1,708 research outputs found

    Microelectronic cmos implementation of a machine learning technique for sensor calibration

    Get PDF
    An integrated machine-learning based adaptive circuit for sensor calibration implemented in standard 0.18Όm CMOS technology with 1.8V power supply is presented in this paper. In addition to linearizing the device response, the proposed system is also capable to correct offset and gain errors. The building blocks conforming the adaptive system are designed and experimentally characterized to generate numerical high-level models which are used to verify the proper performance of each analog block within a defined multilayer perceptron architecture. The network weights, obtained from the learning phase, are stored in a microcontroller EEPROM memory, and then loaded into each of the registers of the proposed integrated prototype. In order to verify the proposed system performance, the non-linear characteristic of a thermistor is compensated as an application example, achieving a relative error er below 3% within an input span of 130°C, which is almost 6 times less than the uncorrected response. The power consumption of the whole system is 1.4mW and it has an active area of 0.86mm 2 . The digital programmability of the network weights provides flexibility when a sensor change is required

    Experimental reconstruction of non-stationary sound and vibration sources by means of Transient Planar Near-field Acoustic Holography

    Get PDF
    A novel algorithm called Transient Planar Near-field Acoustic Holography is presented to analyse nonstationary sound and vibration sources. The method is able to obtain the time-dependent pressure, particle velocity and intensity field at the source plane without any pre-knowledge of the source by inverse propagation of measured pressure fields. This makes it possible to analyse phenomena like transients and run-ups for all kinds of vibrating and sound radiating objects. Transient responses of thin plates are analysed to experimentally validate the performance of the algorithm. The determined velocity at the center of the plate is validated using a laser vibro-meter directed at the center of the plate and the spatial fields are qualitatively compared with theoretical mode shapes. It is shown that the algorithm is able to analyse transient responses of plates with good quantitative as well as qualitative results.</p

    Low Power CMOS Chopper Preamplifier Based on Source-Degeneration Transconductors

    Get PDF
    This paper describes the design of a low-power, low-noise flicker CMOS chopper preamplifier for sensor signal conditioning. The core amplifier and the Gm-C output low pass filter of the proposed fully differential preamplifier are based on a source degeneration transconductor. The circuit was designed in a standard 0.18”m CMOS process with 1.8V supply voltage. It shows 42dB gain, 1 kHz bandwidth and a total power consumption of 84 ”W. The proposed configuration achieves a noise efficiency factor of 4.6 and a total input-referred noise of 560 nVrms integrated from 0.1 to 1 kHz

    High-Linearity Self-Biased CMOS Current Buffer

    Get PDF
    A highly linear fully self-biased class AB current buffer designed in a standard 0.18 mu m CMOS process with 1.8 V power supply is presented in this paper. It is a simple structure that, with a static power consumption of 48 mu W, features an input resistance as low as 89 Omega, high accuracy in the input-output current ratio and total harmonic distortion (THD) figures lower than -60 dB at 30 mu A amplitude signal and 1 kHz frequency. Robustness was proved through Monte Carlo and corner simulations, and finally validated through experimental measurements, showing that the proposed configuration is a suitable choice for high performance low voltage low power applications

    Anthocyanin composition and related pigments in strawberry

    Get PDF
    The anthocyanin composition of the strawberry has been object of various studies, but it is still not fully characterized. It is well known the presence af pelarganidin 3 - glucoside (Pg 3 -gluc) as major anthocyanin, usually accompanied of smaller proportions of pelargonidin 3- rutinoside (Pg 3 -rut) and cyanidin 3-glucosid e (Cy. 3- gluc).ComissĂŁo Europeia (Fundo Social Europeu) e Governo PortuguĂȘs atravĂ©s do Programa PRODEP (III) - ref.ÂȘ 5.3/N/199.006/00-Doutoramento

    Validation of metabolic syndrome using medical records in the SUN cohort

    Get PDF
    The objective of this study was to evaluate the validity of self reported criteria of Metabolic Syndrome (MS) in the SUN (Seguimiento Universidad de Navarra) cohort using their medical records as the gold standard. METHODS: We selected 336 participants and we obtained MS related data according to Adult Treatment Panel III (ATP III) and International Diabetes Federation (IDF). Then we compared information on the self reported diagnosis of MS and MS diagnosed in their medical records. We calculated the proportion of confirmed MS, the proportion of confirmed non-MS and the intraclass correlation coefficients for each component of the MS. RESULTS: From those 336 selected participants, we obtained sufficient data in 172 participants to confirm or reject MS using ATP III criteria. The proportion of confirmed MS was 91.2% (95% CI: 80.7- 97.1) and the proportion of confirmed non-MS was 92.2% (95% CI: 85.7-96.4) using ATP III criteria. The proportion of confirmed MS using IDF criteria was 100% (95% CI: 87.2-100) and the proportion of confirmed non-MS was 97.1% (95% CI: 85.1-99.9). Kappa Index was 0.82 in the group diagnosed by ATP III criteria and 0.97 in the group diagnosed by IDF criteria. Intraclass correlation coefficients for the different component of MS were: 0.93 (IC 95%:0.91- 0.95) for BMI; 0.96 (IC 95%: 0.93-0.98) for waist circumference; 0.75 (IC 95%: 0.66-0.82) for fasting glucose; 0.50 (IC 95%:0.35-0.639) for HDL cholesterol; 0.78 (IC 95%: 0.70-0.84) for triglycerides; 0.49 (IC 95%:0.34-0.61) for systolic blood pressure and 0.55 (IC 95%: 0.41-0.65) for diastolic blood pressure. CONCLUSIONS: Self-reported MS based on self reported components of the SM in a Spanish cohort of university graduates was sufficiently valid as to be used in epidemiological studies

