Microstructural Changes in Wheat Starch Dispersions During Heating and Cooling

Microstructural changes in 8-11% wheat starch dispersions during heating, cooling and cold storage have been evaluated by light microscopy and scanning electron microscopy. Heat treatment of wheat starch dispersions gives rise to two stages of swelling and solubilization. During the first phase of swelling, solubilized amylose was observed ln the centre of the granules and, to some extent, outside the granules. Further swelling deformed the granules and more amylose was released. When the temperature treatment took place under shear, the outer layer of the swo llen granules fra ctured at 94°C and above, and amylopectin fragments were dispersed into the cont inuous amylose phase. Fragmentation of amylopectin was not observed when samples were heated with a minimum of mechanical action. There were also differences in the final gel structure between samples due to the mechanical treatment during preparation. Aggregation of amylose took place on cooling and could be observed as irregularities in the gel structure. When the amount of released amylose was limited during the initial phase of swelling and below the critical concentration for gel formation, cooling resulted in deposition of amylose at the surface of the granules. This was expected to have an impact on the behaviour of the granules on further processing

Microstructure and Rheological Properties of Composites of Potato Starch Granules and Amylose: A Comparison of Observed and Predicted Structures

Potato starch granules were gelatinised in amylose solution to study the effect of adding amylose to a highswelling granular starch system. The effects of varying the amount of potato starch from 1-10% , added to a solution of 2% amylose, were studied by means of dynamic viscoelastic measurements and light microscopy. The granules gelatinised in amylose solution had a lower degree of swelling than those gelatinised in water. The restricted swelling in amylose was reflected in a decrease in the complex shear modulus (G*) at 75\u27C. GeJatinisation in 2% amylopectin also caused a decrease in G*, but gelatinisation in 2% 0-glucose did not affect the rheological behaviour. Microstructural analysis showed that the added amylose was present outside the granules after swelling, whereas the inherent amylose from the potato starch seemed to have diffused main] y to the inner aqueous centre of the granules. The mixed potato starch/amylose systems showed a fast gelation comparable to that of cereal starch. The results were analysed by a model predicting the shear modulus of aqueous biphasic gels. When the system is regarded as a continuous network of added amylose with dispersed potato starch granules, the results from both microscopy and rheology are in excellent agreement with the model at potato starch concentrations below 6%. As the potato starch concentration was raised, the high swelling potential of the potato starch granules led to partial disruption of the continuous amylose network. The results imply that the inherent amylose from potato starch did not contribute to the gel strength caused by the added solubilised amylose

Immunohistochemical Techniques Applied to Raw and Mildly Heat Treated Meat Systems

Immunohistology was performed with six commercially available antibodies directed against myosins, actins and collagens. The corresponding antigens, appearing on the surface of cryo-sections from meat and meat products heat treated to different end temperatures, were visualized using these antibodies. The meat and meat products were heated from 20 °C to 80 °C. At 80 °C the meat systems were devoid of thermal transitions as judged from differential scanning calorimetric measurements. Our results showed that although reduced binding was the case for systems heated above 60 °C, the signals from the antibody labelling was still sufficiently strong to provide information about specific antigens in meat systems heated to 70-80 °C. Antibodies with a high initial affinity bound to the their respective antigens after the latter had been heated to a few degrees above their denaturation temperature as detected in a scanning calorimeter. This investigation points to the possibility of fmding sufficiently good commercial antibodies to perform immunohistology on meat products heated to temperatures between 70-80 °C. This is important as many commercial meat products are heated to end temperatures in this range. Several examples of the labelling intensity obtained on heated meat and meat products are given. In addition, an example using double labelling with antibodies to collagen III and an antibody to slow myosin in a food product heated to 75 °C is given. Problems related to non-specific staining and to non-specific effects of heat treatment are also briefly discussed

Oxygen for breathlessness in patients with chronic obstructive pulmonary disease who do not qualify for home oxygen therapy

