Atomic hydrogen maser active oscillator cavity and bulb design optimization

The performance characteristics and reliability of the active oscillator atomic hydrogen maser depend upon oscillation parameters which characterize the interaction region of the maser, the resonant cavity and atom storage bulb assembly. With particular attention to use of the cavity frequency switching servo (1) to reduce cavity pulling, it is important to maintain high oscillation level, high atomic beam flux utilization efficiency, small spin exchange parameter and high cavity quality factor. It is also desirable to have a small and rigid cavity and bulb structure and to minimize the cavity temperature sensitivity. Curves for a novel hydrogen maser cavity configuration which is partially loaded with a quartz dielectric cylinder and show the relationships between cavity length, cavity diameter, bulb size, dielectric thickness, cavity quality factor, filling factor and cavity frequency temperature coefficient are presented. The results are discussed in terms of improvement in maser performance resulting from particular design choices

An ellipsometer with variable angle of incidence for studies in ultrahigh vacuum

The windows for the vacuum chamber are incorporated into the optical bench system by means of flexible bellows which allow measurements to be made over a large range of angle of incidence, one of which is chosen so that maximum sensitivity is obtained. The principal angle of incidence was determined, and straightforward corrections for strain birefringence of vacuum chamber windows were made. Atomically clean surfaces of sodium chloride and lithium fluoride were investigated to verify the performance of the system. Submonolayer and monolayer coverage of water on these surfaces could be detected. On cleavage planes of NaCl, a first monolayer of adsorbed water is complete at about one torr only

Three years of greenhouse gas column-averaged dry air mole fractions retrieved from satellite – Part 2: Methane

Carbon dioxide (CO2) and methane (CH4) are the two most important anthropogenic greenhouse gases. SCIAMACHY on ENVISAT is the first satellite instrument whose measurements are sensitive to concentration changes of the two gases at all altitude levels down to the Earth's surface where the source/sink signals are largest. We have processed three years (2003–2005) of SCIAMACHY near-infrared nadir measurements to simultaneously retrieve vertical columns of CO2 (from the 1.58 µm absorption band), CH4 (1.66 µm) and oxygen (O2 A-band at 0.76 µm) using the scientific retrieval algorithm WFM-DOAS. We show that the latest version of WFM-DOAS, version 1.0, which is used for this study, has been significantly improved with respect to its accuracy compared to the previous versions while essentially maintaining its high processing speed (~1 min per orbit, corresponding to ~6000 single measurements, and per gas on a standard PC). The greenhouse gas columns are converted to dry air column-averaged mole fractions, denoted XCO2 (in ppm) and XCH4 (in ppb), by dividing the greenhouse gas columns by simultaneously retrieved dry air columns. For XCO2 dry air columns are obtained from the retrieved O2 columns. For XCH4 dry air columns are obtained from the retrieved CO2 columns because of better cancellation of light path related errors compared to using O2 columns retrieved from the spectrally distant O2 A-band. Here we focus on a discussion of the XCH4 data set. The XCO2 data set is discussed in a separate paper (Part 1). For 2003 we present detailed comparisons with the TM5 model which has been optimally matched to highly accurate but sparse methane surface observations. After accounting for a systematic low bias of ~2% agreement with TM5 is typically within 1–2%. We investigated to what extent the SCIAMACHY XCH4 is influenced by the variability of atmospheric CO2 using global CO2 fields from NOAA's CO2 assimilation system CarbonTracker. We show that the CO2 corrected and uncorrected XCH4 spatio-temporal pattern are very similar but that agreement with TM5 is better for the CarbonTracker CO2 corrected XCH4. In line with previous studies (e.g., Frankenberg et al., 2005b) we find higher methane over the tropics compared to the model. We show that tropical methane is also higher when normalizing the CH4 columns with retrieved O2 columns instead of CO2. In consistency with recent results of Frankenberg et al. (2008b) it is shown that the magnitude of the retrieved tropical methane is sensitive to the choice of the spectroscopic line parameters of water vapour. Concerning inter-annual variability we find similar methane spatio-temporal pattern for 2003 and 2004. For 2005 the retrieved methane shows significantly higher variability compared to the two previous years, most likely due to somewhat larger noise of the spectral measurement

The microfoundations of audit quality

The three essays collected in this dissertation relate to the microfoundations of audit quality. The first essay shows how auditors prioritize easy tasks and how this affects their judgment performance, and by extension audit quality. The second essay deals with how auditors learn in the workplace. The third essay investigates how auditors’ usage of automated tools and techniques affects their professional skepticism. Together, these essays shed light on how individual auditor behaviors, judgments, and decision-making can impact audit quality. By examining auditing from an operational perspective, these findings provide a more realistic understanding of the complexities of modern audit engagements and shed light on the microfoundations of audit quality. As regulators and policymakers continue to express concerns about audit quality, these studies offer actionable interventions that can help improve audit quality.<br/

Characterizations of linear sufficient statistics

A surjective bounded linear operator T from a Banach space X to a Banach space Y must be a sufficient statistic for a dominated family of probability measures defined on the Borel sets of X. These results were applied, so that they characterize linear sufficient statistics for families of the exponential type, including as special cases the Wishart and multivariate normal distributions. The latter result was used to establish precisely which procedures for sampling from a normal population had the property that the sample mean was a sufficient statistic

2015 researcher's mini-symposium

Postgraduate researchers from the Faculties of Science, Engineering, Medicine & Surgery and Health Sciences gathered for a forum to present their research interests. The symposium was held in the afternoon of 30 January 2015 in the Engineering Lecture Theatre. The symposium promoted multi-disciplinary networking between various university faculties. Participants were invited based on research topic diversity and gender balance.peer-reviewe

Educational Software for Rating and Sizing Chemical Reactors

An educational software for Rating and Sizing Chemical Reactors is presented in this work. The user-friendly software designed using C# is presented in a step-by-step, simple-to-follow format. Design equations are analyzed for batch and flow reactors. Having been tested with sample problems from relevant literatures, it is believed that it can serve as an important tool in solving chemical Reaction Engineering problems. Results obtained show a high level of accuracy, although with slight differences from that obtained in the literature. This can be attributed to truncation errors when using manual calculation method