Measurement of the cosmic ray spectrum above 4×10184{\times}10^{18} eV using inclined events detected with the Pierre Auger Observatory

A measurement of the cosmic-ray spectrum for energies exceeding $4{\times}10^{18}$ eV is presented, which is based on the analysis of showers with zenith angles greater than $60^{\circ}$ detected with the Pierre Auger Observatory between 1 January 2004 and 31 December 2013. The measured spectrum confirms a flux suppression at the highest energies. Above $5.3{\times}10^{18}$ eV, the "ankle", the flux can be described by a power law $E^{-\gamma}$ with index $\gamma=2.70 \pm 0.02 \,\text{(stat)} \pm 0.1\,\text{(sys)}$ followed by a smooth suppression region. For the energy ($E_\text{s}$) at which the spectral flux has fallen to one-half of its extrapolated value in the absence of suppression, we find $E_\text{s}=(5.12\pm0.25\,\text{(stat)}^{+1.0}_{-1.2}\,\text{(sys)}){\times}10^{19}$ eV.Comment: Replaced with published version. Added journal reference and DO

Energy Estimation of Cosmic Rays with the Engineering Radio Array of the Pierre Auger Observatory

The Auger Engineering Radio Array (AERA) is part of the Pierre Auger Observatory and is used to detect the radio emission of cosmic-ray air showers. These observations are compared to the data of the surface detector stations of the Observatory, which provide well-calibrated information on the cosmic-ray energies and arrival directions. The response of the radio stations in the 30 to 80 MHz regime has been thoroughly calibrated to enable the reconstruction of the incoming electric field. For the latter, the energy deposit per area is determined from the radio pulses at each observer position and is interpolated using a two-dimensional function that takes into account signal asymmetries due to interference between the geomagnetic and charge-excess emission components. The spatial integral over the signal distribution gives a direct measurement of the energy transferred from the primary cosmic ray into radio emission in the AERA frequency range. We measure 15.8 MeV of radiation energy for a 1 EeV air shower arriving perpendicularly to the geomagnetic field. This radiation energy -- corrected for geometrical effects -- is used as a cosmic-ray energy estimator. Performing an absolute energy calibration against the surface-detector information, we observe that this radio-energy estimator scales quadratically with the cosmic-ray energy as expected for coherent emission. We find an energy resolution of the radio reconstruction of 22% for the data set and 17% for a high-quality subset containing only events with at least five radio stations with signal.Comment: Replaced with published version. Added journal reference and DO

Measurement of the Radiation Energy in the Radio Signal of Extensive Air Showers as a Universal Estimator of Cosmic-Ray Energy

We measure the energy emitted by extensive air showers in the form of radio emission in the frequency range from 30 to 80 MHz. Exploiting the accurate energy scale of the Pierre Auger Observatory, we obtain a radiation energy of 15.8 \pm 0.7 (stat) \pm 6.7 (sys) MeV for cosmic rays with an energy of 1 EeV arriving perpendicularly to a geomagnetic field of 0.24 G, scaling quadratically with the cosmic-ray energy. A comparison with predictions from state-of-the-art first-principle calculations shows agreement with our measurement. The radiation energy provides direct access to the calorimetric energy in the electromagnetic cascade of extensive air showers. Comparison with our result thus allows the direct calibration of any cosmic-ray radio detector against the well-established energy scale of the Pierre Auger Observatory.Comment: Replaced with published version. Added journal reference and DOI. Supplemental material in the ancillary file

Examining the generalizability of research findings from archival data

This initiative examined systematically the extent to which a large set of archival research findings generalizes across contexts. We repeated the key analyses for 29 original strategic management effects in the same context (direct reproduction) as well as in 52 novel time periods and geographies; 45% of the reproductions returned results matching the original reports together with 55% of tests in different spans of years and 40% of tests in novel geographies. Some original findings were associated with multiple new tests. Reproducibility was the best predictor of generalizability—for the findings that proved directly reproducible, 84% emerged in other available time periods and 57% emerged in other geographies. Overall, only limited empirical evidence emerged for context sensitivity. In a forecasting survey, independent scientists were able to anticipate which effects would find support in tests in new samples

The Science Performance of JWST as Characterized in Commissioning

This paper characterizes the actual science performance of the James Webb Space Telescope (JWST), as determined from the six month commissioning period. We summarize the performance of the spacecraft, telescope, science instruments, and ground system, with an emphasis on differences from pre-launch expectations. Commissioning has made clear that JWST is fully capable of achieving the discoveries for which it was built. Moreover, almost across the board, the science performance of JWST is better than expected; in most cases, JWST will go deeper faster than expected. The telescope and instrument suite have demonstrated the sensitivity, stability, image quality, and spectral range that are necessary to transform our understanding of the cosmos through observations spanning from near-earth asteroids to the most distant galaxies.Comment: 5th version as accepted to PASP; 31 pages, 18 figures; https://iopscience.iop.org/article/10.1088/1538-3873/acb29

