Evaluating the effectiveness of Cooperative/Coordinated Multipoint (CoMP) LTE feature in uplink and downlink transmissions

Shannon demonstrated that the channel capacity depends of the ratio of the received signal power to interference plus noise power (SINR). Inter-cell interference caused by neighbouring base stations (BSs) has been identified as one of the most severe problem towards the deployment of LTE technology as it can significantly deteriorate the performance of cellside User Equipment (UE). However, because of regulatory and radiation restrictions as well as operational costs, signal power may only be increased only up to a certain limit to reduce the interference. The other common radio propagation impairment is multipath. Multipath refers to a scenario where multiple copies of a signal propagate to a receiver using different paths. The paths can be created due to signal reflection, scattering and diffraction. As will be discussed later the effects of multipath contribute little to intercell interference because multipath characteristics such as delay spread are compensated for using cyclic prefixes. In this work, we will limit our scope to interference as it has been identified as the main cause of performance degradation for cell edge users due to the full frequency reuse technique used in LTE. To mitigate interference 3GPP devised options of increasing the capacity in LTEAdvanced Release 12 which include the use of spectral aggregation, employing Multiple Input and Multiple Output (MIMO) Antenna techniques, deploying more base stations and micro and femto cells, increasing the degree of sectorisation and Coordinated Multipoint (CoMP). We are primarily interested in evaluating performance improvements introduced when uplink (UL) and downlink (DL) coordinated/cooperative multipoint (CoMP) is enabled in LTE Advanced Release 12 as a way of reducing interference among sites. The CoMP option of reducing interference does not require deployment of new equipment compared to the other options mentioned above hence network deployment costs are minimal. CoMP in theory is known to reduce interference especially for cell edge users and therefore improves network fairness. With CoMP, multiple points coordinate with each other such that transmission of signals to and from other points do not incur serious interference or the interference can even be exploited as a meaningful signal. In September 2011 work on specifications for CoMP support was started in 3GPP LTEAdvanced as one of the core features in LTE-Advanced Release 11 to improve cell edge user throughput as well as the average network throughput. We set to do field measurements in the evaluation of the effectiveness of CoMP in LTE. 3GPP LTE Release 12 was used and cell edge users' performance was the focus. The network operates in 2330 - 2350 MHz band (Channel 40). From the field measurements, it was demonstrated that the CoMP (Scenario 2) feature indeed effective in improving service quality/user experience/fairness for cell edge users. CoMP inherently improves network capacity. A seven (7) percent throughput was noticed

Performance Modelling and Analysis of a New CoMP-based Handover Scheme for Next Generation Wireless Networks. Performance Modelling and Analysis for the Design and Development of a New Handover Scheme for Cell Edge Users in Next Generation Wireless Networks (NGWNs) Based on the Coordinated Multi-Point (CoMP) Joint Transmission (JT) Technique

Inter-Cell Interference (ICI) will be one of main problems for degrading the performance of future wireless networks at cell edge. This adverse situation will become worst in the presence of dense deployment of micro and macro cells. In this context, the Coordinated Multi-Point (CoMP) technique was introduced to mitigate ICI in Next Generation Wireless Networks (NGWN) and increase their network performance at cell edge. Even though the CoMP technique provides satisfactory solutions of various problems at cell edge, nevertheless existing CoMP handover schemes do not prevent unnecessary handover initialisation decisions and never discuss the drawbacks of CoMP handover technique such as excessive feedback and resource sharing among UEs. In this research, new CoMP-based handover schemes are proposed in order to minimise unnecessary handover decisions at cell edge and determine solution of drawbacks of CoMP technique in conjunction with signal measurements such as Reference Signal Received Power (RSRP) and Received Signal Received Quality (RSRQ). A combination of calculations of RSRP and RSRQ facilitate a credible decision making process of CoMP mode and handover mode at cell edge. Typical numerical experiments indicate that by triggering the CoMP mode along with solutions of drawbacks, the overall network performance is constantly increase as the number of unnecessary handovers is progressively reduced

Ubiquitous Cell-Free Massive MIMO Communications

Since the first cellular networks were trialled in the 1970s, we have witnessed an incredible wireless revolution. From 1G to 4G, the massive traffic growth has been managed by a combination of wider bandwidths, refined radio interfaces, and network densification, namely increasing the number of antennas per site. Due its cost-efficiency, the latter has contributed the most. Massive MIMO (multiple-input multiple-output) is a key 5G technology that uses massive antenna arrays to provide a very high beamforming gain and spatially multiplexing of users, and hence, increases the spectral and energy efficiency. It constitutes a centralized solution to densify a network, and its performance is limited by the inter-cell interference inherent in its cell-centric design. Conversely, ubiquitous cell-free Massive MIMO refers to a distributed Massive MIMO system implementing coherent user-centric transmission to overcome the inter-cell interference limitation in cellular networks and provide additional macro-diversity. These features, combined with the system scalability inherent in the Massive MIMO design, distinguishes ubiquitous cell-free Massive MIMO from prior coordinated distributed wireless systems. In this article, we investigate the enormous potential of this promising technology while addressing practical deployment issues to deal with the increased back/front-hauling overhead deriving from the signal co-processing.Comment: Published in EURASIP Journal on Wireless Communications and Networking on August 5, 201

