21 research outputs found
Studying boundary layer methane isotopy and vertical mixing processes at a rewetted peatland site using an unmanned aircraft system
The combination of two well-established methods, of quadrocopter-borne air sampling and methane isotopic analyses, is applied to determine the source process of methane at different altitudes and to study mixing processes. A proof-of-concept study was performed to demonstrate the capabilities of quadrocopter air sampling for subsequently analysing the methane isotopic composition ÎŽ13C in the laboratory. The advantage of the system compared to classical sampling on the ground and at tall towers is the flexibility concerning sampling location, and in particular the flexible choice of sampling altitude, allowing the study of the layering and mixing of air masses with potentially different spatial origin of air masses and methane. Boundary layer mixing processes and the methane isotopic composition were studied at Polder Zarnekow in MecklenburgâWest Pomerania in the north-east of Germany, which has become a strong source of biogenically produced methane after rewetting the drained and degraded peatland. Methane fluxes are measured continuously at the site. They show high emissions from May to September, and a strong diurnal variability. For two case studies on 23 May and 5 September 2018, vertical profiles of temperature and humidity were recorded up to an altitude of 650 and 1000âm, respectively, during the morning transition. Air samples were taken at different altitudes and analysed in the laboratory for methane isotopic composition. The values showed a different isotopic composition in the vertical distribution during stable conditions in the morning (delta values of â51.5ââ° below the temperature inversion at an altitude of 150âm on 23 May 2018 and at an altitude of 50âm on 5 September 2018, delta values of â50.1ââ° above). After the onset of turbulent mixing, the isotopic composition was the same throughout the vertical column with a mean delta value of â49.9â±â0.45ââ°. The systematically more negative delta values occurred only as long as the nocturnal temperature inversion was present. During the September study, water samples were analysed as well for methane concentration and isotopic composition in order to provide a link between surface and atmosphere. The water samples reveal high variability on horizontal scales of a few tens of metres for this particular case. The airborne sampling system and consecutive analysis chain were shown to provide reliable and reproducible results for two samples obtained simultaneously. The method presents a powerful tool for distinguishing the source process of methane at different altitudes. The isotopic composition showed clearly depleted delta values directly above a biological methane source when vertical mixing was hampered by a temperature inversion, and different delta values above, where the air masses originate from a different footprint area. The vertical distribution of methane isotopic composition can serve as tracer for mixing processes of methane within the atmospheric boundary layer
Spectral and spatial shaping of laser-driven proton beams using a pulsed high-field magnet beamline
Recommended from our members
Unmanned Aerial Systems for Investigating the Polar Atmospheric Boundary LayerâTechnical Challenges and Examples of Applications
Unmanned aerial systems (UAS) fill a gap in high-resolution observations of meteorological parameters on small scales in the atmospheric boundary layer (ABL). Especially in the remote polar areas, there is a strong need for such detailed observations with different research foci. In this study, three systems are presented which have been adapted to the particular needs for operating in harsh polar environments: The fixed-wing aircraft M2AV with a mass of 6 kg, the quadrocopter ALICE with a mass of 19 kg, and the fixed-wing aircraft ALADINA with a mass of almost 25 kg. For all three systems, their particular modifications for polar operations are documented, in particular the insulation and heating requirements for low temperatures. Each system has completed meteorological observations under challenging conditions, including take-offand landing on the ice surface, low temperatures (down to-28 °C), icing, and, for the quadrocopter, under the impact of the rotor downwash. The influence on the measured parameters is addressed here in the form of numerical simulations and spectral data analysis. Furthermore, results from several case studies are discussed: With the M2AV, low-level flights above leads in Antarctic sea ice were performed to study the impact of areas of open water within ice surfaces on the ABL, and a comparison with simulations was performed. ALICE was used to study the small-scale structure and short-term variability of the ABL during a cruise of RV Polarstern to the 79° N glacier in Greenland. With ALADINA, aerosol measurements of different size classes were performed in Ny-Alesund, Svalbard, in highly complex terrain. In particular, very small, freshly formed particles are difficult to monitor and require the active control of temperature inside the instruments. The main aim of the article is to demonstrate the potential of UAS for ABL studies in polar environments, and to provide practical advice for future research activities with similar systems. © 2020 by the authors
Unmanned Aerial Systems for Investigating the Polar Atmospheric Boundary LayerâTechnical Challenges and Examples of Applications
Unmanned aerial systems (UAS) fill a gap in high-resolution observations of meteorological parameters on small scales in the atmospheric boundary layer (ABL). Especially in the remote polar areas, there is a strong need for such detailed observations with different research foci. In this study, three systems are presented which have been adapted to the particular needs for operating in harsh polar environments: The fixed-wing aircraft M^2AV with a mass of 6 kg, the quadrocopter ALICE with a mass of 19 kg, and the fixed-wing aircraft ALADINA with a mass of almost 25 kg. For all three systems, their particular modifications for polar operations are documented, in particular the insulation and heating requirements for low temperatures. Each system has completed meteorological observations under challenging conditions, including take-off and landing on the ice surface, low temperatures (down to â28 °C), icing, and, for the quadrocopter, under the impact of the rotor downwash. The influence on the measured parameters is addressed here in the form of numerical simulations and spectral data analysis. Furthermore, results from several case studies are discussed: With the M^2AV, low-level flights above leads in Antarctic sea ice were performed to study the impact of areas of open water within ice surfaces on the ABL, and a comparison with simulations was performed. ALICE was used to study the small-scale structure and short-term variability of the ABL during a cruise of RV Polarstern to the 79°N glacier in Greenland. With ALADINA, aerosol measurements of different size classes were performed in Ny-Ă
