898 research outputs found
A comparative study of circular and rectangular bended plunging jets
In the present work we study the topology, mixing properties, turbulence quantities, dependence on the outlet geometry of a sharp-edged orifice plunging jet which first issues horizontally in air and then plunges in a water pool. The investigated orifices shapes are circular and rectangular. Data are acquired at different Reynolds numbers in the range 11000-25000, based on the orifice diameter (equal to 2 cm) and on the average exit velocity, as derived from flow rate measurements. Velocity fields in vertical and horizontal planes are measured using planar time-resolved Particle Image Velocimetry. Results show a clear asymmetry of the cross-velocity profiles both in circular and rectangular cases, with the latter that revealed a shape which is Reynolds num-ber dependent. Axial velocity decays, potential core lengths and spreading rates highlight an opposite trend between the two jet geometries, thus suggesting a higher mixing for the lowest Reynolds number circular jet and the highest rectangular one. Plunging angle shows a dependency on Reynolds number. Moreover, it seems to play a role in the evolution of the upper and lower side of the jet due to the onset of a co-flow. Ambient mass entrainment points out the different interactions of the two plunging jets with the ambient flow: in circular case, it entrains fluid from the surroundings, from horizontal to vertical planes in streamwise direction, while in rectangular one it ejects flow from vertical to horizontal planes. Finally, Strouhal numbers are derived for main vortices frequencies along jet centerline, other than upper and lower sides
Recommended from our members
Experimental Investigation on the Behavior of Artificial Magnetic Cilia
This paper was presented at the 4th Micro and Nano Flows Conference (MNF2014), which was held at University College, London, UK. The conference was organised by Brunel University and supported by the Italian Union of Thermofluiddynamics, IPEM, the Process Intensification Network, the Institution of Mechanical Engineers, the Heat Transfer Society, HEXAG - the Heat Exchange Action Group, and the Energy Institute, ASME Press, LCN London Centre for Nanotechnology, UCL University College London, UCL Engineering, the International NanoScience Community, www.nanopaprika.eu.In the present work, the flow fields induced by the movement of artificial cilia under the effect of
a magnetic field are investigated. In order to obtain almost steady conditions, the set-up consists of fixed cilia
which oscillate under the action of a rotating magnetic field. The aim of the work is to determine under
which geometrical configurations a net flow rate or a global mixing is obtained. The results show that cilia
mounted in the direction of rotation allow net fluid flow, whereas those in radial position have larger
turbulent kinetic energy. Thus, the former could be used as micro-pump, whereas the latter as micro-mixer
Le emergenze toraciche nel nostro territorio. Studio sull'incidenza, osservazioni tecno-organizzative, necessitĂ e proposte operative
no abstrac
On the structure of turbulent gravel bed flow: Implications for sediment transport
The main objective of this study was to examine the turbulent flow field over gravel particles as a first step towards understanding sediment transport in a gravel bed river. Specifically, the vertical momentum flux in gravel bed turbulent flow was investigated with particular attention to the near-bed region. Spatial organization of vertical momentum flux was studied with stereoscopic Particle Image Velocimetry (PIV) measurements in a horizontal layer 1mm above the gravel crests. The vertical momentum flux through the water column was described with digital PIV measurements in three vertical planes. The data showed that near the gravel bed, net turbulent momentum flux spatially varies with respect to bed topography. Analysis of the vertical velocity data revealed that near the gravel particle crests, there is a significant net vertical form-induced momentum flux approximately with the same order of magnitude as the net ver- tical turbulent momentum flux. Above the crests, total net vertical momentum flux is positive. However, below the crests, despite noticeable positive form-induced momentum flux, total net vertical momentum flux is negative. Results of quadrant analysis show that variation of turbulent net vertical momentum flux through water column is in agreement with prevalence of upward movement of low velocity flow (known as ejection) above gravel crests and downward movement of high velocity flow (known as sweep) below gravel crests. Below gravel crests ( â0 . 1 < z/H < 0 . 0 ), there is a region where the contribution of second quadrant to Reynolds shear stress is lower than fourth quadrant, while the contribution of second quadrant to vertical momentum flux is higher than fourth quadrant. This can be interpreted that ejection events in this region are strong enough to lift up fine particles but their contribution is not sufficient to move fine particles in the longitudinal direction
Post-graduate medical education in public health: The case of Italy and a call for action
Public health technical expertise is of crucial importance to inform decision makers\u2019
action in the field of health and its broader determinants. Improving education and
training of public health professionals for both practice and research is the starting
point to strengthen the role of public health so that current health challenges can
be efficiently tackled. At the Association of Schools of Public Health in the European
Region (ASPHER) Deans\u2019 & Directors\u2019 2017 Annual Retreat, we presented the structure
and management of public health training system in Italy, and we reported recent data
on Italian public health specialists\u2019 educational experience, employment opportunities
and job satisfaction. Public health training in Italy is implemented in the context
of the post-graduate medical education residency programme in Hygiene and
Preventive Medicine, delivered by 34 University-based Schools of Public Health.
