251 research outputs found
Comparison of near-interface traps in AlO/4H-SiC and AlO/SiO/4H-SiC structures
Aluminum oxide (Al2O3) has been grown by atomic layer deposition on n-type
4H-SiC with and without a thin silicon dioxide (SiO2) intermediate layer. By
means of Capacitance Voltage and Thermal Dielectric Relaxation Current
measurements, the interface properties have been investigated. Whereas for the
samples with an interfacial SiO2 layer the highest near-interface trap density
is found at 0.3 eV below the conduction band edge, Ec, the samples with only
the Al2O3 dielectric exhibit a nearly trap free region close to Ec. For the
Al2O3/SiC interface, the highest trap density appears between 0.4 to 0.6 eV
below Ec. The results indicate the possibility for SiC-based MOSFETs with Al2O3
as the gate dielectric layer in future high performance devices.Comment: 3 figures. Applied Physics Letters, accepted for publicatio
Properties of a radiation-induced charge multiplication region in epitaxial silicon diodes
Charge multiplication (CM) in pn epitaxial silicon pad diodes of 75, 100
and 150 \upmum thickness at high voltages after proton irradiation with 1 MeV
neutron equivalent fluences in the order of cm was studied as
an option to overcome the strong trapping of charge carriers in the innermost
tracking region of future Super-LHC detectors. Charge collection efficiency
(CCE) measurements using the Transient Current Technique (TCT) with radiation
of different penetration (670, 830, 1060 nm laser light and -particles
with optional absorbers) were used to locate the CM region close to the
p-implantation. The dependence of CM on material, thickness of the
epitaxial layer, annealing and temperature was studied. The collected charge in
the CM regime was found to be proportional to the deposited charge, uniform
over the diode area and stable over a period of several days. Randomly
occurring micro discharges at high voltages turned out to be the largest
challenge for operation of the diodes in the CM regime. Although at high
voltages an increase of the TCT baseline noise was observed, the
signal-to-noise ratio was found to improve due to CM for laser light. Possible
effects on the charge spectra measured with laser light due to statistical
fluctuations in the CM process were not observed. In contrast, the relative
width of the spectra increased in the case of -particles, probably due
to varying charge deposited in the CM region.Comment: 11 pages, accepted by NIM
Optoelectronic and stability properties of quasi-2D alkylammonium based perovskites
Electronic and stability properties of quasi-2D alkylammonium perovskites are
investigated using density functional theory (DFT) calculations and validated
experimentally on selected classes of compounds. Our analysis is focused on
perovskite structures of formula (A)(A)PbX, with
large cations A = butyl-, pentyl-, hexylammonium (BA, PA, HXA), small cations
A = methylammonium, formamidinium, ethylammonium, guanidinium (MA,FA,EA,GA)
and halogens X = I, Br, Cl. The role of the halogen ions is outlined for the
band structure, stability and defect formation energies. Two opposing trends
are found for the absorption efficiency versus stability, the latter being
assessed with respect to possible degradation mechanisms. Experimental
validation is performed on quasi-2D perovskites based on pentylammonium
cations, namely: (PA)PbX and (PA)(MA)PbX, synthesized by
antisolvent-assisted vapor crystallization. Structural and optical analysis are
inline with the DFT based calculations. In addition, the thermogravimetric
analysis shows an enhanced stability of bromide and chloride based compounds,
in agreement with the theoretical predictions.Comment: 8 pages, 8 figure
On the phase identity and its thermal evolution of lead free (Bi1/2Na1/2)TiO3-6 mol% BaTiO3
Temperature-dependent dielectric permittivity of 0.94(Bi1/2Na1/2) TiO3-0.06BaTiO(3) (BNT-6BT) lead-free piezoceramics was studied to disentangle the existing unclear issues over the crystallographic aspects and phase stability of the system. Application of existing phenomenological relaxor models enabled the relaxor contribution to the entire dielectric permittivity spectra to be deconvoluted. The deconvoluted data in comparison with the temperature-dependent dielectric permittivity of a classical perovskite relaxor, La-modified lead zirconate titanate, clearly suggest that BNT-6BT belongs to the same relaxor category, which was also confirmed by a comparative study on the temperature-dependent polarization hysteresis loops of both materials. Based on these results, we propose that the low-temperature dielectric anomaly does not involve any phase transition such as ferroelectric-toantiferroelectric. Supported by transmission electron microscopy and X-ray diffraction experiments at ambient temperature, we propose that the commonly observed two dielectric anomalies are attributed to thermal evolution of ferroelectric polar nanoregions of R3c and P4bm symmetry, which coexist nearly throughout the entire temperature range and reversibly transform into each other with temperature.open1128
Influence of long-range dipolar interactions on the phase stability and hysteresis shapes of ferroelectric and antiferroelectric multilayers
Phase transition and field driven hysteresis evolution of a two-dimensional Ising grid consisting of ferroelectric-antiferroelectric multilayers that take into account the long range dipolar interactions were simulated by a Monte-Carlo method. Simulations were carried out for a 1+1 bilayer and a 5+5 superlattice. Phase stabilities of components comprising the structures with an electrostatic-like coupling term were also studied. An electrostatic-like coupling, in the absence of an applied field, can drive the ferroelectric layers towards 180º domains with very flat domain interfaces mainly due to the competition between this term and the dipole-dipole interaction. The antiferroelectric layers do not undergo an antiferroelectric-to-ferroelectric transition under the influence of an electrostatic-like coupling between layers as the ferroelectric layer splits into periodic domains at the expense of the domain wall energy. The long-range interactions become significant near the interfaces. For high periodicity structures with several interfaces, the interlayer long-range interactions substantially impact the configuration of the ferroelectric layers while the antiferroelectric layers remain quite stable unless these layers are near the Neel temperature. In systems investigated with several interfaces, the hysteresis loops do not exhibit a clear presence of antiferroelectricity that could be expected in the presence of anti-parallel dipoles, i. e., the switching takes place abruptly. Some recent experimental observations in ferroelectric-antiferroelectric multilayers are discussed where we conclude that the different electrical properties of bilayers and superlattices are not only due to strain effects alone but also long-range interactions. The latter manifests itself particularly in superlattices where layers are periodically exposed to each other at the interfaces