© 2016 The Cochrane Collaboration. Published by John Wiley & Sons, Ltd. Background: Breathlessness is a cardinal symptom of chronic obstructive pulmonary disease (COPD). Long-term oxygen therapy (LTOT) is given to improve survival time in people with COPD and severe chronic hypoxaemia at rest. The efficacy of oxygen therapy for breathlessness and health-related quality of life (HRQOL) in people with COPD and mild or no hypoxaemia who do not meet the criteria for LTOT has not been established. Objectives: To determine the efficacy of oxygen versus air in mildly hypoxaemic or non-hypoxaemic patients with COPD in terms of (1) breathlessness; (2) HRQOL; (3) patient preference whether to continue therapy; and (4) oxygen-related adverse events. Search methods: We searched the Cochrane Airways Group Register, the Cochrane Central Register of Controlled Trials (CENTRAL), MEDLINE and Embase, to 12 July 2016, for randomised controlled trials (RCTs). We handsearched the reference lists of included articles. Selection criteria: We included RCTs of the effects of non-invasive oxygen versus air on breathlessness, HRQOL or patient preference to continue therapy among people with COPD and mild or no hypoxaemia (partial pressure of oxygen (PaO2) > 7.3 kPa) who were not already receiving LTOT. Two review authors independently assessed articles for inclusion in the review. Data collection and analysis: Two review authors independently collected and analysed data. We assessed risk of bias by using the Cochrane 'Risk of bias tool'. We pooled effects recorded on different scales as standardised mean differences (SMDs) with 95% confidence intervals (CIs) using random-effects models. Lower SMDs indicated decreased breathlessness and reduced HRQOL. We performed subanalyses and sensitivity analyses and assessed the quality of evidence according to the Grading of Recommendations, Assessment, Development and Evaluations (GRADE) approach. Main results: Compared with the previous review, which was published in 2011, we included 14 additional studies (493 participants), excluded one study and included data for meta-analysis of HRQOL. In total, we included in this review 44 studies including 1195 participants, and we included 33 of these (901 participants)in the meta-analysis. We found that breathlessness during exercise or daily activities was reduced by oxygen compared with air (32 studies; 865 participants; SMD -0.34, 95% CI -0.48 to -0.21; I2 = 37%; low-quality evidence). This translates to a decrease in breathlessness of about 0.7 points on a 0 to 10 numerical rating scale. In contrast, we found no effect of short-burst oxygen given before exercise (four studies; 90 participants; SMD 0.01, 95% CI -0.26 to 0.28; I2 = 0%; low-quality evidence). Oxygen reduced breathlessness measured during exercise tests (25 studies; 442 participants; SMD -0.34, 95% CI -0.46 to -0.22; I2 = 29%; moderate-quality evidence), whereas evidence of an effect on breathlessness measured in daily life was limited (two studies; 274 participants; SMD -0.13, 95% CI, -0.37 to 0.11; I2 = 0%; low-quality evidence). Oxygen did not clearly affect HRQOL (five studies; 267 participants; SMD 0.10, 95% CI -0.06 to 0.26; I2 = 0%; low-quality evidence). Patient preference and adverse events could not be analysed owing to insufficient data. Authors' conclusions: We are moderately confident that oxygen can relieve breathlessness when given during exercise to mildly hypoxaemic and non-hypoxaemic people with chronic obstructive pulmonary disease who would not otherwise qualify for home oxygen therapy. Most evidence pertains to acute effects during exercise tests, and no evidence indicates that oxygen decreases breathlessness in the daily life setting. Findings show that oxygen does not affect health-related quality of life

Interacting supernovae and supernova impostors. SN 2007sv: the major eruption of a massive star in UGC 5979

We report the results of the photometric and spectroscopic monitoring campaign of the transient SN 2007sv. The observables are similar to those of type IIn supernovae, a well-known class of objects whose ejecta interact with pre-existing circum-stellar material. The spectra show a blue continuum at early phases and prominent Balmer lines in emission, however, the absolute magnitude at the discovery of SN 2007sv (M_R = - 14.25 +/- 0.38) indicate it to be most likely a supernova impostor. This classification is also supported by the lack of evidence in the spectra of very high velocity material as expected in supernova ejecta. In addition we find no unequivocal evidence of broad lines of alpha - and/or Fe-peak elements. The comparison with the absolute light curves of other interacting objects (including type IIn supernovae) highlights the overall similarity with the prototypical impostor SN 1997bs. This supports our claim that SN 2007sv was not a genuine supernova, and was instead a supernova impostor, most likely similar to the major eruption of a luminous blue variable.Comment: Accepted for publication in MNRAS. 15 pages, 11 figures, 5 table

Oxygen vacancies versus fluorine at CeO2(111): a case of mistaken identity?

