Solution phase, solid state, and theoretical investigations on the MacMillan imidazolidinone

A combination of soln. phase NMR, X-ray crystallog. studies, and DFT calcns. provide a consistent structural conformation for iminium ions derived from the MacMillan imidazolidinone

10 µm minority-carrier diffusion lengths in Si wires synthesized by Cu-catalyzed vapor-liquid-solid growth

The effective electron minority-carrier diffusion length, L_(n,eff), for 2.0 µm diameter Si wires that were synthesized by Cu-catalyzed vapor-liquid-solid growth was measured by scanning photocurrent microscopy. In dark, ambient conditions, L_(n,eff) was limited by surface recombination to a value of ≤ 0.7 µm. However, a value of L_(n,eff) = 10.5±1 µm was measured under broad-area illumination in low-level injection. The relatively long minority-carrier diffusion length observed under illumination is consistent with an increased surface passivation resulting from filling of the surface states of the Si wires by photogenerated carriers. These relatively large L_(n,eff) values have important implications for the design of high-efficiency, radial-junction photovoltaic cells from arrays of Si wires synthesized by metal-catalyzed growth processes

Series Bosch System Development

State-of-the-art (SOA) carbon dioxide (CO2) reduction technology for the International Space Station produces methane as a byproduct. This methane is subsequently vented overboard. The associated loss of hydrogen ultimately reduces the mass of oxygen that can be recovered from CO2 in a closed-loop life support system. As an alternative to SOA CO2 reduction technology, NASA is exploring a Series-Bosch system capable of reducing CO2 with hydrogen to form water and solid carbon. This results in 100% theoretical recovery of oxygen from metabolic CO2. In the past, Bosch-based technology did not trade favorably against SOA technology due to a high power demand, low reaction efficiencies, concerns with carbon containment, and large resupply requirements necessary to replace expended catalyst cartridges. An alternative approach to Bosch technology, labeled "Series-Bosch," employs a new system design with optimized multi-stage reactors and a membrane-based separation and recycle capability. Multi-physics modeling of the first stage reactor, along with chemical process modeling of the integrated system, has resulted in a design with potential to trade significantly better than previous Bosch technology. The modeling process and resulting system architecture selection are discussed

Phantom of the Opera: ETF Shorting and Shareholder Voting

The short-selling of exchange-traded funds (ETFs) creates "phantom" ETF shares, trading at ETF market prices, with cash flows rights but no associated voting rights. Unlike regular ETF shares backed by the underlying securities of the ETF and voted as directed by the sponsor, phantom ETF shares are backed by collateral that is not voted. Introducing a novel measure of phantom shares both of the ETF and corresponding underlying securities, we find that increases in phantom shares are associated with decreases in number of proxy votes cast (for and against), and increases in broker non-votes, the vote premium, and value-reducing acquisitions

Institutional experience with a rotational total skin electron irradiation (RTSEI) technique—A three decade review (1981–2012)

AbstractTotal skin electron irradiation (TSEI) for patients with cutaneous lymphomas is technically challenging, and numerous approaches have been developed to overcome the many field matching problems associated with such a large and complex treatment volume. Since 1981 we have delivered TSEI using a rotational total skin electron irradiation (RTSEI) technique in conjunction with patch, treat and boost fields in order to provide complete skin and dose coverage. Initially we used a 6MeV electron beam at an extended source-skin distance (SSD) on a modified linear accelerator. More recently we began using a high dose rate electron mode on a commercially available linear accelerator. The RTSEI technique allows the delivery of a seamless surface dose to the majority of the patient's skin surface in a single treatment. In this review paper we present our three-decade experience with the technical development, dosimetry, treatment delivery and clinical outcomes of our RTSEI technique

High-performance Si microwire photovoltaics

Crystalline Si wires, grown by the vapor–liquid–solid (VLS) process, have emerged as promising candidate materials for lowcost, thin-film photovoltaics. Here, we demonstrate VLS-grown Si microwires that have suitable electrical properties for high-performance photovoltaic applications, including long minority-carrier diffusion lengths (L_n » 30 µm) and low surface recombination velocities (S « 70 cm·s^(-1)). Single-wire radial p–n junction solar cells were fabricated with amorphous silicon and silicon nitride surface coatings, achieving up to 9.0% apparent photovoltaic efficiency, and exhibiting up to ~600 mV open-circuit voltage with over 80% fill factor. Projective single-wire measurements and optoelectronic simulations suggest that large-area Si wire-array solar cells have the potential to exceed 17% energy-conversion efficiency, offering a promising route toward cost-effective crystalline Si photovoltaics

