Limb bone scaling in hopping diprotodonts and quadrupedal artiodactyls

Bone adaptation is modulated by the timing, direction, rate, and magnitude of mechanical loads. To investigate whether frequent slow, or infrequent fast, gaits could dominate bone adaptation to load, we compared scaling of the limb bones from two mammalian herbivore clades that use radically different high-speed gaits, bipedal hopping and quadrupedal galloping. Forelimb and hindlimb bones were collected from 20 artiodactyl and 15 diprotodont species (body mass M 1.05 - 1536 kg) and scanned in clinical computed tomography or X-ray microtomography. Second moment of area (Imax) and bone length (l) were measured. Scaling relations (y = axb) were calculated for l vs M for each bone and for Imax vs M and Imax vs l for every 5% of length. Imax vs M scaling relationships were broadly similar between clades despite the diprotodont forelimb being nearly unloaded, and the hindlimb highly loaded, during bipedal hopping. Imax vs l and l vs M scaling were related to locomotor and behavioural specialisations. Low-intensity loads may be sufficient to maintain bone mass across a wide range of species. Occasional high-intensity gaits might not break through the load sensitivity saturation engendered by frequent low-intensity gaits

Altered lacunar and vascular porosity in osteogenesis imperfecta mouse bone as revealed by synchrotron tomography contributes to bone fragility

Osteogenesis imperfecta (brittle bone disease) is caused by mutations in the collagen genes and results in skeletal fragility. Changes in bone porosity at the tissue level indicate changes in bone metabolism and alter bone mechanical integrity. We investigated the cortical bone tissue porosity of a mouse model of the disease, oim, in comparison to a wild type (WT-C57BL/6), and examined the influence of canal architecture on bone mechanical performance.High-resolution 3D representations of the posterior tibial and the lateral humeral mid-diaphysis of the bones were acquired for both mouse groups using synchrotron radiation-based computed tomography at a nominal resolution of 700 nm. Volumetric morphometric indices were determined for cortical bone, canal network and osteocyte lacunae. The influence of canal porosity architecture on bone mechanics was investigated using microarchitectural finite element (?FE) models of the cortical bone. Bright-field microscopy of stained sections was used to determine if canals were vascular.Although total cortical porosity was comparable between oim and WT bone, oim bone had more numerous and more branched canals (p < 0.001), and more osteocyte lacunae per unit volume compared to WT (p < 0.001). Lacunae in oim were more spherical in shape compared to the ellipsoidal WT lacunae (p < 0.001). Histology revealed blood vessels in all WT and oim canals. ?FE models of cortical bone revealed that small and branched canals, typical of oim bone, increase the risk of bone failure. These results portray a state of compromised bone quality in oim bone at the tissue level, which contributes to its deficient mechanical properties

In Vivo Time- Resolved Microtomography Reveals the Mechanics of the Blowfly Flight Motor

Dipteran flies are amongst the smallest and most agile of flying animals. Their wings are driven indirectly by large power muscles, which cause cyclical deformations of the thorax that are amplified through the intricate wing hinge. Asymmetric flight manoeuvres are controlled by 13 pairs of steering muscles acting directly on the wing articulations. Collectively the steering muscles account for <3% of total flight muscle mass, raising the question of how they can modulate the vastly greater output of the power muscles during manoeuvres. Here we present the results of a synchrotron-based study performing micrometre-resolution, time-resolved microtomography on the 145 Hz wingbeat of blowflies. These data represent the first four-dimensional visualizations of an organism's internal movements on sub-millisecond and micrometre scales. This technique allows us to visualize and measure the three-dimensional movements of five of the largest steering muscles, and to place these in the context of the deforming thoracic mechanism that the muscles actuate. Our visualizations show that the steering muscles operate through a diverse range of nonlinear mechanisms, revealing several unexpected features that could not have been identified using any other technique. The tendons of some steering muscles buckle on every wingbeat to accommodate high amplitude movements of the wing hinge. Other steering muscles absorb kinetic energy from an oscillating control linkage, which rotates at low wingbeat amplitude but translates at high wingbeat amplitude. Kinetic energy is distributed differently in these two modes of oscillation, which may play a role in asymmetric power management during flight control. Structural flexibility is known to be important to the aerodynamic efficiency of insect wings, and to the function of their indirect power muscles. We show that it is integral also to the operation of the steering muscles, and so to the functional flexibility of the insect flight motor

Sexually dimorphic tibia shape is linked to natural osteoarthritis in STR/Ort mice

Human osteoarthritis (OA) is detected only at late stages. Male STR/Ort mice develop knee OA spontaneously with known longitudinal trajectory, offering scope to identify OA predisposing factors. We exploit the lack of overt OA in female STR/Ort and in both sexes of parental, control CBA mice to explore whether early divergence in tibial bone mass or shape are linked to emergent OA

Transient peak-strain matching partially recovers the age-impaired mechanoadaptive cortical bone response

Mechanoadaptation maintains bone mass and architecture; its failure underlies age-related decline in bone strength. It is unclear whether this is due to failure of osteocytes to sense strain, osteoblasts to form bone or insufficient mechanical stimulus. Mechanoadaptation can be restored to aged bone by surgical neurectomy, suggesting that changes in loading history can rescue mechanoadaptation. We use non-biased, whole-bone tibial analyses, along with characterisation of surface strains and ensuing mechanoadaptive responses in mice at a range of ages, to explore whether sufficient load magnitude can activate mechanoadaptation in aged bone. We find that younger mice adapt when imposed strains are lower than in mature and aged bone. Intriguingly, imposition of short-term, high magnitude loading effectively primes cortical but not trabecular bone of aged mice to respond. This response was regionally-matched to highest strains measured by digital image correlation and to osteocytic mechanoactivation. These data indicate that aged bone’s loading response can be partially recovered, non-invasively by transient, focal high strain regions. Our results indicate that old murine bone does respond to load when the loading is of sufficient magnitude, and bones’ age-related adaptation failure may be due to insufficient mechanical stimulus to trigger mechanoadaptation

