Prevention of fish photobacteriosis. Comparison of the efficacy of intraperitoneally administered commercial and experimental vaccines

Two commercial multivalent vaccines against vibriosis, caused by Vibrio anguillarum serotype(s) and photobacteriosis, caused by Photobacterium damsela subsp. piscicida, one with oil adjuvant (AJ) and the other,being an aqueous solution (AV), and an experimental monovalent (Ph. damselae subsp. piscicida) vaccine inactivated with formalin or heat, namely EVF and EVH, were tested in laboratory trials on sea bass (Dicentrarchus labrax) in respect to their efficacy against experimentally induced photobacteriosis. The first trial aiming at high bacterial pressure was carried out 34 days post-vaccination and resulted in 90% mortalities in the control. The relative per cent survival (RPS) of vaccinated fish was calculated at 24, 3.7, 0 and 0 for the AJ, AV, EVF and EVH formulations, respectively. The second trial aiming at medium bacterial pressure was carried out 49 days post-vaccination and resulted in 45% mortalities in the control. The relative per cent survival (RPS) of vaccinated fish was calculated at 100, 92.7, 77.8 and 66.7 for the AJ, EVF, EVH and AV, formulations, respectively. Apparently, under both these high and medium bacterial pressure conditions, the commercial vaccine AJ performed better than the commercial vaccine AV, while under medium pressure there was no statistical difference between the performance of EVF and AJ. The measurement of specific antibody titers in sera collected from all fish groups 49 days post-vaccination, showed high levels in the fish vaccinated with the AJ vaccine, almost three times lower levels for the AV and EVF vaccines and even lower levels for the EVH vaccine. Results are discussed in respect to the choices mariculture companies have in selecting a commercial vaccine against photobacteriosis and possible alternatives, which, if commercially developed, may reduce vaccine cost

Temperature-ramped 129Xe spin-exchange optical pumping

We describe temperature-ramped spin-exchange optical pumping (TR-SEOP) in an automated high-throughput batch-mode 129Xe hyperpolarizer utilizing three key temperature regimes: (i) “hot”where the 129Xe hyperpolarization rate is maximal, (ii) “warm”-where the 129Xe hyperpolarization approaches unity, and (iii) “cool” where hyperpolarized 129Xe gas is transferred into a Tedlar bag with low Rb content (<5 ng per ∼1 L dose) suitable for human imaging applications. Unlike with the conventional approach of batch-mode SEOP, here all three temperature regimes may be operated under continuous high-power (170 W) laser irradiation, and hyperpolarized 129Xe gas is delivered without the need for a cryocollection step. The variable-temperature approach increased the SEOP rate by more than 2-fold compared to the constant-temperature polarization rate (e.g., giving effective values for the exponential buildup constant γSEOP of 62.5 ± 3.7 × 10−3 min−1 vs 29.9 ± 1.2 × 10−3 min−1) while achieving nearly the same maximum %PXe value (88.0 ± 0.8% vs 90.1% ± 0.8%, for a 500 Torr (67 kPa) Xe cell loadingcorresponding to nuclear magnetic resonance/magnetic resonance imaging (NMR/MRI) enhancements of ∼3.1 × 105 and ∼2.32 × 108 at the relevant fields for clinical imaging and HP 129Xe production of 3 T and 4 mT, respectively); moreover, the intercycle “dead” time was also significantly decreased. The higher-throughput TR-SEOP approach can be implemented without sacrificing the level of 129Xe hyperpolarization or the experimental stability for automation-making this approach beneficial for improving the overall 129Xe production rate in clinical settings

Structural identification of Egnatia Odos bridges based on ambient and earthquake induced vibrations

The dynamic characteristics of two representative R/C bridges on Egnatia Odos motorway in Greece are estimated based on low amplitude ambient and earthquake-induced vibrations. The present work outlines the instrumentation details, algorithms for computing modal characteristics (modal frequencies, damping ratios and modeshapes), modal-based finite element model updating methods for estimating structural parameters, and numerical results for the modal and structural dynamic characteristics of the two bridges based on ambient and earthquake induced vibrations. Transverse, bending and longitudinal modes are reliably identified and stiffness-related properties of the piers, deck and elastomeric bearings of the finite element models of the two bridges are estimated. Results provide qualitative and quantitative information on the dynamic behavior of the bridge systems and their components under low-amplitude vibrations. Modeling assumptions are discussed based on the differences in the characteristics identified from ambient and earthquake vibration measurements. The sources of the differences observed between the identified modal and structural characteristics of the bridges and those predicted by finite element models used for design are investigated and properly justified

