Advanced Gas Turbine (AGT) powertrain system

A 74.5 kW(100 hp) advanced automotive gas turbine engine is described. A design iteration to improve the weight and production cost associated with the original concept is discussed. Major rig tests included 15 hours of compressor testing to 80% design speed and the results are presented. Approximately 150 hours of cold flow testing showed duct loss to be less than the design goal. Combustor test results are presented for initial checkout tests. Turbine design and rig fabrication is discussed. From a materials study of six methods to fabricate rotors, two have been selected for further effort. A discussion of all six methods is given

Advanced Gas Turbine (AGT) power-train system development

Technical work on the design and component testing of a 74.5 kW (100 hp) advanced automotive gas turbine is described. Selected component ceramic component design, and procurement were tested. Compressor tests of a modified rotor showed high speed performance improvement over previous rotor designs; efficiency improved by 2.5%, corrected flow by 4.6%, and pressure ratio by 11.6% at 100% speed. The aerodynamic design is completed for both the gasifier and power turbines. Ceramic (silicon carbide) gasifier rotors were spin tested to failure. Improving strengths is indicated by burst speeds and the group of five rotors failed at speeds between 104% and 116% of engine rated speed. The emission results from combustor testing showed NOx levels to be nearly one order of magnitude lower than with previous designs. A one piece ceramic exhaust duct/regenerator seal platform is designed with acceptable low stress levels

Closed-loop recycling of plastics enabled by dynamic covalent diketoenamine bonds.

Recycled plastics are low-value commodities due to residual impurities and the degradation of polymer properties with each cycle of re-use. Plastics that undergo reversible polymerization allow high-value monomers to be recovered and re-manufactured into pristine materials, which should incentivize recycling in closed-loop life cycles. However, monomer recovery is often costly, incompatible with complex mixtures and energy-intensive. Here, we show that next-generation plastics-polymerized using dynamic covalent diketoenamine bonds-allow the recovery of monomers from common additives, even in mixed waste streams. Poly(diketoenamine)s 'click' together from a wide variety of triketones and aromatic or aliphatic amines, yielding only water as a by-product. Recovered monomers can be re-manufactured into the same polymer formulation, without loss of performance, as well as other polymer formulations with differentiated properties. The ease with which poly(diketoenamine)s can be manufactured, used, recycled and re-used-without losing value-points to new directions in designing sustainable polymers with minimal environmental impact

Nutritional strategies of British professional and amateur natural bodybuilders during competition preparation

Background: To prepare for competition, bodybuilders employ strategies based around: energy restriction, resistance training, cardiovascular exercise, isometric "posing", and supplementation. Cohorts of professional (PRO) natural bodybuilders offer insights into how these strategies are implemented by elite competitors, and are undocumented in the scientific literature. Methods: Forty-seven competitors (33 male (8 PRO, 25 amateur (AMA), 14 female (5 PRO, 9 AMA) participated in the study. All PROs were eligible to compete with the Drug Free Athletes Coalition (DFAC), and all AMAs were recruited from the British Natural Bodybuilding Federation (BNBF). Competitors in these organisations are subject to a polygraph and are drug tested in accordance with the World Anti-Doping Agency. We report the results of a cross-sectional study of drug free bodybuilders competing at BNBF qualifying events, and the DFAC and World Natural Bodybuilding Federation finals. Participants completed a 34-item questionnaire assessing dietary intake at three time points (start, middle and end) of competition preparation. Participants recorded their food intake over a 24-h period in grams and/or portions. Dietary intakes of PRO and AMA competitors were then compared. Repeated measures ANOVA was used to test if nutrient intake changed over time, and for associations with division. Results: Male PROs reported significantly (p < 0.05) more bodybuilding experience than AMAs (PRO: 12.3 +/- 9.2, AMA: 2.4 +/- 1.4 yrs). Male PROs lost less body mass per week (PRO: 0.5 +/- 0.1, AMA: 0.7 +/- 0.2%, p < 0.05), and reported more weeks dieting (PRO: 28.1 +/- 8.1, AMA: 21.0 +/- 9.4 wks, P = 0.06). Significant differences (p < 0.05) of carbohydrate and energy were also recorded, as well as a difference (p = 0.03) in the estimated energy deficit (EED), between male PRO (2.0 +/- 5.5 kcal) and AMA (- 3.4 +/- 5.5 kcal) competitors. Conclusions: Longer diets and slower weight loss utilized by PROs likely contributed towards a lower EED compared to the AMAs. Slower weight loss may constitute an effective strategy for maintaining energy availability and muscle mass during an energy deficit. These findings require corroboration, but will interest bodybuilders and coaches

