The influence of incorporation of Mn on the pitting corrosion performance of CrFeCoNi High Entropy Alloy at different temperatures

The electrochemical behavior and susceptibility to pitting corrosion of CrFeCoNi and CrMnFeCoNi high entropy alloys were studied in a 0.1 M NaCl solution at temperatures ranging from 25 to 75 °C. Electrochemical measurements revealed that CrMnFeCoNi is more susceptible to oxide film breakdown and localized corrosion compared to CrFeCoNi. Post corrosion microscopic observations showed severe pitting corrosion for CrMnFeCoNi in higher temperatures compared to CrFeCoNi. Based on in-depth XPS profile measurements on the remaining oxide films, this behavior was attributed to the depletion of Cr in the oxide film and detrimental presence of Mn in the matrix solid solution of CrMnFeCoNi

Effect of high-pressure torsion on microstructure, mechanical properties and corrosion resistance of cast pure Mg

© 2018, The Author(s). High-pressure torsion (HPT) processing was applied to cast pure magnesium, and the effects of the deformation on the microstructure, hardness, tensile properties and corrosion resistance were evaluated. The microstructures of the processed samples were examined by electron backscatter diffraction, and the mechanical properties were determined by Vickers hardness and tensile testing. The corrosion resistance was studied using electrochemical impedance spectroscopy in a 3.5% NaCl solution. The results show that HPT processing effectively refines the grain size of Mg from millimeters in the cast structure to a few micrometers after processing and also creates a basal texture on the surface. It was found that one or five turns of HPT produced no significant difference in the grain size of the processed Mg and the hardness was a maximum after one turn due to recovery in some grains. Measurements showed that the yield strength of the cast Mg increased by about seven times whereas the corrosion resistance was not significantly affected by the HPT processing

Enhancement of electrical conductivity and corrosion resistance by gold-nickel coating of additively manufactured AlSi10Mg alloy

Abstract Gold-nickel coatings (Au–Ni) were applied by electrodeposition (ED) and electroless deposition (ELD) on additively manufactured (AM) AlSi10Mg alloy to improve the electrical conductivity and electrochemical behavior. Characterization of the Au–Ni coatings was performed by a scanning electron microscope equipped with energy dispersive X-ray spectroscopy (EDS) and x-ray diffraction to study the tiny features. The surface indentation hardness of the coated alloy was evaluated to study the coating strength. The electrochemical behavior of the as-built part and its counterpart, Au–Ni coated surfaces, were evaluated by conducting potentiodynamic polarization (PDP) and electrochemical impedance spectroscopy (EIS) in a 3.5% NaCl solution. The results revealed that the Au–Ni coatings with layers thickness of ∼2 and 10 μm, respectively, could overcome the surface critical defects, i.e., pores and flaws. The surface hardness of the coated AM alloy has significantly increased six times due to the hard Ni layer. The electrochemical measurements showed a significant decrease in the anodic dissolution rate and increase in pitting corrosion resistance for the Au–Ni coated surfaces compared to the bare AM AlSi10Mg alloy with the as-built and polished surface condition in chloride solution. This was attributed to the stability of the Au–Ni coatings against the anodic overpotential. Moreover, it was observed that the Au–Ni coatings reduce the electrical resistance of the studied AM alloy by 40%. Consequently, the surface electrical conductivity property of the AM AlSi10Mg alloy was enhanced by both Au–Ni coating procedures