INDUSTRIAL DEVELOPMENT IN A DEPRESSED AREA: MALE-FEMALE DIFFERENCES IN ATTITUDES

Community/Rural/Urban Development,

Complementary Sensory and Associative Microcircuitry in Primary Olfactory Cortex

The three-layered primary olfactory (piriform) cortex is the largest component of the olfactory cortex. Sensory and intracortical inputs converge on principal cells in the anterior piriform cortex (aPC).Wecharacterize organization principles of the sensory and intracortical microcircuitry of layer II and III principal cells in acute slices of rat aPC using laser-scanning photostimulation and fast two-photon population Ca²⁺ imaging. Layer II and III principal cells are set up on a superficial-to-deep vertical axis. We found that the position on this axis correlates with input resistance and bursting behavior. These parameters scale with distinct patterns of incorporation into sensory and associative microcircuits, resulting in a converse gradient of sensory and intracortical inputs. In layer II, sensory circuits dominate superficial cells, whereas incorporation in intracortical circuits increases with depth. Layer III pyramidal cells receive more intracortical inputs than layer II pyramidal cells, but with an asymmetric dorsal offset. This microcircuit organization results in a diverse hybrid feedforward/recurrent network of neurons integrating varying ratios of intracortical and sensory input depending on a cell’s position on the superficial-to-deep vertical axis. Since burstiness of spiking correlates with both the cell’s location on this axis and its incorporation in intracortical microcircuitry, the neuronal output mode may encode a given cell’s involvement in sensory versus associative processing

Pacemaker implantation in small hospitals: complication rates comparable to larger centres

Some countries have a demography that makes it necessary to maintain relatively small pacemaker centres. We wanted to assess the quality of pacemaker surgery in two such hospitals. Through patient records we gathered information on ∼535 consecutive primary pacemaker implantations in two small pacemaker centres with 30 and 80 annual operations, respectively. All patients were followed for 3 years. All complications documented in the patient records were registered. Furthermore, we performed a non-systematic literature search comparing our data with reports from major centres published over the last 10 years.We found 72 complications in 64 (12.0%) of the patients, the most common being bleeding, lead failure, and pneumothorax. If minor bleedings without any consequences for the patients are excluded, the number of complications was 46 in 40 patients (7.5%). We had to reoperate on 5.2% of the patients. There was no statistically significant difference in complication rates between the two hospitals. Education candidates generated statistically significant more complications than experienced doctors (13.7 vs. 7.1%, P < 0.05). There are no generally accepted norms of complication rates in pacemaker surgery. However, we found no indications that our centres have a rate of complications that is unacceptably high

Measurement of heavy-hole spin dephasing in (InGa)As quantum dots

We measure the spin dephasing of holes localized in self-assembled (InGa)As quantum dots by spin noise spectroscopy. The localized holes show a distinct hyperfine interaction with the nuclear spin bath despite the p-type symmetry of the valence band states. The experiments reveal a short spin relaxation time {\tau}_{fast}^{hh} of 27 ns and a second, long spin relaxation time {\tau}_{slow}^{hh} which exceeds the latter by more than one order of magnitude. The two times are attributed to heavy hole spins aligned perpendicular and parallel to the stochastic nuclear magnetic field. Intensity dependent measurements and numerical simulations reveal that the long relaxation time is still obscured by light absorption, despite low laser intensity and large detuning. Off-resonant light absorption causes a suppression of the spin noise signal due to the creation of a second hole entailing a vanishing hole spin polarization.Comment: accepted to be published in AP