Dissecting the Shared Genetic Architecture of Suicide Attempt, Psychiatric Disorders, and Known Risk Factors

Background Suicide is a leading cause of death worldwide, and nonfatal suicide attempts, which occur far more frequently, are a major source of disability and social and economic burden. Both have substantial genetic etiology, which is partially shared and partially distinct from that of related psychiatric disorders. Methods We conducted a genome-wide association study (GWAS) of 29,782 suicide attempt (SA) cases and 519,961 controls in the International Suicide Genetics Consortium (ISGC). The GWAS of SA was conditioned on psychiatric disorders using GWAS summary statistics via multitrait-based conditional and joint analysis, to remove genetic effects on SA mediated by psychiatric disorders. We investigated the shared and divergent genetic architectures of SA, psychiatric disorders, and other known risk factors. Results Two loci reached genome-wide significance for SA: the major histocompatibility complex and an intergenic locus on chromosome 7, the latter of which remained associated with SA after conditioning on psychiatric disorders and replicated in an independent cohort from the Million Veteran Program. This locus has been implicated in risk-taking behavior, smoking, and insomnia. SA showed strong genetic correlation with psychiatric disorders, particularly major depression, and also with smoking, pain, risk-taking behavior, sleep disturbances, lower educational attainment, reproductive traits, lower socioeconomic status, and poorer general health. After conditioning on psychiatric disorders, the genetic correlations between SA and psychiatric disorders decreased, whereas those with nonpsychiatric traits remained largely unchanged. Conclusions Our results identify a risk locus that contributes more strongly to SA than other phenotypes and suggest a shared underlying biology between SA and known risk factors that is not mediated by psychiatric disorders.Peer reviewe

Impact of opioid-free analgesia on pain severity and patient satisfaction after discharge from surgery: multispecialty, prospective cohort study in 25 countries

Background: Balancing opioid stewardship and the need for adequate analgesia following discharge after surgery is challenging. This study aimed to compare the outcomes for patients discharged with opioid versus opioid-free analgesia after common surgical procedures.Methods: This international, multicentre, prospective cohort study collected data from patients undergoing common acute and elective general surgical, urological, gynaecological, and orthopaedic procedures. The primary outcomes were patient-reported time in severe pain measured on a numerical analogue scale from 0 to 100% and patient-reported satisfaction with pain relief during the first week following discharge. Data were collected by in-hospital chart review and patient telephone interview 1 week after discharge.Results: The study recruited 4273 patients from 144 centres in 25 countries; 1311 patients (30.7%) were prescribed opioid analgesia at discharge. Patients reported being in severe pain for 10 (i.q.r. 1-30)% of the first week after discharge and rated satisfaction with analgesia as 90 (i.q.r. 80-100) of 100. After adjustment for confounders, opioid analgesia on discharge was independently associated with increased pain severity (risk ratio 1.52, 95% c.i. 1.31 to 1.76; P < 0.001) and re-presentation to healthcare providers owing to side-effects of medication (OR 2.38, 95% c.i. 1.36 to 4.17; P = 0.004), but not with satisfaction with analgesia (beta coefficient 0.92, 95% c.i. -1.52 to 3.36; P = 0.468) compared with opioid-free analgesia. Although opioid prescribing varied greatly between high-income and low- and middle-income countries, patient-reported outcomes did not.Conclusion: Opioid analgesia prescription on surgical discharge is associated with a higher risk of re-presentation owing to side-effects of medication and increased patient-reported pain, but not with changes in patient-reported satisfaction. Opioid-free discharge analgesia should be adopted routinely

