62 research outputs found
Design and analysis of parity-check-code-based optical recording systems
Ph.DNUS-TU/E JOINT PH.D. PROGRAMM
CHANNEL CODING TECHNIQUES FOR A MULTIPLE TRACK DIGITAL MAGNETIC RECORDING SYSTEM
In magnetic recording greater area) bit packing densities are achieved through increasing
track density by reducing space between and width of the recording tracks, and/or
reducing the wavelength of the recorded information. This leads to the requirement of
higher precision tape transport mechanisms and dedicated coding circuitry.
A TMS320 10 digital signal processor is applied to a standard low-cost, low precision,
multiple-track, compact cassette tape recording system. Advanced signal processing and
coding techniques are employed to maximise recording density and to compensate for
the mechanical deficiencies of this system. Parallel software encoding/decoding
algorithms have been developed for several Run-Length Limited modulation codes. The
results for a peak detection system show that Bi-Phase L code can be reliably employed
up to a data rate of 5kbits/second/track. Development of a second system employing a
TMS32025 and sampling detection permitted the utilisation of adaptive equalisation to
slim the readback pulse. Application of conventional read equalisation techniques, that
oppose inter-symbol interference, resulted in a 30% increase in performance.
Further investigation shows that greater linear recording densities can be achieved by
employing Partial Response signalling and Maximum Likelihood Detection. Partial
response signalling schemes use controlled inter-symbol interference to increase
recording density at the expense of a multi-level read back waveform which results in an
increased noise penalty. Maximum Likelihood Sequence detection employs soft
decisions on the readback waveform to recover this loss. The associated modulation
coding techniques required for optimised operation of such a system are discussed.
Two-dimensional run-length-limited (d, ky) modulation codes provide a further means of
increasing storage capacity in multi-track recording systems. For example the code rate
of a single track run length-limited code with constraints (1, 3), such as Miller code, can
be increased by over 25% when using a 4-track two-dimensional code with the same d
constraint and with the k constraint satisfied across a number of parallel channels. The k
constraint along an individual track, kx, can be increased without loss of clock
synchronisation since the clocking information derived by frequent signal transitions
can be sub-divided across a number of, y, parallel tracks in terms of a ky constraint. This
permits more code words to be generated for a given (d, k) constraint in two dimensions
than is possible in one dimension. This coding technique is furthered by development of
a reverse enumeration scheme based on the trellis description of the (d, ky) constraints.
The application of a two-dimensional code to a high linear density system employing
extended class IV partial response signalling and maximum likelihood detection is
proposed. Finally, additional coding constraints to improve spectral response and error
performance are discussed.Hewlett Packard, Computer Peripherals Division (Bristol
Modulation codes for mobile communications
M.Ing. (Electrical and Electronic Engineering)Please refer to full text to view abstrac
Analysis of the IEEE 802.15.4a ultra wideband physical layer through wireless sensor network simulations in OMNET++
Wireless Sensor Networks are the main representative of pervasive computing in large-scale physical environments. These networks consist of a large number of small, wireless devices embedded in the physical world to be used for surveillance, environmental monitoring or other data capture, processing and transfer applications. Ultra wideband has emerged as one of the newest and most promising concepts for wireless technology. Considering all its advantages it seems a likely communication technology candidate for future wireless sensor networks. This paper considers the viability of ultra wideband technology in wireless sensor networks by employing an IEEE 802.15.4a low-rate ultra wideband physical layer model in the OMNET++ simulation environment. An elaborate investigation into the inner workings of the IEEE 802.15.4a UWB physical layer is performed. Simulation experiments are used to provide a detailed analysis of the performance of the IEEE 802.15.4a UWB physical layer over several communication distances. A proposal for a cognitive, adaptive communication approach to optimize for speed and distance is also presented. AFRIKAANS : Draadlose Sensor Netwerke is die hoof verteenwoordiger vir deurdringende rekenarisering in groot skaal fisiese omgewings. Hierdie tipe netwerke bestaan uit ’n groot aantal klein, draadlose apparate wat in die fisiese wêreld ingesluit word vir die doel van bewaking, omgewings monitering en vele ander data opvang, verwerk en oordrag applikasies. Ultra wyeband het opgestaan as een van die nuutste en mees belowend konsepte vir draadlose kommunikasie tegnologie. As al die voordele van dié kommunikasie tegnologie in ag geneem word, blyk dit om ’n baie goeie kandidaat te wees vir gebruik in toekomstige draadlose sensor netwerke. Hierdie verhandeling oorweeg die vatbaarheid van die gebruik van die ultra wyeband tegnologie in draadlose sensor netwerke deur ’n IEEE 802.15.4a lae-tempo ultra wyeband fisiese laag model in die OMNET++ simulasie omgewing toe te pas. ’n Breedvoerige ondersoek word geloots om die fyn binneste werking van die IEEE 802.15.4a UWB fisiese laag te verstaan. Simulasie eksperimente word gebruik om ’n meer gedetaileerde analiese omtrent die werkverrigting van die IEEE 802.15.4a UWB fisiese laag te verkry oor verskillende kommunikasie afstande. ’n Voorstel vir ’n omgewings bewuste, aanpasbare kommunikasie tegniek word bespreek met die doel om die spoed en afstand van kommunikasie te optimiseer.Dissertation (MEng)--University of Pretoria, 2011.Electrical, Electronic and Computer Engineeringunrestricte
Efficient Signal, Code, and Receiver Designs for MIMO Communication Systems
Thesis Supervisor: Gregory W. Wornell
Title: ProfessorThe so-called diversity-multiplexing tradeoff characterizes the fundamental interaction between the robustness and capacity gains obtainable from multiple-input and
multiple-output (MIMO) systems in fading environments. This thesis develops practical schemes for approaching the optimal tradeoff in various delay and complexity
regimes. We focus on a two-transmit and two-receive antenna system, in which the
receiver has channel knowledge, but the transmitter does not.