Accumulation of formamide in hydrothermal pores to form prebiotic nucleobases

Formamide is one of the important compounds from which prebiotic molecules can be synthesized, provided that its concentration is sufficiently high. For nucleotides and short DNA strands, it has been shown that a high degree of accumulation in hydrothermal pores occurs, so that temperature gradients might play a role in the origin of life [Baaske P, et al. (2007) Proc Natl Acad Sci USA 104(22):9346−9351]. We show that the same combination of thermophoresis and convection in hydrothermal pores leads to accumulation of formamide up to concentrations where nucleobases are formed. The thermophoretic properties of aqueous formamide solutions are studied by means of Infrared Thermal Diffusion Forced Rayleigh Scattering. These data are used in numerical finite element calculations in hydrothermal pores for various initial concentrations, ambient temperatures, and pore sizes. The high degree of formamide accumulation is due to an unusual temperature and concentration dependence of the thermophoretic behavior of formamide. The accumulation fold in part of the pores increases strongly with increasing aspect ratio of the pores, and saturates to highly concentrated aqueous formamide solutions of ∼85 wt% at large aspect ratios. Time-dependent studies show that these high concentrations are reached after 45–90 d, starting with an initial formamide weight fraction of 10−3 wt % that is typical for concentrations in shallow lakes on early Earth

Impact of laminar flow velocity of different acids on enamel calcium loss

Objective: The aim of the study was to evaluate the impact of flow velocity under laminar flow conditions of different acidic solutions on enamel erosion. Material and methods: A total of 240 bovine enamel specimens were prepared and allocated to 30 groups (n = 8 each). Samples of 18 groups were superfused in a flow chamber system with laminar flow behavior using 1ml of citric acid or hydrochloric acid (HCl) of pH 2.0, 2.6 or 3.0. Flow rates in the sample chamber were adjusted to 10, 60 or 100μl/min. To simulate turbulent flow behavior, samples of six groups were immersed in 1ml of the respective solution, which was vortexed (15min, 600rpm). For simulating non-agitated conditions, specimens of the remaining six groups were immersed in 1ml of the respective solution without stirring. Calcium in the solutions, released from the enamel samples, was determined using Arsenazo III method. Results: For acidic solutions of pH 2.6 and 3.0, erosive potential of citric acid was equivalent to that of HCl at a flow of 100μl/min. The same observation was made for the samples subjected to turbulent conditions at pH 3. At all other conditions, citric acid induced a significantly higher calcium loss than HCl. Conclusion: It is concluded that under slow laminar flow conditions, flow rate variations lead to higher erosive impact of citric acid compared to hydrochloric acid at pH 2.0, but not at pH ≥ 2.6 and increasing laminar flow or turbulent conditions. Clinical relevance: Erosive enamel dissolution under laminar flow conditions is a complex issue influenced by flow rate and acidic substrat

Use of soil moisture information in yield models

There are no author-identified significant results in this report

Derivation of coarse-grained simulation models of chlorophyll molecules in lipid bilayers for applications in light harvesting systems

The correct interplay of interactions between protein, pigment and lipid molecules is highly relevant for our understanding of the association behavior of the light harvesting complex (LHCII) of green plants. To cover the relevant time and length scales in this multicomponent system, a multi-scale simulation ansatz is employed that subsequently uses a classical all atomistic (AA) model to derive a suitable coarse grained (CG) model which can be backmapped into the AA resolution, aiming for a seamless conversion between two scales. Such an approach requires a faithful description of not only the protein and lipid components, but also the interaction functions for the indispensable pigment molecules, chlorophyll b and chlorophyll a (referred to as chl b/chl a). In this paper we develop a CG model for chl b and chl a in a dipalmitoylphosphatidyl choline (DPPC) bilayer system. The structural properties and the distribution behavior of chl within the lipid bilayer in the CG simulations are consistent with those of AA reference simulations. The non-bonded potentials are parameterized such that they fit to the thermodynamics based MARTINI force-field for the lipid bilayer and the protein. The CG simulation shows chl aggregation in the lipid bilayer which is supported by fluorescence quenching experiments. It is shown that the derived chl model is well suited for CG simulations of stable, structurally consistent, trimeric LHCII and can in the future be used to study their large scale aggregation behavior.publishe