Terahertz wave transmission in flexible polystyrene-lined hollow metallic waveguides for the 2.5-5 THz band.

A low-loss and low-dispersive optical-fiber-like hybrid HE11 mode is developed within a wide band in metallic hollow waveguides if their inner walls are coated with a thin dielectric layer. We investigate terahertz (THz) transmission losses from 0.5 to 5.5 THz and bending losses at 2.85 THz in a polystyrene-lined silver waveguides with core diameters small enough (1 mm) to minimize the number of undesired modes and to make the waveguide flexible, while keeping the transmission loss of the HE11 mode low. The experimentally measured loss is below 10 dB/m for 2 < ? < 2.85 THz (∼4-4.5 dB/m at 2.85 THz) and it is estimated to be below 3 dB/m for 3 < ? < 5 THz according to the numerical calculations. At ∼1.25 THz, the waveguide shows an absorption peak of ∼75 dB/m related to the transition between the TM11-like mode and the HE11 mode. Numerical modeling reproduces the measured absorption spectrum but underestimates the losses at the absorption peak, suggesting imperfections in the waveguide walls and that the losses can be reduced further. © 2013 Optical Society of America

Bias-correction in the CCAFS-Climate Portal: A description of methodologies

Global Climate Models (GCMs) have been the primary source of information for constructing climate scenarios, and they provide the basis for climate change impacts assessments of climate change at all scales, from local to global. However, impact studies rarely use GCM outputs directly because errors in GCM simulations relative to historical observations are large (Ramirez-Villegas et al. 2013), and because the spatial resolution is generally too coarse to satisfy the requirements for finer-scale impact studies. More specifically, the typical GCM spatial resolution (50 km or even more) is not practical for assessing agricultural landscapes, particularly in the tropics, where orographic and climatic conditions vary significantly across relatively small distances (Tabor & Williams, 2010). Hence, it is important to bias-correct and downscale the raw climate model outputs in order to produce climate projections that are better fit for agricultural modeling. Here we describe three different calibration approaches to produce reliable daily climate for future periods, employed in a new interface in CCAFS-Climate portal (www.ccafs-climate.org/data_bias_corrected/), as follows: (a) bias correction (or nudging) (Hawkins et al., 2013), (b) change factor (Hawkins et al., 2013) and (c) Quantile Mapping (Gudmundsson et al., 2012). In addition, briefly describe some observational datasets relevant to agricultural modeling and employed as the historical observations for the calibration methods mentioned here

Quantum Measurement and the Aharonov-Bohm Effect with Superposed Magnetic Fluxes

We consider the magnetic flux in a quantum mechanical superposition of two values and find that the Aharonov-Bohm effect interference pattern contains information about the nature of the superposition, allowing information about the state of the flux to be extracted without disturbance. The information is obtained without transfer of energy or momentum and by accumulated nonlocal interactions of the vector potential $\vec{A}$ with many charged particles forming the interference pattern, rather than with a single particle. We suggest an experimental test using already experimentally realized superposed currents in a superconducting ring and discuss broader implications.Comment: 6 pages, 4 figures; Changes from version 3: corrected typo (not present in versions 1 and 2) in Eq. 8; Changes from version 2: shortened abstract; added refs and material in Section IV. The final publication is available at: http://link.springer.com/article/10.1007/s11128-013-0652-

Quantitative evaluation of lateral forces on the patella: static and kinematic magnetic resonance imaging