Advanced Gas Turbine (AGT): Power-train system development

Technical work on the design and effort leading to the testing of a 74.5 kW (100 hp) automotive gas turbine is described. The general effort was concentrated on building an engine for test starting in July. The buildup progressed with only routine problems and the engine was delivered to the test stand 9 July. In addition to the engine build effort, work continued in selected component areas. Ceramic turbine parts were built and tested. Burst tests of ceramic rotors show strengths are approaching that achieved in test bars; proof testing is required for acceptable strength ceramic vanes. Over 25 hours was accumulated on the combustor rig in three test modes: pilot nozzle only, start nozzle, and main nozzle operation. Satisfactory ignition was achieved for a wide range of starting speeds and the lean blowout limit was as low as 0.06 kg/b (0.14 lb/hr). Lean blowout was more a function of nozzle atomization than fuel/air ratio. A variety of cycle points were tested. Transition from start nozzle flow to main nozzle flow was done manually without difficulty. Regenerator parts were qualification tested without incident and the parts were assembled on schedule. Rig based performance matched first build requirements. Repeated failures in the harmonic drive gearbox during rig testing resulted in that concept being abandoned for an alternate scheme

Response of selected microorganisms to experimental planetary environments

The anaerobic utilization of phosphite or phosphine and the significance of this conversion to potential contamination of Jupiter were investigated. A sporeforming organism was isolated from Cape Canaveral soil which anaerobically converts hypophosphite to phosphate. This conversion coincides with an increase in turbidity of the culture and with phosphate accumulation in the medium. Investigations of omnitherms (organisms which grow over a broad temperature range, i.e. 3 -55 C were also conducted. The cellular morphology of 28 of these isolates was investigated, and all were demonstrated to be sporeformers. Biochemical characterizations are also presented. Procedures for replicate plating were evaluated, and those results are also presented. The procedures for different replicate-plating techniques are presented, and these are evaluated on the basis of reproducibility, percentage of viable transfer, and ease of use. Standardized procedures for the enumeration of microbial populations from ocean-dredge samples from Cape Canaveral are also presented

A Fascinating Polynomial Sequence arising from an Electrostatics Problem on the Sphere

A positive unit point charge approaching from infinity a perfectly spherical isolated conductor carrying a total charge of +1 will eventually cause a negatively charged spherical cap to appear. The determination of the smallest distance $\rho(d)$ ($d$ is the dimension of the unit sphere) from the point charge to the sphere where still all of the sphere is positively charged is known as Gonchar's problem. Using classical potential theory for the harmonic case, we show that $1+\rho(d)$ is equal to the largest positive zero of a certain sequence of monic polynomials of degree $2d-1$ with integer coefficients which we call Gonchar polynomials. Rather surprisingly, $\rho(2)$ is the Golden ratio and $\rho(4)$ the lesser known Plastic number. But Gonchar polynomials have other interesting properties. We discuss their factorizations, investigate their zeros and present some challenging conjectures.Comment: 12 pages, 6 figures, 1 tabl

Drawing the Line: How African, Caribbean and White British Women Live Out Psychologically Abusive Experiences

The final, definitive version of this paper has been published in Violence Against Women, 19 (9):1104-32, Sept 2013 by SAGE Publications Ltd, All rights reserved. © The Author(s) 2013. The online version of this article can be found at: http://vaw.sagepub.com/content/19/9/110

Motherhood, Moral Authority and the Charismatic Matriarch in the Aftermath of Lethal Violence

Images of maternal suffering are an evocative and powerful means of communication in a world where the private grief of victims has increasingly become subject to commodification and public consumption. This article looks at the influence of bereaved mothers as symbols of respect, peace and dignity in the aftermath of violence, and as a result their persuasive presence in family activism. Drawing upon two case studies, this article explores the importance of victims’ stories in public life and, in particular, the presence of the charismatic matriarch in creating communities of solidarity, raising awareness of harms that have previously gone unheard and prompting policy change. It considers the ‘canonical’ story of the mother in public life and concludes by arguing that more attention should be paid to victims’ stories and their influence on policy-making, politics and eventually in becoming public grievances

Structure and oxidation kinetics of the Si(100)-SiO2 interface

We present first-principles calculations of the structural and electronic properties of Si(001)-SiO2 interfaces. We first arrive at reasonable structures for the c-Si/a-SiO2 interface via a Monte-Carlo simulated annealing applied to an empirical interatomic potential, and then relax these structures using first-principles calculations within the framework of density-functional theory. We find a transition region at the interface, having a thickness on the order of 20\AA, in which there is some oxygen deficiency and a corresponding presence of sub-oxide Si species (mostly Si^+2 and Si^+3). Distributions of bond lengths and bond angles, and the nature of the electronic states at the interface, are investigated and discussed. The behavior of atomic oxygen in a-SiO2 is also investigated. The peroxyl linkage configuration is found to be lower in energy than interstitial or threefold configurations. Based on these results, we suggest a possible mechanism for oxygen diffusion in a-SiO2 that may be relevant to the oxidation process.Comment: 7 pages, two-column style with 6 postscript figures embedded. Uses REVTEX and epsf macros. Also available at http://www.physics.rutgers.edu/~dhv/preprints/index.html#ng_sio