Comparison of effectiveness between a conventional catheter and a manual commercial catheter: randomized trial of simulation of intraosseous access in a biological model

Introduction: In the emergency services an action of paramount importance in critically ill patients is to obtain an early vascular access. When vascular access is not established, an intraosseous route should be obtained; otherwise, the mortality of these critically ill patients is almost 100%. In Colombia, the intraosseous access is not used because of the high costs of the devices and the lack of training of the healthcare staff to conduct the procedure.Objective: To determine the efficacy of a low-cost device to establish intraosseous access.Materials and methods: Quantitative approach, experimental design in a simulated environment with chicken tarsus and metatarsus. An analysis was conducted using frequency tables and central tendency measurements. Likewise, further analyses were done using Fisher's exact test, Chi2, and Mann-Whitney test.Results: A total of 99% of the procedures were successful with both catheters. The average time for intraosseous access was 6.6 seconds with Insyte 14 catheter and 4.7 seconds with Din 1515x Illinois Desch device (P=0.001). There were no significant differences in the number of attempts to secure a successful intraosseous access using any of the 2 devices (P=0.56).Conclusion: There was no significant difference between the Ci 14 and the Si 14 catheter to establish a successful intraosseous access in the chicken tarsus and metatarsus in a simulated environment. © 2019 Sociedad Colombiana de Anestesiología y Reanimación (S.C.A.R.E.)

Yard-Sale exchange on networks: Wealth sharing and wealth appropriation

Yard-Sale (YS) is a stochastic multiplicative wealth-exchange model with two phases: a stable one where wealth is shared, and an unstable one where wealth condenses onto one agent. YS is here studied numerically on 1d rings, 2d square lattices, and random graphs with variable average coordination, comparing its properties with those in mean field (MF). Equilibrium properties in the stable phase are almost unaffected by the introduction of a network. Measurement of decorrelation times in the stable phase allow us to determine the critical interface with very good precision, and it turns out to be the same, for all networks analyzed, as the one that can be analytically derived in MF. In the unstable phase, on the other hand, dynamical as well as asymptotic properties are strongly network-dependent. Wealth no longer condenses on a single agent, as in MF, but onto an extensive set of agents, the properties of which depend on the network. Connections with previous studies of coalescence of immobile reactants are discussed, and their analytic predictions are successfully compared with our numerical results.Comment: 10 pages, 7 figures. Submitted to JSTA

Το λογισμικό SpatialAnalyzer & εφαρμογές του σε προβλήματα βιομηχανικής γεωδαισίας

This paper reports a first study exploring genomic prediction for adaptation of sorghum [Sorghum bicolor (L.) Moench] to drought-stress (D-ET) and nonstress (W-ET) environment types. The objective was to evaluate the impact of both modeling genotype × environment interaction (G×E) and accounting for heterogeneous variances of marker effects on genomic prediction of parental breeding values for grain yield within and across environment types (ETs). For this aim, different genetic covariance structures and different weights for individual markers were investigated in best linear unbiased prediction (BLUP)-based prediction models. The BLUP models used a kinship matrix combining pedigree and genomic information, termed K-BLUP. The dataset comprised testcross yield performances under D-ET and W-ET as well as pedigree and genomic data. In general, modeling G×E increased predictive ability and reduced empirical bias of genomic predictions for broad adaptation across both ETs vs. models that ignored G×E by fitting a main genetic effect only. Genomic predictions for specific adaptation to D-ET or W-ET were also improved by K-BLUP models that explicitly accommodated G×E and used data from both ETs relative to prediction models that used data from the targeted ET exclusively or models that used all the data but assumed no G×E. Allowing for heterogeneous marker variances through weighted K-BLUP produced clear increments (43–72%) in predictive ability of genomic prediction for grain yield in all adaptation scenarios. We conclude that G×E as well as locus-specific genetic variances should be accommodated in genomic prediction models to improve adaptability of sorghum to variable environmental conditions

