17,551 research outputs found
Strain-stress study of AlxGa1-xN/AlN heterostructures on c-plane sapphire and related optical properties
This work presents a systematic study of stress and strain of AlxGa1-xN/AlN
with composition ranging from GaN to AlN, grown on a c-plane sapphire by
metal-organic chemical vapor deposition, using synchrotron radiation
high-resolution X-ray diffraction and reciprocal space mapping. The c-plane of
the AlxGa1-xN epitaxial layers exhibits compressive strain, while the a-plane
exhibits tensile strain. The biaxial stress and strain are found to increase
with increasing Al composition, although the lattice mismatch between the
AlxGa1-xN and the buffer layer AlN gets smaller. A reduction in the lateral
coherence lengths and an increase in the edge and screw dislocations are seen
as the AlxGa1-xN composition is varied from GaN to AlN, exhibiting a clear
dependence of the crystal properties of AlxGa1-xN on the Al content. The
bandgap of the epitaxial layers is slightly lower than predicted value due to a
larger tensile strain effect on the a-axis compared to the compressive strain
on the c-axis. Raman characteristics of the AlxGa1-xN samples exhibit a shift
in the phonon peaks with the Al composition. The effect of strain is also
discussed on the optical phonon energies of the epitaxial layers. The
techniques discussed here can be used to study other similar materials.Comment: 14 pages, 5 figures, 2 table
Laser Velocimeter Measurements in the Leakage Annulus of a Whirling Shrouded Centrifugal Pump
Previous experiments conducted in the Rotor Force Test Facility at the California Institute of Technology have thoroughly examined the effect of leakage flows on the rotordynamic forces on a centrifugal pump impeller undergoing a prescribed circular whirl. These leakage flows have been shown to contribute substantially to the total fluid induced forces acting on a pump. However, to date nothing is known of the flow field in the leakage annulus of shrouded centrifugal pumps. No attempt has been made to qualitatively or quantitatively examine the velocity field in the leakage annulus. Hence the test objective of this experiment is to acquire fluid velocity data for a geometry representative of the leakage annulus of a shrouded centrifugal pump while the rotor is whirling using laser velocimetry. Tests are performed over a range of whirl ratios and a flowrate typical of Space Shuttle Turbopump designs. In addition to a qualitive study of the flow field, the velocity data can be used to anchor flow models
A cohort study of influences, health outcomes and costs of patients' health-seeking behaviour for minor ailments from primary and emergency care settings
To compare health-related and cost-related outcomes of consultations for symptoms suggestive of minor ailments in emergency departments (EDs), general practices and community pharmacies
Photon angular distribution and nuclear-state alignment in nuclear excitation by electron capture
The alignment of nuclear states resonantly formed in nuclear excitation by
electron capture (NEEC) is studied by means of a density matrix technique. The
vibrational excitations of the nucleus are described by a collective model and
the electrons are treated in a relativistic framework. Formulas for the angular
distribution of photons emitted in the nuclear relaxation are derived. We
present numerical results for alignment parameters and photon angular
distributions for a number of heavy elements in the case of E2 nuclear
transitions. Our results are intended to help future experimental attempts to
discern NEEC from radiative recombination, which is the dominant competing
process
Reconfigurable quadruple quantum dots in a silicon nanowire transistor
We present a novel reconfigurable metal-oxide-semiconductor multi-gate
transistor that can host a quadruple quantum dot in silicon. The device consist
of an industrial quadruple-gate silicon nanowire field-effect transistor.