Micro-to nano-scale characterisation of polyamide structures of the SW30HR RO membrane using advanced electron microscopy and stain tracers

The development of new reverse osmosis (RO) membranes with enhanced performance would benefit from a detailed knowledge of the membrane structures which participate in the filtration process. Here, we examined the hierarchical structures of the polyamide (PA) active layer of the SW30HR RO membrane. Scanning electron microscopy combined with focused ion beam milling (FIB-SEM) was used to obtain the 3-D reconstructions of membrane morphology with 5 nm cross-sectional resolution (comparable with the resolution of low magnification TEM imaging in 2D) and 30 nm slice thickness. The complex folding of the PA layer was examined in 3 dimensions, enabling the quantification of key structural properties of the PA layer, including the local thickness, volume, surface area and their derivatives. The PA layer was found to exhibit a much higher and convoluted surface area than that estimated via atomic force microscopy (AFM). Cross-sectional scanning transmission electron microscopy (STEM) was used to observe the distribution of a tracer stain under various conditions. The behaviour of stain in dry and wet PA indicated that the permeation pathways have a dynamic nature and are activated by water. High resolution STEM imaging of the stained PA nano-films revealed the presence of <1 nm pore-like structures with a size compatible with free volume estimations by positron annihilation lifetime spectroscopy (PALS). This study presents a comprehensive map of the active PA layer across different length scales (from micro- to sub-nanometre) and mechanistic insight into their role in the permeation process

The vocal apparatus: An understudied tool to reconstruct the evolutionary history of echolocation in bats?

Laryngeal echolocation in bats could have evolved following two scenarios: a single origin from a common ancestor or an independent acquisition inside the two clades Yinpterochiroptera and Yangochiroptera. Later, some members of Yinpterochiroptera possibly lost their ability to echolocate. In bats, the larynx produces vocalizations for communication and, in most species, for echolocation. Here, we describe how comparative chiropteran laryngeal morphology is a novel area of research that could improve the understanding of echolocation and may help resolve the evolutionary history of bats. This review provides morphological descriptions and comparisons of the bat larynx and bioacoustics interpretations. We discuss the importance of understanding: (1) laryngeal sound production so it may be linked with the evolution of the chiropteran auditory system; and (2) the evolution of laryngeal morphology to understand the ecological and behavioural aspects of bat biology. We find that a strong phylogenetic signal is potentially the main source explaining macroevolutionary variation in laryngeal form among bats. We predict that the three parameters of sound production in echolocation (frequency, intensity, and rate of calls) are independently modulated by different laryngeal components, but this hypothesis remains understudied in terms of species diversity

Limb bone scaling in hopping macropods and quadrupedal artiodactyls

Bone adaptation is modulated by the timing, direction, rate and magnitude of mechanical loads. To investigate whether frequent slow, or infrequent fast, gaits could dominate bone adaptation to load, we compared scaling of the limb bones from two mammalian herbivore clades that use radically different high-speed gaits, bipedal hopping (suborder Macropodiformes; kangaroos and kin) and quadrupedal galloping (order Artiodactyla; goats, deer and kin). Forelimb and hindlimb bones were collected from 20 artiodactyl and 15 macropod species (body mass M 1.05–1536 kg) and scanned in computed tomography or X-ray microtomography. Second moment of area (Imax) and bone length (l) were measured. Scaling relations (y = axb) were calculated for l versus M for each bone and for Imax versus M and Imax versus l for every 5% of length. Imax versus M scaling relationships were broadly similar between clades despite the macropod forelimb being nearly unloaded, and the hindlimb highly loaded, during bipedal hopping. Imax versus l and l versus M scaling were related to locomotor and behavioural specializations. Low-intensity loads may be sufficient to maintain bone mass across a wide range of species. Occasional high-intensity gaits might not break through the load sensitivity saturation engendered by frequent low-intensity gaits

Mechanical adaptation of trabecular bone morphology in the mammalian mandible

Alveolar bone, together with the underlying trabecular bone, fulfils an important role in providing structural support against masticatory forces. Diseases such as osteoporosis or periodontitis cause alveolar bone resorption which weakens this structural support and is a major cause of tooth loss. However, the functional relationship between alveolar bone remodelling within the molar region and masticatory forces is not well understood. This study investigated this relationship by comparing mammalian species with different diets and functional loading (Felis catus, Cercocebus atys, Homo sapiens, Sus scrofa, Oryctolagus cuniculus, Ovis aries). We performed histomorphometric analyses of trabecular bone morphology (bone volume fraction, trabecular thickness and trabecular spacing) and quantified the variation of bone and tooth root volumes along the tooth row. A principal component analysis and non-parametric MANOVA showed statistically significant differences in trabecular bone morphology between species with contrasting functional loading, but these differences were not seen in sub-adult specimens. Our results support a strong, but complex link between masticatory function and trabecular bone morphology. Further understanding of a potential functional relationship could aid the diagnosis and treatment of mandibular diseases causing alveolar bone resorption, and guide the design and evaluation of dental implants