OBJECTIVE: To evaluate the usefulness of combining static and kinematic magnetic resonance imaging in the evaluation of the femoropatellar joint. MATERIALS AND METHODS: Twenty healthy volunteers (40 knees) and 23 patients (43 knees) were submitted to both static and kinematic magnetic resonance imaging on a 1.5 tesla whole-body magnetic resonance scanner. The knees were positioned at 30º flexion with the quadrature knee coil at the inner end of the examination table. The patellar translation was evaluated by measurements of bisect offset, lateral patellar displacement and patellar tilt angle. The nonparametric Wilcoxon test was utilized for statistical analysis of data resulting from the static and kinematic studies in both groups. Nonparametric Mann-Whitney test was utilized in the comparison between healthy volunteers and patients. RESULTS: Statistical analysis demonstrated significant differences (p < 0.05) between static and kinematic magnetic resonance imaging for the three parameters evaluated in both groups. Among the patients the differences between static and kinematic measurements were greater than those found in the volunteers, at 30&deg; and 20&deg; flexion, with bisect offset and lateral patellar displacement. CONCLUSION: Static and kinematic magnetic resonance imaging, when performed in association, demonstrated that the lateral forces being exerted on the patella are higher at a knee flexion at the range between 20&deg; and 30&deg;, particularly in individuals symptomatic for femoropatellar instability.OBJETIVO: Avaliar a validade da ressonância magnética cinemática combinada com a ressonância magnética estática no estudo da articulação femoropatelar. MATERIAIS E MÉTODOS: Foram realizadas ressonância magnética estática e ressonância magnética cinemática em 20 voluntários assintomáticos (40 joelhos) e em 23 pacientes (43 joelhos), em aparelho de configuração fechada de 1,5 tesla de campo. Os indivíduos foram posicionados na extremidade da mesa, em 30&deg; de flexão. A translação patelar foi avaliada medindo-se o desvio da bissetriz, o deslocamento lateral da patela e o ângulo de inclinação da patela. Para a comparação entre os estudos estático e cinemático, foi utilizado o teste não-paramétrico de Wilcoxon. Para a comparação entre os voluntários e os pacientes, foi utilizado o teste de Mann-Whitney. RESULTADOS: Houve diferenças significantes entre a ressonância magnética estática e a ressonância magnética cinemática (p < 0,05) nos três parâmetros utilizados. No grupo dos pacientes, as diferenças entre a ressonância magnética estática e a ressonância magnética cinemática foram maiores que nos voluntários a 20&deg; e a 30&deg; de flexão, com o desvio da bissetriz e com o deslocamento lateral da patela. CONCLUSÃO: A combinação da ressonância magnética estática e ressonância magnética cinemática evidenciou que a força resultante lateral é maior na faixa de 20&deg; e 30&deg; de flexão, especialmente nos indivíduos sintomáticos, para a instabilidade femoropatelar.Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)Universidade Federal de São Paulo (UNIFESP) Escola Paulista de Medicina Departamento de Diagnóstico por ImagemSociedade Brasileira de Ortopedia e TraumatologiaUniversidade Federal de São Paulo (UNIFESP) Escola Paulista de Medicina Departamento de Ortopedia e TraumatologiaUniversidade Federal de São Paulo (UNIFESP) Escola Paulista de Medicina Departamento de Medicina Preventiva e BioestatísticaUNIFESP, EPM, Depto. de Diagnóstico por ImagemUNIFESP, EPM, Depto. de Ortopedia e TraumatologiaUNIFESP, EPM, Depto. de Medicina Preventiva e BioestatísticaSciEL

The inevitable youthfulness of known high-redshift radio galaxies

Radio galaxies can be seen out to very high redshifts, where in principle they can serve as probes of the early evolution of the Universe. Here we show that for any model of radio-galaxy evolution in which the luminosity decreases with time after an initial rapid increase (that is, essentially all reasonable models), all observable high-redshift radio-galaxies must be seen when the lobes are less than 10^7 years old. This means that high-redshift radio galaxies can be used as a high-time-resolution probe of evolution in the early Universe. Moreover, this result helps to explain many observed trends of radio-galaxy properties with redshift [(i) the `alignment effect' of optical emission along radio-jet axes, (ii) the increased distortion in radio structure, (iii) the decrease in physical sizes, (iv) the increase in radio depolarisation, and (v) the increase in dust emission] without needing to invoke explanations based on cosmology or strong evolution of the surrounding intergalactic medium with cosmic time, thereby avoiding conflict with current theories of structure formation.Comment: To appear in Nature. 4 pages, 2 colour figures available on request. Also available at http://www-astro.physics.ox.ac.uk/~km

Thermal energy storage of molten salt–based nanofluid containing nano-encapsulated metal alloy phase change materials

