Laryngeal mask airway in neonatal stabilization and transport: a retrospective study.

Laryngeal mask airway (LMA) may be considered by health caregivers of level I–II hospitals for neonatal resuscitation and stabilization before and during interhospital care, but literature provides little information on this aspect. This study reviewed the use of LMA during stabilization and transport in a large series of neonates. This is a retrospective study evaluating the use of LMA in infants who underwent emergency transport by the Eastern Veneto Neonatal Emergency Transport Service between January 2003 and December 2021. All data were obtained from transport registry, transport forms, and hospital charts. In total, 64/3252 transferred neonates (2%) received positive pressure ventilation with an LMA, with increasing trend over time (p = 0.001). Most of these neonates were transferred after birth (97%), due to a respiratory or neurologic disease (95%). LMA was used before the transport (n = 60), during the transport (n = 1), or both (n = 3). No device-related adverse effects were recorded. Sixty-one neonates (95%) survived and were discharged/transferred from the receiving center

Beamlet scraping and its influence on the beam divergence at the BATMAN Upgrade test facility

For the ITER fusion experiment, two neutral beam injectors are required for plasma heating and current drive. Each injector supplies a power of about 17 MW, obtained from neutralization of 40 A (46 A), 1 MeV (0.87 MeV) negative deuterium (hydrogen) ions. The full beam is composed of 1280 beamlets, formed in 16 beamlet groups, and strict requirements apply to the beamlet core divergence (<7 mrad). The test facility BATMAN Upgrade uses an ITER-like grid with one beamlet group, which consists of 70 apertures. In a joint campaign performed by IPP and Consorzio RFX to better assess the beam optics, the divergence of a single beamlet was compared to a group of beamlets at BATMAN Upgrade. The single beamlet is measured with a carbon fiber composite tile calorimeter and by beam emission spectroscopy, whereas the divergence of the group of beamlets is measured by beam emission spectroscopy only. When increasing the RF power at low extraction voltages, the divergence of the beamlet and of the group of beamlets is continuously decreasing and no inflection point toward an overperveant beam is found. At the same time, scraping of the extracted ion beam at the second grid (extraction grid) takes place at higher RF power, supported by the absence of the normally seen linear behavior between the measured negative ion density in the plasma close to the extraction system and the measured extracted ion current. Beside its influence on the divergence, beamlet scraping needs to be considered for the determination of the correct perveance and contributes to the measured coextracted electron current

Peat soil burning in the Mezzano lowland (Po Plain, Italy): triggering mechanisms and environmental consequences.

The effects of peat burning on organic-rich agricultural soils of the Mezzano Lowland (NE Italy) were evaluated on soil profiles variously affected by smoldering. Profiles were investigated for pH, electrical conductivity, bulk density, elemental and isotopic composition of distinct carbon (and nitrogen) fractions. The results suggest that the horizons affected by carbon loss lie at depths 10–70 cm, where the highest temperatures are developed. We suggest that the exothermal oxidation of methane (mediated by biological activity) plays a significant role in the triggering mechanism. In the interested soils we estimated a potential loss of Soil Organic Carbon of approximately 110 kg m−2 within the first meter, corresponding to 580 kg CO2 m−3. The released greenhouse gas is coupled with a loss of soil structure and nutrients. Moreover, the process plausibly triggers mobility of metals bound in organometallic complexes. All these consequences negatively affect the environment, the agricultural activities and possibly also health of the local people

Soil carbon investigation in three pedoclimatic and agronomic settings of northern Italy

Sustainable agricultural management is needed to promote carbon (C) sequestration in soil, prevent loss of soil fertility, and reduce the release of greenhouse gases. However, the influence of agronomic practices on soil C sequestration depends on the existing pedoclimatic features. We characterized the soils of three farms far away each other in the Emilia-Romagna region (Northern Italy): an organic farm in the Northern Apennines, a biodynamic farm, and a conventional farm on the Po Plain. The total, inorganic, and organic carbon in soil, as well as the distinct humic fractions were investigated, analyzing both the elemental and isotopic (13C/12C) composition. In soils, organic matter appears to be variously affected by mineralization processes induced by microorganisms that consume organic carbon. In particular, organic carbon declined in farms located in the plain (e.g., organic carbon down to 0.75 wt%; carbon stock0-30 cm down to 33 Mg/ha), because of the warmer climate and moderately alkaline environment that enhance soil microbial activity. On the other hand, at the mountain farm, the minimum soil disturbance, the cold climate, and the neutral conditions favored soil C sequestration (organic carbon up to 4.42 wt%; carbon stock0-30 cm up to 160 Mg/ha) in humified organic compounds with long turnover, which can limit greenhouse gas emissions into the atmosphere. This work shows the need for thorough soil investigations, to propose tailored best-practices that can reconcile productivity and soil sustainability

