767 research outputs found
High-Pressure Amorphous Nitrogen
The phase diagram and stability limits of diatomic solid nitrogen have been
explored in a wide pressure--temperature range by several optical spectroscopic
techniques. A newly characterized narrow-gap semiconducting phase has
been found to exist in a range of 80--270 GPa and 10--510 K. The vibrational
and optical properties of the phase produced under these conditions
indicate that it is largely amorphous and back transforms to a new molecular
phase. The band gap of the phase is found to decrease with pressure
indicating possible metallization by band overlap above 280 GPa.Comment: 5 pages, 4 figure
Beitrag zum Problem der heterosynaptischen Facilitation in Aplysia californica
1. Heterosynaptic facilitation (H.S.F.) of single neurons in the central nervous system of Aplysia can be repeated virtually indefinitely, provided sufficient time is allowed for recovery between the trials.Peer Reviewedhttp://deepblue.lib.umich.edu/bitstream/2027.42/47439/1/424_2004_Article_BF00362956.pd
Optical properties of MgH2 measured in situ in a novel gas cell for ellipsometry/spectrophotometry
The dielectric properties of alpha-MgH2 are investigated in the photon energy
range between 1 and 6.5 eV. For this purpose, a novel sample configuration and
experimental setup are developed that allow both optical transmission and
ellipsometric measurements of a transparent thin film in equilibrium with
hydrogen. We show that alpha-MgH2 is a transparent, colour neutral insulator
with a band gap of 5.6 +/- 0.1 eV. It has an intrinsic transparency of about
80% over the whole visible spectrum. The dielectric function found in this work
confirms very recent band structure calculations using the GW approximation by
Alford and Chou [J.A. Alford and M.Y. Chou (unpublished)]. As Pd is used as a
cap layer we report also the optical properties of PdHx thin films.Comment: REVTeX4, 15 pages, 12 figures, 5 table
Comparative study of the structural and optical properties of epitaxial CuFeO2 and CuFe1−xGaxO2 delafossite thin films grown by pulsed laser deposition methods
This paper was accepted for publication in the journal Thin Solid Films and the definitive published version is available at http://dx.doi.org/10.1016/j.tsf.2017.02.005Three samples of epitaxial delafossite CuFeO2 and CuFe1 − xGaxO2 films were grown using Pulsed Laser Deposition techniques in high vacuum. The sample thicknesses were estimated to be 21 nm, 75 nm for the CuFeO2 films and ~ 37 nm for the composite sample containing gallium. The estimated gallium fraction of substituted ferric atoms was x = 0.25 for the composite sample. We present the study of the fundamental band gap(s) for each sample via observation of their respective optical absorption properties in the NIR-VIS region using transmittance and diffuse reflection spectroscopy. Predominant absorption edges measured at 1.1 eV and 2.1 eV from transmittance spectra were observed for the CuFeO2 samples. The sample of CuFe1 − xGaxO2 showed a measurable shift to 1.5 eV of the lower band-gap and a strong absorption edge located at 2.3 eV attributed to direct band to band transitions. This study also found evidence of changes between apparent absorption edges between transmittance and diffuse reflectance spectroscopies of each sample and it may be resultant from absorption channels via surface states
Energy band diagram of device-grade silicon nanocrystals
This work was supported by the EPSRC (EP/K022237/1) and the Leverhulme International Network (IN-2012-136). SA would like to acknowledge the support of the Ulster University Vice-Chancellor's Research Studentship and CR that of the NI-DEL studentship.Device grade silicon nanocrystals (NCs) are synthesized using an atmospheric-pressure plasma technique. The Si NCs have a small and well defined size of about 2.3 nm. The synthesis system allows for the direct creation of thin films, enabling a range of measurements to be performed and easy implementation of this material in different devices. The chemical stability of the Si NCs is evaluated, showing relatively long-term durability thanks to hydrogen surface terminations. Optical and electrical characterization techniques, including Kelvin probe, ultraviolet photoemission spectroscopy and Mott-Schottky analysis, are employed to determine the energy band diagram of the Si NCs.Publisher PDFPeer reviewe
