Influence of annealing parameters on the ferromagnetic properties of optimally passivated (Ga,Mn)As epilayers

The influence of annealing parameters - temperature and time - on the magnetic properties of As-capped (Ga,Mn)As epitaxial thin films have been investigated. The dependence of the transition temperature (Tc) on annealing time marks out two regions. The Tc peak behavior, characteristic of the first region, is more pronounced for thick samples, while for the second (`saturated') region the effect of the annealing time is more pronounced for thin samples. A right choice of the passivation medium, growth conditions along with optimal annealing parameters routinely yield Tc-values of ~ 150 K and above, regardless of the thickness of the epilayers.Comment: 5 pages, 3 figure

Electronic structure and chemical bonding in Ti2AlC investigated by soft x-ray emission spectroscopy

The electronic structure of the nanolaminated transition metal carbide Ti2AlC has been investigated by bulk-sensitive soft x-ray emission spectroscopy. The measured Ti L, C K and Al L emission spectra are compared with calculated spectra using ab initio density-functional theory including dipole matrix elements. The detailed investigation of the electronic structure and chemical bonding provides increased understanding of the physical properties of this type of nanolaminates. Three different types of bond regions are identified; the relatively weak Ti 3d - Al 3p hybridization 1 eV below the Fermi level, and the Ti 3d - C 2p and Ti 3d - C 2s hybridizations which are stronger and deeper in energy are observed around 2.5 eV and 10 eV below the Fermi level, respectively. A strongly modified spectral shape of the 3s final states in comparison to pure Al is detected for the buried Al monolayers indirectly reflecting the Ti 3d - Al 3p hybridization. The differences between the electronic and crystal structures of Ti2AlC, Ti3AlC2 and TiC are discussed in relation to the number of Al layers per Ti layer in the two former systems and the corresponding change of the unusual materials properties.Comment: 14 pages, 7 figures; PACS:78.70.En, 71.15.Mb, 71.20.-

Electronic structure and chemical bonding in Ti4SiC3 investigated by soft x-ray emission spectroscopy and first principle theory

The electronic structure in the new transition metal carbide Ti4SiC3 has been investigated by bulk-sensitive soft x-ray emission spectroscopy and compared to the well-studied Ti3SiC2 and TiC systems. The measured high-resolution Ti L, C K and Si L x-ray emission spectra are discussed with ab initio calculations based on density-functional theory including core-to-valence dipole matrix elements. The detailed investigations of the Ti-C and Ti-Si chemical bonds provide increased understanding of the physical properties of these nanolaminates. A strongly modified spectral shape is detected for the buried Si monolayers due to Si 3p hybridization with the Ti 3d orbitals. As a result of relaxation of the crystal structure and the charge-transfer from Ti (and Si) to C, the strength of the Ti-C covalent bond is increased. The differences between the electronic and crystal structures of Ti4SiC3 and Ti3SiC2 are discussed in relation to the number of Si layers per Ti layer in the two systems and the corresponding change of materials properties.Comment: 12 pages, 7 figures, 1 tabl

Electronic structure investigation of Ti3AlC2, Ti3SiC2, and Ti3GeC2 by soft-X-ray emission spectroscopy

The electronic structures of epitaxially grown films of Ti3AlC2, Ti3SiC2 and Ti3GeC2 have been investigated by bulk-sensitive soft X-ray emission spectroscopy. The measured high-resolution Ti L, C K, Al L, Si L and Ge M emission spectra are compared with ab initio density-functional theory including core-to-valence dipole matrix elements. A qualitative agreement between experiment and theory is obtained. A weak covalent Ti-Al bond is manifested by a pronounced shoulder in the Ti L-emission of Ti3AlC2. As Al is replaced with Si or Ge, the shoulder disappears. For the buried Al and Si-layers, strongly hybridized spectral shapes are detected in Ti3AlC2 and Ti3SiC2, respectively. As a result of relaxation of the crystal structure and the increased charge-transfer from Ti to C, the Ti-C bonding is strengthened. The differences between the electronic structures are discussed in relation to the bonding in the nanolaminates and the corresponding change of materials properties.Comment: 15 pages, 8 figure

