83 research outputs found
Listeria monocytogenes HAZARD MANAGEMENT IN A TYPICAL PRODUCT: THE CIAUSCOLO
The aim of the present study is to investigate operative procedures that allow to minimize Listeria monocytogenes (L. m.) hazard in the main traditional sausage of the internal areas of Marche (Italy): the Ciauscolo, that has received the quality trademark PGI. It is made from lean cuts of well mature pork that is finely minced, adding fat which give the salami his characteristic softness and flavour. It is characterized by having a very little maturing period that determine high aw levels and, for this peculiarity, it allows L. m development
Detection of Solar Coronal Mass Ejections from Raw Images with Deep Convolutional Neural Networks
Coronal Mass Ejections (CMEs) are massive releases of plasma from the solar corona. When the charged material is ejected towards the Earth, it can cause geomagnetic storms and severely damage electronic equipment and power grids. Early detection of CMEs is therefore crucial for damage containment. In this paper, we study detection of CMEs from sequential images of the solar corona acquired by a satellite. A low-complexity deep neural network is trained to process the raw images, ideally directly on the satellite, in order to provide early alerts
Coronal Diagnostics from Narrowband Images around 30.4 nm
Images taken in the band centered at 30.4 nm are routinely used to map the
radiance of the He II Ly alpha line on the solar disk. That line is one of the
strongest, if not the strongest, line in the EUV observed in the solar
spectrum, and one of the few lines in that wavelength range providing
information on the upper chromosphere or lower transition region. However, when
observing the off-limb corona the contribution from the nearby Si XI 30.3 nm
line can become significant. In this work we aim at estimating the relative
contribution of those two lines in the solar corona around the minimum of solar
activity. We combine measurements from CDS taken in August 2008 with
temperature and density profiles from semiempirical models of the corona to
compute the radiances of the two lines, and of other representative coronal
lines (e.g., Mg X 62.5 nm, Si XII 52.1 nm). Considering both diagnosed
quantities from line ratios (temperatures and densities) and line radiances in
absolute units, we obtain a good overall match between observations and models.
We find that the Si XI line dominates the He II line from just above the limb
up to ~2 R_Sun in streamers, while its contribution to narrowband imaging in
the 30.4 nm band is expected to become smaller, even negligible in the corona
beyond ~2 - 3 R_Sun, the precise value being strongly dependent on the coronal
temperature profile.Comment: 26 pages, 11 figures; to be published in: Solar Physic
Comparing extrapolations of the coronal magnetic field structure at 2.5 solar radii with multi-viewpoint coronagraphic observations
The magnetic field shapes the structure of the solar corona but we still know
little about the interrelationships between the coronal magnetic field
configurations and the resulting quasi-stationary structures observed in
coronagraphic images (as streamers, plumes, coronal holes). One way to obtain
information on the large-scale structure of the coronal magnetic field is to
extrapolate it from photospheric data and compare the results with
coronagraphic images. Our aim is to verify if this comparison can be a fast
method to check systematically the reliability of the many methods available to
reconstruct the coronal magnetic field. Coronal fields are usually extrapolated
from photospheric measurements typically in a region close to the central
meridian on the solar disk and then compared with coronagraphic images at the
limbs, acquired at least 7 days before or after to account for solar rotation,
implicitly assuming that no significant changes occurred in the corona during
that period. In this work, we combine images from three coronagraphs
(SOHO/LASCO-C2 and the two STEREO/SECCHI-COR1) observing the Sun from different
viewing angles to build Carrington maps covering the entire corona to reduce
the effect of temporal evolution to ~ 5 days. We then compare the position of
the observed streamers in these Carrington maps with that of the neutral lines
obtained from four different magnetic field extrapolations, to evaluate the
performances of the latter in the solar corona. Our results show that the
location of coronal streamers can provide important indications to discriminate
between different magnetic field extrapolations.Comment: Accepted by A&A the 20th of May, 201
Slow wind belt in the quiet solar corona
The slow solar wind belt in the quiet corona, observed with the Metis
coronagraph on board Solar Orbiter on May 15, 2020, during the activity minimum
