130 research outputs found

    Adaptive hard and tough mechanical response in single-crystal B1 VNx ceramics via control of anion vacancies

    Full text link
    High hardness and toughness are generally considered mutually exclusive properties for single-crystal ceramics. Combining experiments and ab initio molecular dynamics (AIMD) atomistic simulations at room temperature, we demonstrate that both the hardness and toughness of single-crystal NaCl-structure VNx/MgO(001) thin films are simultaneously enhanced through the incorporation of anion vacancies. Nanoindentation results show that VN0.8, here considered as representative understoichiometric VNx system, is ~20% harder, as well as more resistant to fracture than stoichiometric VN samples. AIMD modeling of VN and VN0.8 supercells subjected to [001] and [110] elongation reveal that the tensile strengths of the two materials are similar. Nevertheless, while the stoichiometric VN phase systematically cleaves in a brittle manner at tensile yield points, the understoichiometric compound activates transformation-toughening mechanisms that dissipate accumulated stresses. AIMD simulations also show that VN0.8 exhibits an initially greater resistance to both {110} and {111} shear deformation than VN. However, for progressively increasing shear strains, the VN0.8 mechanical behavior gradually evolves from harder to more ductile than VN. The transition is mediated by anion vacancies, which facilitate {110} and {111} lattice slip by reducing activation shear stresses by as much as 35%. Electronic-structure analyses show that the two-regime hard/tough mechanical response of VN0.8 primarily stems from its intrinsic ability to transfer d electrons between 2nd-neighbor and 4th-neighbor (i.e., across vacancy sites) V-V metallic states. Our work offers a route for electronic-structure design of hard materials in which a plastic mechanical response is triggered with loading

    Species-specific responses to ocean acidification should account for local adaptation and adaptive plasticity

    Get PDF
    Global stressors, such as ocean acidification, constitute a rapidly emerging and significant problem for marine organisms, ecosystem functioning and services. The coastal ecosystems of the Humboldt Current System (HCS) off Chile harbour a broad physical–chemical latitudinal and temporal gradient with considerable patchiness in local oceanographic conditions. This heterogeneity may, in turn, modulate the specific tolerances of organisms to climate stress in species with populations distributed along this environmental gradient. Negative response ratios are observed in species models (mussels, gastropods and planktonic copepods) exposed to changes in the partial pressure of CO2 (pCO2) far from the average and extreme pCO2 levels experienced in their native habitats. This variability in response between populations reveals the potential role of local adaptation and/or adaptive phenotypic plasticity in increasing resilience of species to environmental change. The growing use of standard ocean acidification scenarios and treatment levels in experimental protocols brings with it a danger that inter-population differences are confounded by the varying environmental conditions naturally experienced by different populations. Here, we propose the use of a simple index taking into account the natural pCO2 variability, for a better interpretation of the potential consequences of ocean acidification on species inhabiting variable coastal ecosystems. Using scenarios that take into account the natural variability will allow understanding of the limits to plasticity across organismal traits, populations and species

    Indentation Hardness Measurements at Macro-, Micro-, and Nanoscale: A Critical Overview

    Get PDF
    The Brinell, Vickers, Meyer, Rockwell, Shore, IHRD, Knoop, Buchholz, and nanoindentation methods used to measure the indentation hardness of materials at different scales are compared, and main issues and misconceptions in the understanding of these methods are comprehensively reviewed and discussed. Basic equations and parameters employed to calculate hardness are clearly explained, and the different international standards for each method are summarized. The limits for each scale are explored, and the different forms to calculate hardness in each method are compared and established. The influence of elasticity and plasticity of the material in each measurement method is reviewed, and the impact of the surface deformation around the indenter on hardness values is examined. The difficulties for practical conversions of hardness values measured by different methods are explained. Finally, main issues in the hardness interpretation at different scales are carefully discussed, like the influence of grain size in polycrystalline materials, indentation size effects at micro-and nanoscale, and the effect of the substrate when calculating thin films hardness. The paper improves the understanding of what hardness means and what hardness measurements imply at different scales.Funding Agencies|Swedish Government Strategic Research Area in Materials Science on Functional Materials at Linkoping University ((Faculty Grant SFO Mat LiU) [2009 00971]</p