Lentiviral gene therapy corrects platelet phenotype and function in patients with Wiskott-Aldrich syndrome

BACKGROUND: Thrombocytopenia is a serious issue for all patients with classical Wiskott-Aldrich syndrome (WAS) and X-linked thrombocytopenia (XLT) because it causes severe and life-threatening bleeding. Lentiviral gene therapy (GT) for WAS has shown promising results in terms of immune reconstitution. However, despite the reduced severity and frequency of bleeding events, platelet counts remain low in GT-treated patients. OBJECTIVE: We carefully investigated platelet defects in terms of phenotype and function in untreated patients with WAS and assessed the effect of GT treatment on platelet dysfunction. METHODS: We analyzed a cohort of 20 patients with WAS/XLT, 15 of them receiving GT. Platelet phenotype and function were analyzed by using electron microscopy, flow cytometry, and an aggregation assay. Platelet protein composition was assessed before and after GT by means of proteomic profile analysis. RESULTS: We show that platelets from untreated patients with WAS have reduced size, abnormal ultrastructure, and a hyperactivated phenotype at steady state, whereas activation and aggregation responses to agonists are decreased. GT restores platelet size and function early after treatment and reduces the hyperactivated phenotype proportionally to WAS protein expression and length of follow-up. CONCLUSIONS: Our study highlights the coexistence of morphologic and multiple functional defects in platelets lacking WAS protein and demonstrates that GT normalizes the platelet proteomic profile with consequent restoration of platelet ultrastructure and phenotype, which might explain the observed reduction of bleeding episodes after GT. These results are instrumental also from the perspective of a future clinical trial in patients with XLT only presenting with microthrombocytopenia

Start of SPIDER operation towards ITER neutral beams

Heating Neutral Beam (HNB) Injectors will constitute the main plasma heating and current drive tool both in ITER and JT60-SA, which are the next major experimental steps for demonstrating nuclear fusion as viable energy source. In ITER, in order to achieve the required thermonuclear fusion power gain Q=10 for short pulse operation and Q=5 for long pulse operation (up to 3600s), two HNB injectors will be needed [1], each delivering a total power of about 16.5 MW into the magnetically-confined plasma, by means of neutral hydrogen or deuterium particles having a specific energy of about 1 MeV. Since only negatively charged particles can be efficiently neutralized at such energy, the ITER HNB injectors [2] will be based on negative ions, generated by caesium-catalysed surface conversion of atoms in a radio-frequency driven plasma source. A negative deuterium ion current of more than 40 A will be extracted, accelerated and focused in a multi-aperture, multi-stage electrostatic accelerator, having 1280 apertures (~ 14 mm diam.) and 5 acceleration stages (~200 kV each) [3]. After passing through a narrow gas-cell neutralizer, the residual ions will be deflected and discarded, whereas the neutralized particles will continue their trajectory through a duct into the tokamak vessels to deliver the required heating power to the ITER plasma for a pulse duration of about 3600 s. Although the operating principles and the implementation of the most critical parts of the injector have been tested in different experiments, the ITER NBI requirements have never been simultaneously attained. In order to reduce the risks and to optimize the design and operating procedures of the HNB for ITER, a dedicated Neutral Beam Test Facility (NBTF) [4] has been promoted by the ITER Organization with the contribution of the European Union\u2019s Joint Undertaking for ITER and of the Italian Government, with the participation of the Japanese and Indian Domestic Agencies (JADA and INDA) and of several European laboratories, such as IPP-Garching, KIT-Karlsruhe, CCFE-Culham, CEA-Cadarache. The NBTF, nicknamed PRIMA, has been set up at Consorzio RFX in Padova, Italy [5]. The planned experiments will verify continuous HNB operation for one hour, under stringent requirements for beam divergence (< 7 mrad) and aiming (within 2 mrad). To study and optimise HNB performances, the NBTF includes two experiments: MITICA, full-scale NBI prototype with 1 MeV particle energy and SPIDER, with 100 keV particle energy and 40 A current, aiming at testing and optimizing the full-scale ion source. SPIDER will focus on source uniformity, negative ion current density and beam optics. In June 2018 the experimental operation of SPIDER has started

