A schlieren method for ultra-low angle light scattering measurements

We describe a self calibrating optical technique that allows to perform absolute measurements of scattering cross sections for the light scattered at extremely small angles. Very good performances are obtained by using a very simple optical layout similar to that used for the schlieren method, a technique traditionally used for mapping local refraction index changes. The scattered intensity distribution is recovered by a statistical analysis of the random interference of the light scattered in a half-plane of the scattering wave vectors and the main transmitted beam. High quality data can be obtained by proper statistical accumulation of scattered intensity frames, and the static stray light contributions can be eliminated rigorously. The potentialities of the method are tested in a scattering experiment from non equilibrium fluctuations during a free diffusion experiment. Contributions of light scattered from length scales as long as Lambda=1 mm can be accurately determined.Comment: 7 pages, 3 figure

Salinity Gradients for Sustainable Energy: Primer, Progress, and Prospects

Combining two solutions of different composition releases the Gibbs free energy of mixing. By using engineered processes to control the mixing, chemical energy stored in salinity gradients can be harnessed for useful work. In this critical review, we present an overview of the current progress in salinity gradient power generation, discuss the prospects and challenges of the foremost technologies — pressure retarded osmosis (PRO), reverse electrodialysis (RED), and capacitive mixing (CapMix) and provide perspectives on the outlook of salinity gradient power generation. Momentous strides have been made in technical development of salinity gradient technologies and field demonstrations with natural and anthropogenic salinity gradients (for example, seawater–river water and desalination brine-wastewater, respectively), but fouling persists to be a pivotal operational challenge that can significantly ebb away cost-competitiveness. Natural hypersaline sources (e.g., hypersaline lakes and salt domes) can achieve greater concentration difference and, thus, offer opportunities to overcome some of the limitations inherent to seawater–river water. Technological advances needed to fully exploit the larger salinity gradients are identified. While seawater desalination brine is a seemingly attractive high salinity anthropogenic stream that is otherwise wasted, actual feasibility hinges on the appropriate pairing with a suitable low salinity stream. Engineered solutions are foulant-free and can be thermally regenerative for application in low-temperature heat utilization. Alternatively, PRO, RED, and CapMix can be coupled with their analog separation process (reverse osmosis, electrodialysis, and capacitive deionization, respectively) in salinity gradient flow batteries for energy storage in chemical potential of the engineered solutions. Rigorous techno-economic assessments can more clearly identify the prospects of low-grade heat conversion and large-scale energy storage. While research attention is squarely focused on efficiency and power improvements, efforts to mitigate fouling and lower membrane and electrode cost will be equally important to reduce levelized cost of salinity gradient energy production and, thus, boost PRO, RED, and CapMix power generation to be competitive with other renewable technologies. Cognizance of the recent key developments and technical progress on the different technological fronts can help steer the strategic advancement of salinity gradient as a sustainable energy source

Shear-induced quench of long-range correlations in a liquid mixture

A static correlation function of concentration fluctuations in a (dilute) binary liquid mixture subjected to both a concentration gradient and uniform shear flow is investigated within the framework of fluctuating hydrodynamics. It is shown that a well-known $|\nabla c|^2/k^4$ long-range correlation at large wave numbers $k$ crosses over to a weaker divergent one for wave numbers satisfying $k<(\dot{\gamma}/D)^{1/2}$, while an asymptotic shear-controlled power-law dependence is confirmed at much smaller wave numbers given by $k\ll (\dot{\gamma}/\nu)^{1/2}$, where $c$, $\dot{\gamma}$, $D$ and $\nu$ are the mass concentration, the rate of the shear, the mass diffusivity and the kinematic viscosity of the mixture, respectively. The result will provide for the first time the possibility to observe the shear-induced suppression of a long-range correlation experimentally by using, for example, a low-angle light scattering technique.Comment: 8pages, 2figure

Variability of selected trace elements of different meat cuts determined by ICP-MS and DRC-ICPMS

The aim of this study was to determine the levels of cadmium, lead, iron, zinc, selenium, manganese, copper and molybdenum in different cuts of beef, pork, lamb, chicken and foal collected from supermarkets and butcheries in Switzerland. The concentrations of manganese, copper, molybdenum, zinc, iron, selenium, cadmium and lead were determined by inductively coupled plasma mass spectrometry (ICP-MS) after microwave digestion. Mean values and their respective coefficients of variation were calculated from the measured concentrations. The concentrations found for cadmium and lead ranged from 0.6 to 3.9 μg/100 g and 1.0 to 2.1 μg/100 g, respectively. Concentrations ranged between 0.5 and 3.3 mg/100 g for iron, 0.7 and 5.1 mg/100 g for zinc, 9 and 44 μg/100 g for selenium, 3.1 and 16.7 μg/100 g for manganese, 0.3 and 132 μg/100 g for copper and 0.9 and 3.2 μg/100 g for molybdenum. Differences found for the concentrations in meat from different species as well as between the individual meat cuts were notable for iron, zinc, selenium and copper. Manganese concentrations were found to vary unsystematically within muscles and species. Molybdenum concentrations were higher in chicken meat in comparison with the mammalian meats. The highest coefficients of variation were found for manganese (13% to 142%) and copper (13% to 224%), while the lowest was found for zinc (4% to 45%). In conclusion, in order to provide an accurate overview and to be able to calculate reliable dietary intakes, it is important to include the variability in food composition dat

Real-Time Wavelet-transform spectrum analyzer for the investigation of 1/f^\alpha noise