of the cycle 24, in a field of view extending from 3.8 to 7.0
, is formed by a slow and dense wind stream running along the coronal
current sheet, accelerating in the radial direction and reaching at 6.8
a speed within 150 km s and 190 km s, depending on the
assumptions on the velocity distribution of the neutral hydrogen atoms in the
coronal plasma. The slow stream is separated by thin regions of high velocity
shear from faster streams, almost symmetric relative to the current sheet, with
peak velocity within 175 km s and 230 km s at the same coronal
level. The density-velocity structure of the slow wind zone is discussed in
terms of the expansion factor of the open magnetic field lines that is known to
be related to the speed of the quasi-steady solar wind, and in relation to the
presence of a web of quasi separatrix layers, S-web, the potential sites of
reconnection that release coronal plasma into the wind. The parameters
characterizing the coronal magnetic field lines are derived from 3D MHD model
calculations. The S-web is found to coincide with the latitudinal region where
the slow wind is observed in the outer corona and is surrounded by thin layers
of open field lines expanding in a non-monotonic way
Search for low energy neutrinos in correlation with the 8 events observed by the EXPLORER and NAUTILUS detectors in 2001
We report on a search for low-energy neutrino (antineutrino) bursts in
correlation with the 8 time coincident events observed by the gravitational
waves detectors EXPLORER and NAUTILUS (GWD) during the year 2001. The search,
conducted with the LVD detector (INFN Gran Sasso National Laboratory, Italy),
has considered several neutrino reactions, corresponding to different neutrino
species, and a wide range of time intervals around the (GWD) observed events.
No evidence for statistically significant correlated signals in LVD has been
found. Assuming two different origins for neutrino emission, the cooling of a
neutron star from a core-collapse supernova or from coalescing neutron stars
and the accretion of shocked matter, and taking into account neutrino
oscillations, we derive limits to the total energy emitted in neutrinos and to
the amount of accreting mass, respectively.Comment: Accepted for publication in Astronomy and Astrophysic
Turbulence and wave transmission at an ICME-driven shock observed by the Solar Orbiter and Wind
Aims. An interplanetary coronal mass ejection (ICME) event was observed by the Solar Orbiter at 0.8 AU on 2020 April 19 and by Wind at 1 AU on 2020 April 20. Futhermore, an interplanetary shock wave was driven in front of the ICME. Here, we focus on the transmission of the magnetic fluctuations across the shock and we analyze the characteristic wave modes of solar wind turbulence in the vicinity of the shock observed by both spacecraft. Methods. The observed ICME event is characterized by a magnetic helicity-based technique. The ICME-driven shock normal was determined by magnetic coplanarity method for the Solar Orbiter and using a mixed plasma and field approach for Wind. The power spectra of magnetic field fluctuations were generated by applying both a fast Fourier transform and Morlet wavelet analysis. To understand the nature of waves observed near the shock, we used the normalized magnetic helicity as a diagnostic parameter. The wavelet-reconstructed magnetic field fluctuation hodograms were used to further study the polarization properties of waves. Results. We find that the ICME-driven shock observed by Solar Orbiter and Wind is a fast, forward oblique shock with a more perpendicular shock angle at the Wind position. After the shock crossing, the magnetic field fluctuation power increases. Most of the magnetic field fluctuation power resides in the transverse fluctuations. In the vicinity of the shock, both spacecraft observe right-hand polarized waves in the spacecraft frame. The upstream wave signatures fall within a relatively broad and low frequency band, which might be attributed to low frequency MHD waves excited by the streaming particles. For the downstream magnetic wave activity, we find oblique kinetic Alfven waves with frequencies near the proton cyclotron frequency in the spacecraft frame. The frequency of the downstream waves increases by a factor of similar to 7-10 due to the shock compression and the Doppler effect.Peer reviewe
Connecting Solar Orbiter remote-sensing observations and Parker Solar Probe in situ measurements with a numerical MHD reconstruction of the Parker spiral