We propose a resolution to the puzzle presented by the surface defects observed with STM at the (111) surface facet of CeO2 single crystals. In the seminal paper of Esch et al. [Science 309, 752 (2005)] they were identified with oxygen vacancies, but the observed behavior of these defects is inconsistent with the results of density functional theory (DFT) studies of oxygen vacancies in the literature. We resolve these inconsistencies via DFT calculations of the properties of both oxygen vacancies and fluorine impurities at CeO2(111), the latter having recently been shown to exist in high concentrations in single crystals from a widely used commercial source of such samples. We find that the simulated filled-state STM images of surface-layer oxygen vacancies and fluorine impurities are essentially identical, which would render problematic their experimental distinction by such images alone. However, we find that our theoretical results for the most stable location, mobility, and tendency to cluster, of fluorine impurities are consistent with experimental observations, in contrast to those for oxygen vacancies. Based on these results, we propose that the surface defects observed in STM experiments on CeO2 single crystals reported heretofore were not oxygen vacancies, but fluorine impurities. Since the similarity of the simulated STM images of the two defects is due primarily to the relative energies of the 2p states of oxygen and fluorine ions, this confusion might also occur for other oxides which have been either doped or contaminated with fluorine

The acceleration and storage of radioactive ions for a neutrino factory

The term beta-beam has been coined for the production of a pure beam of electron neutrinos or their antiparticles through the decay of radioactive ions circulating in a storage ring. This concept requires radioactive ions to be accelerated to a Lorentz gamma of 150 for 6He and 60 for 18Ne. The neutrino source itself consists of a storage ring for this energy range, with long straight sections in line with the experiment(s). Such a decay ring does not exist at CERN today, nor does a high-intensity proton source for the production of the radioactive ions. Nevertheless, the existing CERN accelerator infrastructure could be used as this would still represent an important saving for a beta-beam facility. This paper outlines the first study, while some of the more speculative ideas will need further investigations.Comment: Accepted for publication in proceedings of Nufact02, London, 200

Transformation kinetics of alloys under non-isothermal conditions

The overall solid-to-solid phase transformation kinetics under non-isothermal conditions has been modeled by means of a differential equation method. The method requires provisions for expressions of the fraction of the transformed phase in equilibrium condition and the relaxation time for transition as functions of temperature. The thermal history is an input to the model. We have used the method to calculate the time/temperature variation of the volume fraction of the favored phase in the alpha-to-beta transition in a zirconium alloy under heating and cooling, in agreement with experimental results. We also present a formulation that accounts for both additive and non-additive phase transformation processes. Moreover, a method based on the concept of path integral, which considers all the possible paths in thermal histories to reach the final state, is suggested.Comment: 16 pages, 7 figures. To appear in Modelling Simul. Mater. Sci. En

Implications of the BATTERY 2030+ AI-Assisted Toolkit on Future Low-TRL Battery Discoveries and Chemistries

Funder: Swedish national Strategic e‐Science programmeFunder: Deutsche Forschungsgemeinschaft; Id: http://dx.doi.org/10.13039/501100001659BATTERY 2030+ targets the development of a chemistry neutral platform for accelerating the development of new sustainable high-performance batteries. Here, a description is given of how the AI-assisted toolkits and methodologies developed in BATTERY 2030+ can be transferred and applied to representative examples of future battery chemistries, materials, and concepts. This perspective highlights some of the main scientific and technological challenges facing emerging low-technology readiness level (TRL) battery chemistries and concepts, and specifically how the AI-assisted toolkit developed within BIG-MAP and other BATTERY 2030+ projects can be applied to resolve these. The methodological perspectives and challenges in areas like predictive long time- and length-scale simulations of multi-species systems, dynamic processes at battery interfaces, deep learned multi-scaling and explainable AI, as well as AI-assisted materials characterization, self-driving labs, closed-loop optimization, and AI for advanced sensing and self-healing are introduced. A description is given of tools and modules can be transferred to be applied to a select set of emerging low-TRL battery chemistries and concepts covering multivalent anodes, metal-sulfur/oxygen systems, non-crystalline, nano-structured and disordered systems, organic battery materials, and bulk vs. interface-limited batteries

Impacts of exhaust gas cleaning systems (EGCS) discharge waters on planktonic biological indicators

Exhaust Gas Cleaning Systems (EGCS), operating in open-loop mode, continuously release acidic effluents (scrubber waters) to marine waters. Furthermore, scrubber waters contain high concentrations of metals, polycyclic aromatic hydrocarbons (PAHs), and alkylated PAHs, potentially affecting the plankton in the receiving waters. Toxicity tests evidenced significant impairments in planktonic indicators after acute, early-life stage, and long-term exposures to scrubber water produced by a vessel operating with high sulphur fuel. Acute effects on bacterial bioluminescence (Aliivibrio fischeri), algal growth (Phaeodactylum tricornutum, Dunaliella tertiolecta), and copepod survival (Acartia tonsa) were evident at 10 % and 20 % scrubber water, while larval development in mussels (Mytilus galloprovincialis) showed a 50 % reduction at ∼5 % scrubber water. Conversely, larval development and reproductive success of A. tonsa were severely affected at scrubber water concentrations ≤1.1 %, indicating the risk of severe impacts on copepod populations which in turn may result in impairment of the whole food web