196 research outputs found
Off-axis reflection zone plate for quantitative soft x-ray source characterization
A compact system for high-resolution spectroscopy and quantitative photon flux and brilliance measurements of pulsed soft x-ray sources is described. The calibrated system combines a novel elliptical off-axis reflection zone plate with charge-coupled device detection for simultaneous spectral and spatial measurements. Experiments on a water-window droplet-target laser-plasma source demonstrate lambda/Delta lambda greater than or equal to 1000 spectral resolution and absolute flux and brilliance measurements. (C) 1997 American Institute of Physics
Linear plasmon dispersion in single-wall carbon nanotubes and the collective excitation spectrum of graphene
We have measured a strictly linear pi-plasmon dispersion along the axis of
individualized single wall carbon nanotubes, which is completely different from
plasmon dispersions of graphite or bundled single wall carbon nanotubes.
Comparative ab initio studies on graphene based systems allow us to reproduce
the different dispersions. This suggests that individualized nanotubes provide
viable experimental access to collective electronic excitations of graphene,
and it validates the use of graphene to understand electronic excitations of
carbon nanotubes. In particular, the calculations reveal that local field
effects (LFE) cause a mixing of electronic transitions, including the 'Dirac
cone', resulting in the observed linear dispersion
A buffer gas beam source for short, intense and slow molecular pulses
Experiments with cold molecules usually begin with a molecular source. We describe the construction and characteristics of a cryogenic buff er gas source of CaF molecules. The source emits pulses with a typical duration of 240 μs, a mean speed of about 150 m/s, and a flux of 5x 10¹⁰ molecules per steradian per pulse in a single rotational state
The Human Minor Histocompatibility Antigen1 Is a RhoGAP
The human minor Histocompatibility Antigen HMHA-1 is a major target of immune responses after allogeneic stem cell transplantation applied for the treatment of leukemia and solid tumors. The restriction of its expression to hematopoietic cells and many solid tumors raised questions regarding its cellular functions. Sequence analysis of the HMHA-1 encoding HMHA1 protein revealed the presence of a possible C-terminal RhoGTPase Activating Protein (GAP) domain and an N-terminal BAR domain. Rho-family GTPases, including Rac1, Cdc42, and RhoA are key regulators of the actin cytoskeleton and control cell spreading and migration. RhoGTPase activity is under tight control as aberrant signaling can lead to pathology, including inflammation and cancer. Whereas Guanine nucleotide Exchange Factors (GEFs) mediate the exchange of GDP for GTP resulting in RhoGTPase activation, GAPs catalyze the low intrinsic GTPase activity of active RhoGTPases, resulting in inactivation. Here we identify the HMHA1 protein as a novel RhoGAP. We show that HMHA1 constructs, lacking the N-terminal region, negatively regulate the actin cytoskeleton as well as cell spreading. Furthermore, we show that HMHA1 regulates RhoGTPase activity in vitro and in vivo. Finally, we demonstrate that the HMHA1 N-terminal BAR domain is auto-inhibitory as HMHA1 mutants lacking this region, but not full-length HMHA1, showed GAP activity towards RhoGTPases. In conclusion, this study shows that HMHA1 acts as a RhoGAP to regulate GTPase activity, cytoskeletal remodeling and cell spreading, which are crucial functions in normal hematopoietic and cancer cells
Investigation of Thermal Stability Effects of Thick Hydrogenated Amorphous Silicon Precursor Layers for Liquid Phase Crystallized Silicon
The thermal stability of thick amp; 8776;4 amp; 8201; amp; 956;m plasma grown hydrogenated amorphous silicon a Si H layers on glass upon application of a rather rapid annealing step is investigated. Such films are of interest as precursor layers for laser liquid phase crystallized silicon solar cells. However, at least half day annealing at T amp; 8776;550 amp; 8201; C is considered to be necessary so far to reduce the hydrogen H content and thus avoid blistering and peeling during the crystallization process due to H. By varying the deposition conditions of a Si H, layers of rather different thermal stability are fabricated. Changes in the surface morphology of these a Si H layers are investigated using scanning electron microscopy and profilometry measurements. Hydrogen effusion, secondary ion mass spectrometry SIMS depth profiling, and Raman spectroscopy measurements are also carried out. In summary, amorphous silicon precursor layers are fabricated that can be heated within 30 amp; 8201;min to a temperature of 550 amp; 8201; C without peeling and major surface morphological changes. Successful laser liquid phase crystallization of such material is demonstrated. The physical nature of a Si H material stability instability upon application of rapid heating is studie
What do dust sinks tell us about their sources and past environmental dynamics? A case study for oxygen isotope stages 3–2 in the Middle Rhine Valley, Germany
The study of geological archives of dust is of great relevance as they are
directly linked to past atmospheric circulation and bear the potential to
reconstruct dust provenance and flux relative to climate changes. Among the
dust sinks, loess–palaeosol sequences (LPSs) represent the only continental
and non-aquatic archives that are predominantly built up by dust deposits
close to source areas, providing detailed information on Quaternary climatic
and terrestrial environmental changes. Upper Pleistocene LPSs of western
central Europe have been investigated in great detail showing their linkage
to millennial-scale northern hemispheric climate oscillations, but
comprehensive data on dust composition and potential source–sink
relationships as well as inferred past atmospheric circulation patterns for
this region are still fragmentary.
