Advanced Optical Diagnostics for Ice Crystal Cloud Measurements in the NASA Glenn Propulsion Systems Laboratory

A light extinction tomography technique has been developed to monitor ice water clouds upstream of a direct connected engine in the Propulsion Systems Laboratory (PSL) at NASA Glenn Research Center (GRC). The system consists of 60 laser diodes with sheet generating optics and 120 detectors mounted around a 36-inch diameter ring. The sources are pulsed sequentially while the detectors acquire line-of-sight extinction data for each laser pulse. Using computed tomography algorithms, the extinction data are analyzed to produce a plot of the relative water content in the measurement plane. To target the low-spatial-frequency nature of ice water clouds, unique tomography algorithms were developed using filtered back-projection methods and direct inversion methods that use Gaussian basis functions. With the availability of a priori knowledge of the mean droplet size and the total water content at some point in the measurement plane, the tomography system can provide near real-time in-situ quantitative full-field total water content data at a measurement plane approximately 5 feet upstream of the engine inlet. Results from ice crystal clouds in the PSL are presented. In addition to the optical tomography technique, laser sheet imaging has also been applied in the PSL to provide planar ice cloud uniformity and relative water content data during facility calibration before the tomography system was available and also as validation data for the tomography system. A comparison between the laser sheet system and light extinction tomography resulting data are also presented. Very good agreement of imaged intensity and water content is demonstrated for both techniques. Also, comparative studies between the two techniques show excellent agreement in calculation of bulk total water content averaged over the center of the pipe

An Overview of Aeropropulsion Wind Tunnel Productivity Improvements at the NASA Lewis Research Center

Enhancing wind tunnel test productivity in terms of increased efficiency, reduced cost, and expanded flexibility is a high-priofity goal of the NASA Lewis Research Center's Aeropropulsion Facilities and Experiments Division. Over the past several years, several significant productivity improvements were implemented: test times were shortened by using facility and test article automation; additional flexibility was provided to the research customer by using the remote-access control room and by expanding facility operating envelopes; facility throughput was greatly increased and electric power cost for facility operation reduced by using the three-shift operation. One method being used to reduce electric power costs and expand the facility operating envelop in the 8- by 6-Foot Supersonic Wind Tunnel is operating the drive system with only one of the three drive motors. Metrics are being used to document several categories of facility utilization, which in turn allows tracking of test productivity. This paper provides an overview of the productivity improvements already in place in the large wind tunnels at NASA Lewis and presents plans for future improvements

Overexpression of the Linker Histone-binding Protein tNASP Affects Progression through the Cell Cycle

NASP is an H1 histone-binding protein that is cell cycle-regulated and occurs in two major forms: tNASP, found in gametes, embryonic cells, and transformed cells; and sNASP, found in all rapidly dividing somatic cells (Richardson, R. T., Batova, I. N., Widgren, E. E., Zheng, L. X., Whitfield, M., Marzluff, W. F., and O'Rand, M. G. (2000) J. Biol. Chem. 275, 30378-30386). When full-length tNASP fused to green fluorescent protein (GFP) is transiently transfected into HeLa cells, it is efficiently transported into the nucleus within 2 h after translation in the cytoplasm, whereas the NASP nuclear localization signal (NLS) deletion mutant (NASP-DeltaNLS-GFP) is retained in the cytoplasm. In HeLa cells synchronized by a double thymidine block and transiently transfected to overexpress full-length tNASP or NASP-DeltaNLS, progression through the G(1)/S border is delayed. Cells transiently transfected to overexpress the histone-binding site (HBS) deletion mutant (NASP-DeltaHBS) or sNASP were not delayed in progression through the G(1)/S border. By using a DNA supercoiling assay, in vitro binding data demonstrate that H1 histone-tNASP complexes can transfer H1 histones to DNA, whereas NASP-DeltaHBS cannot. Measurement of NASP mobility in the nucleus by fluorescence recovery after photobleaching indicates that NASP mobility is virtually identical to that reported for H1 histones. These data suggest that NASP-H1 complexes exist in the nucleus and that tNASP can influence cell cycle progression through the G(1)/S border through mediation of DNA-H1 histone binding

The Demonstration of a Light Extinction Tomography System at the NASA Glenn Research Center's Icing Research Tunnel

