High In-content InGaN layers synthesized by plasma-assisted molecular-beam epitaxy: growth conditions, strain relaxation and In incorporation kinetics

We report the interplay between In incorporation and strain relaxation kinetics in high-In-content InxGa1-xN (x = 0.3) layers grown by plasma-assisted molecular-beam epitaxy. For In mole fractions x = 0.13-0.48, best structural and morphological quality is obtained under In excess conditions, at In accumulation limit, and at a growth temperature where InGaN decomposition is active. Under such conditions, in situ and ex situ analysis of the evolution of the crystalline structure with the growth thickness points to an onset of misfit relaxation after the growth of 40 nm, and a gradual relaxation during more than 200 nm which results in an inhomogeneous strain distribution along the growth axis. This process is associated with a compositional pulling effect, i.e. indium incorporation is partially inhibited in presence of compressive strain, resulting in a compositional gradient with increasing In mole fraction towards the surface

Grain size effect on the thermal-induced martensitic transformation in polycrystalline Cu-based shape memory alloys

In Cu-based SMA alloys, the grain size (d) effect on the martensitic transformation temperature was investigated for a wide range of d. Specimens were prepared by different heat treatments in order to create a range of grain sizes, from about 500 nm (ribbons and tapes obtained by rapid solidification techniques) up to 6 mm diameter single-crystals (grown by the Bridgman method). Information obtained from the literature was also included in the set of analyzed experimental data. The reduction of grain size shifts the forward transformation temperature downwards. These grain-size effects are observed in specimens with d below ∼ 100 μm, and become more pronounced for d below ∼ 20 μm. An empirical expression was obtained that describes the grain-size effect over the whole temperature range. The obtained curve differs considerably from the Hall-Petch behaviour reported in the literature by some other investigators.Fil: la Roca, Paulo Matías. Consejo Nacional de Investigaciones Científicas y Técnicas. Centro Científico Tecnológico Rosario. Instituto de Física de Rosario (i); Argentina. Universidad Nacional de Rosario. Facultad de Ciencias Exactas, Ingeniería y Agrimensura; ArgentinaFil: Isola, Lucio Manuel. Consejo Nacional de Investigaciones Científicas y Técnicas. Centro Científico Tecnológico Rosario. Instituto de Física de Rosario (i); Argentina. Universidad Nacional de Rosario. Facultad de Ciencias Exactas, Ingeniería y Agrimensura; ArgentinaFil: Sobrero, Cesar Enrique. Consejo Nacional de Investigaciones Científicas y Técnicas. Centro Científico Tecnológico Rosario. Instituto de Física de Rosario (i); Argentina. Universidad Nacional de Rosario. Facultad de Ciencias Exactas, Ingeniería y Agrimensura; ArgentinaFil: Vermaut, P.. Ecole Nationale Superieure de Chimie de Paris; FranciaFil: Malarria, Jorge Alberto. Consejo Nacional de Investigaciones Científicas y Técnicas. Centro Científico Tecnológico Rosario. Instituto de Física de Rosario (i); Argentina. Universidad Nacional de Rosario. Facultad de Ciencias Exactas, Ingeniería y Agrimensura; Argentin

Combination of electron energy-loss spectroscopy and energy dispersive x-ray spectroscopy to determine indium concentration in InGaN thin film structures

We demonstrate a method to determine the indium concentration, x, of In x Ga1-x N thin films by combining plasmon excitation studies in electron energy-loss spectroscopy (EELS) with a novel way of quantification of the intensity of x-ray lines in energy-dispersive x-ray spectroscopy (EDXS). The plasmon peak in EELS of InGaN is relatively broad. We fitted a Lorentz function to the main plasmon peak to suppress noise and the influence from the neighboring Ga 3d transition in the spectrum, which improves the precision in the evaluation of the plasmon peak position. As the indium concentration of InGaN is difficult to control during high temperature growth due to partial In desorption, the nominal indium concentrations provided by the growers were not considered reliable. The indium concentration obtained from EDXS quantification using Oxford Instrument ISIS 300 x-ray standard quantification software often did not agree with the nominal indium concentration, and quantification using K and L lines was inconsistent. We therefore developed a self-consistent iterative procedure to determine the In content from thickness-dependent k-factors, as described in recent work submitted to Journal of Microscopy. When the plasmon peak position is plotted versus the indium concentration from EDXS we obtain a linear relationship over the whole compositional range, and the standard error from linear least-squares fitting shows that the indium concentration can be determined from the plasmon peak position to within Δx = ± 0.037 standard deviation

Investigation of early stage deformation mechanisms in a metastable β titanium alloy showing combined twinning-induced plasticity and transformation-induced plasticity effects

International audienceAs expected from the alloy design procedure, combined Twinning Induced Plasticity (TWIP) and Transformation Induced Plasticity (TRIP) effects are activated in a metastable β Ti-12(wt.%)Mo alloy. In-situ Synchrotron X-ray diffraction (XRD), electron backscatter diffraction (EBSD) and transmission electron microscopy (TEM) observations were carried out to investigate the deformation mechanisms and microstructure evolution sequence. In the early deformation stage, primary strain/stress induced phase transformations (β->ω and β->α'') and primary mechanical twinning ({332} and {112}) are simultaneously activated. Secondary martensitic phase transformation and secondary mechanical twinning are then triggered in the twinned β zones. The {332} twinning and the subsequence secondary mechanisms dominate the early stage deformation process. The evolution of the deformation microstructure results in a high strain hardening rate (~2GPa) bringing about high tensile strength (~1GPa) and large uniform elongation (> 0.38)