Future Experiences: Sustainable Development and the Global South

The Sustainable Development and the Global South project was jointly conceived by the Innovation School at Glasgow School of Art in partnership with the Sustainable Futures in Africa Network (SFA), and the University of Glasgow. Graduating final year BDes Product Design students from the Innovation School were presented with a challenge-based project to produce a vision of the future based on current trends that relate to Sustainable Development work and the Global South. This project involved working closely with researchers, academics and professionals specialising in human geography, education, health, environment, engineering, cultural practice and community engagement who are part of the Sustainable Futures in Africa Network which includes a Scottish hub, led from the University of Glasgow. Included in the network was a representative from an NGO that builds schools in Malawi, an entrepreneur who runs an ethical clothing company that partners with producers in the Global South, a senior governance officer from the UK Government’s Department for International Development (DFID), a research network administrator, and international graduate students from Africa based at Scottish institutions. In addition to the SFA, external experts from design studio AndThen and GOODD design consultancy were engaged. The objective of this project was to investigate, in both analytical and speculative ways, future forms and functions of Sustainable Development work in relation to the Global South in ten years from now, to develop future scenarios and design the artefacts, services and the experiences associated with these future visions. On completion of the project and learning experience it was intended that the students would be able to recognise and articulate the impact and sustainability of their design propositions, consider the life-cycle of their proposals and the values these might create for the intended users, communities and contexts. The project was completed in January 2020, as the Covid-19 pandemic was just beginning its spread around the world. This unprecedented catastrophe reinforced the importance of supporting those most in need – the citizens of developing regions in the Global South. In April 2020, the heads of all the UN’s major agencies issued an open letter warning of the risks the virus posed to the world’s most vulnerable countries. It called on wealthier nations to increase funding and help to tackle issues such as the cessation of aid as a result of cancelled flights and disrupted supply routes. These and many other concerns highlighted during the crisis are among the topics explored in this project, which feels even more relevant and urgent than when it was initiated in the summer of 2019. One of the most significant societal shifts currently taking place within the field of sustainable development work is its transformation from being understood as a process of growth or, at its most benign, poverty alleviation, to one of community empowerment and civic participation. The public’s role is developing beyond once-passive community members and recipients of aid, into stakeholders valued for their local knowledge, lived experiences, participation in development projects, and contribution towards policy-making and decision-making. This new dynamic is changing the traditional North-South relationship and holds the potential to challenge the geopolitical hegemony of International Development. The impetus for this shift is a decolonial, collaborative approach to development, research and practice; increased local empowerment, and sustainable solutions to problems that are co-created in context with those affected by and affecting the issue in question. This project asked students to consider what happens in this global landscape ten years from now where Sustainable Development has evolved to the extent that new forms of work and communities of practice transform how people engage, learn and interact with each other, with stakeholders and with the global community around them. The brief gave students the opportunity to explore the underlying complexities regarding sustainable futures, the post-colonial dynamic between ‘norths’ and ‘souths’, post-capitalism and human agency, to envision a future world context, develop it as an experiential exhibit, and produce the designed products, services and experiences for the people who might live and work within it. The project was divided into two sections: The first was a collaborative stage where groups of students were assigned a specific domain to collectively research one aspect of the project challenge, these domains included; Health, Energy, Mobility, Economies, Education, Societal Structures and Environment. Each of these domains were examined through the lenses of Social, Technological, Economic, Ethical, Educational, Values, Political, Legal and Ecological (STEEEVPLE) and were tailored in use, as appropriate per domain. The groups focused on researching and exploring their specific domain and gathering as much information and understanding while working with the external experts to further their knowledge. This group stage culminated in a series of Future World exhibits which tangibly manifest the cohort’s collective knowledge and collaborative understanding of what the future could look like in 10 years from now, after exploring the possible consequences of current actions. The second stage saw students explore their individual response to the Future World that had been created in the first stage. Each student developed their own response to the research by iteratively creating a design outcome that was appropriate to the subject matter. This culminated in each student producing a designed product, service or system and a visual communication of the future experience which they had created. A visual summary of the journey and stages (Project Journey Map) is included within the repository and outlines the collaborative process of designing and the innovative nature of the project’s pedagogical model. The project aims to reveal and address the emerging possibilities collaboratively created by Sustainable Development professionals and designers interacting and learning from each other, to present preferable futures which reveal socio-ecological innovations in development work with the Global South in the near future. The deposited materials are arranged as follows: Readme files - two readme files relate to stage one and stage two of the project as outlined above. Project Journey Map - gives a visual overview of the pedagogical structure and timeline of the project. Data folders - the data folders for stage one of the project are named by the domains through which each group explored possible futures. The data folders for stage two of the project are named for the individual students who conducted the work

The James Webb Space Telescope Mission

Twenty-six years ago a small committee report, building on earlier studies, expounded a compelling and poetic vision for the future of astronomy, calling for an infrared-optimized space telescope with an aperture of at least $4m$. With the support of their governments in the US, Europe, and Canada, 20,000 people realized that vision as the $6.5m$ James Webb Space Telescope. A generation of astronomers will celebrate their accomplishments for the life of the mission, potentially as long as 20 years, and beyond. This report and the scientific discoveries that follow are extended thank-you notes to the 20,000 team members. The telescope is working perfectly, with much better image quality than expected. In this and accompanying papers, we give a brief history, describe the observatory, outline its objectives and current observing program, and discuss the inventions and people who made it possible. We cite detailed reports on the design and the measured performance on orbit.Comment: Accepted by PASP for the special issue on The James Webb Space Telescope Overview, 29 pages, 4 figure