176 research outputs found
Experimental demonstration of a suspended diffractively coupled optical cavity
All-reflective optical systems are under consideration for future gravitational wave detector topologies. One approach in proposed designs is to use diffraction gratings as input couplers for FabryâPerot cavities. We present an experimental demonstration of a fully suspended diffractively coupled cavity and investigate the use of conventional PoundâDreverâHall length sensing and control techniques to maintain the required operating condition
An investigation of eddy-current damping of multi-stage pendulum suspensions for use in interferometric gravitational wave detectors
In this article we discuss theoretical and experimental investigations of the use of eddy-current damping for multi-stage pendulum suspensions such as those intended for use in Advanced LIGO, the proposed upgrade to LIGO (the US laser interferometric gravitational-wave observatory). The design of these suspensions is based on the triple pendulum suspension design developed for GEO 600, the German/UK interferometric gravitational wave detector, currently being commissioned. In that detector all the low frequency resonant modes of the triple pendulums are damped by control systems using collocated sensing and feedback at the highest mass of each pendulum, so that significant attenuation of noise associated with this so-called local control is achieved at the test masses. To achieve the more stringent noise levels planned for Advanced LIGO, the GEO 600 local control design needs some modification. Here we address one particular approach, namely that of using eddy-current damping as a replacement or supplement to active damping for some or all of the modes of the pendulums. We show that eddy-current damping is indeed a practical alternative to the development of very low noise sensors for active damping of triple pendulums, and may also have application to the heavier quadruple pendulums at a reduced level of damping
Status of the GEO600 gravitational wave detector
The GEO600 laser interferometric gravitational wave detector is approaching the end of its commissioning phase which started in 1995.During a test run in January 2002 the detector was operated for 15 days in a power-recycled michelson configuration. The detector and environmental data which were acquired during this test run were used to test the data analysis code. This paper describes the subsystems of GEO600, the status of the detector by August 2002 and the plans towards the first science run
The Search for Gravitational Waves
Experiments aimed at searching for gravitational waves from astrophysical
sources have been under development for the last 40 years, but only now are
sensitivities reaching the level where there is a real possibility of
detections being made within the next five years. In this article a history of
detector development will be followed by a description of current detectors
such as LIGO, VIRGO, GEO 600, TAMA 300, Nautilus and Auriga. Preliminary
results from these detectors will be discussed and related to predicted
detection rates for some types of sources. Experimental challenges for detector
design are introduced and discussed in the context of detector developments for
the future.Comment: 21 pages, 7 figures, accepted J. Phys. B: At. Mol. Opt. Phy
The status of GEO 600
The GEO 600 laser interferometer with 600m armlength is part of a worldwide network of gravitational wave detectors. GEO 600 is unique in having advanced multiple pendulum suspensions with a monolithic last stage and in employing a signal recycled optical design. This paper describes the recent commissioning of the interferometer and its operation in signal recycled mode
Detector Description and Performance for the First Coincidence Observations between LIGO and GEO
For 17 days in August and September 2002, the LIGO and GEO interferometer
gravitational wave detectors were operated in coincidence to produce their
first data for scientific analysis. Although the detectors were still far from
their design sensitivity levels, the data can be used to place better upper
limits on the flux of gravitational waves incident on the earth than previous
direct measurements. This paper describes the instruments and the data in some
detail, as a companion to analysis papers based on the first data.Comment: 41 pages, 9 figures 17 Sept 03: author list amended, minor editorial
change
Scientific Objectives of Einstein Telescope
The advanced interferometer network will herald a new era in observational
astronomy. There is a very strong science case to go beyond the advanced
detector network and build detectors that operate in a frequency range from 1
Hz-10 kHz, with sensitivity a factor ten better in amplitude. Such detectors
will be able to probe a range of topics in nuclear physics, astronomy,
cosmology and fundamental physics, providing insights into many unsolved
problems in these areas.Comment: 18 pages, 4 figures, Plenary talk given at Amaldi Meeting, July 201
Setting upper limits on the strength of periodic gravitational waves from PSR J1939+2134 using the first science data from the GEO 600 and LIGO detectors
Data collected by the GEO 600 and LIGO interferometric gravitational wave detectors during their first observational science run were searched for continuous gravitational waves from the pulsar J1939+2134 at twice its rotation frequency. Two independent analysis methods were used and are demonstrated in this paper: a frequency domain method and a time domain method. Both achieve consistent null results, placing new upper limits on the strength of the pulsar's gravitational wave emission. A model emission mechanism is used to interpret the limits as a constraint on the pulsar's equatorial ellipticity
Searching for gravitational waves from known pulsars
We present upper limits on the amplitude of gravitational waves from 28
isolated pulsars using data from the second science run of LIGO. The results
are also expressed as a constraint on the pulsars' equatorial ellipticities. We
discuss a new way of presenting such ellipticity upper limits that takes
account of the uncertainties of the pulsar moment of inertia. We also extend
our previous method to search for known pulsars in binary systems, of which
there are about 80 in the sensitive frequency range of LIGO and GEO 600.Comment: Accepted by CQG for the proceeding of GWDAW9, 7 pages, 2 figure
A Joint Search for Gravitational Wave Bursts with AURIGA and LIGO
The first simultaneous operation of the AURIGA detector and the LIGO
observatory was an opportunity to explore real data, joint analysis methods
between two very different types of gravitational wave detectors: resonant bars
and interferometers. This paper describes a coincident gravitational wave burst
search, where data from the LIGO interferometers are cross-correlated at the
time of AURIGA candidate events to identify coherent transients. The analysis
pipeline is tuned with two thresholds, on the signal-to-noise ratio of AURIGA
candidate events and on the significance of the cross-correlation test in LIGO.
The false alarm rate is estimated by introducing time shifts between data sets
and the network detection efficiency is measured with simulated signals with
power in the narrower AURIGA band. In the absence of a detection, we discuss
how to set an upper limit on the rate of gravitational waves and to interpret
it according to different source models. Due to the short amount of analyzed
data and to the high rate of non-Gaussian transients in the detectors noise at
the time, the relevance of this study is methodological: this was the first
joint search for gravitational wave bursts among detectors with such different
spectral sensitivity and the first opportunity for the resonant and
interferometric communities to unify languages and techniques in the pursuit of
their common goal.Comment: 18 pages, IOP, 12 EPS figure
- âŠ