Retrieval of 3D polygonal objects based on multiresolution signatures

In this paper we present a method for retrieving 3D polygonal objects by using two sets of multiresolution signatures. Both sets are based on the progressive elimination of object's details by iterative processing of the 3D meshes. The first set, with five parameters, is based on mesh smoothing. This mainly affects an object's surface. The second set, with three parameters, is based on difference volumes after successive mesh erosions and dilations. Characteristic feature vectors are constructed by combining the features at three mesh resolutions of each object. In addition to being invariant to mesh resolution, the feature vectors are invariant to translation, rotation and size of the objects. The method was tested on a set of 40 complex objects with mesh resolutions different from those used in constructing the feature vectors. By using all eight features, the average ranking rate obtained was 1.075: 37 objects were ranked first and only 3 objects were ranked second. Additional tests were carried out to determine the significance of individual features and all combinations. The same ranking rate of 1.075 can be obtained by using some combinations of only three features. © 2011 Springer-Verlag

SHREC 2011: robust feature detection and description benchmark

Feature-based approaches have recently become very popular in computer vision and image analysis applications, and are becoming a promising direction in shape retrieval. SHREC'11 robust feature detection and description benchmark simulates the feature detection and description stages of feature-based shape retrieval algorithms. The benchmark tests the performance of shape feature detectors and descriptors under a wide variety of transformations. The benchmark allows evaluating how algorithms cope with certain classes of transformations and strength of the transformations that can be dealt with. The present paper is a report of the SHREC'11 robust feature detection and description benchmark results.Comment: This is a full version of the SHREC'11 report published in 3DO

Uso de de almidón de papa andina nativa y deshidratada (chuño) como estabilizantes en la elaboración de yogur firme reducido en grasa

El yogur es el alimento lácteo fermentado de mayor consumo a nivel internacional, debido tanto a sus propiedades nutricionales y sensoriales distintivas como por su impacto positivo en la salud del consumidor. Así, el mercado de yogur es uno de los más dinámicos del sector lácteo, con propuestas novedosas, entre las cuales se destaca las variedades con contenido reducido en grasas. Sin embargo, la omisión de la grasa introduce problemas de calidad que conducen al rechazo por el consumidor. La principal estrategia empleada para superar estas limitaciones es el agregado de hidrocoloides (HC) como estabilizantes. El objetivo del presente trabajo fue evaluar la influencia del agregado de almidón de papa andina nativa y de "chuño" (papa andina congelada y deshidratada) como estabilizantes en la elaboración de yogur firme bajo en grasas. Se prepararon tres formulaciones de yogures a partir de leche descremada reconstituida (10%, p/v) añadida con almidón de papa nativo (AN) o "chuño" (ACH) [2,5% (p/v) final en producto]. Los HC previamente disueltos en leche (en proporción 1:10) se agregaron previo al tratamiento térmico (90°C, 5 min con agitación). La fermentación de la leche se llevo a cabo a 45ºC en baño de agua hasta pH 4,5. El grado de sinéresis, propiedades de flujo y viscoelásticas de los yogures fueron evaluados y comparados con los de un yogur control preparado sin almidón, en los días 1, 7, 14 y 28 de almacenamiento. Para la obtención de las curvas de flujo y las medidas oscilatorias se utilizó un reómetro (AR 2000; TA Instruments, New Castle, DE, EE. UU.) geometría plato-plato de 40 mm. El agregado de almidones de AN y ACH modificó significativamente los parámetros evaluados en relación al yogur control. En relación a la sinéresis, los mayores valores se observaron en el YC, efecto que incrementó significativamente con el tiempo de almacenamiento. Se observa que las formulaciones con almidones no mostraron diferencias significativas entre ellas hasta el día 7. Sin embargo, el YCH incrementó paulatinamente los valores de sinéresis luego del día 14, mientras que en la formulación YN no se observaron diferencias hasta el final del ensayo. Además, las muestras mostraron claras diferencias en cuanto a sus propiedades reológicas. En términos generales, los yogures que contienen almidones exhibieron valores de viscosidad aparente más altos que los observados en el YC después de 1 día de almacenamiento, tendencia que se mantuvo hasta el final del ensayo. Por otra parte, los valores de los módulos viscoso (G'), elástico (G'') y complejo (G*) incrementaron proporcionalmente a la frecuencia angular, siendo G' superior a G'' en todos los casos. G* también mostró diferencias entre las muestras, siendo significativamente mayores en las muestras con AN, seguida de ACH, en relación al control para todos los tiempos evaluados. Nuestros resultados demostraron que la incorporación de almidones de papa andina y chuño en la formulación de yogur firme reducido en grasas permitió reducir el grado de sinéresis proporcionando mejores características reológicas al producto final.Centro de Investigación y Desarrollo en Criotecnología de Alimento