Understanding and protecting vulnerable financial consumers

This article considers how consumer protection law and policy should address the interests of particularly vulnerable financial consumers. Specifically, the article proposes a taxonomy of vulnerability which helps to identify (a) what makes consumers particularly vulnerable, and (b) how consumer protection law and consumer policy (broadly understood) can respond to these causes in a way that provides such consumers with appropriate protection. Changes to economic conditions, legal requirements on traders and our understanding of consumer behaviour make discussion of these issues particularly topical. There is little doubt that finding solutions is extremely difficult. Trade-offs are necessary and some enduring factors that contribute to vulnerability, in particular poverty, sometimes appear intractable. Nevertheless, it is submitted that by identifying clearly both why consumers are vulnerable and how the factors that lead to such vulnerability can be addressed, it is possible to construct an environment which respects consumer choice while ensuring that the most vulnerable are protected appropriately

Results from the CERN pilot CLOUD experiment

During a 4-week run in October–November 2006, a pilot experiment was performed at the CERN Proton Synchrotron in preparation for the Cosmics Leaving OUtdoor Droplets (CLOUD) experiment, whose aim is to study the possible influence of cosmic rays on clouds. The purpose of the pilot experiment was firstly to carry out exploratory measurements of the effect of ionising particle radiation on aerosol formation from trace H2SO4 vapour and secondly to provide technical input for the CLOUD design. A total of 44 nucleation bursts were produced and recorded, with formation rates of particles above the 3 nm detection threshold of between 0.1 and 100 cm−3 s−1, and growth rates between 2 and 37 nm h−1. The corresponding H2SO4 concentrations were typically around 106 cm−3 or less. The experimentally-measured formation rates and H2SO4 concentrations are comparable to those found in the atmosphere, supporting the idea that sulphuric acid is involved in the nucleation of atmospheric aerosols. However, sulphuric acid alone is not able to explain the observed rapid growth rates, which suggests the presence of additional trace vapours in the aerosol chamber, whose identity is unknown. By analysing the charged fraction, a few of the aerosol bursts appear to have a contribution from ion-induced nucleation and ion-ion recombination to form neutral clusters. Some indications were also found for the accelerator beam timing and intensity to influence the aerosol particle formation rate at the highest experimental SO2 concentrations of 6 ppb, although none was found at lower concentrations. Overall, the exploratory measurements provide suggestive evidence for ion-induced nucleation or ion-ion recombination as sources of aerosol particles. However in order to quantify the conditions under which ion processes become significant, improvements are needed in controlling the experimental variables and in the reproducibility of the experiments. Finally, concerning technical aspects, the most important lessons for the CLOUD design include the stringent requirement of internal cleanliness of the aerosol chamber, as well as maintenance of extremely stable temperatures (variations below 0.1 _C)

Are female students in general and nursing students more ready for teamwork and interprofessional collaboration in healthcare?

<p>Abstract</p> <p>Background</p> <p>Interprofessional Education (IPE) is now spreading worldwide and many universities are now including IPE in their curricula. The aim of this study was to investigate whether or not such student characteristics as gender, previous working experience in healthcare, educational progress and features of the learning environment, such as educational programmes and curriculum design, have an impact on their open-mindedness about co-operation with other professions.</p> <p>Methods</p> <p>Medical and nursing students at two Swedish universities were invited to fill in the Readiness for Interprofessional Learning Scale (RIPLS). Totally, 955 students were invited and 70.2% (n = 670) participated in the study. A factor analysis of the RIPLS revealed four item groupings (factors) for our empirical data, but only one had sufficient internal consistency. This factor was labelled "Team Player".</p> <p>Results</p> <p>Regardless of the educational programme, female students were more positive to teamwork than male students. Nursing students in general displayed more positive beliefs about teamwork and collaboration than medical students. Exposure to different interprofessional curricula and previous exposure to interprofessional education were only to a minor extent associated with a positive attitude towards teamwork. Educational progress did not seem to influence these beliefs.</p> <p>Conclusions</p> <p>The establishment of interprofessional teamwork is a major challenge for modern healthcare. This study indicates some directions for more successful interprofessional education. Efforts should be directed at informing particularly male medical students about the need for teamwork in modern healthcare systems. The results also imply that study of other factors, such as the student's personality, is needed for fully understanding readiness for teamwork and interprofessional collaboration in healthcare. We also believe that the RIPL Scale still can be further adjusted.</p