We first investigate uncoded transmission. We propose a class of lattice-reduction-
aided low-complexity detectors that can achieve near maximum likelihood performance and the best diversity-multiplexing tradeoff achievable by any length-one code.
We also design a family of structured space-time block codes that we call tilted-
QAM codes. It achieves the optimal infinite-delay tradeoff with the necessary minimum delay of two, answering a previously open question. It uses constellation rotation
ideas to effectively spread information across space and time. We identify rotation
angles that are universally optimal at all rates in terms of a determinant criterion.
We further develop efficient coding schemes using long error correction codes.
In particular, we combine them with tilted-QAM codes using hard and soft decision decoding to obtain good performance at moderate SNR. These new systems are
compared to orthogonal space-time coded systems, which we show to achieve near optimal performance at low SNR. We also examine traditional sequential versions and
develop new block versions of the Bell Labs layered architecture (BLAST). While
some of these can in principle reach the performance limit at all SNRs, we show they
also have various practical problems.
Finally, for the case where no channel knowledge is available, we present a geometric view of the signal design problem. This view reveals how training based
approaches can achieve the optimal (non-coherent) diversity-multiplexing tradeNational Science Foundation Graduate Research Fellowship Program, the AT&T Labs Fellowship Program, HP through the HP/MIT Alliance, TI through the Leadership Universities Program, NSF, Army Research Laboratory under Collaborative Technology Alliance and MARCO/DARPA
Ultra-wideband Based Indoor Localization of Mobile Nodes in ToA and TDoA Configurations
Zandian R. Ultra-wideband Based Indoor Localization of Mobile Nodes in ToA and TDoA Configurations. Bielefeld: Universität Bielefeld; 2019.This thesis discusses the utilization of ultra-wideband (UWB) technology in indoor localization scenarios and proposes system setup and evaluates different localization algorithms in order to improve the localization accuracy and stability of such systems in non-ideal conditions of the indoor environment.
Recent developments and advances of technology in the areas of ubiquitous Internet, robotics and internet of things (IoT) have resulted in emerging new application areas in daily life in which localization systems are vital. The significant demand for a robust and accurate localization system that is applicable in indoor areas lacking satellites link, can be sensed. The UWB technology offers accurate localization systems with an accuracy of below 10 cm and covering the range of up to a few hundred meters thanks to their dedicated large bandwidth, modulation technique and signal power.
In this thesis, the technology behind the UWB systems is discussed in detail. In terms of localization topologies, different scenarios with the focus on time-based methods are introduced. The main focus of this thesis is on the differential time of arrival localization systems (TDoA) with unilateral constellation that is suitable for robotic localization and navigation applications.
A new approach for synchronization of TDoA topology is proposed and influence of clock inaccuracies in such systems are thoroughly evaluated. For localization engine, two groups of static and dynamic iterative algorithms are introduced. Among the possible dynamic methods, extended Kalman filter (EKF), H∞ and unscented Kalman filter (UKF) are discussed and meticulously evaluated.
In order to tackle the non-line of sight (NLOS) problem of such systems, for detection stage several solutions which are based on parametric machine learning methods are proposed. Furthermore, for mitigation phase two solutions namely adjustment of measurement variance and innovation term are suggested. Practical results prove the efficiency and high reliability of the proposed algorithms with positive NLOS condition detection rate of more than 87%.
In practical trials, the localization system is evaluated in indoor and outdoor arenas in both line of sight and non-line of sight conditions. The results show that the proposed detection and mitigation methods can be successfully applied for both small and large-scale arenas with the higher performance of the localization filters in terms of accuracy in large-scale scenarios
Recent Application in Biometrics
In the recent years, a number of recognition and authentication systems based on biometric measurements have been proposed. Algorithms and sensors have been developed to acquire and process many different biometric traits. Moreover, the biometric technology is being used in novel ways, with potential commercial and practical implications to our daily activities. The key objective of the book is to provide a collection of comprehensive references on some recent theoretical development as well as novel applications in biometrics. The topics covered in this book reflect well both aspects of development. They include biometric sample quality, privacy preserving and cancellable biometrics, contactless biometrics, novel and unconventional biometrics, and the technical challenges in implementing the technology in portable devices. The book consists of 15 chapters. It is divided into four sections, namely, biometric applications on mobile platforms, cancelable biometrics, biometric encryption, and other applications. The book was reviewed by editors Dr. Jucheng Yang and Dr. Norman Poh. We deeply appreciate the efforts of our guest editors: Dr. Girija Chetty, Dr. Loris Nanni, Dr. Jianjiang Feng, Dr. Dongsun Park and Dr. Sook Yoon, as well as a number of anonymous reviewers
- …