10,846 research outputs found
A General Formula for Black Hole Gravitational Wave Kicks
Although the gravitational wave kick velocity in the orbital plane of
coalescing black holes has been understood for some time, apparently
conflicting formulae have been proposed for the dominant out-of-plane kick,
each a good fit to different data sets. This is important to resolve because it
is only the out-of-plane kicks that can reach more than 500 km/s and can thus
eject merged remnants from galaxies. Using a different ansatz for the
out-of-plane kick, we show that we can fit almost all existing data to better
than 5 %. This is good enough for any astrophysical calculation, and shows that
the previous apparent conflict was only because the two data sets explored
different aspects of the kick parameter space.Comment: 14 pages
Почему необходимо принимать во внимание вагинальное введение лекарственных средств
ВЛАГАЛИЩЕЛЕКАРСТВА, ПУТИ ВВЕДЕНИ
Modeling kicks from the merger of generic black-hole binaries
Recent numerical relativistic results demonstrate that the merger of
comparable-mass spinning black holes has a maximum ``recoil kick'' of up to
\sim 4000 \kms. However the scaling of these recoil velocities with mass
ratio is poorly understood. We present new runs showing that the maximum
possible kick perpendicular to the orbital plane does not scale as
(where is the symmetric mass ratio), as previously proposed, but is more
consistent with , at least for systems with low orbital precession.
We discuss the effect of this dependence on galactic ejection scenarios and
retention of intermediate-mass black holes in globular clusters.Comment: 5 pages, 1 figure, 3 tables. Version published in Astrophys. J. Let
Atom chips on direct bonded copper substrates
We present the use of direct bonded copper (DBC) for the straightforward
fabrication of high power atom chips. Atom chips using DBC have several
benefits: excellent copper/substrate adhesion, high purity, thick (> 100
microns) copper layers, high substrate thermal conductivity, high aspect ratio
wires, the potential for rapid (< 8 hr) fabrication, and three dimensional atom
chip structures. Two mask options for DBC atom chip fabrication are presented,
as well as two methods for etching wire patterns into the copper layer. The
wire aspect ratio that optimizes the magnetic field gradient as a function of
power dissipation is determined to be 0.84:1 (height:width). The optimal wire
thickness as a function of magnetic trapping height is also determined. A test
chip, able to support 100 A of current for 2 s without failing, is used to
determine the thermal impedance of the DBC. An assembly using two DBC atom
chips to provide magnetic confinement is also shown.Comment: 8 pages, 5 figure
Adjustable microchip ring trap for cold atoms and molecules
We describe the design and function of a circular magnetic waveguide produced
from wires on a microchip for atom interferometry using deBroglie waves. The
guide is a two-dimensional magnetic minimum for trapping weak-field seeking
states of atoms or molecules with a magnetic dipole moment. The design consists
of seven circular wires sharing a common radius. We describe the design, the
time-dependent currents of the wires and show that it is possible to form a
circular waveguide with adjustable height and gradient while minimizing
perturbation resulting from leads or wire crossings. This maximal area geometry
is suited for rotation sensing with atom interferometry via the Sagnac effect
using either cold atoms, molecules and Bose-condensed systems
Vector and Axial Form Factors Applied to Neutrino Quasielastic Scattering
We calculate the quasielastic cross sections for neutrino scattering on
nucleons using up to date fits to the nucleon elastic electromagnetic form
factors GEp, GEn, GMp, GMn, and weak form factors. We show the extraction of Fa
for neutrino experiments. We show how well \minerva, a new approved experiment
at FNAL, can measure Fa. We show the that Fa has a different contribution to
the anti-neutrino cross section, and how the anti-neutrino data can be used to
check Fa extracted from neutrino scattering.Comment: Presented by Howard Budd at NuInt04, Mar. 2004, Laboratori Nazionali
del Gran Sasso - INFN - Assergi, Ital
Novel Applications of Carbon Isotopes in Atmospheric CO2: What Can Atmospheric Measurements Teach Us About Processes in the Biosphere?
Conventionally, measurements of carbon isotopes in atmospheric CO2 (δ13CO2) have been used to partition fluxes between terrestrial and ocean carbon pools. However, novel analytical approaches combined with an increase in the spatial extent and frequency of δ13CO2 measurements allow us to conduct a global analysis of δ13CO2 variability to infer the isotopic composition of source CO2 to the atmosphere (δs). This global analysis yields coherent seasonal patterns of isotopic enrichment. Our results indicate that seasonal values of δs are more highly correlated with vapor pressure deficit (r = 0.404) than relative humidity (r = 0.149). We then evaluate two widely used stomatal conductance models and determine that the Leuning Model, which is primarily driven by vapor pressure deficit is more effective globally at predicting δs (RMSE = 1.6‰) than the Ball-Woodrow-Berry model, which is driven by relative humidity (RMSE = 2.7‰). Thus stomatal conductance on a global scale may be more sensitive to changes in vapor pressure deficit than relative humidity. This approach highlights a new application of using δ13CO2 measurements to validate global models
Splinting Method for Preventing Thermal Injuries in Patients with Malleolar Fractures of the Ankle after Operative Treatment Performed Under Regional Anesthesia
After performing open reduction and internal fixation (ORIF) for treating malleolar fractures of the ankle, surgeons typically use plaster splints during postoperative recovery of patients. Use of regional anesthesia during ORIF has been noted as a risk factor for burns in patients using plaster splints, possibly owing to inability to feel pain after undergoing regional block. We describe a successful postoperative splinting technique used for preventing thermal injuries in this patient population. We reviewed medical records of patients between 2011 and 2013 at our institution with malleolar ankle fractures who had underwent ORIF under general anesthesia, peripheral nerve block, or a combination of both. Patients without follow-up were excluded; therefore, 154 were included. No thermal injuries were noted, operative reduction of the fracture was maintained, and the cost of each splint was $13.19. Use of the current technique in applying plaster splints may help effectively prevent postoperative thermal injuries
- …