63 research outputs found

    Atmospheric Benzene Observations from an Oil and Gas Field in the Denver Julesburg Basin in July and August 2014

    Get PDF
    High time resolution measurements of volatile organic compounds (VOCs) were collectedusing a proton-transfer-reaction quadrupole mass spectrometry (PTR-QMS) instrument at the PlattevilleAtmospheric Observatory (PAO) in Colorado to investigate how oil and natural gas (ONG) developmentimpacts air quality within the Wattenburg Gas Field (WGF) in the Denver-Julesburg Basin. The measurementswere carried out in July and August 2014 as part of NASAs Deriving Information on Surface Conditions fromColumn and Vertically Resolved Observations Relevant to Air Quality (DISCOVER-AQ) field campaign. ThePTR-QMS data were supported by pressurized whole air canister samples and airborne vertical and horizontalsurveys of VOCs. Unexpectedly high benzene mixing ratios were observed at PAO at ground level (meanbenzene 0.53 ppbv, maximum benzene 29.3 ppbv), primarily at night (mean nighttime benzene 0.73ppbv). These high benzene levels were associated with southwesterly winds. The airborne measurementsindicate that benzene originated from within the WGF, and typical source signatures detected in the canistersamples implicate emissions from ONG activities rather than urban vehicular emissions as primary benzenesource. This conclusion is backed by a regional toluene-to-benzene ratio analysis which associated southerlyflow with vehicular emissions from the Denver area. Weak benzene-to-CO correlations confirmed that trafficemissions were not responsible for the observed high benzene levels. Previous measurements at the BoulderAtmospheric Observatory (BAO) and our data obtained at PAO allow us to locate the source of benzeneenhancements between the two atmospheric observatories. Fugitive emissions of benzene from ONGoperations in the Platteville area are discussed as the most likely causes of enhanced benzene levels at PAO

    Sensitivity to grid resolution in the ability of a chemical transport model to simulate observed oxidant chemistry under high-isoprene conditions

    Get PDF
    Formation of ozone and organic aerosol in continental atmospheres depends on whether isoprene emitted by vegetation is oxidized by the high-NOx pathway (where peroxy radicals react with NO) or by low-NOx pathways (where peroxy radicals react by alternate channels, mostly with HO2). We used mixed layer observations from the SEAC4RS aircraft campaign over the Southeast US to test the ability of the GEOS-Chem chemical transport model at different grid resolutions (0.25°  ×  0.3125°, 2°  ×  2.5°, 4°  ×  5°) to simulate this chemistry under high-isoprene, variable-NOx conditions. Observations of isoprene and NOx over the Southeast US show a negative correlation, reflecting the spatial segregation of emissions; this negative correlation is captured in the model at 0.25°  ×  0.3125° resolution but not at coarser resolutions. As a result, less isoprene oxidation takes place by the high-NOx pathway in the model at 0.25°  ×  0.3125° resolution (54 %) than at coarser resolution (59 %). The cumulative probability distribution functions (CDFs) of NOx, isoprene, and ozone concentrations show little difference across model resolutions and good agreement with observations, while formaldehyde is overestimated at coarse resolution because excessive isoprene oxidation takes place by the high-NOx pathway with high formaldehyde yield. The good agreement of simulated and observed concentration variances implies that smaller-scale non-linearities (urban and power plant plumes) are not important on the regional scale. Correlations of simulated vs. observed concentrations do not improve with grid resolution because finer modes of variability are intrinsically more difficult to capture. Higher model resolution leads to decreased conversion of NOx to organic nitrates and increased conversion to nitric acid, with total reactive nitrogen oxides (NOy) changing little across model resolutions. Model concentrations in the lower free troposphere are also insensitive to grid resolution. The overall low sensitivity of modeled concentrations to grid resolution implies that coarse resolution is adequate when modeling continental boundary layer chemistry for global applications

    In situ measurements of water uptake by black carbon-containing aerosol in wildfire plumes

    Get PDF
    Water uptake by black carbon (BC)-containing aerosol was quantified in North American wildfire plumes of varying age (1 to ~40 h old) sampled during the SEAC4RS mission (2013). A Humidified Dual SP2 (HD-SP2) is used to optically size BC-containing particles under dry and humid conditions from which we extract the hygroscopicity parameter, κ, of materials internally mixed with BC. Instrumental variability and the uncertainty of the technique are briefly discussed. An ensemble average κ of 0.04 is found for the set of plumes sampled, consistent with previous estimates of bulk aerosol hygroscopicity from biomass burning sources. The temporal evolution of κ in the Yosemite Rim Fire plume is explored to constrain the rate of conversion of BC-containing aerosol from hydrophobic to more hydrophilic modes in these emissions. A BC-specific κ increase of ~0.06 over 40 h is found, fit well with an exponential curve corresponding to a transition from a κ of 0 to a κ of ~0.09 with an e-folding time of 29 h. Although only a few percent of wildfire particles contain BC, a similar κ increase is estimated for bulk aerosol and the measured aerosol composition is used to infer that the observed κ change is driven by a combination of incorporation of ammonium sulfate and oxidation of existing organic materials. Finally, a substantial fraction of wildfire-generated BC-containing aerosol is calculated to be active as cloud condensation nuclei shortly after emission likely indicating efficient wet removal. These results can constrain model treatment of BC from wildfire sources