Automated Calibration of Electrochemical Oxygen Sensors for Use in Compost Bedded Pack Barns

The objective of this study was to develop an automated calibration process for a galvanic cell type oxygen sensor. The manufacturer recommended a two-point calibration at room temperature; however, testing revealed that the response was not linear when both the temperature and oxygen concentrations varied. Thus, additional points were needed to generate a representative calibration equation and to reduce the sensor prediction interval. The calibration process needed to be capable of automatically recording sensor response (voltage) at an array of temperatures and oxygen concentrations. Calibration gases were used to precisely control the oxygen concentration inside a small manifold, and an electronically controlled water bath was used to regulate the sensor and gas temperature. A custom computer program controlled the sampling order and the data collection process. The responses for three sensors were recorded at six temperature (10°C, 20°C, 30°C, 40°C, 50°C, and 60°C) and five oxygen concentration (0%, 5%, 10%, 15%, and 20% O2 absolute) combinations, for a total of 30 measurements per calibration. Calibration data were used to create a second-degree polynomial model with oxygen sensor voltage and temperature as input parameters, which reduced the prediction interval by over 1% O2 for each of the three sensors tested. The resulting prediction intervals ranged between 0.75% and 0.95% O2. Three sensors were mounted in a prototype oxygen probe and tested under controlled conditions to demonstrate the ability to measure oxygen concentration versus depth in a composting environment

Si microwire-array solar cells

Si microwire-array solar cells with Air Mass 1.5 Global conversion efficiencies of up to 7.9% have been fabricated using an active volume of Si equivalent to a 4 μm thick Si wafer. These solar cells exhibited open-circuit voltages of 500 mV, short-circuit current densities (J_(sc)) of up to 24 mA cm^(-2), and fill factors >65% and employed Al_2O_3 dielectric particles that scattered light incident in the space between the wires, a Ag back reflector that prevented the escape of incident illumination from the back surface of the solar cell, and an a-SiN_x:H passivation/anti-reflection layer. Wire-array solar cells without some or all of these design features were also fabricated to demonstrate the importance of the light-trapping elements in achieving a high J_(sc). Scanning photocurrent microscopy images of the microwire-array solar cells revealed that the higher J_(sc) of the most advanced cell design resulted from an increased absorption of light incident in the space between the wires. Spectral response measurements further revealed that solar cells with light-trapping elements exhibited improved red and infrared response, as compared to solar cells without light-trapping elements

Mojave remote sensing field experiment

The Mojave Remote Sensing Field Experiment (MFE), conducted in June 1988, involved acquisition of Thermal Infrared Multispectral Scanner (TIMS); C, L, and P-band polarimetric radar (AIRSAR) data; and simultaneous field observations at the Pisgah and Cima volcanic fields, and Lavic and Silver Lake Playas, Mojave Desert, California. A LANDSAT Thematic Mapper (TM) scene is also included in the MFE archive. TM-based reflectance and TIMS-based emissivity surface spectra were extracted for selected surfaces. Radiative transfer procedures were used to model the atmosphere and surface simultaneously, with the constraint that the spectra must be consistent with field-based spectral observations. AIRSAR data were calibrated to backscatter cross sections using corner reflectors deployed at target sites. Analyses of MFE data focus on extraction of reflectance, emissivity, and cross section for lava flows of various ages and degradation states. Results have relevance for the evolution of volcanic plains on Venus and Mars

Changes in the red giant and dusty environment of the recurrent nova RS Ophiuchi following the 2006 eruption

We present near-infrared spectroscopy of the recurrent nova RS Ophiuchi (RS Oph) obtained on several occasions after its latest outburst in 2006 February. The 1–5 μm spectra are dominated by the red giant, but the H i, He i and coronal lines present during the eruption are present in all our observations. From the fits of the computed infrared spectral energy distributions to the observed fluxes, we find Teff= 4200 ± 200 K for the red giant. The first overtone CO bands at 2.3 μm, formed in the atmosphere of the red giant, are variable. The spectra clearly exhibit an infrared excess due to dust emission longward of 5 μm; we estimate an effective temperature for the emitting dust shell of 500 K, and find that the dust emission is also variable, being beyond the limit of detection in 2007. Most likely, the secondary star in RS Oph is intrinsically variable