We report relatively high employment rates across the county and wide
spectrum of career opportunities for young public health specialists. However,
job security is low and training expectations only partially met. We call upon
other Schools of Public Health to scale up the survey within the broad ASPHER
community in a shared and coordinated action of systematically collecting useful
data that can inform the development of public health education and training
models, their implementation and fruitful interaction with population health,
health systems and services
Modular development of manufacturing simulation models.
It is common practice within manufacturing companies to create simulation models at different time periods. These models are often used to represent various parts of the manufacturing systems. In general, these pre-built simulation models are required to be integrated together in order to evaluate the entire manufacturing system, this is not a simple task. This research addresses the issues involved in the integration of pre-built simulation models. An in depth literature review was carried out to identify current strategies to overcome these issues. Based on structured research work, a set of recommendations is proposed to ensure easy integration of models. This set of recommendations will help simulation practitioners to minimise the errors occurred during the integration of simulation models. The findings conclude more effort is required than is anticipated by most model builders and involves far more than 'just simply changing' the name of variables. A set of recommendations is therefore proposed to cope with the complexity and understanding of manufacturing systems. The research focuses on manufacturing systems but in general can be applied elsewhere
Guidelines on "Standards of management of idiopathic scoliosis with corrective braces in everyday clinics and in clinical research": SOSORT Consensus 2008
<p>Abstract</p> <p>Background</p> <p>Reported failure rates,(defined based on percentage of cases progressing to surgery) of corrective bracing for idiopathic scoliosis are highly variable. This may be due to the quality of the brace itself, but also of the patient care during treatment. The latter is sometimes neglected, even though it is considered a main determinant of good results among conservative experts of SOSORT. The aim of this paper was to develop and verify the Consensus on management of scoliosis patients treated with braces</p> <p>Methods</p> <p>We followed a Delphi process in four steps, distributing and gradually changing according to the results a set of recommendations: we involved the SOSORT Board twice, then all SOSORT members twice, with a Pre-Meeting Questionnaire (PMQ), and during a Consensus Session at the SOSORT Athens Meeting with a Meeting Questionnaire (MQ). We set a 90% agreement as the minimum to be reached.</p> <p>Results</p> <p>We had a 71% response rate to PMQ, and 66.7% to MQ. Since the PMQ we had a good agreement (no answers below 72% â 70.2% over 90%). With the MQ the agreement consistently increased for all the answers previously below 90% (no answers below 83%, 75% over 90%). With increasing experience in bracing all numerical criteria tended to become more strict. We finally produced a set of 14 recommendations, grouped in 6 Domains (Experience/competence, Behaviours, Prescription, Construction, Brace Check, Follow-up).</p> <p>Conclusion</p> <p>The Consensus permits establishment of recommendations concerning the standards of management of idiopathic scoliosis with bracing, with the aim to increase efficacy and compliance to treatment. The SOSORT recommends to professionals engaged in patient care to follow the guidelines of this Consensus in their clinical practice. The SOSORT criteria should also be followed in clinical research studies to achieve a minimum quality of care. If the aim is to verify the efficacy of bracing these criteria should be companions of the methodological research criteria for bracing proposed by other societies.</p
Cluster Lenses
Clusters of galaxies are the most recently assembled, massive, bound
structures in the Universe. As predicted by General Relativity, given their
masses, clusters strongly deform space-time in their vicinity. Clusters act as
some of the most powerful gravitational lenses in the Universe. Light rays
traversing through clusters from distant sources are hence deflected, and the
resulting images of these distant objects therefore appear distorted and