A wavelet transform spectrum analyzer operating in real time within the frequency range 3X10^(-5) - 1.3X10^5 Hz has been implemented on a low-cost Digital Signal Processing board operating at 150MHz. The wavelet decomposition of the signal allows to efficiently process non-stationary signals dominated by large amplitude events fairly well localized in time, thus providing the natural tool to analyze processes characterized by 1/f^alpha power spectrum. The parallel architecture of the DSP allows the real-time processing of the wavelet transform of the signal sampled at 0.3MHz. The bandwidth is about 220dB, almost ten decades. The power spectrum of the scattered intensity is processed in real time from the mean square value of the wavelet coefficients within each frequency band. The performances of the spectrum analyzer have been investigated by performing Dynamic Light Scattering experiments on colloidal suspensions and by comparing the measured spectra with the correlation functions data obtained with a traditional multi tau correlator. In order to asses the potentialities of the spectrum analyzer in the investigation of processes involving a wide range of timescales, we have performed measurements on a model system where fluctuations in the scattered intensities are generated by the number fluctuations in a dilute colloidal suspension illuminated by a wide beam. This system is characterized by a power-law spectrum with exponent -3/2 in the scattered intensity fluctuations. The spectrum analyzer allows to recover the power spectrum with a dynamic range spanning about 8 decades. The advantages of wavelet analysis versus correlation analysis in the investigation of processes characterized by a wide distribution of time scales and non-stationary processes are briefly discussed.Comment: 12 pages, 6 figure

Materials selection for optimum energy production by double layer expansion methods

NOTICE: this is the author’s version of a work that was accepted for publication in Journal of Power Sources. Changes resulting from the publishing process, such as peer review, editing, corrections, structural formatting, and other quality control mechanisms may not be reflected in this document. Changes may have been made to this work since it was submitted for publication. A definitive version was subsequently published in Journal of Power Sources (2014) DOI:http://dx.doi.org/10.1016/j.jpowsour.2013.12.125The capacitive mixing procedure for energy extraction based on Double Layer Expansion (CDLE) belongs to the group of so-called CAPMIX techniques, which aim at obtaining energy from the salinity difference between fresh and sea waters. Specifically, the CDLE technique takes advantage of the voltage rise that occurs when sea water is exchanged for river water in a pair of porous electrodes which jointly behave as an electrical double layer supercapacitor. In this article, we deal with some experimental aspects that are key for optimizing the extracted energy, and have not been analyzed yet with sufficient detail. This investigation will help in evaluating those parameters which we need to be fixed in a future CDLE device. These include the charging potential, the durations of the different cycle steps, the load resistance used, and the porosity and hydrophilicity of the carbon.Departamento de Física Aplicada, Universidad de GranadaThe research leading to these results received funding from the European Union 7th Framework Programme (FP7/2007-2013) under agreement No. 256868. Further financial support from Junta de Andalucía (Spain), project PE-2008-FQM3993 is also gratefully acknowledged

Fluctuations in fluids in thermal nonequilibrium states below the convective Rayleigh-Benard instability

Starting from the linearized fluctuating Boussinesq equations we derive an expression for the structure factor of fluids in stationary convection-free thermal nonequilibrium states, taking into account both gravity and finite-size effects. It is demonstrated how the combined effects of gravity and finite size causes the structure factor to go through a maximum value as a function of the wave number $q$. The appearance of this maximum is associated with a crossover from a $q^{-4}$ dependence for larger $q$ to a $q^2$ dependence for very small $q$. The relevance of this theoretical result for the interpretation of light scattering and shadowgraph experiments is elucidated. The relationship with studies on various aspects of the problem by other investigators is discussed. The paper thus provides a unified treatment for dealing with fluctuations in fluid layers subjected to a stationary temperature gradient regardless of the sign of the Rayleigh number $R$, provided that $R$ is smaller than the critical value $R_\mathrm{c}$ associated with the appearance of Rayleigh-B\'{e}nard convection.Comment: 33 pages, 6 figures, accepted for publication: Physica

Polyelectrolyte-coated carbons used in the generation of blue energy from salinity differences

This is the unedited version of this manuscript. The publisher's edited version can be reached at this URL: http://pubs.rsc.org/en/content/articlelanding/2014/cp/c4cp03527e#!divAbstractIn this work we present a method for the production of clean, renewable electrical energy from the exchange of solutions with different salinities. Activated carbon films are coated with negatively or positively charged polyelectrolytes by well-established adsorption methods. When two oppositely charged coated films are placed in contact with an ionic solution, the potential difference between them will be equal to the difference between their Donnan potentials, and hence, energy can be extracted by building an electrochemical cell with such electrodes. A model is elaborated on the operation of the cell, based on the electrokinetic theory of soft particles. All the features of the model are experimentally reproduced, although a small quantitative difference concerning the maximum opencircuit voltage is found, suggesting that the coating is the key point to improve the efficiency. In the used experimental conditions, we obtain a power of 12.1 mW/m2. Overall, the method proves to be a fruitful and simple approach to salinity-gradient energy production. Obtaining energy from salinity differences asDepartamento de Física AplicadaThe research leading to these results received funding from the European Union 7th Framework Programme (FP7/2007-2013) under agreement No. 256868. Further financial sup- ports from Junta de Andalucía, project PE2012-FQM694, and Ministerio de Economía y Competitividad (Spain), project FIS2013-47666-C3-1-R

Equilibrium and nonequilibrium fluctuations at the interface between two fluid phases

We have performed small-angle light-scattering measurements of the static structure factor of a critical binary mixture undergoing diffusive partial remixing. An uncommon scattering geometry integrates the structure factor over the sample thickness, allowing different regions of the concentration profile to be probed simultaneously. Our experiment shows the existence of interface capillary waves throughout the macroscopic evolution to an equilibrium interface, and allows to derive the time evolution of surface tension. Interfacial properties are shown to attain their equilibrium values quickly compared to the system's macroscopic equilibration time.Comment: 10 pages, 5 figures, submitted to PR