    Enzymatic extraction of hydroxycinnamic acids from coffee pulp

    Get PDF
    Ferulic, caffeic, p-coumaric and chlorogenic acids are classified as hydroxycinnamic acids, presenting anticarcinogenic, anti-inflammatory and antioxidant properties. In this work, enzymatic extraction has been studied in order to extract high value-added products like hydroxycinnamic acids from coffee pulp. A commercial pectinase and enzyme extract produced by Rhizomucor pusillus strain 23aIV in solid-state fermentation using olive oil or coffee pulp (CP) as an inducer of the feruloyl esterase activity were evaluated separately and mixed. The total content (covalently linked and free) of ferulic, caffeic, p-coumaric and chlorogenic acids was 5276 mg per kg of coffee pulp. Distribution was as follows (in %): chlorogenic acid 58.7, caffeic acid 37.6, ferulic acid 2.1 and p-coumaric acid 1.5. Most of the hydroxycinnamic acids were covalently bound to the cell wall (in %): p-coumaric acid 97.2, caffeic acid 94.4, chlorogenic acid 76.9 and ferulic acid 73.4. The content of covalently linked hydroxycinnamic acid was used to calculate the enzyme extraction yield. The maximum carbon dioxide rate for the solid-state fermentation using olive oil as an inducer was higher and it was reached in a short cultivation time. Nevertheless, the feruloyl esterase (FAE) activity (units per mg of protein) obtained in the fermentation using CP as an inducer was 31.8 % higher in comparison with that obtained in the fermentation using olive oil as the inducer. To our knowledge, this is the first report indicating the composition of both esterified and free ferulic, caffeic, p-coumaric and chlorogenic acids in coffee pulp. The highest yield of extraction of hydroxycinnamic acids was obtained by mixing the produced enzyme extract using coffee pulp as an inducer and a commercial pectinase. Extraction yields were as follows (in %): chlorogenic acid 54.4, ferulic acid 19.8, p-coumaric acid 7.2 and caffeic acid 2.3. An important increase in the added value of coffee pulp was mainly due to the extraction of chlorogenic acid

    Primordial nucleosynthesis with a varying fine structure constant: An improved estimate

    Full text link
    We compute primordial light-element abundances for cases with fine structure constant alpha different from the present value, including many sources of alpha dependence neglected in previous calculations. Specifically, we consider contributions arising from Coulomb barrier penetration, photon coupling to nuclear currents, and the electromagnetic components of nuclear masses. We find the primordial abundances to depend more weakly on alpha than previously estimated, by up to a factor of 2 in the case of ^7Li. We discuss the constraints on variations in alpha from the individual abundance measurements and the uncertainties affecting these constraints. While the present best measurements of primordial D/H, ^4He/H, and ^7Li/H may be reconciled pairwise by adjusting alpha and the universal baryon density, no value of alpha allows all three to be accommodated simultaneously without consideration of systematic error. The combination of measured abundances with observations of acoustic peaks in the cosmic microwave background favors no change in alpha within the uncertainties.Comment: Phys. Rev. D accepted version; minor changes in response to refere

    The neutral hydrogen cosmological mass density at z = 5

    Get PDF
    We present the largest homogeneous survey of z > 4.4 damped Lyα systems (DLAs) using the spectra of 163 QSOs that comprise the Giant Gemini GMOS (GGG) survey. With this survey we make the most precise high-redshift measurement of the cosmological mass density of neutral hydrogen, ΩHi. At such high redshift, important systematic uncertainties in the identification of DLAs are produced by strong intergalactic medium absorption and QSO continuum placement. These can cause spurious DLA detections, result in real DLAs being missed or bias the inferred DLA column density distribution. We correct for these effects using a combination of mock and higher resolution spectra, and show that for the GGG DLA sample the uncertainties introduced are smaller than the statistical errors on ΩHi. We find ΩHI=0.98+0.20−0.18×10−3 at 〈z〉 = 4.9, assuming a 20 per cent contribution from lower column density systems below the DLA threshold. By comparing to literature measurements at lower redshifts, we show that ΩHi can be described by the functional form ΩHI(z)∝(1+z)0.4. This gradual decrease from z = 5 to 0 is consistent with the bulk of H I gas being a transitory phase fuelling star formation, which is continually replenished by more highly ionized gas from the intergalactic medium and from recycled galactic winds
    • 

    corecore