Allogeneic Hematopoietic Stem Cell Transplantation After Prior Lung Transplantation for Hereditary Pulmonary Alveolar Proteinosis: A Case Report

Pulmonary alveolar proteinosis (PAP) is a rare, diffuse lung disorder characterized by surfactant accumulation in the small airways due to defective clearance by alveolar macrophages, resulting in impaired gas exchange. Whole lung lavage is the current standard of care treatment for PAP. Lung transplantation is an accepted treatment option when whole lung lavage or other experimental treatment options are ineffective, or in case of extensive pulmonary fibrosis secondary to PAP. A disadvantage of lung transplantation is recurrence of PAP in the transplanted lungs, especially in hereditary PAP. The hereditary form of PAP is an ultra-rare condition caused by genetic mutations in genes encoding for the granulocyte macrophage-colony stimulating factor (GM-CSF) receptor, and intrinsically affects bone marrow derived-monocytes, which differentiate into macrophages in the lung. Consequently, these macrophages typically display disrupted GM-CSF receptor-signaling, causing defective surfactant clearance. Bone marrow/hematopoietic stem cell transplantation may potentially reverse the lung disease in hereditary PAP. In patients with hereditary PAP undergoing lung transplantation, post-lung transplant recurrence of PAP may theoretically be averted by subsequent hematopoietic stem cell transplantation, which results in a graft-versus-disease (PAP) effect, and thus could improve long-term outcome. We describe the successful long-term post-transplant outcome of a unique case of end-stage respiratory failure due to hereditary PAP-induced pulmonary fibrosis, successfully treated by bilateral lung transplantation and subsequent allogeneic hematopoietic stem cell transplantation. Our report supports treatment with serial lung and hematopoietic stem cell transplantation to improve quality of life and prolong survival, without PAP recurrence, in selected patients with end-stage hereditary PAP

“It’s Like Hating Puppies!” Employee Disengagement and Corporate Social Responsibility

Corporate social responsibility (CSR) has been linked with numerous organizational advantages, including recruitment, retention, productivity, and morale, which relate specifically to employees. However, despite specific benefits of CSR relating to employees and their importance as a stakeholder group, it is noteworthy that a lack of attention has been paid to the individual level of analysis with CSR primarily being studied at the organizational level. Both research and practice of CSR have largely treated the individual organization as a “black box,” failing to account for individual differences amongst employees and the resulting variations in antecedents to CSR engagement or disengagement. This is further exacerbated by the tendency in stakeholder theory to homogenize priorities within a single stakeholder group. In response, utilizing case study data drawn from three multinational tourism and hospitality organizations, combined with extensive interview data collected from CSR leaders, industry professionals, engaged, and disengaged employees, this exploratory research produces a finer-grained understanding of employees as a stakeholder group, identifying a number of opportunities and barriers for individual employee engagement in CSR interventions. This research proposes that employees are situated along a spectrum of engagement from actively engaged to actively disengaged. While there are some common drivers of engagement across the entire spectrum of employees, differences also exist depending on the degree to which employees, rather than senior management, support corporate responsibility within their organizations. Key antecedents to CSR engagement that vary depending on employees’ existing level of broader engagement include organizational culture, CSR intervention design, employee CSR perceptions, and the observed benefits of participation

Characterization of dislocations in anisotropic materials by large angle convergent beam electron diffraction

It is shown that the characterization of the Burgers vector of dislocations, by large angle convergent beam electron diffraction, using the Cherns and Preston rules, is possible in elastically anisotropic materials, provided some care is taken in the choice of the Bragg lines used for the analysis

High Performance Algorithms for Toeplitz and block Toeplitz matrices

this paper we discuss several high performance variants of the classical Schur algorithm algorithms to factor symmetric block Toeplitz matrices. Specifically we discuss routines to factor symmetric positive definite, positive semidefinite and indefinite matrices. Algorithms to obtain the QR factorization of exactly and nearly rank deficient Toeplitz matrices are also discussed. In this paper the classical Schur algorithm for obtaining the Cholesky factorization of symmetric positive definite block Toeplitz matrices [9, 8] is generalized to the block Toeplitz matrix case using a block generalization of the hyperbolic Householder reflectors. The block generalization of the Schur algorithm and various blocking schemes differing in the amount of storage and computational primitives used are described in Section 2. Blocking the hyperbolic Householder transformations allows us to apply these transformations using BLAS 3 primitives rather than the BLAS 2 primitives which are required for plain hyperbolic Householder transformations. On machines with a memory hierarchy this provides us with a faster algorithm. For symmetric indefinite block Toeplitz matrices the Schur algorithm breaks down if the matrix has singular principal minors. A scheme to modify the block Schur algorithm by per