Consumer acceptance of minced meat patties from boars in four European countries

A consumer study was performed in four EU countries to further clarify the acceptability of meat with boar taint. In Denmark, France, Italy and Poland, a total of 476 female consumers evaluated 8 meat patties from boars with varying levels of skatole (0.10-0.40μg/g fat tissue) and androstenone (0.47-2.00 μg/g fat tissue), in a pair-wise comparison with patties from castrates. Boar meat patties were always less preferred than the castrate meat patties, regardless of the level of androstenone and skatole. Acceptability of the boar meat patties decreased with increasing skatole level. In samples with low skatole levels, higher levels of androstenone also reduced acceptability among androstenone sensitive consumers. No clear threshold levels for androstenone and skatole could be identified. Maps presenting the reduction in preference due to increasing levels of skatole and androstenone, and corrected for the general acceptance of the meat product were developed, taking into account androstenone sensitivity. Further work is needed, covering the whole range of androstenone and skatole levels found in entire male pigs and for a wider set of meat products.info:eu-repo/semantics/acceptedVersio

Green Production of Anionic Surfactant Obtained from Pea Protein

A pea protein isolate was hydrolyzed by a double enzyme treatment method in order to obtain short peptide sequences used as raw materials to produce lipopeptides-based surfactants. Pea protein hydrolysates were prepared using the combination of Alcalase and Flavourzyme. The influence of the process variables was studied to optimize the proteolytic degradation to high degrees of hydrolysis. The average peptide chain lengths were obtained at 3–5 amino acid units after a hydrolysis of 30 min with the mixture of enzymes. Then, N-acylation in water, in presence of acid chloride (C12 and C16), carried out with a conversion rate of amine functions of 90%, allowed to obtain anionic surfactant mixtures (lipopeptides and sodium fatty acids). These two steps were performed in water, in continuous and did not generate any waste. This process was therefore in line with green chemistry principles. The surface activities (CMC, foaming and emulsifying properties) of these mixtures were also studied. These formulations obtained from natural renewable resources and the reactions done under environmental respect, could replace petrochemical based surfactants for some applications

Effects of breed‐production system on collagen, textural, and sensory traits of 10 European beef cattle breeds

In the current study the collagen, texture, and sensory characteristics of meat from 712 yearling males of 10 local Spanish and French beef breeds raised in their typical production systems were described. The breed‐production system affected collagen and texture variables but affected sensory variables only slightly. There was a large amount of intra breed‐production system variation for all the variables. French breeds had lower values for collagen solubility (~12%) than Spanish breeds (~40%). Stress (WB) varied from 36 N/cm2 in Casina to 44 N/cm2 in Salers, whereas compression stress at 80% ranged from 35 N/cm2 in Asturiana de los Valles to 40 N/cm2 in Salers. Oven cooking resulted in higher cooking losses (24%) than cooking on a grill (12%). Cooking losses increased as the grill temperature increased. Numerous significant correlations were found among variables. Carcass weight is associated with all the collagen and texture variables. Correlation coefficients among texture and collagen variables were statistically significant and these correlation coefficients were in general higher for solubility percentage than for total collagen content, highlighting the importance of the solubility of collagen rather than total collagen in determining meat textural properties. Practical applications. To differentiate a product in the market, it is necessary to define its characteristics. Differentiation allows increasing the added value of products and, therefore, income of the farmers. In addition, it guarantees to the consumers that the product they purchase has the intrinsic and extrinsic quality features that they seek. For consumers, beef texture is one of the most important quality attributes sought, therefore, studying factors that can affect beef texture is a major interest for the industry.info:eu-repo/semantics/acceptedVersio