PRL3-DDX21 transcriptional control of endolysosomal genes restricts melanocyte stem cell differentiation

Melanocytes, replenished throughout life by melanocyte stem cells (MSCs), play a critical role in pigmentation and melanoma. Here, we reveal a function for the metastasis-associated phosphatase of regenerating liver 3 (PRL3) in MSC regeneration. We show that PRL3 binds to the RNA helicase DDX21, thereby restricting productive transcription by RNAPII at master transcription factor (MITF)-regulated endolysosomal vesicle genes. In zebrafish, this mechanism controls premature melanoblast expansion and differentiation from MSCs. In melanoma patients, restricted transcription of this endolysosomal vesicle pathway is a hallmark of PRL3-high melanomas. Our work presents the conceptual advance that PRL3-mediated control of transcriptional elongation is a differentiation checkpoint mechanism for activated MSCs and has clinical relevance for the activity of PRL3 in regenerating tissue and cancer

Model for screening of resonant magnetic perturbations by plasma in a realistic tokamak geometry and its impact on divertor strike points

This work addresses the question of the relation between strike-point splitting and magnetic stochasticity at the edge of a poloidally diverted tokamak in the presence of externally imposed magnetic perturbations. More specifically, ad-hoc helical current sheets are introduced in order to mimic a hypothetical screening of the external resonant magnetic perturbations by the plasma. These current sheets, which suppress magnetic islands, are found to reduce the amount of splitting expected at the target, which suggests that screening effects should be observable experimentally. Multiple screening current sheets reinforce each other, i.e. less current relative to the case of only one current sheet is required to screen the perturbation.Comment: Accepted in the Proceedings of the 19th International Conference on Plasma Surface Interactions, to be published in Journal of Nuclear Materials. Version 2: minor formatting and text improvements, more results mentioned in the conclusion and abstrac

On the mechanisms governing gas penetration into a tokamak plasma during a massive gas injection

A new 1D radial fluid code, IMAGINE, is used to simulate the penetration of gas into a tokamak plasma during a massive gas injection (MGI). The main result is that the gas is in general strongly braked as it reaches the plasma, due to mechanisms related to charge exchange and (to a smaller extent) recombination. As a result, only a fraction of the gas penetrates into the plasma. Also, a shock wave is created in the gas which propagates away from the plasma, braking and compressing the incoming gas. Simulation results are quantitatively consistent, at least in terms of orders of magnitude, with experimental data for a D 2 MGI into a JET Ohmic plasma. Simulations of MGI into the background plasma surrounding a runaway electron beam show that if the background electron density is too high, the gas may not penetrate, suggesting a possible explanation for the recent results of Reux et al in JET (2015 Nucl. Fusion 55 093013)

Modelling of the effect of ELMs on fuel retention at the bulk W divertor of JET

Effect of ELMs on fuel retention at the bulk W target of JET ITER-Like Wall was studied with multi-scale calculations. Plasma input parameters were taken from ELMy H-mode plasma experiment. The energetic intra-ELM fuel particles get implanted and create near-surface defects up to depths of few tens of nm, which act as the main fuel trapping sites during ELMs. Clustering of implantation-induced vacancies were found to take place. The incoming flux of inter-ELM plasma particles increases the different filling levels of trapped fuel in defects. The temperature increase of the W target during the pulse increases the fuel detrapping rate. The inter-ELM fuel particle flux refills the partially emptied trapping sites and fills new sites. This leads to a competing effect on the retention and release rates of the implanted particles. At high temperatures the main retention appeared in larger vacancy clusters due to increased clustering rate