The availability of Thermal Energy Storage systems in Concentrated Solar Power plants makes them suitable to handle the gap between energy supply and power demand. Increasing the total thermal energy storage capacity of the Thermal Energy Storage materials used is of interest to improve their efficiency. In this work the thermal energy storage of the so called solar salt (60% NaNO₃ - 40% KNO₃) was improved by adding a phase change material composed of Al-Cu alloy nanoencapsulated with an aluminium oxide layer naturally formed when exposed to oxygen. The resistance of the oxide shell to thermal cycling up to 570 °C and its compatibility with the molten salt were proved. The specific heat and the total thermal energy storage were evaluated at different solid mass loads. Although the specific heat and thus the sensible heat storage decreases with solid content, the contribution of the phase change enthalpy and the latent heat storage can increase the total thermal energy storage up to a 17.8% at constant volume basis comparison. Besides, the thermal conductivity of the nanofluid was increased when adding the nanoparticles improving its heat transfer performance under some particular conditions

Ten-year survival of ART restorations in permanent posterior teeth

This study evaluated the 10-year clinical performance of high-viscosity glass-ionomer cement placed in posterior permanent teeth by means of the Atraumatic Restorative Treatment (ART) approach. One operator placed 167 single- and 107 multiple-surface restorations in 43 high-risk caries pregnant women (mean decayed teeth = 9.8 ± 5.5). Examinations were performed at 1-, 2-, and 10-year intervals according to ART criteria. In the last evaluation, the US Public Health Service (USPHS) criteria were also used. After 10 years, 129 restorations (47.1%) were evaluated and achieved a cumulative survival rate of 49.0% (SE 7.2%). The 10-year survival of single- and multiple-surface ART restorations assessed using the ART criteria were 65.2% (SE 7.3%) and 30.6% (SE 9.9%), respectively. This difference was significant (jackknife SE of difference; p < 0.05). Using the USPHS criteria, the 10-year survival of single- and multiple-surface ART restorations were 86.5% and 57.6%, respectively. The primary causes of failure were total loss (9.3%) and marginal defects (5.4%). The survival rates observed, especially for the single-surface restorations, confirm the potential of the ART approach for restoring and saving posterior permanent teeth

Body composition, nutritional profile and muscular fitness affect bone health in a sample of schoolchildren from Colombia: The Fuprecol Study

This is the final version of the article. Available from the publisher via the DOI in this record.The objective of the present study is to investigate the relationships between body composition, nutritional profile, muscular fitness (MF) and bone health in a sample of children and adolescents from Colombia. Participants included 1118 children and adolescents (54.6% girls). Calcaneal broadband ultrasound attenuation (c-BUA) was obtained as a marker of bone health. Body composition (fat mass and lean mass) was assessed using bioelectrical impedance analysis. Furthermore height, weight, waist circumference and Tanner stage were measured and body mass index (BMI) was calculated. Standing long-jump (SLJ) and isometric handgrip dynamometry were used respectively as indicators of lower and upper body muscular fitness. A muscular index score was also computed by summing up the standardised values of both SLJ and handgrip strength. Dietary intake and degree of adherence to the Mediterranean diet were assessed by a 7-day recall questionnaire for food frequency and the Kidmed questionnaire. Poor bone health was considered using a z-score cut off of ≤−1.5 standard deviation. Once the results were adjusted for age and Tanner stage, the predisposing factors of having a c-BUA z-score ≤−1.5 standard deviation included being underweight or obese, having an unhealthy lean mass, having an unhealthy fat mass, SLJ performance, handgrip performance, and unhealthy muscular index score. In conclusion, body composition (fat mass and lean body mass) and MF both influenced bone health in a sample of children and adolescents from Colombia. Thus promoting strength adaptation and preservation in Colombian youth will help to improve bone health, an important protective factor against osteoporosis in later life.: We would like to acknowledge to Bogota District Education Department for supporting data collection for this study. The authors also thank the participating Bogota District students, teachers, schools, and staff. The “FUPRECOL Study” was possible given the financial support provided by the Instituto Colombiano para el Desarrollo de la Ciencia y la Tecnología “Francisco José de Caldas” COLCIENCIAS (Contract Number 671-2014 Code 122265743978). Also, during the completion of this paper, AG-H was visiting researchers at the University of Rosario (CEMA, Bogotá, Colombia), supported with grants awarded by Proyectos Basales y Vicerrectoría de Investigación, Desarrollo e Innovación” (Universidad de Santiago de Chile, USACH)