Information Switching Processor (ISP) contention analysis and control

Future satellite communications, as a viable means of communications and an alternative to terrestrial networks, demand flexibility and low end-user cost. On-board switching/processing satellites potentially provide these features, allowing flexible interconnection among multiple spot beams, direct to the user communications services using very small aperture terminals (VSAT's), independent uplink and downlink access/transmission system designs optimized to user's traffic requirements, efficient TDM downlink transmission, and better link performance. A flexible switching system on the satellite in conjunction with low-cost user terminals will likely benefit future satellite network users

Survey of switching techniques in high-speed networks and their performance

One of the most promising approaches for high speed networks for integrated service applications is fast packet switching, or ATM (Asynchronous Transfer Mode). ATM can be characterized by very high speed transmission links and simple, hard wired protocols within a network. To match the transmission speed of the network links, and to minimize the overhead due to the processing of network protocols, the switching of cells is done in hardware switching fabrics in ATM networks.A number of designs has been proposed for implementing ATM switches. While many differences exist among the proposals, the vast majority of them is based on self-routing multi-stage interconnection networks. This is because of the desirable features of multi-stage interconnection networks such as self-routing capability and suitability for VLSI implementation.Existing ATM switch architectures can be classified into two major classes: blocking switches, where blockings of cells may occur within a switch when more than one cell contends for the same internal link, and non-blocking switches, where no internal blocking occurs. A large number of techniques has also been proposed to improve the performance of blocking and nonblocking switches. In this paper, we present an extensive survey of the existing proposals for ATM switch architectures, focusing on their performance issues

Architecture design and performance analysis of practical buffered-crossbar packet switches

Combined input crosspoint buffered (CICB) packet switches were introduced to relax inputoutput arbitration timing and provide high throughput under admissible traffic. However, the amount of memory required in the crossbar of an N x N switch is N2x k x L, where k is the crosspoint buffer size and needs to be of size RTT in cells, L is the packet size. RTT is the round-trip time which is defined by the distance between line cards and switch fabric. When the switch size is large or RTT is not negligible, the memory amount required makes the implementation costly or infeasible for buffered crossbar switches. To reduce the required memory amount, a family of shared memory combined-input crosspoint-buffered (SMCB) packet switches, where the crosspoint buffers are shared among inputs, are introduced in this thesis. One of the proposed switches uses a memory speedup of in and dynamic memory allocation, and the other switch avoids speedup by arbitrating the access of inputs to the crosspoint buffers. These two switches reduce the required memory of the buffered crossbar by 50% or more and achieve equivalent throughput under independent and identical traffic with uniform distributions when using random selections. The proposed mSMCB switch is extended to support differentiated services and long RTT. To support P traffic classes with different priorities, CICB switches have been reported to use N2x k x L x P amount of memory to avoid blocking of high priority cells.The proposed SMCB switch with support for differentiated services requires 1/mP of the memory amount in the buffered crossbar and achieves similar throughput performance to that of a CICB switch with similar priority management, while using no speedup in the shared memory. The throughput performance of SMCB switch with crosspoint buffers shared by inputs (I-SMCB) is studied under multicast traffic. An output-based shared-memory crosspoint buffered (O-SMCB) packet switch is proposed where the crosspoint buffers are shared by two outputs and use no speedup. The proposed O-SMCB switch provides high performance under admissible uniform and nonuniform multicast traffic models while using 50% of the memory used in CICB switches. Furthermore, the O-SMCB switch provides higher throughput than the I-SMCB switch. As SMCB switches can efficiently support an RTT twice as long as that supported by CICB switches and as the performance of SMCB switches is bounded by a matching between inputs and crosspoint buffers, a new family of CICB switches with flexible access to crosspoint buffers are proposed to support longer RTTs than SMCB switches and to provide higher throughput under a wide variety of admissible traffic models. The CICB switches with flexible access allow an input to use any available crosspoint buffer at a given output. The proposed switches reduce the required crosspoint buffer size by a factor of N , keep the service of cells in sequence, and use no speedup. This new class of switches achieve higher throughput performance than CICB switches under a large variety of traffic models, while supporting long RTTs. Crosspoint buffered switches that are implemented in single chips have limited scalability. To support a large number of ports in crosspoint buffered switches, memory-memory-memory (MMM) Clos-network switches are an alternative. The MMM switches that use minimum memory amount at the central module is studied. Although, this switch can provide a moderate throughput, MMM switch may serve cells out of sequence. As keeping cells in sequence in an MMM switch may require buffers be distributed per flow, an MMM with extended memory in the switch modules is studied. To solve the out of sequence problem in MMM switches, a queuing architecture is proposed for an MMM switch. The service of cells in sequence is analyzed

Performance analysis of virtual path over large-scale ATM switches.