Here, we present an integrative approach that systematically combines
sedimentological, rock magnetic, and bulk geochemical data, as well as information
on Sr and Nd isotope composition, enabling a synthetic interpretation of LPS formation. We focus on the Schwalbenberg RP1 profile in the Middle Rhine
Valley in Germany and integrate our data into a robust age model that has
recently been established based on high-resolution radiocarbon dating of
earthworm calcite granules. We show that Schwalbenberg RP1 is subdivided
into a lower section corresponding to late oxygen isotope stage 3 (OIS; ∼ 40–30 ka)
and an upper section dating into the Last Glacial Maximum (LGM; ∼ 24–22 ka),
separated by a major stratigraphic unconformity. Sedimentological proxies of
wind dynamics (U ratio) and pedogenesis (finest clay) of the lower section
attest to comparable and largely synchronous patterns of northern
hemispheric climatic changes supporting the overall synchronicity of
climatic changes in and around the North Atlantic region. The anisotropy of
magnetic susceptibility (AMS) reveals a clear correlation between finer
grain size and increasing AMS foliation within interstadials, possibly owing
to continuous accumulation of dust during pedogenic phases. Such a clear
negative correlation has so far not been described for any LPS on
stadial–interstadial scales.
Distinct shifts in several proxy data supported by changes in isotope
composition (87Sr/86Sr and εNd) within the lower
section are interpreted as changes in provenance and decreasing weathering
simultaneously with an overall cooling and aridification towards the end of
OIS 3 (after ∼ 35 ka) and enhanced wind activity with
significant input of coarse-grained material recycled from local sources
related to increased landscape instability (after ∼ 31.5 ka).
We find that environmental conditions within the upper section, most likely
dominated by local to regional environmental signals, significantly differ
from those in the lower section. In addition, AMS-based reconstructions of
near-surface wind trends may indicate the influence of north-easterly winds
beside the overall dominance of westerlies. The integrative approach
contributes to a more comprehensive understanding of LPS formation including
changes in dust composition and associated circulation patterns during
Quaternary climate changes.</p
Effect of Polypropylene fibres on the Workability parameters of Extrudable Cementitious Material
Additive manufacturing in construction industry has been introduced as an aspiration for a more sustainable built environment and currently evolving with high demand amongst researches. This study is an investigation of the influence of polypropylene (PP) fibre addition on the workability parameters of a new extrudable concrete mixture. As the quality of final printed structure prominently depends on the fresh state properties of concrete, this investigation mainly focused on the rheological properties such as workability (flow), setting time, extrudability and buildability. These parameters were systematically investigated through a small scale experimental process with time after mixing. The selected control mix with Ground granulated blast furnace slag (GGBS) and Silica Fume (SF) was used in this analysis. The Control cementitious specimens without fibre inclusion and with fibre addition in different volume fraction of binder, ranging from 0.5% to 3% were printed. The results showed that the fibre addition of 0, 0.5 and 1.0% have the better flowability and extrudability compared to 1.5, 2 and 3%. Also, reduction in the print quality was assessed visually with increasing fibre percentage. However, results indicated that the initial setting time is comparatively low for those mixes with higher fibre inclusion which is required for better bond strength between layers. Moreover, higher fibre content caused better buildability and shape retention in the extruded samples
Approaches and challenges to the study of loess—Introduction to the LoessFest Special Issue
In September 2016, the annual meeting of the International Union for Quaternary Research's Loess and Pedostratigraphy Focus Group, traditionally referred to as a LoessFest, met in Eau Claire, Wisconsin, USA. The 2016 LoessFest focused on thin loess deposits and loess transportation surfaces. This LoessFest included 75 registered participants from 10 countries. Almost half of the participants were from outside the United States, and 18 of the participants were students. This review is the introduction to the special issue for Quaternary Research that originated from presentations and discussions at the 2016 LoessFest. This introduction highlights current understanding and ongoing work on loess in various regions of the world and provides brief summaries of some of the current approaches/strategies used to study loess deposits
Molecules cooled below the Doppler limit
The ability to cool atoms below the Doppler limit -- the minimum temperature reachable by Doppler cooling -- has been essential to most experiments with quantum degenerate gases, optical lattices and atomic fountains, among many other applications. A broad set of new applications await ultracold molecules, and the extension of laser cooling to molecules has begun. A molecular magneto-optical trap has been demonstrated, where molecules approached the Doppler limit. However, the sub-Doppler temperatures required for most applications have not yet been reached. Here we cool molecules to 50 uK, well below the Doppler limit, using a three-dimensional optical molasses. These ultracold molecules could be loaded into optical tweezers to trap arbitrary arrays for quantum simulation, launched into a molecular fountain for testing fundamental physics, and used to study ultracold collisions and ultracold chemistry
Dynamical x-ray microscopy investigation of electromigration in passivated inlaid Cu interconnect structures
- …