INTERFERENCE MANAGEMENT IN LTE SYSTEM AND BEYOUND

The key challenges to high throughput in cellular wireless communication system are interference, mobility and bandwidth limitation. Mobility has never been a problem until recently, bandwidth has been constantly improved upon through the evolutions in cellular wireless communication system but interference has been a constant limitation to any improvement that may have resulted from such evolution. The fundamental challenge to a system designer or a researcher is how to achieve high data rate in motion (high speed) in a cellular system that is intrinsically interference-limited. Multi-antenna is the solution to data on the move and the capacity of multi-antenna system has been demonstrated to increase proportionally with increase in the number of antennas at both transmitter and receiver for point-to-point communications and multi-user environment. However, the capacity gain in both uplink and downlink is limited in a multi-user environment like cellular system by interference, the number of antennas at the base station, complexity and space constraint particularly for a mobile terminal. This challenge in the downlink provided the motivation to investigate successive interference cancellation (SIC) as an interference management tool LTE system and beyond. The Simulation revealed that ordered successive interference (OSIC) out performs non-ordered successive interference cancellation (NSIC) and the additional complexity is justified based on the associated gain in BER performance of OSIC. The major drawback of OSIC is that it is not efficient in network environment employing power control or power allocation. Additional interference management techniques will be required to fully manage the interference.fi=Opinnäytetyö kokotekstinä PDF-muodossa.|en=Thesis fulltext in PDF format.|sv=Lärdomsprov tillgängligt som fulltext i PDF-format

Coordinated Multipoint Transmission in Femtocell Systems

3GPP includes the LTE air interface specifications in various releases. Several interesting features such as Home Enhanced Node-B (HeNB) known as femtocells and Coordinated Multipoint Transmission (CoMP) have been introduced. According to the requirements, Long Term Evolution is expected to provide higher data rates especially at cell edge. In this thesis, a noteworthy implementation of Coordinated Multipoint Transmission is proposed to fulfill the performance targets of 4G cellular networks. The coordination takes place in a femtocell network for downlink in this study. The coordination enhances the signal quality received at the user terminal resulting in an improvement in the indoor coverage, cell capacity, lower CAPEX and enhanced network topology. This thesis studies the positive and negative aspects of implementation of CoMP in femtocell systems within LTE framework. The basic work done throughout this thesis is to investigate the parameter configuration and performance evaluation of downlink base station coordination in LTE femtocell scenario. 3GPP's technical specifications are applied for both macrocell and femtocell deployment. Parameter optimization and performance evaluation are examined for the users in the femtocell from different perspectives

Multi-user interference mitigation under limited feedback requirements for WCDMA systems with base station cooperation

One of the techniques that has been recently identified for dealing with multi-user interference (MUI) in future communications systems is base station (BS) cooperation or joint processing. However, perfect MUI cancellation with this technique demands severe synchronization requirements, perfect and global channel state information (CSI), and an increased backhaul and signaling overhead. In this paper, we consider a more realistic layout with the aim of mitigating the MUI, where only local CSI is available at the BSs. Due to synchronization inaccuracies and errors in the channel estimation, the system becomes partially asynchronous. In the downlink of wideband code division multiple access based systems, this asynchronism stands for the loss of the orthogonality of the spreading codes allocated to users and thus, for an increase in the MUI level of the system. In this contribution, we propose a framework for mitigating the MUI which builds in three main steps: definition of a cooperation area based on the channel characteristics, statistical modeling of the average MUI power experienced by each user and a specific spreading code allocation scheme for users served with joint processing. This code allocation assigns spreading codes to users in such a way that minimum average cross-correlation between active users can be achieved. Interestingly, these steps can be performed with a limited amount of extra feedback from the user's side

Towards 5th Generation Cellular Mobile Networks

Cellular mobile networks have enabled ubiquitous communications and largely changed the way we live and work. At the same time, the network itself has been undergoing significant changes in the process of meeting our ever increasing demands on data rate and quality of service. In this article, we show the path of the evolution in both standards and techniques, and provide our vision for the future of the cellular networks. We review the evolution of international standards for cellular mobile networks in the last two decades, describe how the network layout has been migrating from rigid cellular architecture to random and dense small cells, and provide an indepth discussion on potential enabling techniques for the next generation (5G) cellular networks, particularly massive MIMO and multiband base-station antennas