by Tang Oo.Thesis submitted in: December 1997.Thesis (M.Phil.)--Chinese University of Hong Kong, 1998.Includes bibliographical references (leaves 68-[75]).Abstract also in Chinese.Chapter 1 --- Introduction --- p.1Chapter 1.1 --- Background --- p.1Chapter 1.2 --- The Concept of Cross-Path Switching --- p.8Chapter 1.3 --- Contribution and Organization of Thesis --- p.12Chapter 2 --- The Virtual Path Scheduling Scheme --- p.14Chapter 2.1 --- The Trade-off Between Throughput and Concentration Loss --- p.14Chapter 2.2 --- Partition of Virtual Paths --- p.19Chapter 2.3 --- The Capacity and Route Assignment of Virtual Paths --- p.21Chapter 3 --- Performance Analysis and Simulation Results --- p.28Chapter 3.1 --- The Improvement of Concentration Loss --- p.28Chapter 3.2 --- The Throughput with Look-ahead Scheme --- p.30Chapter 3.3 --- The Throughput with Input Smoothing Scheme --- p.34Chapter 3.4 --- The Throughput with Bursty Source --- p.37Chapter 3.5 --- Buffer Dimensioning and The Cell Loss Probability Due to Buffer Overflow --- p.38Chapter 4 --- Capacity Assignment and Evaluation of Multiplexing Gain --- p.47Chapter 4.1 --- Principle of Capacity Assignment --- p.47Chapter 4.2 --- The Model of Virtual Path --- p.49Chapter 4.3 --- Capacity Assignment for CBR Service --- p.51Chapter 4.4 --- Capacity Assignment for Real-time VBR Service --- p.53Chapter 4.5 --- Capacity Assignment for Non Real-time VBR Service --- p.55Chapter 4.6 --- Capacity Matrix --- p.56Chapter 4.7 --- The Evaluation of Multiplexing Gain of Input Stage --- p.58Chapter 5 --- Discussions and Conclusions --- p.64Bibliography --- p.6

On the design of a high-performance adaptive router for CC-NUMA multiprocessors

Copyright © 2003 IEEEThis work presents the design and evaluation of an adaptive packet router aimed at supporting CC-NUMA traffic. We exploit a simple and efficient packet injection mechanism to avoid deadlock, which leads to a fully adaptive routing by employing only three virtual channels. In addition, we selectively use output buffers for implementing the most utilized virtual paths in order to reduce head-of-line blocking. The careful implementation of these features has resulted in a good trade off between network performance and hardware cost. The outcome of this research is a High-Performance Adaptive Router (HPAR), which adequately balances the needs of parallel applications: minimal network latency at low loads and high throughput at heavy loads. The paper includes an evaluation process in which HPAR is compared with other adaptive routers using FIFO input buffering, with or without additional virtual channels to reduce head-of-line blocking. This evaluation contemplates both the VLSI costs of each router and their performance under synthetic and real application workloads. To make the comparison fair, all the routers use the same efficient deadlock avoidance mechanism. In all the experiments, HPAR exhibited the best response among all the routers tested. The throughput gains ranged from 10 percent to 40 percent in respect to its most direct rival, which employs more hardware resources. Other results shown that HPAR achieves up to 83 percent of its theoretical maximum throughput under random traffic and up to 70 percent when running real applications. Moreover, the observed packet latencies were comparable to those exhibited by simpler routers. Therefore, HPAR can be considered as a suitable candidate to implement packet interchange in next generations of CC-NUMA multiprocessors.Valentín Puente, José-Ángel Gregorio, Ramón Beivide, and Cruz Iz

A Performance evaluation of several ATM switching architectures

The goal of this thesis is to evaluate the performance of three Asynchronous Transfer Mode switching architectures. After examining many different ATM switching architectures in literature, the three architectures chosen for study were the Knockout switch, the Sunshine switch, and the Helical switch. A discrete-time, event driven system simulator, named ProModel, was used to model the switching behavior of these architectures. Each switching architecture was modeled and studied under at least two design configurations. The performance of the three architectures was then investigated under three different traffic types representative of traffic found in B-ISDN: random, constant bit rate, and bursty. Several key performance parameters were measured and compared between the architectures. This thesis also explored the implementation complexities and fault tolerance of the three selected architectures

Investigation of SNARE mediated membrane fusion and its regulation by optimized single molecule method

Neurotransmitter release going through synaptic vesicle cycle is one key step how signal is transported in our brains. The mechanism on molecular level has been under development and debated for decades. Many milestones have been made including, the identification of SNARE as core assembly machinery, the clarification of synaptotagmin as calcium sensor, the recognition of NSF and SNAP as disassembly apparatus, the determination of complexin and SM protein as regulatory protein. However, the sequence of their involvement in synaptic vesicle cycle, the relationship between the structure and psychological function, microscale fusion mechanism and are under further investigation. This puzzle is completing with effort from international groups and our group. Complexin as one regulatory protein, has been found owning both inhibitory and facilitatory function. This dual function adds more complication to identify the role of complexin in membrane fusion. Research groups get either inhibitory or facilitatory function based on the experimental condition, which is contradictory. Also, single molecule FRET mixing assay has been adopted widely as one method to isolate membrane fusion system in vitro to give more detailed information on step-by-step mechanism. One major method in single molecule FRET, content mixing, faces obstacles by slow time scale and low fusion percentage. By looking deeper into complexin function, we optimize content mixing and for the first time we observed complexin showing both inhibitory and facilitatory role in a concentration dependent manner