of which were reversed upon subsequent cholesterol repletion. Furthermore, co-patching analysis by fluorescence microscopy indicated that p14 did not co-localize with classical lipid-anchored raft markers. These data suggest that the p14 FAST protein associates with heterogeneous membrane microdomains, a distinct subset of which is defined by cholesterol-dependent Lubrol WX resistance and which may be more relevant to the membrane fusion process. © 2006 by The American Society for Biochemistry and Molecular Biology, Inc
- …