magnified. Lensing by clusters occurs in two regimes, each with unique
observational signatures. The strong lensing regime is characterized by effects
readily seen by eye, namely, the production of giant arcs, multiple-images, and
arclets. The weak lensing regime is characterized by small deformations in the
shapes of background galaxies only detectable statistically. Cluster lenses
have been exploited successfully to address several important current questions
in cosmology: (i) the study of the lens(es) - understanding cluster mass
distributions and issues pertaining to cluster formation and evolution, as well
as constraining the nature of dark matter; (ii) the study of the lensed objects
- probing the properties of the background lensed galaxy population - which is
statistically at higher redshifts and of lower intrinsic luminosity thus
enabling the probing of galaxy formation at the earliest times right up to the
Dark Ages; and (iii) the study of the geometry of the Universe - as the
strength of lensing depends on the ratios of angular diameter distances between
the lens, source and observer, lens deflections are sensitive to the value of
cosmological parameters and offer a powerful geometric tool to probe Dark
Energy. In this review, we present the basics of cluster lensing and provide a
current status report of the field.Comment: About 120 pages - Published in Open Access at:
http://www.springerlink.com/content/j183018170485723/ . arXiv admin note:
text overlap with arXiv:astro-ph/0504478 and arXiv:1003.3674 by other author
Recurrence and mortality according to Estrogen Receptor status for breast cancer patients undergoing conservative surgery. Ipsilateral breast tumour recurrence dynamics provides clues for tumour biology within the residual breast
BACKGROUND: The study was designed to determine how tumour hormone receptor status affects the subsequent pattern over time (dynamics) of breast cancer recurrence and death following conservative primary breast cancer resection.
METHODS: Time span from primary resection until both first recurrence and death were considered among 2825 patients undergoing conservative surgery with or without breast radiotherapy. The hazard rates for ipsilateral breast tumour recurrence (IBTR), distant metastasis (DM) and mortality throughout 10 years of follow-up were assessed.
RESULTS: DM dynamics displays the same bimodal pattern (first early peak at about 24 months, second late peak at the sixth-seventh year) for both estrogen receptor (ER) positive (P) and negative (N) tumours and for all local treatments and metastatic sites. The hazard rates for IBTR maintain the bimodal pattern for ERP and ERN tumours; however, each IBTR recurrence peak for ERP tumours is delayed in comparison to the corresponding timing of recurrence peaks for ERN tumours. Mortality dynamics is markedly different for ERP and ERN tumours with more early deaths among patients with ERN than among patients with ERP primary tumours.
CONCLUSION: DM dynamics is not influenced by the extent of conservative primary tumour resection and is similar for both ER phenotypes across different metastatic sites, suggesting similar mechanisms for tumour development at distant sites despite apparently different microenvironments. The IBTR risk peak delay observed in ERP tumours is an exception to the common recurrence risk rhythm. This suggests that the microenvironment within the residual breast tissue may enforce more stringent constraints upon ERP breast tumour cell growth than other tissues, prolonging the latency of IBTR. This local environment is, however, apparently less constraining to ERN cells, as IBTR dynamics is similar to the corresponding recurrence dynamics among other distant tissue
Hadronic Mass Moments in Inclusive Semileptonic B Meson Decays
We have measured the first and second moments of the hadronic mass-squared
distribution in B -> X_c l nu, for P(lepton) > 1.5 GeV/c. We find <M_X^2 -
M_D[Bar]^2> = 0.251 +- 0.066 GeV^2, )^2 > = 0.576 +- 0.170
GeV^4, where M_D[Bar] is the spin-averaged D meson mass.
From that first moment and the first moment of the photon energy spectrum in
b -> s gamma, we find the HQET parameter lambda_1 (MS[Bar], to order 1/M^3 and
beta_0 alpha_s^2) to be -0.24 +- 0.11 GeV^2. Using these first moments and the
B semileptonic width, and assuming parton-hadron duality, we obtain |V_cb| =
0.0404 +- 0.0013.Comment: 11 pages postscript, also available through
http://w4.lns.cornell.edu/public/CLNS, submitted to PR
- âŠ