Radio over fibre distribution systems for ultra-wide band and millimetre wave applications

Short range wireless technology such as ultra-wideband (UWB) and 60 GHz millimetre wave (mm-wave) play a key role for wireless connectivity in indoor home, office environment or large enclosed public areas. UWB has been allocated at the frequency band 3.1-10.6 GHz with an emission power below -41.3 dBm. Mm-wave signals around 60 GHz have also attracted much attention to support high-speed data for short range wireless applications. The wide bandwidth and high allowable transmit power at 60 GHz enable multi-Gbps wireless transmission over typical indoor distances. Radio-over-fibre (RoF) systems are used to extend the propagation distance of both UWB and mm-wave signals over hundred of meters inside a building. UWB or mm-wave signals over fibre can be generated first at the central office before being distributed to the remote access points through optical fibre. In this work, we investigate two new techniques to generate and distribute UWB signals. These techniques are based on generating Gaussian pulse position modulation (PPM) using a gain switched laser (GSL). The simulation and experimental results have been carried out to show the suitability of employing gain switching in UWB over fibre systems (UWBoF) to develop a reliable, simple, and low cost technique for distributing UWB pulses. The second part of this work proposes two configurations for optical mm-wave generation and transmission of 3 Gbps downstream data based on GSL. We investigate the distribution of these two methods over fibre with wireless link, and demonstrate the system simplicity and cost efficiency for mm-wave over fibre systems. Both configurations are simulated to verify our obtained results and show system performance at higher bit rates. In the third part, we generate phase modulated mm-waves by using an external injection of a modulated light source into GSL. The performance of this system is experimentally investigated and simulated for different fiber links

Optical generation and wireless transmission of 60 GHz OOK signals using gain switched laser

We present a novel, simple and cost effective system for optical millimeter-wave generation and transmission of 3 Gbps data based on gain switching. System performance has been investigated, including wireless transmission and power budget analysis

An IR-UWB photonic distribution system

Experimental results are presented for a novel distribution system for an impulse radio ultra-wideband (UWB) radio signals employing a gain-switched laser. The pulse position modulated short optical pulses with a bit rate of 1.25 Gb/s are transmitted over fiber to a remote antenna unit, where the signal is converted to the electrical domain and undergoes spectral shaping to remove unwanted components according to UWB requirements. An experimental radio terminal has also been constructed to enable bit-error-rate measurements to be carried out. These experiments show that the optical distribution system will be capable of supporting the radio part of the system

Demonstrating doubly-differential quadrature phase shift keying in the optical domain

We report for the first time the experimental demonstration of doubly differential quadrature phase shift keying (DDQPSK) using optical coherent detection. This method is more robust against high frequency offsets (FO) than conventional single differential quadrature phase shift keying (SDQPSK) with offset compensation. DDQPSK is shown to be able to compensate large FOs (up to the baud rate) and has lower computational requirements than other FO compensation methods. DDQPSK is a simple algorithm to implement in a real-time decoder for optical burst switched network scenarios. Simulation results are also provided, which show good agreement with the experimental results for both SDQPSK and DDQPSK transmissions

Pilot-tone assisted 16-QAM photonic wireless bridge operating at 250 GHz

A photonic wireless bridge operating at a carrier frequency of 250 GHz is proposed and demonstrated. To mitigate the phase noise of the free-running lasers present in such a link, the tone-assisted carrier recovery is used. Compared to the blind phase noise compensation (PNC) algorithm, this technique exhibited penalties of 0.15 dB and 0.46 dB when used with aggregated Lorentzian linewidths of 28 kHz and 359 kHz, respectively, and 20 GBd 16-quadrature amplitude modulation (QAM) signals. The wireless bridge is also demonstrated in a wavelength division multiplexing (WDM) scenario, where 5 optical channels are generated and sent to the Tx remote antenna unit (RAU). In this configuration, the full band from 224 GHz to 294 GHz is used. Finally, a 50 Gbit/s transmission is achieved with the proposed wireless bridge in single channel configuration. The wireless transmission distance is limited to 10 cm due to the low power emitted by the uni-travelling carrier photodiode used in the experiments. However, link budget calculations based on state-of-the-art THz technology show that distances >1000 m can be achieved with this approach.Comment: 13 pages, in Journal of Lightwave Technolog

Electro-optical generation and distribution of ultrawideband signals based on the gain switching technique