Genomic classifier for guiding treatment of intermediate-risk prostate cancers to dose-escalated image-guided radiotherapy without hormone therapy
Cryo-EM structure of a helicase loading intermediate containing ORC-Cdc6-Cdt1-MCM2-7 bound to DNA
In eukaryotes, the Cdt1-bound replicative helicase core MCM2-7 is loaded onto DNA by the ORC-Cdc6 ATPase to form a prereplicative complex (pre-RC) with an MCM2-7 double hexamer encircling DNA. Using purified components in the presence of ATP-γS, we have captured in vitro an intermediate in pre-RC assembly that contains a complex between the ORC-Cdc6 and Cdt1-MCM2-7 heteroheptamers called the OCCM. Cryo-EM studies of this 14-subunit complex reveal that the two separate heptameric complexes are engaged extensively, with the ORC-Cdc6 N-terminal AAA+ domains latching onto the C-terminal AAA+ motor domains of the MCM2-7 hexamer. The conformation of ORC-Cdc6 undergoes a concerted change into a right-handed spiral with helical symmetry that is identical to that of the DNA double helix. The resulting ORC-Cdc6 helicase loader shows a notable structural similarity to the replication factor C clamp loader, suggesting a conserved mechanism of action
Estimating Loss to Follow-Up in HIV-Infected Patients on Antiretroviral Therapy: The Effect of the Competing Risk of Death in Zambia and Switzerland
BACKGROUND:
Loss to follow-up (LTFU) is common in antiretroviral therapy (ART) programmes. Mortality is a competing risk (CR) for LTFU; however, it is often overlooked in cohort analyses. We examined how the CR of death affected LTFU estimates in Zambia and Switzerland.
METHODS AND FINDINGS:
HIV-infected patients aged ≥18 years who started ART 2004-2008 in observational cohorts in Zambia and Switzerland were included. We compared standard Kaplan-Meier curves with CR cumulative incidence. We calculated hazard ratios for LTFU across CD4 cell count strata using cause-specific Cox models, or Fine and Gray subdistribution models, adjusting for age, gender, body mass index and clinical stage. 89,339 patients from Zambia and 1,860 patients from Switzerland were included. 12,237 patients (13.7%) in Zambia and 129 patients (6.9%) in Switzerland were LTFU and 8,498 (9.5%) and 29 patients (1.6%), respectively, died. In Zambia, the probability of LTFU was overestimated in Kaplan-Meier curves: estimates at 3.5 years were 29.3% for patients starting ART with CD4 cells <100 cells/µl and 15.4% among patients starting with ≥350 cells/µL. The estimates from CR cumulative incidence were 22.9% and 13.6%, respectively. Little difference was found between naïve and CR analyses in Switzerland since only few patients died. The results from Cox and Fine and Gray models were similar: in Zambia the risk of loss to follow-up and death increased with decreasing CD4 counts at the start of ART, whereas in Switzerland there was a trend in the opposite direction, with patients with higher CD4 cell counts more likely to be lost to follow-up.
CONCLUSIONS:
In ART programmes in low-income settings the competing risk of death can substantially bias standard analyses of LTFU. The CD4 cell count and other prognostic factors may be differentially associated with LTFU in low-income and high-income settings
Analysis and design of randomised clinical trials involving competing risks endpoints
<p>Abstract</p> <p>Background</p> <p>In randomised clinical trials involving time-to-event outcomes, the failures concerned may be events of an entirely different nature and as such define a classical competing risks framework. In designing and analysing clinical trials involving such endpoints, it is important to account for the competing events, and evaluate how each contributes to the overall failure. An appropriate choice of statistical model is important for adequate determination of sample size.</p> <p>Methods</p> <p>We describe how competing events may be summarised in such trials using cumulative incidence functions and Gray's test. The statistical modelling of competing events using proportional cause-specific and subdistribution hazard functions, and the corresponding procedures for sample size estimation are outlined. These are illustrated using data from a randomised clinical trial (SQNP01) of patients with advanced (non-metastatic) nasopharyngeal cancer.</p> <p>Results</p> <p>In this trial, treatment has no effect on the competing event of loco-regional recurrence. Thus the effects of treatment on the hazard of distant metastasis were similar via both the cause-specific (unadjusted <it>csHR </it>= 0.43, 95% CI 0.25 - 0.72) and subdistribution (unadjusted <it>subHR </it>0.43; 95% CI 0.25 - 0.76) hazard analyses, in favour of concurrent chemo-radiotherapy followed by adjuvant chemotherapy. Adjusting for nodal status and tumour size did not alter the results. The results of the logrank test (<it>p </it>= 0.002) comparing the cause-specific hazards and the Gray's test (<it>p </it>= 0.003) comparing the cumulative incidences also led to the same conclusion. However, the subdistribution hazard analysis requires many more subjects than the cause-specific hazard analysis to detect the same magnitude of effect.</p> <p>Conclusions</p> <p>The cause-specific hazard analysis is appropriate for analysing competing risks outcomes when treatment has no effect on the cause-specific hazard of the competing event. It requires fewer subjects than the subdistribution hazard analysis for a similar effect size. However, if the main and competing events are influenced in opposing directions by an intervention, a subdistribution hazard analysis may be warranted.</p
- …