    Comparison of the chemical evolution and characteristics of 495 biomass burning plumes intercepted by the NASA DC-8 aircraft during the ARCTAS/CARB-2008 field campaign

    Get PDF
    This paper compares measurements of gaseous and particulate emissions from a wide range of biomass-burning plumes intercepted by the NASA DC-8 research aircraft during the three phases of the ARCTAS-2008 experiment: ARCTAS-A, based out of Fairbanks, Alaska USA (3 April to 19 April 2008); ARCTAS-B based out of Cold Lake, Alberta, Canada (29 June to 13 July 2008); and ARCTAS-CARB, based out of Palmdale, California, USA (18 June to 24 June 2008). Extensive investigations of boreal fire plume evolution were undertaken during ARCTAS-B, where four distinct fire plumes that were intercepted by the aircraft over a range of down-wind distances (0.1 to 16 hr transport times) were studied in detail. Based on these analyses, there was no evidence for ozone production and a box model simulation of the data confirmed that net ozone production was slow (on average 1 ppbv h−1 in the first 3 h and much lower afterwards) due to limited NOx. Peroxyacetyl nitrate concentrations (PAN) increased with plume age and the box model estimated an average production rate of ~80 pptv h−1 in the first 3 h. Like ozone, there was also no evidence for net secondary inorganic or organic aerosol formation. There was no apparent increase in aerosol mass concentrations in the boreal fire plumes due to secondary organic aerosol (SOA) formation; however, there were indications of chemical processing of the organic aerosols. In addition to the detailed studies of boreal fire plume evolution, about 500 smoke plumes intercepted by the NASA DC-8 aircraft were segregated by fire source region. The normalized excess mixing ratios (i.e. ΔX/ΔCO) of gaseous (carbon dioxide, acetonitrile, hydrogen cyanide, toluene, benzene, methane, oxides of nitrogen (NOx), ozone, PAN) and fine aerosol particulate components (nitrate, sulfate, ammonium, chloride, organic aerosols and water soluble organic carbon) of these plumes were compared

    Identifying Examinees Who Possess Distinct and Reliable Subscores When Added Value is Lacking for the Total Sample

    Get PDF
    Research has demonstrated that although subdomain information may provide no added value beyond the total score, in some contexts such information is of utility to particular demographic subgroups (Sinharay & Haberman, 2014). However, it is argued that the utility of reporting subscores for an individual should not be based on one’s manifest characteristics (e.g., gender or ethnicity), but rather on individual needs for diagnostic information, which is driven by multidimensionality in subdomain scores. To improve the validity of diagnostic information, this study proposed the use of Mahalanobis Distance and HT indices to assess whether an individual’s data significantly departs from unidimensionality. Those examinees that were found to differ significantly were then assessed separately for subscore added value via Haberman’s (2008) procedure. To this end, simulation analyses were conducted to evaluate Type I error, power, and recovery of subscore added value classifications for various levels of subdomain test lengths, subdomain inter-correlations, and proportions of multidimensionality in the total sample. Results demonstrated that the HT index possessed around 100% power across all conditions, while maintaining Type I error below 5%, which led to nearly perfect recovery of subscore added value classifications. In contrast, the power rates for Mahalanobis Distance were much lower ranging from 13% to 61% with Type I errors maintained at the nominal level of 5%. Although the power rates were below the desired criterion of 80%, the cases identified as aberrant using this method were found to have greater variability between subdomain scores, increased reliability, and lower observed subdomain correlations when compared to the generated data. As a result, outlier cases were found to have subscore added value for nearly 100% of cases across conditions even when the generated multidimensional data did not possess subscore added value. These results were cross-validated using a large-scale high-stakes test in which the Mahalanobis Distance measure was found to identify 6.57% of 8,803 test-takers that possessed subscores with added-value who otherwise would have been masked by the unidimensionality of the total sample. Overall, this study suggests that the Mahalanobis Distance measure shows some promise in identifying examinees with multidimensional score profiles
    • …
    corecore