Effect of iodine incorporation on characteristic properties of cadmium telluride deposited in aqueous solution
The electrodeposition of polycrystalline I-doped CdTe was successfully performed from aqueous solutions containing cadmium nitrate (Cd(NO3)2 and tellurium oxide (TeO2). The effects of different I-doping concentrations in the electrolytic bath on the deposited CdTe layers deposited were evaluated structurally, optically, morphologically and electronically using X-ray diffraction (XRD), ultraviolet-visible spectrophotometry, scanning electron microscopy, photoelectrochemical cell measurement and direct-current (DC) conductivity test respectively. The XRD show reduction in the (111) cubic CdTe peak intensity and the calculated crystallite size of the CdTe:I layers above 5 ppm I-doping. At I-doping of 1000 ppm of the CdTe-bath and above, the deposition of only crystalline Te due to the formation of Cd-I complexes debarring the deposition of Cd and co-deposition of CdTe in aqueous solution was observed. Morphologically, reductions in grain size were observed above 5 ppm I-doping with high pinhole density and the formation of cracks within the CdTe:I layers. For the as-deposited CdTe:I layers, conduction type remained n-type across all the explored I-doping concentration of 200 ppm. For the CdCl2 and Ga2(SO4)2+CdCl2 treated CdTe:I layers, the transition from n- to p-type conductivity was observed for the CdTe:I baths doped with 20 ppm and above due to the reduced cadmium deposition on the substrate. The highest conductivity was observed at 5 ppm I-doping of the CdTe-bath. Observations made on the CdTe:I in aqueous solution differs from the non-aqueous solvent documented in the literature. These results are reported systematically in this communication
Intense violet–blue emission and paramagnetism of nanocrystalline Gd3+ doped ZnO ceramics
Nanocrystalline Zn1-xGdxO (x = 0, 0.02, 0.04, 0.06, and 0.08) ceramics were synthesized by ball milling and subsequent solid-state reaction. The transmission electron microscopy (TEM) micrograph of as synthesized samples revealed the formation of crystallites with an average diameter of 60 nm, and the selected area electron diffraction (SAED) pattern confirmed the formation of wurtzite structure. A red shift in the band gap was observed with increasing Gd3+ concentration. The photoluminescence of nanocrystalline Gd3+ doped ZnO exhibited a strong violet–blue emission. Concentration dependence of the emission intensity of Gd3+ in ZnO was studied, and the critical concentration was found to be 4 mol% of Gd3+. The Gd3+ doped ZnO exhibited paramagnetic behavior at room temperature, and the magnetic moment increased with Gd3+ concentration
Hydrogen-doped Brookite TiO2 Nanobullets Array as a Novel Photoanode for Efficient Solar Water Splitting
As a representative photocatalyst for photoelectrochemical solar water splitting, TiO2 has been intensively studied but most researches have focused on the rutile and anatsase phases because brookite, another important crystalline polymorph of TiO2, rarely exists in nature and is difficult to synthesize. In this work, hydrogen doped brookite (H:brookite) nanobullet arrays were synthesized via a well-designed solution reaction for the first time. H:brookite shows highly improved PEC properties with excellent stability, enhanced photocurrent, and significantly high Faradaic efficiency for overall solar water splitting. To support the experimental data, ab initio density functional theory calculations were also conducted. At the interstitial doping site that has minimum formation energy, the hydrogen atoms act as shallow donors and exist as H+. which has the minimum formation energy among three states of hydrogen (H+. H0, and H-). The calculated density of states of H:brookite shows a narrowed bandgap and an increased electron density compared to the pristine brookite. The combined experimental and theoretical results provide frameworks for the exploration of the PEC properties of doped brookite and extend our knowledge regarding the undiscovered properties of brookite of TiO2.ope
- …