The effect of cross-contamination in the sequential interfacial polymerization on the RO performance of polyamide bilayer membranes

International audienceIn this study, hexafluoroalcohol-containing polyamide layer (HFAPA) was prepared on top of a conventional polyamide under-layer (REFPA) via sequential interfacial polymerization (SIP) to improve RO separation behavior, and the performance of the resulting bilayer membrane was thoroughly optimized by investigating the effect of cross-contamination in the SIP process. When several coupons of the polyamide bilayer membrane were prepared by SIP of MPD(aq), TMC(hx) and hexafluoroalcohol-containing diamine (HFAMDA)(aq) in the manner of subsequent membrane dipping, unreacted MPD monomer (mostly captured in the porous PSF support) carried over from the 1st interfacial reaction dissolved and accumulated in the 2nd aqueous solution as verified by UV spectroscopic analysis. The MPD contaminant then participated in the 2nd interfacial reaction, forming copolyamide with HFAMDA monomer onto the REFPA. Depending on the amount of MPD contaminant accumulated in the 2nd aqueous solution, the composition of the resulting co-polyamide in the top-layer varied, causing a significant variation of RO performance; the flux was gradually decreased with the increase of MPD contaminants while the salt rejection slightly increased (from 1st coupon toward 4th coupon). This result indicated that a trace amount of MPD contaminant may be necessary to maximize RO separation behavior. Through in-depth performance evaluation of polyamide bilayer membranes prepared by adding various known-amount of MPD into 2nd HFAMDA solution, and also by applying a frame process (2nd amine solution was applied only top surface of membrane) to eliminate uncontrollable MPD contamination, we have successfully demonstrated consistent RO performance, and identified an optimum material composition to provide superior separation performance. The bilayer membrane prepared by adding 1.2 mol% of MPD to the total amount of HFAMDA in the 2nd aqueous solution showed 99.8% NaCl rejection with the water flux of 45 LMH under the cross-flow filtration performed with 2000 ppm NaCl solution at 400 psi, 25 °C

Gluons and the quark sea at high energies:distributions, polarization, tomography

This report is based on a ten-week program on "Gluons and the quark sea at high-energies", which took place at the Institute for Nuclear Theory in Seattle in Fall 2010. The principal aim of the program was to develop and sharpen the science case for an Electron-Ion Collider (EIC), a facility that will be able to collide electrons and positrons with polarized protons and with light to heavy nuclei at high energies, offering unprecedented possibilities for in-depth studies of quantum chromodynamics. This report is organized around four major themes: i) the spin and flavor structure of the proton, ii) three-dimensional structure of nucleons and nuclei in momentum and configuration space, iii) QCD matter in nuclei, and iv) Electroweak physics and the search for physics beyond the Standard Model. Beginning with an executive summary, the report contains tables of key measurements, chapter overviews for each of the major scientific themes, and detailed individual contributions on various aspects of the scientific opportunities presented by an EIC

Velocity-space sensitivity of the time-of-flight neutron spectrometer at JET

The velocity-space sensitivities of fast-ion diagnostics are often described by so-called weight functions. Recently, we formulated weight functions showing the velocity-space sensitivity of the often dominant beam-target part of neutron energy spectra. These weight functions for neutron emission spectrometry (NES) are independent of the particular NES diagnostic. Here we apply these NES weight functions to the time-of-flight spectrometer TOFOR at JET. By taking the instrumental response function of TOFOR into account, we calculate time-of-flight NES weight functions that enable us to directly determine the velocity-space sensitivity of a given part of a measured time-of-flight spectrum from TOFOR

Relationship of edge localized mode burst times with divertor flux loop signal phase in JET

A phase relationship is identified between sequential edge localized modes (ELMs) occurrence times in a set of H-mode tokamak plasmas to the voltage measured in full flux azimuthal loops in the divertor region. We focus on plasmas in the Joint European Torus where a steady H-mode is sustained over several seconds, during which ELMs are observed in the Be II emission at the divertor. The ELMs analysed arise from intrinsic ELMing, in that there is no deliberate intent to control the ELMing process by external means. We use ELM timings derived from the Be II signal to perform direct time domain analysis of the full flux loop VLD2 and VLD3 signals, which provide a high cadence global measurement proportional to the voltage induced by changes in poloidal magnetic flux. Specifically, we examine how the time interval between pairs of successive ELMs is linked to the time-evolving phase of the full flux loop signals. Each ELM produces a clear early pulse in the full flux loop signals, whose peak time is used to condition our analysis. The arrival time of the following ELM, relative to this pulse, is found to fall into one of two categories: (i) prompt ELMs, which are directly paced by the initial response seen in the flux loop signals; and (ii) all other ELMs, which occur after the initial response of the full flux loop signals has decayed in amplitude. The times at which ELMs in category (ii) occur, relative to the first ELM of the pair, are clustered at times when the instantaneous phase of the full flux loop signal is close to its value at the time of the first ELM

Gluons and the quark sea at high energies: distributions, polarization, tomography

This report is based on a ten-week program on "Gluons and the quark sea at high-energies", which took place at the Institute for Nuclear Theory in Seattle in Fall 2010. The principal aim of the program was to develop and sharpen the science case for an Electron-Ion Collider (EIC), a facility that will be able to collide electrons and positrons with polarized protons and with light to heavy nuclei at high energies, offering unprecedented possibilities for in-depth studies of quantum chromodynamics. This report is organized around four major themes: i) the spin and flavor structure of the proton, ii) three-dimensional structure of nucleons and nuclei in momentum and configuration space, iii) QCD matter in nuclei, and iv) Electroweak physics and the search for physics beyond the Standard Model. Beginning with an executive summary, the report contains tables of key measurements, chapter overviews for each of the major scientific themes, and detailed individual contributions on various aspects of the scientific opportunities presented by an EIC.Comment: 547 pages, A report on the joint BNL/INT/Jlab program on the science case for an Electron-Ion Collider, September 13 to November 19, 2010, Institute for Nuclear Theory, Seattle; v2 with minor changes, matches printed versio