As a key feature, NASA’s Parker Solar Probe (PSP) and ESA-NASA’s Solar Orbiter (SO) missions cooperate to trace solar wind and transients from their sources on the Sun to the inner interplanetary space. The goal of this work is to accurately reconstruct the interplanetary Parker spiral and the connection between coronal features observed remotely by the Metis coronagraph on-board SO and those detected in situ by PSP at the time of the first PSP-SO quadrature of January 2021. We use the Reverse in situ and MHD Approach (RIMAP), a hybrid analytical-numerical method performing data-driven reconstructions of the Parker spiral. RIMAP solves the MHD equations on the equatorial plane with the PLUTO code, using the measurements collected by PSP between 0.1 and 0.2 AU as boundary conditions. Our reconstruction connects density and wind speed measurements provided by Metis (3–6 solar radii) to those acquired by PSP (21.5 solar radii) along a single streamline. The capability of our MHD model to connect the inner corona observed by Metis and the super Alfvénic wind measured by PSP, not only confirms the research pathways provided by multi-spacecraft observations, but also the validity and accuracy of RIMAP reconstructions as a possible test bench to verify models of transient phenomena propagating across the heliosphere, such as coronal mass ejections, solar energetic particles and solar wind switchbacks
Recurrent solar density transients in the slow wind observed with the Metis coronagraph
Aims We aim to investigate and characterize the morphology and dynamics of small-scale coronal plasma density inhomogeneities detected as brighter, denser features propagating outward through the solar corona in the visible-light images of the Metis coronagraph on board Solar Orbiter on February 22, 2021. Our main focus is on investigating their possible origin and contribution to the slow wind variability and dynamics and their dependence on coronal magnetic field configurations and structure. Methods. The method adopted is based on the computations of autocorrelation and cross-correlation functions applied to temporal and spatial series of total brightness as a function of the heliocentric distance and solar latitudes. Results. We find that the plasma density inhomogeneities studied here are small-scale structures with typical radial and transverse sizes, as projected on the plane of sky, on the order of 500 Mm and 40 Mm, respectively, and that they are up to 24 times brighter than the ambient solar wind. The brighter density structures exhibit longer lifetime and more stable shape and dimensions as they travel toward the outer edge of the field of view. The enhanced density structures are ejected with a most probable cadence of about 80 min at or below the inner edge of the Metis field of view (within 3.1 R· 5.7 R· at the time of observations) in a wide latitudinal region corresponding to the site of a complex web of separatrix and quasi-separatrix layers, as resulting from the simulated magnetohydrodynamic configuration of the west limb of the solar corona. Some of the moving density enhancements clearly show morphological characteristics compatible with the switchback phenomenon, supporting the results indicating that the switchbacks occur at the coronal level. The enhanced density structures were ejected into the ambient slow wind with a mean velocity of about 240 ± 40 km s-1, which is significantly higher than that deduced for the ambient solar wind on the basis of previous Metis observations during the solar minimum of cycle 24. The absence of acceleration observed across the coronagraph field of view suggests that the ejected plasmoids are progressively reaching the expansion rate of the ambient wind. Conclusions. The results suggest that the quasi-periodic enhanced-density plasmoids might be the consequence of reconnection phenomena occurring in the complex web of the separatrix and quasi-separatrix layers present in the solar corona. Moreover, the structural characteristics of some of the detected plasmoids are in favor of the presence of switchbacks that originate during interchange reconnection processes occurring at or below 3 R· in the S-web. The speed of the plasma ejected in the reconnection process is higher than that of the ambient slow solar wind and is likely to be related to the energy involved in the process generating the propagating structures
METIS: the visible and UV coronagraph for Solar Orbiter
METIS coronagraph is designed to observe the solar corona with an annular field of view from 1.5 to 2.9 degrees in the visible broadband (580-640 nm) and in the UV HI Lyman-alpha, during the Sun close approaching and high latitude tilting orbit of Solar Orbiter. The big challenge for a coronagraph is the stray light rejection. In this paper after a description of the present METIS optical design, the stray light rejection design is presented in detail together with METIS off-pointing strategies throughout the mission. Data shown in this paper derive from the optimization of the optical design performed with Zemax ray tracing and from laboratory breadboards of the occultation system and of the polarimeter
- …