    Panel Three: The Roles of Juries and the Press in the Modern Judicial System

    Get PDF
    Reactive sputtering by high power impulse magnetron sputtering (HiPIMS) and direct current magnetron sputtering (DCMS) of a Zr target in Ar/H-2 plasmas was employed to deposit Zr-H films on Si(100) substrates, and with H content up to 61 at.% and O contents typically below 0.2 at.% as determined by elastic recoil detection analysis. X-ray photoelectron spectroscopy reveals a chemical shift of similar to 0.7 eV to higher binding energies for the Zr-H films compared to pure Zr films, consistent with a charge transfer from Zr to H in a zirconium hydride. X-ray diffraction shows that the films are single-phase delta-ZrH2 (CaF2 type structure) at H content greater thansimilar to 55 at.% and pole figure measurements give a 111 preferred orientation for these films. Scanning electron microscopy cross-section images show a glasslike microstructure for the HiPIMS films, while the DCMS films are columnar. Nanoindentation yield hardness values of 5.5-7 GPa for the delta-ZrH2 films that is slightly harder than the similar to 5 GPa determined for Zr films and with coefficients of friction in the range of 0.12-0.18 to compare with the range of 0.4-0.6 obtained for Zr films. Wear resistance testing show that phase-pure delta-ZrH2 films deposited by HiPIMS exhibit up to 50 times lower wear rate compared to those containing a secondary Zr phase. Four-point probe measurements give resistivity values in the range of similar to 100-120 mu Omega cm for the delta-ZrH2 films, which is slightly higher compared to Zr films with values in the range 70-80 mu Omega cm

    Ecoregional Analysis of Nearshore Sea-Surface Temperature in the North Pacific

    Get PDF
    The quantification and description of sea surface temperature (SST) is critically important because it can influence the distribution, migration, and invasion of marine species; furthermore, SSTs are expected to be affected by climate change. To better understand present temperature regimes, we assembled a 29-year nearshore time series of mean monthly SSTs along the North Pacific coastline using remotely-sensed satellite data collected with the Advanced Very High Resolution Radiometer (AVHRR) instrument. We then used the dataset to describe nearshore (<20 km offshore) SST patterns of 16 North Pacific ecoregions delineated by the Marine Ecoregions of the World (MEOW) hierarchical schema. Annual mean temperature varied from 3.8°C along the Kamchatka ecoregion to 24.8°C in the Cortezian ecoregion. There are smaller annual ranges and less variability in SST in the Northeast Pacific relative to the Northwest Pacific. Within the 16 ecoregions, 31–94% of the variance in SST is explained by the annual cycle, with the annual cycle explaining the least variation in the Northern California ecoregion and the most variation in the Yellow Sea ecoregion. Clustering on mean monthly SSTs of each ecoregion showed a clear break between the ecoregions within the Warm and Cold Temperate provinces of the MEOW schema, though several of the ecoregions contained within the provinces did not show a significant difference in mean seasonal temperature patterns. Comparison of these temperature patterns shared some similarities and differences with previous biogeographic classifications and the Large Marine Ecosystems (LMEs). Finally, we provide a web link to the processed data for use by other researchers

    Long-term, high frequency in situ measurements of intertidal mussel bed temperatures using biomimetic sensors

    Get PDF
    At a proximal level, the physiological impacts of global climate change on ectothermic organisms are manifest as changes in body temperatures. Especially for plants and animals exposed to direct solar radiation, body temperatures can be substantially different from air temperatures. We deployed biomimetic sensors that approximate the thermal characteristics of intertidal mussels at 71 sites worldwide, from 1998-present. Loggers recorded temperatures at 10-30 min intervals nearly continuously at multiple intertidal elevations. Comparisons against direct measurements of mussel tissue temperature indicated errors of similar to 2.0-2.5 degrees C, during daily fluctuations that often exceeded 15 degrees-20 degrees C. Geographic patterns in thermal stress based on biomimetic logger measurements were generally far more complex than anticipated based only on 'habitat-level' measurements of air or sea surface temperature. This unique data set provides an opportunity to link physiological measurements with spatially-and temporally-explicit field observations of body temperature
    corecore