Exploiting the corner effect, we study the versatility of the structure in the
single quantum dot and the serial double quantum dot regimes and extract the
relevant capacitance parameters. We address the fabrication variability of the
quadruple-gate approach which, paired with improved silicon fabrication
techniques, makes the corner state quantum dot approach a promising candidate
for a scalable quantum information architecture
Impeller flow field characterization with a laser two-focus velocimeter
Use of Computational Fluid Dynamics (CFD) codes, prevalent in the rocket engine turbomachinery industry, necessitates data of sufficient quality and quantity to benchmark computational codes. Existing data bases for typical rocket engine configurations, in particular impellers, are limited. In addition, traditional data acquisition methods have several limitations: typically transducer uncertainties are 0.5% of transducer full scale and traditional pressure probes are unable to provide flow characteristics in the circumferential (blade-to-blade) direction. Laser velocimetry circumvents these limitations by providing +0.5% uncertainty in flow velocity and +0.5% uncertainty in flow angle. The percent of uncertainty in flow velocity is based on the measured value, not full range capability. The laser electronics multiple partitioning capability allows data acquired between blades as the impeller rotates, to be analyzed separately, thus providing blade-to-blade flow characterization. Unlike some probes, the non-intrusive measurements made with the laser velocimeter does not disturb the flow. To this end,, and under Contract (NAS8-38864) to the National Aeronautics and Space Administration (NASA) at Marshall Space Flight Center (MSFC), an extensive test program was undertaken at Rocketdyne. Impellers from two different generic rocket engine pump configurations were examined. The impellers represent different spectrums of pump design: the Space Shuttle Main Engine (SSME) high pressure fuel turbopump (HPFTP) impeller was designed in the 1 1970's the Consortium for CFD application in Propulsion Technology Pump Stage Technology Team (Pump Consortium) optimized impeller was designed with the aid of modern computing techniques. The tester configuration for each of the impellers consisted of an axial inlet, an inducer, a diffuser, and a crossover discharge. While the tested configurations were carefully chosen to be representative of generic rocket engine pumps, several features of both testers were intentionally atypical. A crossover discharge, downstream of the impeller, rather than a volute discharge was used to minimize asymmetric flow conditions that might be reflected in the impeller discharge flow data. Impeller shroud wear ring radial clearances were purposely close to minimize leakage flow, thus increasing confidence in using the inlet data as an input to CFD programs. The empirical study extensively examined the flow fields of the two impellers via performance of laser two-focus velocimeter surveys in an axial plane upstream of the impellers and in multiple radial planes downstream of the impellers. Both studies were performed at the impeller design flow coefficients. Inlet laser surveys that provide CFD code inlet boundary conditions were performed in one axial plane, with ten radial locations surveyed. Three wall static pressures, positioned circumferentially around the impeller inlet, were used to identify asymmetrical pressure distributions in the inlet survey plane. The impeller discharge flow characterization consisted of three radial planes for the SSME HPFTP impeller and two radial planes for the Pump Consortium optimized impeller. Housing wall static pressures were placed to correspond to the radial locations surveyed with the laser velocimeter. Between five and thirteen axial stations across the discharge channel width were examined in each radial plane during the extensive flow mapping. The largely successful empirical flow characterization of two different impellers resulted in a substantial contribution to the limited existing data base, and yielded accurate data for CFD code benchmarking
Results of Radiation Tests of the Anode Front-End Boards for the CMS Endcap Muon Cathode Strip Chambers
Spin-dependent phenomena and device concepts explored in (Ga,Mn)As
Over the past two decades, the research of (Ga,Mn)As has led to a deeper
understanding of relativistic spin-dependent phenomena in magnetic systems. It
has also led to discoveries of new effects and demonstrations of unprecedented
functionalities of experimental spintronic devices with general applicability
to a wide range of materials. In this article we review the basic material
properties that make (Ga,Mn)As a favorable test-bed system for spintronics
research and discuss contributions of (Ga,Mn)As studies in the general context
of the spin-dependent phenomena and device concepts. Special focus is on the
spin-orbit coupling induced effects and the reviewed topics include the
interaction of spin with electrical current, light, and heat.Comment: 47 pages, 41 figure
Field evaluation of selected cassava genotypes for cassava brown streak disease based on symptom expression and virus load
Background
Production of cassava (Manihot esculenta Crantz), a food security crop in sub-Saharan Africa, is threatened by the spread of cassava brown streak disease (CBSD) which manifests in part as a corky necrosis in the storage root. It is caused by either of two virus species, Cassava brown streak virus (CBSV) and Ugandan cassava brown streak virus (UCBSV), resulting in up to 100% yield loss in susceptible varieties.
