385 research outputs found

    Experiments on the stability and transition of two-dimensional and three-dimensional boundary layers with suction

    Get PDF
    The preliminary experimental development work directed towards the understanding of transition in boundary layers with suction is presented. The basic stability experiment was established and the facility was certified

    Effect of leading-edge geometry on boundary-layer receptivity to freestream sound

    Get PDF
    The receptivity to freestream sound of the laminar boundary layer over a semi-infinite flat plate with an elliptic leading edge is simulated numerically. The incompressible flow past the flat plate is computed by solving the full Navier-Stokes equations in general curvilinear coordinates. A finite-difference method which is second-order accurate in space and time is used. Spatial and temporal developments of the Tollmien-Schlichting wave in the boundary layer, due to small-amplitude time-harmonic oscillations of the freestream velocity that closely simulate a sound wave travelling parallel to the plate, are observed. The effect of leading-edge curvature is studied by varying the aspect ratio of the ellipse. The boundary layer over the flat plate with a sharper leading edge is found to be less receptive. The relative contribution of the discontinuity in curvature at the ellipse-flat-plate juncture to receptivity is investigated by smoothing the juncture with a polynomial. Continuous curvature leads to less receptivity. A new geometry of the leading edge, a modified super ellipse, which provides continuous curvature at the juncture with the flat plate, is used to study the effect of continuous curvature and inherent pressure gradient on receptivity

    The Effect of Acoustic Forcing on Instabilities and Breakdown in Swept-Wing Flow over a Backward-Facing Step

    Get PDF
    Instability interaction and breakdown were experimentally investigated in the flow over a swept backward-facing step. Acoustic forcing was used to excite the Tollmien-Schlichting (TS) instability and to acquire phase-locked results. The phase-averaged results illustrate the complex nature of the interaction between the TS and stationary cross flow instabilities. The weak stationary cross flow disturbance causes a distortion of the TS wavefront. The breakdown process is characterized by large positive and negative spikes in velocity. The positive spikes occur near the same time and location as the positive part of the TS wave. Higher-order spectral analysis was used to further investigate the nonlinear interactions between the TS instability and the traveling cross flow disturbances. The results reveal that a likely cause for the generation of the spikes corresponds to nonlinear interactions between the TS, traveling cross flow, and stationary cross flow disturbances. The spikes begin at low amplitudes of the unsteady and steady disturbances (2-4% U (sub e) (i.e. boundary layer edge velocity)) but can achieve very large amplitudes (20-30 percent U (sub e) (i.e. boundary layer edge velocity)) that initiate an early, though highly intermittent, breakdown to turbulence

    Measurements in a Transitioning Cone Boundary Layer at Freestream Mach 3.5

    Get PDF
    An experimental study was conducted in the Supersonic Low-Disturbance Tunnel to investigate naturally-occurring instabilities in a supersonic boundary layer on a 7 deg half- angle cone. All tests were conducted with a nominal freestream Mach number of M(sub infinity) = 3:5, total temperature of T(sub 0) = 299:8 K, and unit Reynolds numbers of Re(sub infinity) x 10(exp -6) = 9:89, 13.85, 21.77, and 25.73 m(exp -1). Instability measurements were acquired under noisy- ow and quiet- ow conditions. Measurements were made to document the freestream and the boundary-layer edge environment, to document the cone baseline flow, and to establish the stability characteristics of the transitioning flow. Pitot pressure and hot-wire boundary- layer measurements were obtained using a model-integrated traverse system. All hot- wire results were single-point measurements and were acquired with a sensor calibrated to mass ux. For the noisy-flow conditions, excellent agreement for the growth rates and mode shapes was achieved between the measured results and linear stability theory (LST). The corresponding N factor at transition from LST is N 3:9. The stability measurements for the quiet-flow conditions were limited to the aft end of the cone. The most unstable first-mode instabilities as predicted by LST were successfully measured, but this unstable first mode was not the dominant instability measured in the boundary layer. Instead, the dominant instabilities were found to be the less-amplified, low-frequency disturbances predicted by linear stability theory, and these instabilities grew according to linear theory. These low-frequency unstable disturbances were initiated by freestream acoustic disturbances through a receptivity process that is believed to occur near the branch I locations of the cone. Under quiet-flow conditions, the boundary layer remained laminar up to the last measurement station for the largest Re1, implying a transition N factor of N greater than 8:5

    Active flow control systems architectures for civil transport aircraft

    Get PDF
    Copyright @ 2010 American Institute of Aeronautics and AstronauticsThis paper considers the effect of choice of actuator technology and associated power systems architecture on the mass cost and power consumption of implementing active flow control systems on civil transport aircraft. The research method is based on the use of a mass model that includes a mass due to systems hardware and a mass due to the system energy usage. An Airbus A320 aircraft wing is used as a case-study application. The mass model parameters are based on first-principle physical analysis of electric and pneumatic power systems combined with empirical data on system hardware from existing equipment suppliers. Flow control methods include direct fluidic, electromechanical-fluidic, and electrofluidic actuator technologies. The mass cost of electrical power distribution is shown to be considerably less than that for pneumatic systems; however, this advantage is reduced by the requirement for relatively heavy electrical power management and conversion systems. A tradeoff exists between system power efficiency and the system hardware mass required to achieve this efficiency. For short-duration operation the flow control solution is driven toward lighter but less power-efficient systems, whereas for long-duration operation there is benefit in considering heavier but more efficient systems. It is estimated that a practical electromechanical-fluidic system for flow separation control may have a mass up to 40% of the slat mass for a leading-edge application and 5% of flap mass for a trailing-edge application.This work is funded by the Sixth European Union Framework Programme as part of the AVERT project (Contract No. AST5-CT-2006-030914

