Photo-electrochemical Hydrogen Sulfide Splitting using SnIV-doped Hematite Photo-anodes

© 2016 The Authors. Published by Elsevier B.V.Spray-pyrolysed SnIV-doped α-Fe2O3 photo-anodes were used for photo-assisted splitting of HS- ions in alkaline aqueous solutions, producing polysulfide (Sn2 -) ions together with hydrogen at the cathode. Subsequent aerial oxidation of polysulfide could be used to produce elemental sulfur. At an applied electrode potential of 1.07 V (RHE) and an irradiance of 5.6 kW m- 2, stable photocurrents of ca. 11 A m- 2 (2 × 10- 3 A W- 1) were recorded over 75 h, polysulfide concentrations increasing linearly with time. Despite being predicted thermodynamically to form iron sulfide(s) in sulfide solutions, such photo-anodes appeared to be stable. In comparison with conventional water splitting under alkaline conditions, the coupled processes of hydrogen sulfide ion oxidation and water reduction had a lower energy requirement

Cerebrospinal fluid adenosine deaminase activity: A complimentary tool in the early diagnosis of tuberculous meningitis

BACKGROUND: Tuberculous meningitis (TBM) is the commonest form of neurotuberculosis caused by Mycobacterium tuberculosis bacilli (MTB). The diagnosis of TBM is often difficult. A reliable, cost-effective and rapid diagnostic test, which can be performed in any standard pathology laboratory, could be of help in the diagnosis of TBM. In the present study we measured the adenosine deaminase (ADA) activity in cerebrospinal fluid (CSF) of TBM and non-TBM patients. METHOD: ADA activity in CSF was determined according to a method based on the Berthlot reaction, which is the formation of a colored indophenol complex from ammonia liberated from adenosine, and quantified spectrophotometrically. RESULTS: The CSF ADA activity from TBM patients was compared with CSF ADA from non-TBM infectious meningitis patients, and from patients with non-infectious neurological disorders. The mean CSF ADA activity was found to be significantly higher in CSF of TBM patients, 14.31 ± 3.87 (2.99–26.94), mean ± SD with range, than in the CSF from non-TBM infectious meningitis, 9.25 ± 2.14 (4.99–13.96) and from the non-infectious neurological disorders group, 2.71 ± 1.96 (0.00–7.68), P < 0.0001 for both comparisons. A cut-off value of 11.39 U/L/min for the TBM patients was calculated from the mean + SD of the non-TBM patients. The ADA test gave a sensitivity of 82% and a specificity of 83% for infectious TBM when this cut-off value was used. CONCLUSION: This study demonstrated that ADA activity in the CSF of TBM patients, using a cut-off value 11.39 U/L/min, can be useful for the early differential diagnosis of TBM. This test can be performed in any pathology laboratory where more sophisticated methods are not available

Effect of growth temperature on the structural, optical and luminescence properties of cadmium telluride nanoparticles

Cadmium telluride (CdTe) has been successfully prepared by a simple wet chemical process at different reaction temperatures. Temperature is one parameter that thermodynamically plays an important role in controlling the growth rate, morphology, size and size distribution of the as-prepared nanoparticles (NPs). Effect of this parameter was investigated on the growth, structural and optical properties of CdTe NPs. It was observed that the Powder X-ray diffraction (XRD) pattern for samples prepared at 50 °C had many impurities from unreacted precursors while those prepared at > 100 °C displayed polycrystalline NPs. The XRD results revealed that the structure of the CdTe NPs was cubic with the planes (111), (220), (311) being the main observed peaks. The crystallite sizes obtained from Scherrer formula increased with the increase in growth temperature (2.86–3.62 nm grown at 50–200 °C respectively). The scanning electron microscopy micrographs showed that the morphology of the nanoparticles possessed spherical-shaped particles over the entire surface. This was further confirmed by high resolution transmission electron microscopy micrographs which also displayed increase in the particle size with an increase in the growth temperature. In the optic study, the photoluminescence (PL) spectra displayed a red shift (540–560 nm) in emission as growth temperature increased from 50 to 200 °C. The highest PL peak intensity was realized at a growth temperature of 150 °C. Absorption band maxima were observed to shift towards longer wavelength for higher growth temperatures. The optical band gap decreased with increase in the growth temperature from 2.67 to 2.08 eV for 50–200 °C respectively

Annealing study and thermal investigation on bismuth sulfide thin films prepared by chemical bath deposition in basic medium

