100 research outputs found

    Best parameter choice of Stochastic Resonance to enhance fault signature in bearings

    Get PDF
    Stochastic Resonance (SR) is a phenomenon studied and exploited for telecommunication, which permits the detection and amplification of weak signals by the assistance of noise. The first papers on this topic date back to the early 80s and were developed to explain some periodic natural phenomena. Other applications are in neuroscience, biology, medicine and, obviously, mechanics. Recently, a few researchers have tried to apply this technique for detecting faults in mechanical systems and also bearings. In this paper we discuss the best way to select the parameters to augment the performance of the algorithm. This is probably the main drawback of SR, since in system identification the procedure should be as blind as possible to be efficient and widely applicable. The classical bi-stable potential form is adopted in our study, with three parameters to be selected. Based on numerical tests, a characteristic trend of the amplification factor has been found with respect to the parameters variation, so that a general rule is consequently determined which gives the best performances in terms of detection and amplification. The SR algorithm is tested on both simulated and experimental data showing a good capacity of increasing the signal to noise ratio

    Mechanical characterization of mortars used in the restoration of historical buildings: an operative atlas for maintenance and conservation

    Get PDF
    The complexity of the architectural and structural restoration of historical buildings requires a careful choice in the use of repair mortars compatible with the original materials of the existing building. It is important to set up an atlas of reference, compared to many mixtures of mortars and conglomerates, useful to support the operational choices in the project of restoration, recovery, and maintenance of historical buildings. The aim is also to encourage the use of local materials with a “short supply chain”, compatible with buildings and installed with traditional techniques. The research makes use of experimental bending, compression and elastic modulus tests on different mixtures of mortars. This paper describes some of the first results obtained so far, because the research is still underway for many different mixtures to test and catalog. The comparison between the data and the reference values that will be identified, will lead to set up a reference atlas of mechanical behavior of repair mortars in order to direct the design and operational choices in function of requirements and performance of specific cases in the field of the restoration of historical buildings

    Nonlinear Dynamics of a Duffing-Like Negative Stiffness Oscillator: Modeling and Experimental Characterization

    Get PDF
    In this paper, a negative stiffness oscillator is modelled and tested to exploit its nonlinear dynamical characteristics. The oscillator is part of a device designed to improve the current collection quality in railway overhead contact lines, and it acts like an asymmetric double-well Duffing system. Thus, it exhibits two stable equilibrium positions plus an unstable one, and the oscillations can either be bounded around one stable point (small oscillations) or include all the three positions (large oscillations). Depending on the input amplitude, the oscillator can exhibit linear and nonlinear dynamics and chaotic motion as well. Furthermore, its design is asymmetrical, and this plays a key role in its dynamic response, as the two natural frequencies associated with the two stable positions differ from each other. The first purpose of this study is to understand the dynamical behavior of the system in the case of linear and nonlinear oscillations around the two stable points and in the case of large oscillations associated with a chaotic motion. To accomplish this task, the device is mounted on a shaking table and it is driven with several levels of excitations and with both harmonic and random inputs. Finally, the nonlinear coefficients associated with the nonlinearities of the system are identified from the measured data

    Modelling of a Free-Piston Generator Based on Spark-Ignition Engine, Linear Electric Machine and Active Rectifier

    Get PDF
    The Free-Piston Linear Generator (FPLG) technology is meant to serve as a link between the period of fossil fuels and the next green power generation. It consists of a Free-Piston Internal Combustion Engine (ICE) mechanically coupled with a Linear Electric Machine (LEM). No constraints on the piston movement and the inherently variable Compression Ratio (CR) result in a low vibrations, low friction, low maintenance costs, multifuel and high efficiency ICE, with a significant reduction of fuel consumption and greenhouse-gas emissions. In this paper the modelling of this new electricity generation system is investigated. The models of a gasoline single-piston Spark Ignition (SI) Free-Piston ICE and of the electric conversion system based on a three-phase LEM and a Space Vector Pulse Width Modulation (SVPWM) controlled active rectifier are developed in the CFD open-source OpenFOAM and Matlab Simulink environments, respectively

    Fault diagnosis of wind turbine gearboxes through on-site measurements and vibrational signal processing

    Get PDF
    Condition monitoring of wind turbine gearboxes has attracted an impressive amount of attention in the wind energy literature. This happens for practical issues, as gearbox damages account for at least the 20% of wind turbines operational unavailability, and for scientific issues as well, because the condition monitoring of gear-based mechanical systems undergoing non-stationary operation is particularly challenging. The present work is devoted to the diagnosis of gearbox damages through a novel approach, designed exclusively for this study, based on on-site measurements and data post-processing. The main point of this method is the relatively easy repeatability, also for wind turbine practitioners, and its low impact on wind turbine operation: actually, the measuring site is not the gearbox itself, but the tower, further from the gearbox but in an easily accessible place. A real test case has been considered: a multi mega-watt wind turbine sited in Italy and owned by the Renvico company. The vibration measurements at the wind turbine suspected to be damaged and at a reference wind turbine are processed through a multivariate Novelty Detection algorithm in the feature space. The application of this algorithm is justified by univariate statistical tests on the time-domain features selected and by a visual inspection of the dataset via Principal Component Analysis. Finally, the novelty indices based on such time-domain features, computed from the accelerometric signals acquired inside the turbine tower, prove to be suitable to highlight a damaged condition in the wind-turbine gearbox, which can be then successfully monitored

    Patterns of Upper Gastrointestinal Diseases Based on Endoscopy in the Period 1998-2001

    Get PDF
    Upper gastrointestinal complaints are common in Kenya. Though these have remained unchanged over the last 20 years, the pattern of upper gastrointestinal disease on endoscopic examination seems to be changing. There appears to be progressive increase in oesophagitis and cancer of the stomach. Peptic ulcer disease has remained stable while Cancer of the oesophagus is still common. The paper intends to report on endoscopic findings at the Centre for Clinical Research, Kenya Medical Research Institute (KEMRI) over the period October 1998 and May 2001. The sources of information are records made at the time of endoscopy and histology reports on biopsies taken. Seven hundred and sixty eight patients were endoscoped. The male to female ratio was 1.7:1 with mean age \ub1SD of 40.8 \ub120.1 years and age range was 3 to 96 years. Majority of the patients had abnormal findings with gastritis being the most common ( 25.8%). It is concluded that gastritis is an important cause of morbidity in Kenya. Oesophagitis, mainly due to gastroesopahageal reflux disease, seems to be on the increase. Gastric cancer is not as rare as previously thought and peptic ulcer disease is still common

    A time-varying inertia pendulum: Analytical modelling and experimental identification

    Get PDF
    In this paper two of the main sources of non-stationary dynamics, namely the time-variability and the presence of nonlinearity, are analysed through the analytical and experimental study of a time-varying inertia pendulum. The pendulum undergoes large swinging amplitudes, so that its equation of motion is definitely nonlinear, and hence becomes a nonlinear time-varying system. The analysis is carried out through two subspace-based techniques for the identification of both the linear time-varying system and the nonlinear system. The flexural and the nonlinear swinging motions of the pendulum are uncoupled and are considered separately: for each of them an analytical model is built for comparisons and the identification procedures are developed. The results demonstrate that a good agreement between the predicted and the identified frequencies can be achieved, for both the considered motions. In particular, the estimates of the swinging frequency are very accurate for the entire domain of possible configurations, in terms of swinging amplitude and mass positio
    • …
    corecore