    Implementing a multisector public-private partnership to improve urban hypertension management in low-and middle- income countries

    Get PDF
    BACKGROUND: Cardiovascular disease presents an increasing health burden to low- and middle-income countries. Although ample therapeutic options and care improvement frameworks exist to address its prime risk factor, hypertension, blood pressure control rates remain poor. We describe the results of an effectiveness study of a multisector urban population health initiative that targets hypertension in a real-world implementation setting in cities across three continents. The initiative followed the "CARDIO4Cities" approach (quality of Care, early Access, policy Reform, Data and digital technology, Intersectoral collaboration, and local Ownership). METHOD: The approach was applied in Ulaanbaatar in Mongolia, Dakar in Senegal, and Sao Paulo in Brazil. In each city, a portfolio of evidence-based practices was implemented, tailored to local priorities and available data. Outcomes were measured by extracting hypertension diagnosis, treatment and control rates from primary health records. Data from 18,997 patients with hypertension in primary health facilities were analyzed. RESULTS: Over one to two years of implementation, blood pressure control rates among enrolled patients receiving medication tripled in Sao Paulo (from 12.3% to 31.2%) and Dakar (from 6.7% to 19.4%) and increased six-fold in Ulaanbaatar (from 3.1% to 19.7%). CONCLUSIONS: This study provides first evidence that a multisectoral population health approach to implement known best-practices, supported by data and digital technologies, and relying on local buy-in and ownership, can improve hypertension control in high-burden urban primary care settings in low-and middle-income countries

    Single photon emission computed tomography (SPECT) of anxiety disorders before and after treatment with citalopram

    Get PDF
    BACKGROUND: Several studies have now examined the effects of selective serotonin reuptake inhibitor (SSRI) treatment on brain function in a variety of anxiety disorders including obsessive-compulsive disorder (OCD), posttraumatic stress disorder (PTSD), and social anxiety disorder (social phobia) (SAD). Regional changes in cerebral perfusion following SSRI treatment have been shown for all three disorders. The orbitofrontal cortex (OFC) (OCD), caudate (OCD), medial pre-frontal/cingulate (OCD, SAD, PTSD), temporal (OCD, SAD, PTSD) and, thalamic regions (OCD, SAD) are some of those implicated. Some data also suggests that higher perfusion pre-treatment in the anterior cingulate (PTSD), OFC, caudate (OCD) and antero-lateral temporal region (SAD) predicts subsequent treatment response. This paper further examines the notion of overlap in the neurocircuitry of treatment and indeed treatment response across anxiety disorders with SSRI treatment. METHODS: Single photon emission computed tomography (SPECT) using Tc-(99 m )HMPAO to assess brain perfusion was performed on subjects with OCD, PTSD, and SAD before and after 8 weeks (SAD) and 12 weeks (OCD and PTSD) treatment with the SSRI citalopram. Statistical parametric mapping (SPM) was used to compare scans (pre- vs post-medication, and responders vs non-responders) in the combined group of subjects. RESULTS: Citalopram treatment resulted in significant deactivation (p = 0.001) for the entire group in the superior (t = 4.78) and anterior (t = 4.04) cingulate, right thalamus (t = 4.66) and left hippocampus (t = 3.96). Deactivation (p = 0.001) within the left precentral (t = 4.26), right mid-frontal (t = 4.03), right inferior frontal (t = 3.99), left prefrontal (3.81) and right precuneus (t= 3.85) was more marked in treatment responders. No pattern of baseline activation distinguished responders from non-responders to subsequent pharmacotherapy. CONCLUSIONS: Although each of the anxiety disorders may be mediated by different neurocircuits, there is some overlap in the functional neuro-anatomy of their response to SSRI treatment. The current data are consistent with previous work demonstrating the importance of limbic circuits in this spectrum of disorders. These play a crucial role in cognitive-affective processing, are innervated by serotonergic neurons, and changes in their activity during serotonergic pharmacotherapy seem crucial

    Protein Expression in the Nucleus Accumbens of Rats Exposed to Developmental Vitamin D Deficiency

    Get PDF
    Introduction: Developmental vitamin D (DVD) deficiency is a candidate risk factor for schizophrenia. Animal models have confirmed that DVD deficiency is associated with a range of altered genomic, proteomic, structural and behavioural outcomes in the rat. Because the nucleus accumbens has been implicated in neuropsychiatric disorders, in the current study we examined protein expression in this region in adult rats exposed to DVD deficienc
    corecore