Silver nanowire networks: Physical properties and potential integration in solar cells

peer reviewedWith the growing interest in flexible electronics and the increased utilization of Indium Tin Oxide electrodes for display and photovoltaic applications the need for new materials is emerging. In this work we present the electro-optical properties of Ag nanowire networks as an alternative transparent conductive material. A comparison of different film deposition techniques is made and indicates that the properties of the network are independent of the fabrication method. Analysis of the electrical behavior as a function of nanowire density is made and compared with theoretical results as well as Monte Carlo simulations. Thermal annealing is shown to reduce the sheet resistance from 1000 Ω/sq to 8 Ω/sq; this reduction is achieved by local sintering of the nanowire junctions. Experimental optimization of Ag nanowire electrodes was undertaken and a peak in the electro-optical properties is observed at approximately 100 mg/m². Finally a discussion of the potential integration of Ag nanowire networks into solar cells is undertaken; we observe that these electrodes show promise as an emerging transparent conductive material, especially for flexible applications

Description of the Vitis vinifera L. phenotypic variability in eno-carpological traits by a Euro-Asiatic collaborative network among ampelographic collections

The grapevine intra-specific variability captured an increasing interest during the last decades, as demonstrated by the number of recently funded European projects focused on the grapevine biodiversity preservation. However, nowadays, crop plants are mainly characterized by genotyping methods. The present work summarizes the phenotype data collected among 20 ampelographic collections spread in 15 countries, covering mostly of the viticultural areas in the Euro-Asiatic range: from Portugal to Armenia and from Cyprus to Luxembourg. Together with agro-climatic characterization of the experimental site, in two years, about 2400 accessions were described, following a common experimental protocol mainly focused on the carpological and oenological traits, obtaining a general overview of the distribution of the considered phenotypic traits in the cultivated Vitis vinifera species. The most replicated cultivars were selected and, for the subset of these reference cultivars, their behavior in the different environmental conditions over sites and years was described by ANOVA methods

Description of the vitis vinifera L. Phenotypic variability in eno-carpological traits by a Euro-Asiatic collaborative network among ampelographic collections

The grapevine intra-specific variability captured an increasing interest during the last decades, as demonstrated by the number of recently funded European projects focused on the grapevine biodiversity preservation. However, nowadays, crop plants are mainly characterized by genotyping methods. The present work summarizes the phenotype data collected among 20 ampelographic collections spread over 15 countries, covering most of the viticultural areas in the Euro-Asiatic region: from Portugal to Armenia and from Cyprus to Luxembourg. Together with agro-climatic characterization of the experimental site, over two years about 2,400 accessions were described. A common experimental protocol mainly focused on the carpological and oe-nological traits was followed, obtaining a general overview of the distribution of the considered phenotypic traits in the cultivated Vitis vinifera species. The most replicated cultivars were selected and, for the subset of these reference cultivars, their behavior in the different environmental conditions over sites and years was described by ANOVA methods

Hsp90 orchestrates transcriptional regulation by Hsf1 and cell wall remodelling by MAPK signalling during thermal adaptation in a pathogenic yeast

Acknowledgments We thank Rebecca Shapiro for creating CaLC1819, CaLC1855 and CaLC1875, Gillian Milne for help with EM, Aaron Mitchell for generously providing the transposon insertion mutant library, Jesus Pla for generously providing the hog1 hst7 mutant, and Cathy Collins for technical assistance.Peer reviewedPublisher PD

Determination of chlorinated solvents in industrial water and wastewater by DAI–GC–ECD

A very simple and quick analytical method, based on direct aqueous injection, for determination of halogenated solvents in refinery water and wastewater, is described. There is a need to determine halogenated solvents in refinery water streams, because they may originate from several processes. There is also a need to develop methods enabling VOX to be determined in samples containing oil fractions. The method described enables simultaneous determination of 26 compounds with low detection limits (sub-μg L−1) and excellent precision, especially for highly halogenated solvents. The matrix effects of four types of sample were evaluated—the method seemed to be relatively insensitive to variations in matrix composition. Deuterated 1,2-dichloroethane was used as internal standard and surrogate compound in quantitative analysis; application of isotopically labelled compounds is rarely reported when non-mass spectrometric detectors are used for analysis. Analysis of real samples showed that the most frequently detected compounds were dichloromethane and 1,2-dichloroethane