Investigating the association between obesity and asthma in 6- to 8-year-old Saudi children:a matched case-control study

Background: Previous studies have demonstrated an association between obesity and asthma, but there remains considerable uncertainty about whether this reflects an underlying causal relationship. Aims: To investigate the association between obesity and asthma in pre-pubertal children and to investigate the roles of airway obstruction and atopy as possible causal mechanisms. Methods: We conducted an age- and sex-matched case–control study of 1,264 6- to 8-year-old schoolchildren with and without asthma recruited from 37 randomly selected schools in Madinah, Saudi Arabia. The body mass index (BMI), waist circumference and skin fold thickness of the 632 children with asthma were compared with those of the 632 control children without asthma. Associations between obesity and asthma, adjusted for other potential risk factors, were assessed separately in boys and girls using conditional logistic regression analysis. The possible mediating roles of atopy and airway obstruction were studied by investigating the impact of incorporating data on sensitisation to common aeroallergens and measurements of lung function. Results: BMI was associated with asthma in boys (odds ratio (OR)=1.14, 95% confidence interval (CI), 1.08–1.20; adjusted OR=1.11, 95% CI, 1.03–1.19) and girls (OR=1.37, 95% CI, 1.26–1.50; adjusted OR=1.38, 95% CI, 1.23–1.56). Adjusting for forced expiratory volume in 1 s had a negligible impact on these associations, but these were attenuated following adjustment for allergic sensitisation, particularly in girls (girls: OR=1.25; 95% CI, 0.96–1.60; boys: OR=1.09, 95% CI, 0.99–1.19). Conclusions: BMI is associated with asthma in pre-pubertal Saudi boys and girls; this effect does not appear to be mediated through respiratory obstruction, but in girls this may at least partially be mediated through increased risk of allergic sensitisation

First Season QUIET Observations: Measurements of CMB Polarization Power Spectra at 43 GHz in the Multipole Range 25 <= ell <= 475

The Q/U Imaging ExperimenT (QUIET) employs coherent receivers at 43GHz and 95GHz, operating on the Chajnantor plateau in the Atacama Desert in Chile, to measure the anisotropy in the polarization of the CMB. QUIET primarily targets the B modes from primordial gravitational waves. The combination of these frequencies gives sensitivity to foreground contributions from diffuse Galactic synchrotron radiation. Between 2008 October and 2010 December, >10,000hours of data were collected, first with the 19-element 43GHz array (3458hours) and then with the 90-element 95GHz array. Each array observes the same four fields, selected for low foregrounds, together covering ~1000deg^2. This paper reports initial results from the 43GHz receiver which has an array sensitivity to CMB fluctuations of 69uK sqrt(s). The data were extensively studied with a large suite of null tests before the power spectra, determined with two independent pipelines, were examined. Analysis choices, including data selection, were modified until the null tests passed. Cross correlating maps with different telescope pointings is used to eliminate a bias. This paper reports the EE, BB and EB power spectra in the multipole range ell=25-475. With the exception of the lowest multipole bin for one of the fields, where a polarized foreground, consistent with Galactic synchrotron radiation, is detected with 3sigma significance, the E-mode spectrum is consistent with the LCDM model, confirming the only previous detection of the first acoustic peak. The B-mode spectrum is consistent with zero, leading to a measurement of the tensor-to-scalar ratio of r=0.35+1.06-0.87. The combination of a new time-stream double-demodulation technique, Mizuguchi-Dragone optics, natural sky rotation, and frequent boresight rotation leads to the lowest level of systematic contamination in the B-mode power so far reported, below the level of r=0.1Comment: 19 pages, 14 figures, higher quality figures are available at http://quiet.uchicago.edu/results/index.html; Fixed a typo and corrected statistical error values used as a reference in Figure 14, showing our systematic uncertainties (unchanged) vs. multipole; Revision to ApJ accepted version, this paper should be cited as "QUIET Collaboration et al. (2011)