The moon: An abundant source of clean and safe fusion fuel for the 21st century

It is shown how helium-3 can be obtained from the moon and how its use in fusion reactors can benefit the inhabitants of this planet. The physics and technology issues associated with the use of He-3 is addressed. A description is given of He-3 distribution on the moon and of methods which could be used to retrieve it

Continental and oceanic crustal magnetization modelling

Inversion of magnetic data from the MAGSAT satellite, to arrive at intensities of magnetization of the Earth's crust, was performed by two different methods. The first method uses a spherical harmonic model of the magnetic field. The coefficients believed to represent sources in the Earth's crust can then be inverted to arrive at vertical dipole moments per unit area at the Earth's surface. The spherical harmonic models contain coefficients of degrees of harmonics up to 23. The dipole moment per unit area for a surface element can then be determined by summing the contribution for each individual degree of harmonic. The magnetic moments were calculated for continental and oceanic areas separately as well as over certain latitudinal segments. Of primary concern was to determine whether there are any differences between continental and oceanic areas. The second analysis with magnetization intensities was made using narrower ranges of degrees of harmonics, assuming that higher degrees are present in the core field signal

The Energy Dependence of Neutron Star Surface Modes and X-ray Burst Oscillations

We calculate the photon energy dependence of the pulsed amplitude of neutron star (NS) surface modes. Simple approximations demonstrate that it depends most strongly on the bursting NS surface temperature. This result compares well with full integrations that include Doppler shifts from rotation and general relativistic corrections to photon propagation. We show that the energy dependence of type I X-ray burst oscillations agrees with that of a surface mode, lending further support to the hypothesis that they originate from surface waves. The energy dependence of the pulsed emission is rather insensitive to the NS inclination, mass and radius, or type of mode, thus hindering constraints on these parameters. We also show that, for this energy-amplitude relation, the majority of the signal (relative to the noise) comes in the 2-25 keV band, so that the current burst oscillation searches with the Rossi X-Ray Timing Explorer are close to optimal. The critical test of the mode hypothesis for X-ray burst oscillations would be a measurement of the energy dependence of burst oscillations from an accreting millisecond pulsar.Comment: Accepted for publication in The Astrophysical Journal, 6 pages, 5 figures (revised version: no changes to text, just edited author list

The instantaneous shear modulus in the shoving model

We point out that the instantaneous shear modulus of the shoving model for the non-Arrhenius temperature dependence of viscous liquids' relaxation time is the experimentally accessible high-frequency plateau modulus, not the idealized instantaneous affine shear modulus that cannot be measured. Data for a large selection of metallic glasses are compared to three different versions of the shoving model. The original shear-modulus based version shows a slight correlation to the Poisson ratio, which is eliminated by the energy-landscape formulation of the model in which the bulk modulus plays a minor role

Competition and bistability of longitudinal modes in a Raman laser

A model for Raman lasers including several longitudinal modes is analyzed. Depending on the choice of the parameters the system can exhibit single-mode emission, wide bistability domains, and self-pulsing. The latter is often characterized by two frequencies, which are clearly related to single-mode and multimode instabilities, in agreement with the interpretation of earlier experimental results

Different intra- and inter-molecular hydrogen-bonding patterns in (3S,4aS,8aS)-2-[(2R,3S)-3-(2,5-X2-benzamido)-2-(2,5-X2-benzo-yloxy)-4-phenyl-butyl]-N-tert-butyldeca-hydro-iso-quinoline-3-carboxamides (X = H or Cl) : compounds with moderate aspartyl protease inhibition activity

We thank the EPSRC National Crystallography Service (University of Southampton) for the X-ray data collections.Peer reviewedPublisher PD

A new quantum fluid at high magnetic fields in the marginal charge-density-wave system α\alpha-(BEDT-TTF)2M_2MHg(SCN)4_4 (where M=M=~K and Rb)

Single crystals of the organic charge-transfer salts $\alpha$-(BEDT-TTF)$_2M$Hg(SCN)$_4$ have been studied using Hall-potential measurements ($M=$K) and magnetization experiments ($M$ = K, Rb). The data show that two types of screening currents occur within the high-field, low-temperature CDW$_x$ phases of these salts in response to time-dependent magnetic fields. The first, which gives rise to the induced Hall potential, is a free current (${\bf j}_{\rm free}$), present at the surface of the sample. The time constant for the decay of these currents is much longer than that expected from the sample resistivity. The second component of the current appears to be magnetic (${\bf j}_{\rm mag}$), in that it is a microscopic, quasi-orbital effect; it is evenly distributed within the bulk of the sample upon saturation. To explain these data, we propose a simple model invoking a new type of quantum fluid comprising a CDW coexisting with a two-dimensional Fermi-surface pocket which describes the two types of current. The model and data are able to account for the body of previous experimental data which had generated apparently contradictory interpretations in terms of the quantum Hall effect or superconductivity.Comment: 13 pages, 11 figure

Photoreflectance and surface photovoltage spectroscopy of beryllium-doped GaAs/AlAs multiple quantum wells

We present an optical study of beryllium delta-doped GaAs/AlAs multiple quantum well (QW) structures designed for sensing terahertz (THz) radiation. Photoreflectance (PR), surface photovoltage (SPV), and wavelength-modulated differential surface photovoltage (DSPV) spectra were measured in the structures with QW widths ranging from 3 to 20 nm and doping densities from 2×10(10) to 5×10(12) cm(–2) at room temperature. The PR spectra displayed Franz-Keldysh oscillations which enabled an estimation of the electric-field strength of ~20 kV/cm at the sample surface. By analyzing the SPV spectra we have determined that a buried interface rather than the sample surface mainly governs the SPV effect. The DSPV spectra revealed sharp features associated with excitonic interband transitions which energies were found to be in a good agreement with those calculated including the nonparabolicity of the energy bands. The dependence of the exciton linewidth broadening on the well width and the quantum index has shown that an average half monolayer well width fluctuations is mostly predominant broadening mechanism for QWs thinner than 10 nm. The line broadening in lightly doped QWs, thicker than 10 nm, was found to arise from thermal broadening with the contribution from Stark broadening due to random electric fields of the ionized impurities in the structures. We finally consider the possible influence of strong internal electric fields, QW imperfections, and doping level on the operation of THz sensors fabricated using the studied structures. © 2005 American Institute of Physic

Study of Chromium-Frit-Type Coatings for High-Temperature Protection of Molybdenum

The achievement of more compact and efficient power plants for aircraft is dependent, among other factors, on the perfection of heat-resisting materials that are superior to those in current use. Molybdenum is one of the high-melting metals (melting point, 4750 F). It is fairly abundant and also can be worked into many of the shapes required in modern power plants. To permit its widespread use at elevated temperatures, however, some means must first be found to prevent its rapid oxidation. The application of a protective coating is one method that might be used to achieve this goal. In the present work, a number of chromium-frit-type coatings were studied. These were bonded to molybdenum specimens by firing in controlled atmospheres to temperatures in the range of 2400 to 2700 F