We demonstrate and compare the generation and distribution of pulse position modulation (PPM) ultrawideband (UWB) signals, based on two different techniques using a gain-switched laser (GSL). One uses a GSL followed by two external modulators, while the second technique employs two laser diodes gain switched (GS) using a combined signal from a pattern generator and an RF signal generator. Bit-error-rate (BER) measurements and eye diagrams for UWB signals have been measured experimentally by using the different GS transmitter configurations and various fiber transmission distances. The simulation of both systems also has been carried out to verify our obtained results, which show the suitability of employing gain switching in a UWB over fiber (UWBoF) system to develop a reliable, simple, and low-cost technique for distributing the impulse-radio UWB (IR-UWB) pulses to the receiver destination

Photonic systems for tunable mm-wave and THz wireless communications

In this paper we present two different techniques for photonic generation of millimeter and THz waves. Each of them tackles the phase noise problem associated with optical sources in a different way. The first one relays on the heterodyne down-conversion of two phase noise correlated optical tones. The correlation is achieved by generation of an optical frequency comb. To select one of the optical lines we use an optical phase lock loop, which besides enabling a frequency offset between output and input, can provide optical gain and is highly selective. The second one relays on the envelope detection of a single sideband-with carrier signal. In this approach the photonic remote antenna unit is implemented as monolithically integrated photonic chip

The 2017 Terahertz Science and Technology Roadmap

Science and technologies based on terahertz frequency electromagnetic radiation (100GHz-30THz) have developed rapidly over the last 30 years. For most of the 20th century, terahertz radiation, then referred to as sub-millimeter wave or far-infrared radiation, was mainly utilized by astronomers and some spectroscopists. Following the development of laser based terahertz time-domain spectroscopy in the 1980s and 1990s the field of THz science and technology expanded rapidly, to the extent that it now touches many areas from fundamental science to “real world” applications. For example THz radiation is being used to optimize materials for new solar cells, and may also be a key technology for the next generation of airport security scanners. While the field was emerging it was possible to keep track of all new developments, however now the field has grown so much that it is increasingly difficult to follow the diverse range of new discoveries and applications that are appearing. At this point in time, when the field of THz science and technology is moving from an emerging to a more established and interdisciplinary field, it is apt to present a roadmap to help identify the breadth and future directions of the field. The aim of this roadmap is to present a snapshot of the present state of THz science and technology in 2016, and provide an opinion on the challenges and opportunities that the future holds. To be able to achieve this aim, we have invited a group of international experts to write 17 sections that cover most of the key areas of THz Science and Technology. We hope that The 2016 Roadmap on THz Science and Technology will prove to be a useful resource by providing a wide ranging introduction to the capabilities of THz radiation for those outside or just entering the field as well as providing perspective and breadth for those who are well established. We also feel that this review should serve as a useful guide for government and funding agencies

Radio over fibre distribution systems for ultra-wide band and millimetre wave applications

Short range wireless technology such as ultra-wideband (UWB) and 60 GHz millimetre wave (mm-wave) play a key role for wireless connectivity in indoor home, office environment or large enclosed public areas. UWB has been allocated at the frequency band 3.1-10.6 GHz with an emission power below -41.3 dBm. Mm-wave signals around 60 GHz have also attracted much attention to support high-speed data for short range wireless applications. The wide bandwidth and high allowable transmit power at 60 GHz enable multi-Gbps wireless transmission over typical indoor distances. Radio-over-fibre (RoF) systems are used to extend the propagation distance of both UWB and mm-wave signals over hundred of meters inside a building. UWB or mm-wave signals over fibre can be generated first at the central office before being distributed to the remote access points through optical fibre. In this work, we investigate two new techniques to generate and distribute UWB signals. These techniques are based on generating Gaussian pulse position modulation (PPM) using a gain switched laser (GSL). The simulation and experimental results have been carried out to show the suitability of employing gain switching in UWB over fibre systems (UWBoF) to develop a reliable, simple, and low cost technique for distributing UWB pulses. The second part of this work proposes two configurations for optical mm-wave generation and transmission of 3 Gbps downstream data based on GSL. We investigate the distribution of these two methods over fibre with wireless link, and demonstrate the system simplicity and cost efficiency for mm-wave over fibre systems. Both configurations are simulated to verify our obtained results and show system performance at higher bit rates. In the third part, we generate phase modulated mm-waves by using an external injection of a modulated light source into GSL. The performance of this system is experimentally investigated and simulated for different fiber links