This is a post-peer-review, pre-copyedit version of an article published in Applied Physics A 124.2 (2018): 166. The final authenticated version is available online at: http://doi.org/10.1007/s00339-018-1584-7Bismuth sulfide thin films were prepared by chemical bath deposition using thiourea as sulfide ion source in basic medium. First, the effects of both the deposition parameters on films growth as well as the annealing effect under argon and sulfur atmosphere on as-deposited thin films were studied. The parameters were found to be influential using the Doehlert matrix experimental design methodology. Ranges for a maximum surface mass of films (3 mg cm-2) were determined. A well crystallized major phase of bismuth sulfide with stoichiometric composition was achieved at 190°C for 3 hours. The prepared thin films were characterized using Grazing Incidence X-ray diffraction (GIXRD), Scanning Electron Microscopy (SEM) and Energy Dispersive X-ray analysis (EDX). Second, the band gap energy value was found to be 1.5 eV. Finally, the thermal properties have been studied for the first time by means of the electropyroelectric (EPE) technique. Indeed, the thermal conductivity varied in the range of 1.20 - 0.60 W m-1 K-1 while the thermal diffusivity values increased in terms of the annealing effect ranging from 1.8 to 3.5 10-7 m2s-1This work was financially supported by the Tunisian Ministry of Higher Education and Scientific Research and by the WINCOST (ENE2016-80788-C5-2-R) project funded by the Spanish Ministry of Economy and Competitivenes

2-Hydroxylethyl methacrylate (HEMA), a tooth restoration component, exerts its genotoxic effects in human gingival fibroblasts trough methacrylic acid, an immediate product of its degradation

HEMA (2-hydroxyethyl methacrylate), a methacrylate commonly used in dentistry, was reported to induce genotoxic effects, but their mechanism is not fully understood. HEMA may be degraded by the oral cavity esterases or through mechanical stress following the chewing process. Methacrylic acid (MAA) is the primary product of HEMA degradation. In the present work we compared cytotoxic and genotoxic effects induced by HEMA and MAA in human gingival fibroblasts (HGFs). A 6-h exposure to HEMA or MAA induced a weak decrease in the viability of HGFs. Neither HEMA nor MAA induced strand breaks in the isolated plasmid DNA, but both compounds evoked DNA damage in HGFs, as evaluated by the alkaline comet assay. Oxidative modifications to the DNA bases were monitored by the DNA repair enzymes Endo III and Fpg. DNA damage induced by HEMA and MAA was not persistent and was removed during a 120 min repair incubation. Results from the neutral comet assay indicated that both compounds induced DNA double strand breaks (DSBs) and they were confirmed by the γ-H2AX assay. Both compounds induced apoptosis and perturbed the cell cycle. Therefore, methacrylic acid, a product of HEMA degradation, may be involved in its cytotoxic and genotoxic action

Micropropagation and conservation of selected endangered anticancer medicinal plants from the Western Ghats of India

Globally, cancer is a constant battle which severely affects the human population. The major limitations of the anticancer drugs are the deleterious side effects on the quality of life. Plants play a vital role in curing many diseases with minimal or no side effects. Phytocompounds derived from various medicinal plants serve as the best source of drugs to treat cancer. The global demand for phytomedicines is mostly reached by the medicinal herbs from the tropical nations of the world even though many plant species are threatened with extinction. India is one of the mega diverse countries of the world due to its ecological habitats, latitudinal variation, and diverse climatic range. Western Ghats of India is one of the most important depositories of endemic herbs. It is found along the stretch of south western part of India and constitutes rain forest with more than 4000 diverse medicinal plant species. In recent times, many of these therapeutically valued herbs have become endangered and are being included under the red-listed plant category in this region. Due to a sharp rise in the demand for plant-based products, this rich collection is diminishing at an alarming rate that eventually triggered dangerous to biodiversity. Thus, conservation of the endangered medicinal plants has become a matter of importance. The conservation by using only in situ approaches may not be sufficient enough to safeguard such a huge bio-resource of endangered medicinal plants. Hence, the use of biotechnological methods would be vital to complement the ex vitro protection programs and help to reestablish endangered plant species. In this backdrop, the key tools of biotechnology that could assist plant conservation were developed in terms of in vitro regeneration, seed banking, DNA storage, pollen storage, germplasm storage, gene bank (field gene banking), tissue bank, and cryopreservation. In this chapter, an attempt has been made to critically review major endangered medicinal plants that possess anticancer compounds and their conservation aspects by integrating various biotechnological tool