lesund, Svalbard, in highly complex terrain. In particular, very small, freshly formed particles are difficult to monitor and require the active control of temperature inside the instruments. The main aim of the article is to demonstrate the potential of UAS for ABL studies in polar environments, and to provide practical advice for future research activities with similar systems
Spectral and spatial shaping of laser-driven proton beams using a pulsed high-field magnet beamline
Intense laser-driven proton pulses, inherently broadband and highly
divergent, pose a challenge to established beamline concepts on the path to
application-adapted irradiation field formation, particularly for 3D. Here we
experimentally show the successful implementation of a highly efficient (50%
transmission) and tuneable dual pulsed solenoid setup to generate a homogeneous
(8.5% uniformity laterally and in depth) volumetric dose distribution
(cylindrical volume of 5 mm diameter and depth) at a single pulse dose of 0.7
Gy via multi-energy slice selection from the broad input spectrum. The
experiments have been conducted at the Petawatt beam of the Dresden Laser
Acceleration Source Draco and were aided by a predictive simulation model
verified by proton transport studies. With the characterised beamline we
investigated manipulation and matching of lateral and depth dose profiles to
various desired applications and targets. Using a specifically adapted dose
profile, we successfully performed first proof-of-concept laser-driven proton
irradiation studies of volumetric in-vivo normal tissue (zebrafish embryos) and
in-vitro tumour tissue (SAS spheroids) samples.Comment: Submitted to Scientific Report
Visualizing Ultrafast Kinetic Instabilities in Laser-Driven Solids using X-ray Scattering
Ultra-intense lasers that ionize and accelerate electrons in solids to near
the speed of light can lead to kinetic instabilities that alter the laser
absorption and subsequent electron transport, isochoric heating, and ion
acceleration. These instabilities can be difficult to characterize, but a novel
approach using X-ray scattering at keV energies allows for their visualization
with femtosecond temporal resolution on the few nanometer mesoscale. Our
experiments on laser-driven flat silicon membranes show the development of
structure with a dominant scale of ~60\unit{nm} in the plane of the laser
axis and laser polarization, and ~95\unit{nm} in the vertical direction with
a growth rate faster than . Combining the XFEL experiments
with simulations provides a complete picture of the structural evolution of
ultra-fast laser-induced instability development, indicating the excitation of
surface plasmons and the growth of a new type of filamentation instability.
These findings provide new insight into the ultra-fast instability processes in
solids under extreme conditions at the nanometer level with important
implications for inertial confinement fusion and laboratory astrophysics
Differences in the carcinogenic evaluation of glyphosate between the International Agency for Research on Cancer (IARC) and the European Food Safety Authority (EFSA)
The International Agency for Research on Cancer (IARC) Monographs Programme identifies chemicals, drugs, mixtures, occupational exposures, lifestyles and personal habits, and physical and biological agents that cause cancer in humans and has evaluated about 1000 agents since 1971. Monographs are written by ad hoc Working Groups (WGs) of international scientific experts over a period of about 12 months ending in an eight-day meeting. The WG evaluates all of the publicly available scientific information on each substance and, through a transparent and rigorous process,1 decides on the degree to which the scientific evidence supports that substance's potential to cause or not cause cancer in humans. For Monograph 112,2 17 expert scientists evaluated the carcinogenic hazard for four insecticides and the herbicide glyphosate.3 The WG concluded that the data for glyphosate meet the criteria for classification as a probable human carcinogen. The European Food Safety Authority (EFSA) is the primary agency of the European Union for risk assessments regarding food safety. In October 2015, EFSA reported4 on their evaluation of the Renewal Assessment Report5 (RAR) for glyphosate that was prepared by the Rapporteur Member State, the German Federal Institute for Risk Assessment (BfR). EFSA concluded that ?glyphosate is unlikely to pose a carcinogenic hazard to humans and the evidence does not support classification with regard to its carcinogenic potential?. Addendum 1 (the BfR Addendum) of the RAR5 discusses the scientific rationale for differing from the IARC WG conclusion. Serious flaws in the scientific evaluation in the RAR incorrectly characterise the potential for a carcinogenic hazard from exposure to glyphosate. Since the RAR is the basis for the European Food Safety Agency (EFSA) conclusion,4 it is critical that these shortcomings are corrected
Example Dataset from a Laser Ion Beam Accelearation Experiment for the Lecture on Research Software Engineering
The dataset is an example experiment with images and metadata from the Laser-driven Ion Acceleration at HZDR from 2019-08-29. The dataset is used for the lecture on research Software Engineering (RSE) at Technische UniversitÀt Dresden.Example Dataset from a Laser Ion Beam Accelearation Experiment for the Lecture on Research Software Engineering is licensed under Attribution 4.0 Internationa
Recommended from our members
Publisher Correction: Spectral and spatial shaping of laser-driven proton beams using a pulsed high-field magnet beamline.
An amendment to this paper has been published and can be accessed via a link at the top of the paper