180 research outputs found
Physics of the dynamic ergodic divertor
The Dynamic Ergodic Divertor (DED) of TEXTOR is presently being installed. It consists of sixteen helically wound coils occupying about 30% of the wall at the HFS. The coils follow field lines on a “pre-selected” magnetic surface and are fed individually outside the vessel. A perturbation field is created by the electrical currents in the perturbation coils with Fourier components resonant to the magnetic surfaces. The stochastic boundary layer is generated in the outermost region of the plasma, which due to long and short connection lengths can be divided into ergodic and laminar regions. Field line tracing and mapping techniques were used to analyse properties of the TEXTOR-DED plasma boundary. The DED will operate with several frequencies (DC or AC up to 10 kHz). In the “dynamic” operation the convective heat flux is deposited to a large plasma-facing surface and forces are transferred to the plasma edge, what can introduce a differential rotation of the plasma
Control of 3D edge radiation structure with resonant magnetic perturbation fields applied to the stochastic layer and stabilization of radiative divertor plasma in LHD
Velocity-space sensitivity of the time-of-flight neutron spectrometer at JET
The velocity-space sensitivities of fast-ion diagnostics are often described by so-called weight functions. Recently, we formulated weight functions showing the velocity-space sensitivity of the often dominant beam-target part of neutron energy spectra. These weight functions for neutron emission spectrometry (NES) are independent of the particular NES diagnostic. Here we apply these NES weight functions to the time-of-flight spectrometer TOFOR at JET. By taking the instrumental response function of TOFOR into account, we calculate time-of-flight NES weight functions that enable us to directly determine the velocity-space sensitivity of a given part of a measured time-of-flight spectrum from TOFOR
Relationship of edge localized mode burst times with divertor flux loop signal phase in JET
A phase relationship is identified between sequential edge localized modes (ELMs) occurrence times in a set of H-mode tokamak plasmas to the voltage measured in full flux azimuthal loops in the divertor region. We focus on plasmas in the Joint European Torus where a steady H-mode is sustained over several seconds, during which ELMs are observed in the Be II emission at the divertor. The ELMs analysed arise from intrinsic ELMing, in that there is no deliberate intent to control the ELMing process by external means. We use ELM timings derived from the Be II signal to perform direct time domain analysis of the full flux loop VLD2 and VLD3 signals, which provide a high cadence global measurement proportional to the voltage induced by changes in poloidal magnetic flux. Specifically, we examine how the time interval between pairs of successive ELMs is linked to the time-evolving phase of the full flux loop signals. Each ELM produces a clear early pulse in the full flux loop signals, whose peak time is used to condition our analysis. The arrival time of the following ELM, relative to this pulse, is found to fall into one of two categories: (i) prompt ELMs, which are directly paced by the initial response seen in the flux loop signals; and (ii) all other ELMs, which occur after the initial response of the full flux loop signals has decayed in amplitude. The times at which ELMs in category (ii) occur, relative to the first ELM of the pair, are clustered at times when the instantaneous phase of the full flux loop signal is close to its value at the time of the first ELM
New mechanism of runaway electron diffusion due to microturbulence in tokamaks
Chaotic transport of runaway electrons in a toroidal system in the presence of a weak small-scale magnetic turbulent field with a wide mode spectrum is studied. Using a fast running mapping, the radial profiles of turbulent diffusion coefficients are calculated. It is found that at large Kubo numbers the chaotic transport of the electrons is described by a fractal-like radial dependence of the diffusion coefficients with reduced or zero values near low-order rational drift surfaces which form transport barriers. The latter can be one of the main reasons of the improved confinement of runaway electrons in tokamaks. One can expect that this effect may lead to the formation of the nested beams of runaway electrons. [http://dx.doi.org/10.1063/1.4736718
A new disruption mitigation valve (DMV) and gas flow in guiding tubes of different diameter
A new disruption mitigation valve, the DMV-30, has been developed and tested. The orifice output area of the valve is a factor of 2.4 and 12.25 times larger than that of its predecessors, DMV-20 and DMV-10, and the gas reservoir amounts to 1.3 L while the older version used at JET had only 0.65 L. The coil which provides the magnetic field pulse for the activation of the piston by an eddy current is outside of the working gas volume such that all gas volumes are now made of stainless steel. The valve has the advantages of the previous developments: it is robust and reproducible, opens fully within 3ms and releases 50% of the gas within about 5ms (He) to 10 ms (Ar). The valve is attached subsequently to two different guiding tubes, one with an inner diameter of 38mm as used presently at JET and one with 102mm inner diameter; the aim of this paper is the analysis of the gas flows for different diameters. The front of the gas pulse propagates with a Mach number of about 2.5 through the tubes, independent of the two diameters. This high speed agrees with theoretical expectations of flow expansion of a half infinite tube in vacuum. In the quasi-stationary phase of the expansion, the gas flows with about sound speed in the 102mm tube and with about half of the sound speed in the 38mm tube
- …