Methods
This study characterized the response of 11 cassava varieties according to CBSD symptom expression and relative CBSV and UCBSV load in a field trial in Uganda. Relative viral load was measured using quantitative RT-PCR using COX as an internal housekeeping gene.
Results
A complex situation was revealed with indications of different resistance mechanisms that restrict virus accumulation and symptom expression. Four response categories were defined. Symptom expression was not always positively correlated with virus load. Substantially different levels of the virus species were found in many genotypes suggesting either resistance to one virus species or the other, or some form of interaction, antagonism or competition between virus species.
Conclusions
A substantial amount of research still needs to be undertaken to fully understand the mechanism and genetic bases of resistance. This information will be useful in informing breeding strategies and restricting virus spread.Background
Production of cassava (Manihot esculenta Crantz), a food security crop in sub-Saharan Africa, is threatened by the spread of cassava brown streak disease (CBSD) which manifests in part as a corky necrosis in the storage root. It is caused by either of two virus species, Cassava brown streak virus (CBSV) and Ugandan cassava brown streak virus (UCBSV), resulting in up to 100% yield loss in susceptible varieties.
Methods
This study characterized the response of 11 cassava varieties according to CBSD symptom expression and relative CBSV and UCBSV load in a field trial in Uganda. Relative viral load was measured using quantitative RT-PCR using COX as an internal housekeeping gene.
Results
A complex situation was revealed with indications of different resistance mechanisms that restrict virus accumulation and symptom expression. Four response categories were defined. Symptom expression was not always positively correlated with virus load. Substantially different levels of the virus species were found in many genotypes suggesting either resistance to one virus species or the other, or some form of interaction, antagonism or competition between virus species.
Conclusions
A substantial amount of research still needs to be undertaken to fully understand the mechanism and genetic bases of resistance. This information will be useful in informing breeding strategies and restricting virus spread.Background
Production of cassava (Manihot esculenta Crantz), a food security crop in sub-Saharan Africa, is threatened by the spread of cassava brown streak disease (CBSD) which manifests in part as a corky necrosis in the storage root. It is caused by either of two virus species, Cassava brown streak virus (CBSV) and Ugandan cassava brown streak virus (UCBSV), resulting in up to 100% yield loss in susceptible varieties.
Methods
This study characterized the response of 11 cassava varieties according to CBSD symptom expression and relative CBSV and UCBSV load in a field trial in Uganda. Relative viral load was measured using quantitative RT-PCR using COX as an internal housekeeping gene.
Results
A complex situation was revealed with indications of different resistance mechanisms that restrict virus accumulation and symptom expression. Four response categories were defined. Symptom expression was not always positively correlated with virus load. Substantially different levels of the virus species were found in many genotypes suggesting either resistance to one virus species or the other, or some form of interaction, antagonism or competition between virus species.
Conclusions
A substantial amount of research still needs to be undertaken to fully understand the mechanism and genetic bases of resistance. This information will be useful in informing breeding strategies and restricting virus spread.Background
Production of cassava (Manihot esculenta Crantz), a food security crop in sub-Saharan Africa, is threatened by the spread of cassava brown streak disease (CBSD) which manifests in part as a corky necrosis in the storage root. It is caused by either of two virus species, Cassava brown streak virus (CBSV) and Ugandan cassava brown streak virus (UCBSV), resulting in up to 100% yield loss in susceptible varieties.
Methods
This study characterized the response of 11 cassava varieties according to CBSD symptom expression and relative CBSV and UCBSV load in a field trial in Uganda. Relative viral load was measured using quantitative RT-PCR using COX as an internal housekeeping gene.
Results
A complex situation was revealed with indications of different resistance mechanisms that restrict virus accumulation and symptom expression. Four response categories were defined. Symptom expression was not always positively correlated with virus load. Substantially different levels of the virus species were found in many genotypes suggesting either resistance to one virus species or the other, or some form of interaction, antagonism or competition between virus species.
Conclusions
A substantial amount of research still needs to be undertaken to fully understand the mechanism and genetic bases of resistance. This information will be useful in informing breeding strategies and restricting virus spread
- …