A prototype light extinction tomography system has been developed for acquiring real-time in-situ icing cloud uniformity and density measurements in the NASA Glenn Research Center's Icing Research Tunnel (IRT). These measurements are currently obtained through periodic manual calibrations of the IRT. These calibrations are time consuming and assume that cloud uniformity and density does not greatly vary between the periodic calibrations. It is envisioned that the new light extinction tomography system will provide the means to make these measurements in-situ in real-time and minimize the need for these manual calibrations. This new system uses the principle of light extinction tomography to measure the spray density and distribution in the test section. The prototype system was installed and successfully demonstrated in the Icing Research Tunnel in early 2018. Data sets were acquired for several standard spray and simulated fault conditions to assess system capability and sensitivity. This paper will describe the prototype light extinction system, the theory behind it, and the results of the demonstration test that was conducted in the IRT

Direct Effects, Compensation, and Recovery in Female Fathead Minnows Exposed to a Model Aromatase Inhibitor

BackgroundSeveral chemicals in the environment have the potential to inhibit aromatase, an enzyme critical to estrogen synthesis.ObjectivesThe objective of this study was to provide a detailed characterization of molecular and biochemical responses of female fathead minnows to a model aromatase inhibitor, fadrozole (FAD).MethodsFish were exposed via water to 0, 3, or 30 microg FAD/L for 8 days and then held in clean water for 8 days, with samples collected at four time points during each 8-day period. We quantified ex vivo steroid production, plasma steroids, and plasma vitellogenin (Vtg) concentrations and analyzed relative transcript abundance of 10 key regulatory genes in ovaries and 3 in pituitary tissue by real-time polymerase chain reaction.ResultsEx vivo 17beta-estradiol (E2) production and plasma E2 and Vtg concentrations were significantly reduced after a single day of exposure to 3 microg or 30 microg FAD/L. However, plasma E2 concentrations recovered by the eighth day of exposure in the 3-microg/L group and within 1 day of cessation of exposure in the 30-microg/L group, indicating concentration- and time-dependent physiologic compensation and recovery. Concentration-dependent increases in transcripts coding for aromatase (A isoform), cytochrome P450 side-chain cleavage, steroidogenic acute regulatory protein, and follicle-stimulating hormone receptor all coincided with increased E2 production and recovery of plasma E2 concentrations.ConclusionsResults of this research highlight the need to consider compensation/adaptation and recovery when developing and interpreting short-term bioassays or biomarkers or when trying to predict the effects of chemical exposures based on mode of action

Implementation of an Ultra-Bright Thermographic Phosphor for Gas Turbine Engine Temperature Measurements

The overall goal of the Aeronautics Research Mission Directorate (ARMD) Seedling Phase II effort was to build on the promising temperature-sensing characteristics of the ultrabright thermographic phosphor Cr-doped gadolinium aluminum perovskite (Cr:GAP) demonstrated in Phase I by transitioning towards an engine environment implementation. The strategy adopted was to take advantage of the unprecedented retention of ultra-bright luminescence from Cr:GAP at temperatures over 1000 C to enable fast 2D temperature mapping of actual component surfaces as well as to utilize inexpensive low-power laser-diode excitation suitable for on-wing diagnostics. A special emphasis was placed on establishing Cr:GAP luminescence-based surface temperature mapping as a new tool for evaluating engine component surface cooling effectiveness

The Demonstration of a Light Extinction Tomography System at the NASA Glenn Research Center's Icing Research Tunnel

A prototype light extinction tomography system has been developed for acquiring real-time in-situ icing cloud uniformity and density measurements in the NASA Glenn Research Center's Icing Research Tunnel (IRT). These measurements are currently obtained through periodic manual calibrations of the IRT. These calibrations are time consuming and assume that cloud uniformity and density does not greatly vary between the periodic calibrations. It is envisioned that the new light extinction tomography system will provide the means to make these measurements in-situ in real-time and minimize the need for these manual calibrations. This new system uses the principle of light extinction tomography to measure the spray density and distribution in the test section. The prototype system was installed and successfully demonstrated in the Icing Research Tunnel in early 2018. Data sets were acquired for several standard spray and simulated fault conditions to assess system capability and sensitivity. This paper will describe the prototype light extinction system, the theory behind it, and the results of the demonstration test that was conducted in the IRT

Temperature Measurements of Thermal Barrier Coating Surfaces Using a Cr-Doped GdAlO3 Thermographic Phosphor

No abstract availabl